• Journal of the Semiconductor & Display Technology
• /
• v.12 no.4
• /
• pp.21-25
• /
• 2013

This paper is for enhancing the breakdown voltage of MHEMTs with an InP-etchstop layer. The fully removed recess structure in the drain side of MHEMT shows that the breakdown voltage enhances from 2 V to 4 V in the previous work. This is because the surface effect at the drain side decreases the channel current and the impact ionization in the channel at high drain voltage. In order to increase the breakdown voltage at the same asymmetric gate-recess structure, the InGaAs channel structure is replaced with the InGaAs/InP composite channel in the simulation. The simulation results with InGaAs/InP channel show that the breakdown voltage increases to 6V in the MHEMT as the current decreases. In this paper, the simulation results for the InGaAs/InP channel are shown and analyzed for the InGaAs/InP composite channel in the MHEMT.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.213-216
• /
• 2001

The use of a thin film of indium between the ITO and the $n^{+}$-InP contact layers for InP/InGaAs HPTs was studied without degrading its excellent optical transmittance properties. ITO/$n^{+}$-InP ohmic contact was successfully achieved by the deposition of Indium and thermal annealing. The specific contact resistance of about 6.6$\times$$10^{-4}$$\Omega\textrm{cm}^2$ was measured by use of the transmission line method (TLM). However, as the thermal annealing was just performed to ITO/$n^{+}$-InP contact without the deposition of Indium between ITO and $n^{+}$-InP, it exhibited schottky characteristics. In the applications, the DC characteristics of InP/InGaAs HPTs with ITO emitter contacts was compared with that of InP/InGaAs HBTs with the opaque emitter contacts.

• Journal of the Korean Vacuum Society
• /
• v.20 no.4
• /
• pp.271-275
• /
• 2011

The role and effect of Sb surfactant on structure and properties of p type gallium nitride (GaN) epilayers have been investigated. It was found that there was a increase of hole concentration with Sb surfactant, compared to typical Mg-doped p-GaN. The structural and optical quality of p-GaN epilayers were accessed by x-ray diffraction, photoluminescence and atomic force microscope measurements. The results clearly show that the increase in hole concentration with Sb surfactant can be resulted from decrease in the dislocations and nitrogen point defects.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.133-133
• /
• 2010

3-5족 화합물 반도체를 이용한 집광형 삼중 접합 태양전지는 35% 이상의 광변환 효율로 주목을 받고 있다. 일반적으로 삼중 접합 태양전지는 넓은 영역대의 파장을 흡수하기 위해 밴드갭이 다른 InGaP, GaAs, Ge이 사용된다. 그 중 하부셀은 기계적 강도가 높고 장파장을 흡수할 수 있는 Ge이 사용되는데, p-type Ge 기판위에 III-V 결정막 성장 시 5족 원소가 확산되어 pn접합을 형성하게 된다. 이러한 구조를 가진 Ge 하부셀이 효율적으로 홀-전자 쌍을 형성하기 위해서는 두꺼운 베이스와 얇은 에미터 접합이 필요하다. InGaP의 phosphorus는 낮은 확산계수로 인해 GaAs의 arsenic에 비해 얇은 접합이 형성 가능하며, Ge표면 에칭효과가 더 적다는 장점이 있다. 이를 고려해 우리 연구그룹에서는 metalorganic chemical vapor depostion(MOCVD)을 이용하여 Ge기판위에 성장한 InGaP layer의 특성을 관찰해 보았다. <111>로 $6^{\circ}$ 기울어진 p-type Ge(100) 기판위에 MOCVD를 통해 InGaP layer를 형성하였고, 성장된 layer를 atomic force microscope(AFM)와 high-resolution x-ray diffraction(HRXRD)을 이용하여 표면형상, 조성, 응력상태 등을 각각 관찰하였다. 또한 phosphorus 확산에 의해 형성되는 도핑농도는 electrochemical capacitance-voltage(ECV)을 이용하여 관찰하였다. 성장된 Ge기판위의 InGaP layer의 경우 특징적으로 높이 50 nm, 밑변 길이 $1\;{\mu}m$의 경사진 표면을 관찰할 수 있었으며, 이러한 구조는 TMIn과 TMGa의 비율이 증가 할수록 감소하였다. 따라서 이러한 경사진 형태의 구조는 격자 불일치 때문인 것으로 판단된다. 추가적으로 V/III ratio의 최적화를 통해 1.3 nm의 표면 거칠기를 갖는 InGaP layer를 얻을 수 있었다. ECV를 통해 Ge 하부셀의 pn접합 형성을 관찰한 결과 약 160 nm에서 접합이 형성되는 것을 관찰할 수 있었다. 또한, 같은 성장 조건의 샘플을 1000 초 열처리 후에 접합깊이의 변화를 관찰한 결과 180 nm에서 접합이 관찰되었지만, GaAs의 arsenic에 의한 pn접합은 열처리 후에 그 깊이가 170 nm에서 300 nm로 증가 하였다. 따라서 삼중접합 태양전지의 제작 공정을 고려할 경우 phosphorus에 의한 접합 형성이 Ge 하부셀의 동작 특성에 유리할 것으로 판단된다.

• Korean Journal of Optics and Photonics
• /
• v.7 no.3
• /
• pp.272-279
• /
• 1996

A simple transfer matrix algorithm to analyze the properties of 2 dimensional waveguides is introduced. We applied this algorithm to strained InGaAs/InGaAsP GINSCH MQW laser structures. We studied how optical confinement factor and effective refractive index, which are important in calculating the modal gain, depend on the structure parameters such as waveguide width, shape of GRIN, and number of quantum wells. Especially we suggested that the concept of effective waveguide width is very useful in understanding the GRINSCH waveguide.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.322.2-322.2
• /
• 2014

Lighting emitting diodes of n-ZnO/MQW/p-GaN structure are fabricated and investigated. To realize this LED structure, n-ZnO/MQW/p-GaN are grown by MOCVD. At several bias voltages, blue-green light is emitted from the ZnO mesa edge. However, the emission is restricted near the mesa edge. It is seen that the hole current does not spread well. It is because conductivity of p-GaN is extremely small. The break down voltage of the device is small compared to conventional InGaN/GaN LEDs. It is seen that ZnO columnar grain boundaries act as leakage current paths and non-radiative recombination center.

• Journal of Sensor Science and Technology
• /
• v.17 no.5
• /
• pp.346-349
• /
• 2008

A metal-semiconductor-metal (MSM) ultraviolet (UV) photodetector (PD) is proposed as an effective UV sensing device for integration with a GaN n-channel MISFET on auto-doped p-type GaN grown on a silicon substrate. Due to the high hole barrier of the metal-p-GaN contact, the dark current density of the fabricated MSM PD was less than $3\;nA/cm^2$ at a bias of up to 5 V. Meanwhile, the UV/visible rejection ratio was 400 and the cutoff wavelength of the spectral responsivity was 365 nm. However, the UV/visible ratio was limited by the sub-bandgap response, which was attributed to defectrelated deep traps in the p-GaN layer of the MSM PD. In conclusion, an MSM PD has a high process compatibility with the n-channel GaN Schottky barrier MISFET fabrication process and epitaxy on a silicon substrate.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.05a
• /
• pp.447-450
• /
• 2000

In this paper, we report a fabrication of InP-based microstructurs for III-V compound semiconductor micromachining. Vertical liquid phase epitaxy(LPE) system was used in order to grow the Inp/InGaAsP/InP layers. The thicknesses of InP top-layer and InGaAsP were 1$\mu\textrm{m}$ and 0.4$\mu\textrm{m}$ respectively. The fabrication of InGaAsP microstructures involves front side bulk micromachining. The experimental result showed the beams must be carefully aligned in the <110> direction since the lateral etching of the beam in the <110> direction is more faster than that of the beam in the <100> direction.

• Journal of Magnetics
• /
• v.20 no.4
• /
• pp.331-335
• /
• 2015

The ferromagnetic and electronic structure for the $Al_xGa_{1-x}P$ and Mn-doped $AlGaP_2$ was studied by using the self-consistent full-potential linear muffin-tin orbital method. The lattice parameters of un-doped $Al_xGa_{1-x}P$ (x = 0.25, 0.5, and 0.75) were optimized. The band-structure and the density of states of Mn-doped $AlGaP_2$ with or without the vacancy were investigated in detail. The P-3p states at the Fermi level dominate rather than the other states. Thus a strong interaction between the Mn-3d and P-3p states is formed. The ferromagnetic ordering of dopant Mn with high magnetic moment is induced due to the (Mn-3d)-(P-3p)-(Mn-3d) hybridization, which is attributed by the partially filled P-3p bands. The holes are mediated with keeping their 3d-characters, therefore the ferromagnetic state is stabilized by this double-exchange mechanism.

• Proceedings of the Optical Society of Korea Conference
• /
• 2009.02a
• /
• pp.525-526
• /
• 2009

we investigated the effect of rapid thermal annealing (RTA) temperature on photoluminescence (PL) of 635 nm InGaP/InGaAlP multiple quantum well structure. RTA is performed with the quantum well structure with 5.5 nm of well width. The highest PL peak intensity is shown at 1 min. of RTA at $720^{\circ}C$ sample as 3 times higher as compared to the as-grown sample. The effect may be assigned to an expected reduction in number of nonradiative recombination centers in the quantum well.