• Membrane and Water Treatment
• /
• v.4 no.1
• /
• pp.69-81
• /
• 2013

The pH-dependent inter-conversion of the three free chlorine species ($Cl_2$, HOCl, OCl-) present in the aqueous hypochlorite solution was theoretically investigated. Each species was found overwhelmingly present in a characteristic pH range. Hypochlorite treatment of the polyamide membrane was carried out over these pH ranges and various membrane responses were observed. As pH is less than 8, membrane tends to be N-chlorinated by $Cl_2$ and HOCl, and N-chlorinated membrane showed reduced water permeance and salt rejection. As pH rises to 10-12, $OCl^-$ appears to be the dominating chlorine species. Membrane hydrolysis was found to well interpret the improved water permeance and salt rejection. When the pH is between 8-10, both N-chlorination and hydrolysis contribute to the response of the membrane, and the treated membrane showed improved salt rejection but reduced water permeation. Excessive hydrolysis occurred while the membrane was treated at pH 13 for the much stronger alkalinity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.12 s.115
• /
• pp.1199-1205
• /
• 2006

This paper proposes a wideband monopole antenna with improved band rejection characteristics by inserting two band notch slots with half wavelength in radiator. The designed antenna is composed of bow-tie patch fed electromagnetically with parasitic ground patch of a semicircular shape. We obtained band rejection filter-like characteristics by controlling coupling amounts between two horizontal resonance slots. Using this technique, we achieved the broad rejection bandwidth and improved skirt characteristics compared with only one notch slot. The measured bandwidth is from 2.7 GHz to 6.9 GHz for VSWR below 2.0 except the limited band of $4.96{\sim}5.51GHz$. This antenna shows a similar radiation pattern of the ideal monopole and the radiation gain reduction is more than $5{\sim}10dB$ on the x-z plane at rejection frequency.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.12 no.3
• /
• pp.313-319
• /
• 2012

The power supply rejection (PSR) of low drop-out (LDO) voltage regulator is improved by employing an error amplifier (EA) which is configured so the power supply noise be cancelled at the output. The LDO regulator is implemented in a 0.13-${\mu}m$ standard CMOS technology. The external supply voltage level is 1.2-V and the output is 1.0-V while the load current can range from 0-mA to 50-mA. The power supply rejection is 46-dB, 49-dB, and 38-dB at DC, 2-MHz, and 10-MHz, respectively. The quiescent current consumption is 65-${\mu}A$.

• Journal of Electrical Engineering and information Science
• /
• v.3 no.1
• /
• pp.126-130
• /
• 1998

In this paper, a new interference rejection filter using the data-recycling technique is presented. The reference signal of the interference rejection filter is formed by using chip decisions, which is correlated with the narrowband interference components of the received signal. The decision feedback techniques reduce the distortion of the desired signal, which is introduced by the interference rejection filter through he use of feedback chip decisions. In order to update the filter coefficients a simple and efficient data-recycling technique that has improved performance over the conventional LMS algorithm is used. The performance of the proposed interference rejection filter is compared to filter with conventional LMS linear filter. The results show that the convergence speed of the proposed interference rejection filter using decision feedback and data-recycling technique is significantly faster than that of the conventional filters. Also, BER performance of the interference rejection filter demonstrates the superiority of the proposed filter algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.3
• /
• pp.211-216
• /
• 1986

This paper presents theoretical analysis and experimental results on an improved interference rejection circuit in the presence of continuous wave interference at center frequency, particularly in a wide-band communication systems. This circuit is based upon a phase locked loop for estimating the CW interference phase and the MSE technique to minimize the estimation error. Therefore, the introduced rejection circuit that minimized the estimated phase error outperforms the rejection circuit with phase estimation only. As a result of experiment, we confirm that this proposed rejection circuit gives a high degree of interference rejection performances when the input J/S is large.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.1120-1123
• /
• 1996

DMC(Dynamic Matrix Control) algorithm has been successfully used in industries for more than a decade. It can handle constraints and easily extended to MIMO case. The application of DMC, however, is limited to the open loop stable process because it uses the FIR(Finite Impulse Response) or FSR(Finite Step Response) model. Integrating process widely used in chemical process industry, is the representative open loop unstable process. The disturbance rejection of DMC is relatively poor due to the assumption that the current disturbance is equivalent to the future disturbance. We propose the IDMC(Improved Dynamic Matrix Control) for the integrating process, as well as non-integrating process. IDMC has shown better disturbance rejection using multi-step ahead predictor for the disturbance.

• Membrane and Water Treatment
• /
• v.12 no.2
• /
• pp.65-73
• /
• 2021

Sponge ball cleaning can generate an abrasion effect, which leads to an attractive increasing in both permeate flux and membrane rejection. The aim of this study was to investigate the influence of the daily sponge ball cleaning (SBC) on the performance of different UF cross-flow membrane modules integrated with a bioreactor. Two 1"-membrane modules and one 1/2"-membrane module were tested. The parameters measured and controlled are temperature, pH, viscosity, particle size, dissolved organic carbon (DOC), total suspended solids (TSS), and permeate flux. The permeate flux could be improved by 60%, for some modules, after 11 days of daily sponge ball cleaning at a transmembrane pressure of 350 kPa and a flow velocity of 4 m/s. Rejection values of all tested modules were improved by 10%. The highest permeate flux of 195 L/㎡.h was achieved using a 1"-membrane module with the aid of its negatively charged membrane material and the daily sponge ball cleaning. In addition, the enhancement in the permeate flux caused by daily sponge ball cleaning improved the energy specific demand for all tested modules. The negatively charged membrane showed the lowest energy specific demand of 1.31 kWh/㎥ in combination with the highest flux, which is a very competitive result.

• Transactions on Electrical and Electronic Materials
• /
• v.7 no.4
• /
• pp.196-203
• /
• 2006

An air-gap type FBAR was designed using Leach equivalent model for analyzing a vertical structure of the FBAR. For the top electrode, Pt, and the bottom electrode, Au, of $1.2{\mu}m$ thickness and the piezoelectric of 0.8,urn thickness, the resonance and anti-resonance occurred at 2.401 GHz and 2.460 GHz, respectively. $S_{11}$ was increased and $S_{21}$ was decreased as the resonance area of FBAR was widened. We observed the characteristics of insertion loss, bandwidth and out-of-band rejection of ladder-type FBAR BPF by changing resonance areas of series and shunt resonators and by adding stages. As the resonance area of series resonator was increased, insertion loss was improved but out-of-band rejection was degraded. And as the resonance area of shunt resonator was increased, insertion loss was degraded a little but out-of-band rejection was improved even without adding stages. We, also, changed the shape of the resonance area from square shape to rectangle shape to examine the effects of the resonator shape on the characteristics of the BPF. The best performances were observed when the sizes of series and shunt resonator are $150{\mu}m{\times}l50{\mu}m\;and\;5{\mu}m{\times}50{\mu}m$, respectively. Out-of-band rejection was improved about 10dB and bandwidth was broadened from 30MHz to 100MHz utilizing inductor tuning on $2{\times}2\;and\; 4{\times}2$ ladder-type BPFs.

• Molecules and Cells
• /
• v.39 no.8
• /
• pp.639-644
• /
• 2016

Discovery of non-invasive diagnostic and predictive biomarkers for acute rejection in liver transplant patients would help to ensure the preservation of liver function in the graft, eventually contributing to improved graft and patient survival. We evaluated selected cytokines and chemokines in the sera from liver transplant patients as potential biomarkers for acute rejection, and found that the combined detection of IL-10, IL-17, and CXCL10 at 1-2 weeks post-operation could predict acute rejection following adult liver transplantation with 97% specificity and 94% sensitivity.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.8
• /
• pp.47-52
• /
• 2008

In order to enhance the rejection performance of the UWB bandpass filter based on the Composite Right- and Left-Handed Transmission-line(CRLH-TL) Metamaterial cell, we propose the lowpass filtering concept that fits into the design objectives : Keeping metamaterial property and miniaturization. So the bandpass filter itself is made far less than a quarter-wavelength and a pair of symmetric comprises lowpass filtering blocks are placed before and after the center CRLH filter which comprises tile interdigitated coupled lines and short-circuited stob. The design result will show the size of 'guided wavelength/8', the fractional bandwidth over 100%, the insertion loss much less than 1 dB, a flat Group-Delay and a good return loss performance, as expected.