• Journal of the korean academy of Pediatric Dentistry
• /
• v.7 no.1
• /
• pp.53-61
• /
• 1980

The purpose of this study was to statistically evaluate the spacing of primary dentition according to whether or not a space existed and measurement of amount of space in 205 children (male 114, female 91) from 2 to 6 years of age. The results were as follows; 1. In the incidence of interdental space on each region, spacing between the primary lateral incisors and primary canine in maxilla and between the primary canine and 1st primary molar in mandible showed the highest percentage, on the other hand, spacing between the 1st and 2nd primary molars in both jaw showed the lowest percentage. 2. In the kinds of interdental space, the state of primate space and other space together showed the highest percentage, and in the degree of spacing, $S_2$ showed the highest percentage in both jaw. 3. In the incidence of primate space, maxillary primate space showed higher percentage than mandibular primate space in bilateral case. 4. In the type of arch form, spaced arch showed higher percentage than closed arch and about the half of closed arch showed crowding. 5. In both Jaw, available space showed incisor segments, canine segments, and premolar segments in order of amount, and there were not statistically significant differences of sex or jaws in the amount of available space.

• The korean journal of orthodontics
• /
• v.14 no.1
• /
• pp.39-45
• /
• 1984

10years and 8 months old patient, who had been wearing Milwaukee brace for 5 months, was treated by multibanded system without extract on. She complianed severe protrusion and interdental spacing of upper anterior teeth. Cephalometric analysis revealed short anterior facial height, infraclusion of the lower first molars and severe profrusion of upper and lower anterior teeth. During orthodontic treatment Milwaukee brace was replaced by TLSO, so the orthopedic force on the dentofacial region was eliminated. After 2 years and 3 months, she gained raised bite, increased interincisal angle, salient reduction in the protrusion of upper central incisals with agreeable overjet, complete obliteration of interdental spacing and reduction of protrusion of upper and lower lips.

• The Journal of Advanced Prosthodontics
• /
• v.2 no.2
• /
• pp.61-63
• /
• 2010

If orthodontists and restorative dentists establish the interdisciplinary approach to esthetic dentistry, the esthetic and functional outcome of their combined efforts will be greatly enhanced. This article describes satisfying esthetic results obtained by the distribution of space for restoration by orthodontic treatment and porcelain laminate veneers in uneven space between maxillary anterior teeth. It is proposed that the use of orthodontic treatment for re-distribution of the space and the use of porcelain laminate veneers to alter crown anatomy provide maximum esthetic and functional correction for patients with irregular interdental spacing.

• The korean journal of orthodontics
• /
• v.47 no.6
• /
• pp.365-374
• /
• 2017

Objective: The objective of this study is to investigate the eruption pattern and root resorption of the bovine anterior dentition in relation to growth-related parameters based on dental maturity. Methods: A cross-sectional study was conducted on 110 bovine anterior mandibles by using standard radiography, cone-beam computed tomography (CBCT), and actual measurements. We determined the relationships between the stages of dental maturity by using a modification of Demirjian's method and various growth-related parameters, such as the activity of the root-resorbing tissue and mobility of the deciduous teeth. The correlation of growth-related parameters with interdental spacing and distal unusual root resorption (DRR) of the deciduous fourth incisor was assessed. The cause of mesial unusual root resorption (MRR) of the deciduous fourth incisor was determined on the basis of the arrangement of the permanent third incisor. Results: An independent t-test and chi-square test indicated significant differences in growth-related parameters associated with dental arch length discrepancy and factors related to the shedding of deciduous teeth between the low and high dental maturity groups. The samples with interdental spacing and DRR showed a larger sum of mesiodistal permanent crown widths and higher dental maturity than did the respective controls. Samples with MRR tended to show a lingually rotated distal tip of the adjacent tooth crown. Conclusions: Dental maturity has relevance to the interdental spaces and unusual root resorption of mixed dentition. The position of the adjacent tooth crown on CBCT may be correlated with the occurrence of unusual root resorption of the incisor.

• Restorative Dentistry and Endodontics
• /
• v.35 no.1
• /
• pp.30-39
• /
• 2010

This study evaluated the influence of the type of restoration and the amount of interdental spacing on the stress distribution in maxillary central incisors restored by means of porcelain laminate veneers and direct composite resin restorations. Three-dimensional finite element models were fabricated to represent different types of restorations. Four clinical situations were considered. Type I, closing diastema using composite resin. Labial border of composite resin was extended just enough to cover the interdental space; Type II, closing diastema using composite resin without reduction of labial surface. Labial border of composite resin was extended distally to cover the half of the total labial surface; Type III, closing diastema using composite resin with reduction of labial surface. Labial border of the preparation and restored composite resin was extended distally two-thirds of the total labial surface; Type IV, closing diastema using porcelain laminate veneer with a feathered-edge preparation technique. Four different interdental spaces (1.0, 2.0. 3.0, 4.0 mm) were applied for each type of restorations. For all types of restoration, adding the width of free extension of the porcelain laminate veneer and composite resin increased the stress occurred at the bonding layer. The maximum stress values observed at the bonding layer of Type IV were higher than that of Type I, II and III. However, the increasing rate of maximum stress value of Type IV was lower than that of Type I, II and III.

• Journal of Periodontal and Implant Science
• /
• v.26 no.3
• /
• pp.763-769
• /
• 1996

A depressed alvelolar ridge and a collapsed interdental papilla in the anterior region may interfere with esthetic prosthodontic repair. The resultant sequelas will cause overcontoured prosthesis or dark shadow under pontic which may not suffice our patients' esthetic demands. So, surgical periodontal treatment has been needed for esthetic repair in deformed ridges and extensive interproximal spacing. Our treatment option alters Dr.Abram's roll technique to make palatally extended connective tissue secondary pedicle flap to obtain additonal connective tissue. Blood supply maintenance, least trauma, and no secondary wound is advantages in this modification.

• Imaging Science in Dentistry
• /
• v.34 no.2
• /
• pp.63-67
• /
• 2004

Purpose: To make a focal trough (image layer) for an average maxillary dental arch of 6-year-old korean in panoramic radiography. Materials and Methods : Phantom for the maxillary dental arch was designed using intercanine width, intermolar width, tooth size, and interdental spacing to record the data of 6-year-old child. The characteristics of pre-corrected panoramic machine (for adult) was evaluated using the phantom, resolution test pattern for margin of the image layer, and metal ball for the center of the image layer. Panoramic image layer of the child was developed by means of decreasing the speed of film-cassette and positioning the phantom backwards, and then the characteristics of post-corrected panoramic machine (for child) were reevaluated. Results: At post-corrected panoramic image layer, beam projection angles at all interdental areas increased for about 2.6-3.8°, the position of the image layer was shifted toward the rotation center for about 2.5 mm at the deciduous central incisior area. The width of image layer decreased at all areas. Conclusion : Increased beam projection angle will reduce the disadvantage of tooth overlap, and the same form between the center of the image layer and dental arch will improve image resolution.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.30 no.3
• /
• pp.453-458
• /
• 2003

Usually Mylar strip and wedge or celluloid strip crown were used in conventional method of restoring proximal carious lesions of primary anterior teeth. But, these methods have some difficulties to place the matrix and wedge due to short crown lenth and interdental spacing of primary teeth. And it is difficult to form proper cavosurface margin due to the rigidity of matrix and inconvenience to support matrix by practitioner's hand in narrow oral cavity of child. This article describes an alternative technique for restoring carious lesions of primary anterior teeth using available straw. This method is very convenient and reduce chair time and it also allows good marginal adaptation.

• The Journal of Korean Academy of Prosthodontics
• /
• v.59 no.1
• /
• pp.63-70
• /
• 2021

Using computer-aided design and manufacturing technique improve quality of treatment in many aspect. This case reports the complete mouth rehabilitation of a patient with amelogenesis imperfecta utilizing digital technology. Clinical examination revealed loss of mastication due to insufficient occlusal stop, missing teeth, interdental spacing due to microdontia, insufficient overbite, and etc. Full veneer crowns for teeth were selected, followed by a fixed partial denture and implant placement was done using CAD-CAM guide template with bone graft for partially edentulous space. Definitive restorations were duplicated by double scanning provisional restorations and successfully delivered to the patient. These full mouth rehabilitation procedures resulted in satisfactory outcomes for the patient functionally and aesthetically.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.38 no.1
• /
• pp.26-33
• /
• 2022

Anterior tooth spacing is observed by pathological tooth movement (PTM), which is common in periodontal patients. And various occlusal factors contribute to PTM, especially in the maxillary anterior region, when there is excessive occlusal force, flaring due to position problem easily occurs. Teeth with loss of periodontal support tissue can secure stability when expanding the support area through intentional splinting, and change the occlusion when restored as a fixed prosthesis. After confirming the stable occlusion through the provisional prosthesis, it can be transferred to the final prosthesis through CAD-CAM. In this case, we present a long-term stable case through accurate diagnosis and treatment of the maxillary anterior teeth that have lost interdental contact.