• 대한기계학회논문집B
• /
• 제27권8호
• /
• pp.1023-1032
• /
• 2003

The effect of local forcing on the separated flow over a backward-facing step is investigated through hot-wire measurements and flow visualization with multi-smoke wires. The boundary layer upstream of the separation point is laminar and the Reynolds number based on the free stream velocity and the step height is 13800. The local forcing is given from a slit located at the step edge and the forcing signal is always defined when the wind tunnel is in operation. In case of single frequency forcing, the streamwise velocity and the reattachment length are measured under forcing with various forcing frequencies. For the range of 0.010〈S $t_{\theta}$〈0.013, the forcing frequency component of the streamwise velocity fluctuation grows exponentially and is saturated at x/h = 0.75 , while its subharmonic component grows following the fundamental and is saturated at x/h = 2.0. However, the saturated value of the subharmonic is much lower than that of the fundamental. It is observed that the vortex formation is inhibited by the forcing at S $t_{\theta}$ = 0.019 . For double frequency forcing, natural instability frequency is adopted as a fundamental frequency and its subharmonic is superposed on it. The fundamental frequency component of the streamwise velocity grows exponentially and is saturated at 0.5 < x/ｈ < 0.75, while its subharmonic component grows following the fundamental and is saturated at x/ｈ= 1.5 . Furthermore, the saturated value of the subharmonic component is much higher than that for the single frequency forcing and is nearly the same or higher than that of the fundamental. It is observed that the subharmonic component does not grow for the narrow range of the initial phase difference. This means that there is a range of the initial phase difference where the vortex parring cannot be enhanced or amplified by double frequency forcing. In addition, this effect of the initial phase difference on the development of the shear layer and the distribution of the reattachment length shows a similar trend. From these observations, it can be inferred that the development of the shear layer and the reattachment length are closely related to the vortex paring.

• Journal of Power Electronics
• /
• 제15권4호
• /
• pp.1085-1092
• /
• 2015

In this paper, the expressions of the estimated information of a single-phase enhanced phase-locked loop (EPLL), when input signal contains harmonics and a DC offset while the fundamental component takes step changes, are derived. The theoretical analysis results indicate that in the estimated information, the n^th-order harmonics cause n+1^th-order periodic ripples, and the DC offset causes a periodic ripple at the fundamental frequency. Step changes of the amplitude, phase angle and frequency of the fundamental component cause a transient periodic ripple at twice the frequency. These periodic ripples deteriorate the performance of the EPLL. A hybrid filter based EPLL (HF-EPLL) is proposed to eliminate these periodic ripples. A delay signal cancellation filter is set at the input of the EPLL to cancel the DC offset and even-order harmonics. A sliding Goertzel transform-based filter is introduced into the amplitude estimation loop and frequency estimation loop to eliminate the periodic ripples caused by the residual input odd-order harmonics and step change of the input fundamental component. The parameter design rules of the two filters are discussed in detail. Experimental waveforms of both the conventional EPLL and the proposed HF-EPLL are given and compared with each other to verify the theoretical analysis and advantages of the proposed HF-EPLL.

• 전기학회논문지P
• /
• 제58권2호
• /
• pp.122-129
• /
• 2009

Frequency is an important operating parameter of a power system. It is essential that the frequency of a power system be maintained very close to its nominal frequency. And frequency measurement devices have need to measure a fast and accurate of frequency using voltage signals. This paper proposes a comparative study of frequency estimation techniques using the high speed FIR filter based algorithm, the DFT filter based algorithm using phasor angle between two phasors, and positive sequence component based algorithm using the half angle between two successive positions of phasor. The discussed three techniques have been formed through numerical manipulation of a discrete system. The proposed techniques have been tested using signals obtained from selected power system model using ATP simulation package. Some test results are shown in this paper.

• Smart Structures and Systems
• /
• 제31권2호
• /
• pp.155-169
• /
• 2023

The quasi-static component of the moving vehicle-induced dynamic response is promising in damage detection as it is sensitive to bridge damage but insensitive to environmental changes. However, accurate extraction of quasi-static component from the dynamic response is challenging especially when the vehicle velocity is high. This paper proposes an adaptive quasi-static component extraction method based on the modified variational mode decomposition (VMD) algorithm. Firstly the analytical solutions of the frequency components caused by road surface roughness, high-frequency dynamic components controlled by bridge natural frequency and quasi-static components in the vehicle-induced bridge response are derived. Then a modified VMD algorithm based on particle swarm algorithm (PSO) and mutual information entropy (MIE) criterion is proposed to adaptively extract the quasi-static components from the vehicle-induced bridge dynamic response. Numerical simulations and real bridge tests are conducted to demonstrate the feasibility of the proposed extraction method. The results indicate that the improved VMD algorithm could extract the quasi-static component of the vehicle-induced bridge dynamic response with high accuracy in the presence of the road surface roughness and measurement noise.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2003년도 Proceedings of the international symposium on the fusion technology
• /
• pp.383-389
• /
• 2003

Clay minerals show a distinct induced-polarization phenomenon, which is one of the most important factors for predicting groundwater flow and contaminant transport. This paper presents a step-by-step process to estimate Cole-Cole parameters from spectral induced-polarization (IP) data measured on the surface of three-dimensional earth. First, the inversion of low-frequency resistivity survey data is made to identify the dc resistivity ${\rho}_dc$ of a volume having IP effects. The other parameters, chargeability m, time constant $\tau$, and frequency dependence c, are sought for the polarizable volume. Next, using multi-frequency data, c can be obtained as high or low asymptotes of the slope of log phase vs. log frequency. Further, for low m, intrinsic $\tau$ is approximated by apparent one, ${\tau}_a$, which is derived from the relation ${{\omega}{\tau}}_a$=1 at an angular frequency $\omega$, where the imaginary component of spectral IP data has an extreme value. Finally, to obtain intrinsic m a two-step linearized procedure has been derived. For a body of given $\tau$ and c, forward modeling with a progression of m values yields a plot of observed vs. intrinsic imaginary components for a frequency. Since this plot is essentially linear, to extract the intrinsic imaginary component is quite simple with an observed value. Using the plot of intrinsic imaginary component vs. m, intrinsic m is determined. We present a synthetic example to illustrate that the Cole-Cole parameters can be recovered from spectral IP data.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 A
• /
• pp.360-362
• /
• 2004

In this paper, as the preceding research for development of intelligent electronic device for digital based substation automation system, we tried to select the most suitable digital filter by comparison of frequency response characteristic, performance of wanted frequency component extraction.

• Transactions on Electrical and Electronic Materials
• /
• 제6권3호
• /
• pp.97-100
• /
• 2005

Dynamic response of organic light-emitting diodes were analyzed in $ITO/Alq_3$(100 nm)/Al device structure with a variation of voltage an frequency. At low frequency region, complex impedance is mostly governed by resistive component, and at high frequency region by capacitive component. Also, we have evaluated resistance, capacitance and permittivity of devices.

• 한국정보전자통신기술학회논문지
• /
• 제12권4호
• /
• pp.349-358
• /
• 2019

본 논문에서는 회전체의 특징 파라미터들을 추출하기 위한 센서의 신호들을 수집하는 방법을 연구하고자 한다. 이를 위해, 모형 시험을 수행하기 위한 진동 테스트 리그를 개발하여 정상적으로 운전하에서의 신호특성을 분석하였다. 다른 진동 요소들로부터 주기적인 충격에 의해 발생되는 진동 성분을 추출하기 위하여 포락 신호처리(Envelope FFT Analysis) 기법을 사용하였다. 회전속도에 따른 신호분석과 더불어 회전체의 저주파수 특성을 잘 나타내는 속도센서 및 진동 테스트 리그의 부하변화에 따른 신호를 분석하였다. 그 결과, 베어링 하우징에서 측정되는 가속도 신호는 진폭이 작으며 조화 성분과 모터의 회전주파수 성분만이 발생함을 확인하였다. 즉, 회전수가 높아짐에 따라 가속도의 진폭이 높아짐을 확인할 수 있었다. 회전속도가 증가하면 원 데이터의 형상의 차이가 있는 것을 확인할 수 있었고, 가속도 FFT 그래프와 비교하였을 경우 저 주파수에서 노이즈에 강하며 해당 회전 주파수 성분을 뚜렷하게 나타내었다. 또한 부하를 변화시켜도 주요 회전 주파수 성분이 증가하지 않음을 알 수 있었다.

• 한국정밀공학회지
• /
• 제31권8호
• /
• pp.697-703
• /
• 2014

This paper is study of solving vibration problem occurred in moving hand of wafer transfer robot in semiconductor manufacturing line. Long settling time for decreasing vibration makes low production rate, and moreover the excessive vibration of hand sometimes breaks the wafer in a cassette. The ways of reducing the moving speed and changing the type of motion profile did not help for lessening vibration. Therefore, we analyzed the mechanical property of the hand such as natural frequency, and frequency component of the motion profile currently used in the manufacturing line. In several conditions of motion profile, we found the best condition of which the frequency component in near of natural frequency of the hand is minimal and this induced small vibration in moving hand. The results were verified theoretically and experimentally using frequency analysis.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 추계학술대회논문집
• /
• pp.898-902
• /
• 2006

The motion of a system composed of a plate, constant springs and varying dampers is considered when the system is subject to harmonic force. Letting the frequencies of harmonic force and damper variation ${\Large f}_1\;and\;{\Large f}_2$ respectively, the displacement at the center of the plate has the strongest component at frequency ${\Large f}_1$. The angular displacement of the plate has strong components at ${\Large f}_1-{\Large f}_2$ and the natural frequency of the rotational mode of the system. If these two frequencies coincide, the plate oscillates with almost single frequency and a large amplitude. Part of these simulation results are proved analytically.