• 전기학회논문지P
• /
• 제66권4호
• /
• pp.188-193
• /
• 2017

In this paper, a ZVS-PWM high-frequency inverter with a PWM control function is applied to commercial system 220[Vrms], and a resonator type ZVS-PWM high-frequency inverter circuit with a fixed-two methods were proposed. The parameters of the transformer model equivalent circuit of a copier fixing device, which is an essential element in the parameter optimization of the proposed circuit, are obtained by using a high-frequency amplifier and its frequency characteristics are described. The proposed method compared to the existing single-ended ZVS-PFM high frequency inverter can suppress the voltage and current peak value of the power semiconductor switching device and reduce the switching loss. The efficiency of the proposed method itself is 98[%] at rated power output. Also, the efficiency of 96[%] can be obtained even at low output, so that the proposed high frequency inverter is very efficient inverter. The total efficiency from the commercial AC input to the inverter output is 93[%] at rated, which is considered efficient for use in copying machines. In addition, the diode bridge loss accounts for the largest portion of the overall system efficiency distribution. On the other hand, the nonparallel filter has a very low loss.

• 한국전자파학회논문지
• /
• 제29권9호
• /
• pp.677-684
• /
• 2018

본 연구는 S-parameter를 이용한 변압기의 고주파 모델링 방법을 제시한다. 1차측과 2차측을 단락 또는 개방 회로를 구성하여 각 상태에서의 반사계수를 Vector Network Analyzer로 측정하였다. 측정 결과로부터 등가회로 소자를 추출하여 고주파 등가회로를 모델링하고, 2-port 회로에서 측정한 S-parameter 측정치와 시뮬레이션 결과를 비교함으로써 타당성을 검증하였다. 이는 정확하고 예측 가능한 고주파 변압기를 설계하는데 적용될 수 있다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제14권6호
• /
• pp.768-776
• /
• 2014

Using a simplified high-frequency small-signal equivalent circuit model for BSIM3 MOSFET, the fully differential two-stage folded-cascode CMOS operational amplifier is analyzed to obtain its small-signal voltage transfer function. As a result, the expressions for dc gain, five zero frequencies, five pole frequencies, unity-gain frequency, and phase margin are derived for op amp design using design equations. Then the analysis result is verified through the comparison with Spice simulations of both a high speed op amp and a low power op amp designed for the $0.13{\mu}m$ CMOS process.

• 대한전자공학회논문지SD
• /
• 제43권6호
• /
• pp.9-17
• /
• 2006

SoC(System-On-Chip) 시스템에서 초 저전력 시스템을 구현하기 위한 dynamic voltage and frequency scaling (DVFS)알고리즘에 사용될 시스템 버스의 다중 코어 전압 레벨을 생성해주는 새로운 다계층(multi-level) 코어 전압용 high-speed level up/down Shifter 회로를 제안한다. 이 회로는 내부 회로군과 외부 회로군 사이에서 서로 다른 전압레벨을 조정 접속하는 I/O용 level up/down shifter interface 회로로도 동시에 사용된다. 제안하는 회로는 인터페이스 접속에서 불가피하게 발생하는 속도감쇄와 Duty Ratio 불안정 문제를 최소화하는 장점을 갖고 있다. 본 회로는 500MHz의 입력 주파수에서 $0.6V\sim1.6V$의 다중 코어 전압을 각 IP들에서 사용되는 전압레벨로, 또는 그 반대의 동작으로 서로 Up/Down 하도록 설계하였다 그리고 제안하는 I/O 용 회로의 level up shifter는 500MHz의 입력 주파수에서 내부 코어 용 level up shifter의 출력전압인 1.6V를 I/O 전압인 1.8V, 2.5V, 3.3V로 전압레벨을 상승 하도록 설계하였으며, level down shifter는 반대의 동작으로 1Ghz의 입력 주파수에서 동작하도록 설계하였다. 시뮬레이션 및 결과는 $0.35{\mu}m$ CMOS Process, $0.13{\mu}m$ IBM CMOS Process 와 65nm CMOS model 변수를 이용한 Hspice를 통하여 검증하였다. 또한, 제안하는 회로의 지연시간 및 파워소모 분석과 동작 주파수에 비례한 출력 전압의 Duty ratio 왜곡에 대한 연구도 하였다.

• 전기전자학회논문지
• /
• 제22권2호
• /
• pp.480-483
• /
• 2018

Wireless power transfer (WPT) is the technology that forces the power to transmit electromagnetic field to an electrical load through an air gap without interconnecting wires. This technology is widely used for the applications from low power smartphone to high power electric railroad. In this paper, the model of wireless power transfer circuit for the low power system is designed for a resonant frequency of 13.45 MHz. Also, a feedback WPT circuit to improve the power transfer efficiency is proposed and shown better performance than the original open WPT circuit, and the methodology for power efficiency improvement is studied as the coupling coefficient increases above 0.01, at which the split frequency is made.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.90-94
• /
• 2000

A conventional power supply to drive a microwave oven has ferro-resonant transformer and high voltage capacitor(HVC). Though it is simple transformer is bulky heavy and has low-efficiency. To improve this defect a high frequency switching inverter-type power supply has been investigated an developed. in recent years. But because of it's additional circuit and devices inverter-type power supply is more expensive than conventional one. In this paper The design procedure of a novel HVC embedded high frequency transformer is proposed for down-sizing and cost reduction. Also transformer equivalent circuit model is derived by FEM analysis and parameter measurements. And the operation of proposed HVC embedded transformer is verified by simulation and experimental results.

• ETRI Journal
• /
• 제31권3호
• /
• pp.298-303
• /
• 2009

A single-switch parallel resonant converter for induction heating is implemented. The circuit consists of an input LC-filter, a bridge rectifier, and a controlled power switch. The switch operates in soft commutation mode and serves as a high frequency generator. The output power is controlled via the switching frequency. A steady state analysis of the converter operation is presented. A closed-loop circuit model is also presented, and the experimental results are compared with the simulation results.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제41회 하계 정기 학술대회 초록집
• /
• pp.142-142
• /
• 2011

Microwave diagnostics method for plasma science and engineering is vigorous research area for its good characteristics such as high sensitivity, reliability, and broad measurement spectrum from low density plasma to high density. We investigate mechanism of microwave probes (hairpin, impedance and absorbtionf probe) and apply it for interpretation of full transmitted spectrum of cutoff probe. Mechanism of the spectrum having same key roles of I-V curve of Langmuir probe is not exactly revealed yet in spite of its importance. This study elucidates physics behind it using a circuit model and E/M wave simulation. Circuit model reveals exact cut-off peak frequency taking account of a collision frequency and a plasma frequency and it enable precise diagnostics of plasma densty from low pressure to high pressre. Cut-off like peaks have been obstacle for choosing cut-off peak is analyzed by E/M simulation and one of cutoff like peaks made by probe holder used for acquire plasma density with cutoff peak applying the hairpin relation. Furthermore, phase difference method for plasma density is conducted. This method uses a single microwave frequency source and it is low-priced.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제13권6호
• /
• pp.556-561
• /
• 2013

Interest in spin-torque oscillators (STOs) has been increasing due to their potential use in communication devices. In particular the magnetic tunnel junction-based STO (MTJ-STO) with high perpendicular anisotropy is gaining attention since it can generate high output power. In this paper, a circuit-level model for an in-plane magnetized MTJ-STO with partial perpendicular anisotropy is proposed. The model includes the perpendicular torque and the shift field for more accurate modeling. The bias voltage dependence of perpendicular torque is represented as quadratic. The model is written in Verilog-A, and simulated using HSPICE simulator with a current-mirror circuit and a multi-stage wideband amplifier. The simulation results show the proposed model can accurately replicate the experimental data such that the power increases and the frequency decreases as the value of the perpendicular anisotropy gets close to the value of the demagnetizing field.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 A
• /
• pp.462-464
• /
• 1994

In this paper, noble electrical equivalent circuit ultrasonic motor is applied by model of parallel one from mechanical equation of piezoelectric device and characteristics estimation is done by equivalent converter. Uitrasonic motor is driven by oscillation circuit of two-phase high frequency inverter. Operating frequency of inverter is described by tracking control method of resonance frequency, according to change of load, temperature etc.