• Korean Journal of Materials Research
• /
• v.8 no.3
• /
• pp.229-237
• /
• 1998

We grew the hexagonal GaN films on (100) Si and (00.1) sapphire substrates in the temperature range of $300~730^{\circ}C$ by the direct reaction between thermally ionized N-source and thermally evaporated Ga-source. The GaN growth rates are increased at the initial stage of GaN formation and it was saturated to some values by the coalescence of each crystallites. The oxygen signal was observed in XPS spectra for all the GaN films grown in this work, especially low- temperature grown GaN film may due to incorporation of the residual oxygen in the growth chamber. The surface of low-temperature and shorter time grown films covered only Ga-droplets. however, with increasing the both substrate temperature and the growth time GaN is growth to crystallites. and coalescence to ring-type crystallites. With sufficient supply of N-source, they were changed to platelets. In the PL spectrum measured at 20 K, we observed the impurity related emission at 3.32eV and 3.38eV.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.1
• /
• pp.6-10
• /
• 2009

In this paper, a selective area growth (SAG) of a GaN/AlGaN double heterostructure (DH) has been performed on r-plane sapphire substrate by using the mixed-source hydride vapor phase epitaxy (HVPE) with multi-sliding boat system. The SAG-GaN/AlGaN DH consists of GaN buffer layer, Te-doped AlGaN n-cladding layer, GaN active layer, Mg-doped AlGaN p-cladding layer, and Mg-doped GaN p-capping layer. The electroluminescence (EL) characteristics show an emission peak of wavelength, 439 nm with a full width at half maximum (FWHM) of approximately 0.64 eV at 20 mA. The I-V measurements show that the turn-on voltage of the SAG-GaN/AlGaN DH is 3.4 V at room temperature. We found that the mixed-source HVPE method with a multi-sliding boat system was one of promising growth methods for III-Nitride LEDs.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.33-38
• /
• 2000

The ~1540 nm Er$^{3+}$ photoluminescence (PL) and photoluminescence excitation (PLE) spectra of Er-implanted Mg-codoped GaN (GaN:Er+Mg) exhibit that the excitation efficiency of a specific Er$^{3+}$ center among different Er$^{3+}$ centers existing in Er-implanted GaN is selectively enhanced, compared to Er-implanted undoped GaN (GaN:Er). In GaN:Er+Mg, the 1540 nm PL peaks characteristic of the so-called "violet-pumped" Er$^{3+}$ center and the ~2.8-3.4 eV (violet) PLE band are significantly strengthened by the Mg-doping. The intra-f absorption PLE bands associated with this "violet-pumped" center are also enhanced by this doping. The 1540 nm PL peaks originating from the violet-pumped center dominate the above-gap-excited Er$^{3+}$ PL spectrum of GaN:Er+Mg, whereas it was unobservable under above-gap excitation in GaN:Er. All of these results indicate that Mg doping increases the efficiency of trap-mediated excitation of Er$^{3+}$ emission in Er-implanted GaN.planted GaN.

• Journal of Sensor Science and Technology
• /
• v.25 no.5
• /
• pp.320-325
• /
• 2016

In this paper, we propose an AlGaN/GaN-based extended-gate metal-insulator-semiconductor high electron mobility transistor (MISHEMT)-type biosensor for detecting streptavidin-biotin complexes. We measure the drain current of the fabricated sensor, which varies depending on the antibody-antigen reaction of streptavidin with biotin molecules. To confirm the immobilization of biotin polyethylene glycol (PEG) thiol, we analyze the Au surface of a GaN sample using X-ray photoelectron spectroscopy (XPS). The proposed biosensor shows higher sensitivity than Si-based extended-gate metal oxide semiconductor field effect transistor (MOSFET)-type biosensor. In addition, the proposed AlGaN/GaN-based extended-gate MISHEMT-type biosensor exhibits better long-term stability, compared to the conventional AlGaN/GaN-based MISHEMT-type biosensor.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.411-412
• /
• 2012

대부분의 상용 LED는 사파이어기판에 성장된 GaN를 기반으로 사용한다. GaN는 $1,000^{\circ}C$ 이상의 높은 온도에서 성장이 이루어지는데 이 경우 GaN과 사파이어 기판과의 높은 열팽창 계수로 인하여 compressive stress를 받게 된다. 이 compressive stress로 인하여 성장된 GaN wafer에 bowing이 일어나게 되고 이는 기판의 대면적화에 커다란 문제로 작용한다. 이런 문제들을 해결하기 위해 여러 방법이 고안되고 있지만 [1,2], 근본적으로 wafer bowing 문제의 해결은 이루어지고 있지 않다. 한편, 일반적으로 박막을 성장할 때 columnar structure를 가지는 박막이 coalescence되면 박막에 tensile stress가 걸린다는 사실이 알려져 있으며 [3], GaN를 저온에서 성장할 경우 columnar structure를 갖는다는 사실이 보고되었다 [4]. 본 연구에서는 이런columnar structure를 갖는 GaN을 이용하여 wafer bowing 문제가 해결된 GaN 박막 성장을 연구하였다. 본 실험에서는, c-plane 사파이어에 유기금속화학증착법(MOCVD)을 이용하여 nano-columnar structure를 갖는 저온 GaN layer을 성장하였다. 그 후 columnar structure를 유지하면서 $1,040^{\circ}C$까지 annealing한 후 고온에서 flat 한 GaN 박막을 nano-columnar structure GaN layer위에 성장 하였다. 우선 저온 GaN layer가 nano-columnar structure를 갖고, 고온에서도 nano-columnar structure가 유지되는 것을 scanning electron microscopy (SEM)과 transmission electron microcopy (TEM)을 통해 확인하였다. 또한 이런 columnar structure 위에 고온에서 성장시킨 flat한 GaN 박막이 성장된 것을 관찰할 수 있었다. 성장된 GaN박막의 wafer bowing 정도를 측정한 결과, columnar structure를 갖고 있는 고온 GaN 박막이 일반적인 GaN에 비해 확연하게 wafer bowing이 감소된 것을 확인할 수 있었다. Columnar structure가 coalescence가 되면서 생기는 tensile stress가 GaN박막의 성장시 발생하는 compressive stress를 compensation하여 wafer bowing이 줄어든 것으로 보인다. 본 발표에서는 이 구조에 대한 구조 및 stress 효과에 대해서 논의할 예정이다.

• Korean Journal of Metals and Materials
• /
• v.48 no.5
• /
• pp.456-461
• /
• 2010

We investigated the In-based ohmic contacts on Nitrogen-face (N-face) n-type GaN, as well as Ga-face n-type GaN, for InGaN-based vertical Light Emitting Diodes (LEDs). For this purpose, we fabricated Circular Transfer Length Method (CTLM) patterns on the N-face n-GaN that were prepared by using a laser-lift off method, as well as on the Ga-face n-GaN that were prepared by using a dry etching method. Then, In/transparent conducting oxide (TCO) and In/TiW schemes were deposited on the CTLM in order for low resistance ohmic contacts to form. The In/TCO scheme on the Ga-face n-GaN showed high specific contact resistance, while the minimum specific contact resistance was only 3${\times}$10$^{-2}$ $\Omega$-cm$^{2}$ after annealing at 300${^{\circ}C}$, which can be attributed to the high sheet resistance of the TCO layer. In contrast, the In/TiW scheme on the Ga-face n-GaN produced low specific contact resistance of 2.1${\times}$10$^{5}$ $\Omega$-cm$^{2}$ after annealing at 500${^{\circ}C}$ for 1 min. In addition, the In/TiW scheme on the N-face n-GaN also resulted in a low specific contact resistance of 2.2${\times}$10$^{-4}$ $\Omega$-cm$^{2}$ after annealing at 300${^{\circ}C}$. These results suggest that both the Ga-face n-GaN and N-face n-GaN.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.6
• /
• pp.503-508
• /
• 2008

In order to reduce the piezoelectric field originated from the well layer which resides in InGaN/GaN light emitting diode, InGaN/GaN superlattice buffer layers were grown at the bottom and the top of the active layer. Measuring the photoluminescence spectra with different reverse bias voltages clearly revealed the condition of the flat band under which the transition energy is maximized and the linewidth is minimized. Accordingly, the piezoelectric field of $In_{0.15}Ga_{0.85}N$ in our sample was estimated as -1.08 MV/cm. It is less than half the value reported in the previous studies, and it is evidenced that the strain has reduced due to the superlattice buffer layers.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.1
• /
• pp.1-5
• /
• 2009

In this study, we performed growth of InGaN/GaN multi quantum well (MQW) structures on semi-polar (1-10]) GaN facet on 8-degree off oriented stripe patterned (100) Si substratcs by MOVPE. The structural and optical properties of the InGaN/GaN multi quantum well (MQW) structures grown on (1-101) GaN stripe depend on $NH_3$ flow rate, TMI flow rate and growth temperature are characterized by cathodoluminescence (CL) and scanning electron microscopy (SEM). With the decrease of $NH_3$ flow rate, the threading dislocation of (1-101) GaN is considerably reduced. We could control the transition wavelength of InGaN/GaN MQW structures from 391.5 nm to 541.2 nm depend on the growth conditions.

• Journal of the Korean Vacuum Society
• /
• v.11 no.1
• /
• pp.50-58
• /
• 2002

The growth of GaN films on Si substrate has many advantages in that Si is less expensive than sapphire substrate and that integration of GaN-based devices with Si substrate is easier The difference of lattice constant and thermal expansion coefficient between GaN and Si is larger than those between GaN and sapphire. However, which results in many defects into the grown GaN. In order to obtain high duality GaN films on Si substrate, we need to reduce defects using the buffer layer such as AlN. In this study, we prepared three types of AlN buffer layer with various crystallinity on Si (111) substrate using MOCVD, Sputtering and MOMBE methods. GaN was grown by MOCVD on three types of AlN/Si substrate. Using TEM and XRD, we carried out comparative investigation of growth and properties of GaN deposited on the various AlN buffers by characterizing lattice coherency, crystallinity, growth orientation and defects formed (voids, stacking faults, dislocations, etc). It is found that the crystallinity of AlN buffer layer has strong effects on growth of GaN. The AlN buffer layers grown by MOCVD and MOMBE showed the reduction of out-of-plane misorientation of GaN at the initial growth stage.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.3
• /
• pp.387-387
• /
• 1998

This paper reports on a thermodynamic analysis for the GaN thick film growth by vapor phaseepitaxy method. The thermodynamic calculation was performed using a chemical stoichiometric algorism. Thesimulation variables include the growth temperature in a range 400~1500 K, the gas ratios $(GaCl_3)/(GaCl_3+NH_3)$and $(N_2)/(GaCl_3+NH_3)$. The theoretical calculation predicts that the growth temperature of GaN be in thelower range of 450~750 K than the experimental results. The difference in the growth temperature betweenthe simulation and the experiments indicates that the vapor phase epitaxy of GaN is kinetically limited,presumably, due to the high activation energy of thin film growth.