• 전기전자학회논문지
• /
• 제23권1호
• /
• pp.53-57
• /
• 2019

본 논문에서는 스위칭 소자를 줄이기 위한 새로운 Z-소스 인버터의 구조와 PWM 펄스 제어 방법에 대하여 제안하였다. 개선된 Z-소스 인버터는 Z-네트워크가 DC전압과 인버터 사이가 아닌 인버터 뒷단과 접지 사이에 연결되며, 이러한 개선된 Z-소스 인버터는 커패시터 돌입 전류 제한 기능과 커패시터 전압 스트레스가 작은 장점을 가지고 있다. 개선된 Z-소스 인버터에서 스위치를 6개에서 4개로 줄이는 새로운 형태의 스위치 저감형 Z-소스 인버터의 Topology를 제안하고, 제안된 Topology에 적합한 PWM 제어 방법을 개발하였다. 제안된 방법은 PSIM 시뮬레이션을 통해 특성과 성능을 확인하였다.

• 전기학회논문지
• /
• 제61권10호
• /
• pp.1432-1441
• /
• 2012

In this study, an improved LCCT(Inductor-Capacitor-Capacitor-Trans) Z-source inverter(Improved LCCT ZSI) with characteristics of Quasi Z-source inverter(QZSI) and LCCT Z-source inverter(LCCT ZSI) is proposed. The proposed inverter can also reduce the voltage stress and input current/capacitor voltage ripples compared with conventional LCCT ZSI and Quasi ZSI. A two winding trans in Z-impedance network of the conventional LCCT ZSI is replaced by a three winding trans in the proposed inverter. To verify the validity of the proposed inverter, a DSP controlled hardware was made and PSIM simulation was executed for each method. Comparing the current and voltage ripples of each method under the condition of input DC voltage 70[V] and output AC voltage 76[Vrms], the input current and capacitor voltage ripple factors of the proposed inverter were low as 11[%] and 1.4[%] respectively. And, for generation of the same output AC voltage of each method, voltage stress of the proposed inverter was low as 175[V] under the condition of duty ratio D=0.15. As mentioned above, we could know that the proposed inverter have the characteristics of low voltage stress, low ripple factor and low operation duty ratio compared with the conventional methods. Finally, the efficiency according to load change/duty ratio and the transient state characteristics were discussed.

• Journal of Electrical Engineering and Technology
• /
• 제7권5호
• /
• pp.714-723
• /
• 2012

A new Z-source inverter (ZSI) topology is developed to improve voltage boost ability. The proposed topology is modified from the switched inductor topology by adding some more inductors and diodes into inductor branch to the conventional Z-source network. The modulation methods developed for the conventional ZSI can be easily utilized in the proposed ZSI. The proposed ZSI has an ability to obtain a higher voltage boost ratio compared with the conventional ZSI under the same shoot-through duty ratio. Since a smaller shoot-through duty ratio is required for high voltage boost, the proposed ZSI is able to reduce the voltage stress on Z-source capacitor and inverter-bridge. Theoretical analysis and operating principle of the proposed topology are explicitly described. In addition, the design guideline of the proposed Z-source network as well as the PWM control method to achieve the desired voltage boost factor is also analyzed in detail. The improved performances are validated by both simulation and experiment.

• Journal of Power Electronics
• /
• 제17권5호
• /
• pp.1195-1202
• /
• 2017

This paper presents a novel topology named a modified capacitor-assisted Z-source inverter (MCA-ZSI) based on the traditional ZSI. The impedance network of the proposed MCA-ZSI consists of two symmetrical cells coupled with two capacitors with an X-shape structure, and each cell has two inductors, two capacitors, and one diode. Compared with other topologies based on switched ZSI with the same number of components used at impedance network, the proposed topology provides higher boost ability, lower voltage stress across inverter switching devices, and lower capacitor voltage stress. The improved performances of the proposed topology are demonstrated in the simulation and experimental results.

• 전력전자학회논문지
• /
• 제18권2호
• /
• pp.123-130
• /
• 2013

This paper proposes the switched trans Z-source inverter(STZSI) which combined the characteristics of the trans Z-source inverter(TZSI) and the switched inductor Z-source inverter(SLZSI). The proposed STZSI has the same performance compared with the SLZSI which is improved the voltage boost performance of the conventional typical X-shaped ZSI, and it has advantage that circuit structure of Z-impedance network is more simple. And, in order to step up the voltage boost factor under the condition of the same duty ratio, unlike the SLZSI adding the inductors and diodes, the proposed method is dune by changing the turn ratio of trans primary winding of Z-impedance network. To confirm the validity of the proposed method, PSIM simulation and a DSP(TMS320F28335) based experiment were performed using trans with turn ratio 1 and 2 under the condition of the input DC voltage VI=50V, duty ratio D=0.1 and D=0.15. As a result, under the same input/ouput condition, the inverter arm voltage stress of the proposed method is reduced to about 15%-22% as compared with typical X-shaped ZSI, and the elements in Z-impedance network of the proposed method is reduced as compared with the SLZSI.

• Journal of Power Electronics
• /
• 제14권5호
• /
• pp.834-841
• /
• 2014

This paper proposes new active switched-capacitor and switched-inductor Z-source inverter (ASC/SL-ZSI) topologies, which can provide a higher boost ability with a small shoot-through time. The proposed ASC/SL-ZSIs inherit all of the advantages of the classical ZSI, and have a stronger voltage boost inversion ability when compared with the classical ZSI. Thus, the output ac voltage quality is significantly improved. In addition, more cells can be cascaded in the impedance network in order to obtain a very high boost ability. The proposed topologies can be applied to photovoltaic or fuel-cell generation systems with low-voltage renewal sources due to their wide range of obtainable voltages. Both simulations and the experimental results are carried out in order to verify performance of the proposed topologies.

• Journal of Power Electronics
• /
• 제14권1호
• /
• pp.11-21
• /
• 2014

A novel switched-inductor quasi-Z-source inverter is proposed in this study. Compared with classic topologies, the boost ability of the proposed topology is strengthened. The voltage stress of the capacitors, diodes, and power devices are reduced, and the current ripple of the DC voltage source is suppressed. Conversion efficiency is also improved. The operation principle of the proposed topology is analyzed in detail and compared with that of similar topologies. The feasibility of the proposed topology is verified by simulations and experiments on a laboratory prototype.

• Journal of Electrical Engineering and Technology
• /
• 제9권2호
• /
• pp.541-549
• /
• 2014

In this paper, an extended switched-inductor quasi-Z-source inverter (ESL-qZSI) with high boost voltage inversion ability is presented, which combines the SL-qZSI with the traditional boost converter, as well as improves the switched-inductor cell. Compared with the classic qZSI topologies, the proposed topology reduces the voltage stresses of capacitors, power devices and diodes for the same input and output voltage. Furthermore, the conversion efficiency is improved. The operation principle of the proposed topology is analyzed in details, which is followed by the comparison between the three topologies. In addition, the performance of the proposed topology is verified by simulations and experiments.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2012년도 전력전자학술대회 논문집
• /
• pp.482-483
• /
• 2012

In this paper, the operation of current-fed quasi-Z-source inverter (QZSI) with buck-boost function, improved reliability, and regeneration capability is analyzed. The modified space modulation technique for controlling effectively both shoot-through time and zero voltage time is suggested. The simulation result is carried out in order to verify the performance of proposed technique.

• Journal of Power Electronics
• /
• 제18권3호
• /
• pp.931-943
• /
• 2018

Wireless power transfer (WPT) technology has been the focus of a lot of research due to its safety and convenience. The Z-source inverter (ZSI) was introduced into WPT systems to realize improved system performance. The ZSI regulates the dc-rail voltage in WPT systems without front-end converters and makes the inverter bridge immune to shoot-through states. However, when the WPT system is combined with a ZSI, the system parameters must be configured to prevent the ZSI from entering an "accidental shoot-through" (AST) state. This state can increase the THD and decrease system power and efficiency. This paper presents a mathematical analysis for the characteristics of a WPT system and a ZSI while addressing the causes of the AST state. To deal with this issue, the impact of the system parameters on the output are analyzed under two control algorithms and the primary compensation capacitance range is derived in detail. To validate the analysis, both simulations and experiments are carried out and the obtained results are presented.