• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 1998.10a
• /
• pp.414-418
• /
• 1998

This study was carried out to analyze permeability of steel slag. Three molds with the same grading of raw steel slag were used to measure the coefficient of permeability. Darcy's law could be applied to the steel slag below 0.5 of critical hydraulic gradient because the water flow changed from laminar flow to turbulent flow above the critical hydraulic gradient. Also, the velocity of flow changed according to hydraulic gradient. The coefficient of permeability of the specimen was $\alpha$$\times$10$^{-3}$ cm/ sec.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1998.10a
• /
• pp.285-291
• /
• 1998

A hydraulic pin-on-disk type tribotester was developed and it's performance was investigated experimentally. The estimate of the performance was accomplished by comparing those of the pneumatic and the dead-weight loading method. The reliability to the performance was conformed. By hydraulic loading method more accra'ate friction coefficient could be got.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.725-732
• /
• 2003

It was achieved that Rowecell test for this undisturbed sample was picked by Block sampler($\phi$:250mm, L:500mm) and hydraulic piston sampler($\phi$:76mm, L:850mm) in the marine clay of YONGYUDO and YEONGJONGDO in this research. Ratio of coefficient of consolidation was analyzed through comparison with C$\_$h/ by CPTu and C$\_$v/ and C$\_$h/ by existent consolidation test. According to analysis, coefficient of consolidation of block sample is fairly greater than coefficient of consolidation of piston sample. And the bigger diameter of undisturbed sample, sample disturbance could know decreasing. Coefficient of consolidation by Rowecell test measured more greatly than coefficient of consolidation by existent consolidation test. Rowecell test could know decreasing consolidation rate because of smear effect by Mandrel injection. Also, C$\_$h/ by CPTu shows deviation by each analysis method, selection of suitable analysis method judged by important leading in the coefficient of consolidation.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.60-68
• /
• 2010

In this study, the seepage flow monitoring method by hydaulic head loss rate graph was developed for the purpose of monitoring the seepage flow from the see side or from the lake on sea dike in which seepage force was varied periodically. The hydraulic head loss rate was defined in this method. The value of the rate is in the range from 0 to 1. the value of 0 means perfectly free flow of seepage. the value of 1 means perfect waterproofing. The value of coefficient of determination in the hydraulic head loss rate graph closer to 1 means that the seepage flow way is stable. The value of coefficient of determination in the hydraulic head loss rate graph closer to 0 means that the hole may exist or the piping may be in the progress. The pore water pressure data measured in Saemangeum sea dike was analyzed with the developed method The result showed that the variation of seepage flow state was detected sensitively by this method and the interception effect of sea dike could be estimated quantitatively.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.9 no.2
• /
• pp.87-93
• /
• 2009

The labyrinth weir can be defined that the plane shape of overflow part is not straight line and is a kind of weir having overflow length increased by changing its plane shape. Recently, the labyrinth weir can be widely applied to various hydraulic facilities such as dam spillway, irrigation facilities, and canal structures by increasing precipitation. This study was performed to analyze the hydraulic characteristics according to triangle labyrinth weir using hydraulic model experiments and finally estimate the discharge coefficients for triangle labyrinth weirs. The formulae of discharge coefficient provided in this study, which make it feasible to calculate the overflow rate by a coefficient of correlation. sum of residuals, MAPE(Mean Absolute Percentage Error), are expected to be widely applied to design of hydraulic facilities such as dam spillway and irrigation system.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.43 no.6
• /
• pp.749-762
• /
• 2023

A depth-integrated model with an approximate Riemann solver for flux computation of the shallow water equations was applied to hydraulic jump experiments. Due to the hydraulic jump, different flow regimes occur simultaneously in a single channel. Therefore, the Weisbach resistance coefficient, which reflects flow conditions rather than the Manning roughness coefficient that is independent of depth or flow, has been employed for flow resistance. Simulation results were in good agreement with experimental results, and it was confirmed that Manning coefficients converted from Weisbach coefficients were appropriately set in the supercritical and subcritical flow reaches, respectively. Limitations of the shallow water equations that rely on hydrostatic assumptions have been revealed in comparison with hydraulic jump experiments, highlighting the need for the introduction of a non-hydrostatic shallow-water flow model.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.17 no.3
• /
• pp.3833-3839
• /
• 1975

The object of this experiment is to find out some flow characteristics of water through sand layer, to prevent moving sands in the filters of the fill Dam, infiltration gallery, well and Deversion Weir. This experiment was accomplished with different particle Sizes of Six Samples and different hydraulic gradient. The results obtained are Summarized as follows. 1. The critical hydraulic gradients for laminar flow was found to be between 1 and 2 when the sand used had the effective diameter, D10 of between 0.18cm and 0.45cm. 2. The critical hydraulic gradients for different particle sizes of sands were varied considerably. 3. There was a negative correlation between critical hydraulic gradient and critical Velocity, and between effective particle diameter D10 and critical hydraulic gradient respectively. 4. In spite of relatively small variation of void ratio of sands used, the values of the coefficient of permeability varied considerably. There was a negative correlation between coefficient of permeability and void ratio.

• Journal of the Korean Society for Precision Engineering
• /
• v.16 no.5 s.98
• /
• pp.194-199
• /
• 1999

For the purpose of improving accuracy in friction and wear test, a hydraulic pin-on-disk type tribotester was developed and its performance was evaluated experimentally. The performance estimation of the tribotesrer was accomplished by comparing both the consistency of the applied normal load and the robustness of the control against the mechanical disturbances with those of the pneumatic and the dead weight loading method respectively. The developed hydraulic pin-on-disk type tribotester showed the better reliability in the performance and the hydraulic loading method provided the more accurate friction coefficient.

• Journal of Ocean Engineering and Technology
• /
• v.38 no.4
• /
• pp.164-173
• /
• 2024

In this study, a submerged breakwater with effective wave control and eco-friendly characteristics is developed and proposed. Hydraulic experiments are conducted to compare the hydraulic performance of a submerged breakwater and an eco-friendly double-row submerged breakwater. The hydraulic characteristics are analyzed based on wave reflections and the transmission-splitting method for each experimental cross-section. This splitting technique utilizes Goda's two-point method, which employs the spectra of two irregular superposed wave fields. In addition, the reliability of the results obtained from the hydraulic experiments is discussed by comparing the results with empirical formulas. The eco-friendly double-row submerged breakwater features approximately half the width of a typical submerged breakwater. Nevertheless, its transmission coefficient (K_T) is approximately 20% more effective, and the difference in the average reflection coefficient (K_R) values between the two is approximately 0.17. Moreover, the dissipation coefficient (K_D) shows a generally similar trend. Based on these experimental results, the hydraulic performance of the eco-friendly double-row submerged breakwater is more efficient regarding wave control, compared with a typical submerged breakwater. These hydraulic characteristics confirm that the numerical model developed for the eco-friendly double-row submerged breakwater accurately reproduces the K_T, K_R, and K_D values within ±5%.

• Microbiology and Biotechnology Letters
• /
• v.25 no.4
• /
• pp.427-433
• /
• 1997

Sludge Returned CMAS process was applied to treat the wastewater from electric accessory manufacturing company while this type of wastewater was usually treated by chemical process. This result show that the removal rate of TCOD was about 70-80% regardless of hydraulic retention time, On the contrary, the removal rate of BOD was abtained in a range of 77-92% depending on hydraulic retention time. In order to remove more than 80% of organic materials with the proposed process, the F/M ratio should be maintained below 0.17. In this case, the calculated value of organic removal rate, Km, was calculated to be 1.26 hr$^{-1}$, and the ratio of cell synthesis/total energy was 0.32 and 0.26 for COD and BOD base, respectively. The yield coefficient was calculated to be 0.242 and the half velocity coefficient was 0.3 hr$^{-1}$. The value of endogenous respiration coefficient was 0.02 hr$^{-1}$. The measured effluent BOD concentration, MLSS concentration in aeration tank, oxygen uptake rate, and sludge production were matched relatively well with the calculated values using above coefficients, In order to optimize the dewatering of sludge, the hydraulic retention time was recommended to be 15. 6 hrs. These results indicate that the wastewater from an eletric accessory manufacturing company can be treated safely with a biological process.