• Journal of the Korean Wood Science and Technology
• /
• v.45 no.1
• /
• pp.53-61
• /
• 2017

In this study, specimens were produced with a column member and a wooden gusset only by inserting an wooden gusset which is a substitute for steel plate into the center of a slit-processed column member. The moment resistance performance of the specimens was compared with that of control specimens that used a steel plate. The measured maximum moments of the specimens produced with GFRP-reinforced wooden laminated gussets and pins were lower by 24% on average compared to the steel plate-inserted specimens, but they showed good toughness. The fracture shape suggests that it was fractured along the annual rings between the pin and the end of the column member. The rigid specimen that integrated a laminated wood and a wooden laminated gusset with adhesive showed 2.8 times greater initial rigidity and 40% greater maximum moment on average compared to the control specimen. The rigid specimens mainly fractured on a glulam around glue line.

• Journal of the Korean Wood Science and Technology
• /
• v.45 no.1
• /
• pp.28-35
• /
• 2017

In this study, specimens of rigid frame joint were produced by integrating joints with adhesive and other specimens were produced by inserting a wooden gusset integrated with a column member into a slit-processed beam member and joining them with pins. Then the moment resistance performances of the specimens were examined. For the wooden gusset, a GFRP-reinforced wooden gusset was used. The calculation results of perfect elasto-plasticity for the frame specimens for which a GFRP-reinforced wooden gusset was inserted into and joined with the slit-processed beam member by pins were 20-80% lower compared to the control group which consisted of steel plate-inserted frame specimens. The rigid frame specimens for which the column and beam members have been integrated with adhesive showed almost no initial residual transformations, as well as 38% greater initial rigidity and 41% greater plasticity compared to the steel plate-inserted joint.

• Journal of the Korean Wood Science and Technology
• /
• v.46 no.1
• /
• pp.93-99
• /
• 2018

It is necessary to review the non-destructive indexes in order to estimate the bending strength performance of the domestic larch lumber. In this study, MOEs (modulus of elastic) the larch lumber (cross-section $89{\times}120mm$) were evaluated through non-destructive methods such as the ultra-sonic method, longitudinal vibration method, and non-destructive bending method. The non-destructive measurement method which best represented the static MOE was determined and applied as the MOR(modulus of rupture) estimation index. The MOE that was measured through the longitudinal vibration method showed the highest correlation with the static MOE. The MOR was highly related to the static MOE. Therefore, the non-destruction MOE measured through the longitudinal vibration method was used to estimate the MOR of the lumber.

• Proceedings of the KSFDT Conference
• /
• 2006.04a
• /
• pp.115-125
• /
• 2006

China has a very large area, but the total and average amount of forest resources are always relative scarcity, retrospect the forest history, when the activities of human beings existed on the earth, the forest resources began to reduce gradually, it indicates that the amount of the forest resources have grate connection with the activities of human beings, especially from the foundation of New China, long term out-of- order logging and unsustainable development make the forest resources and ecological environment be destructed seriously. However, although Chinese forest resources still face a large number of complicated problems, it has already begun to recover and been into the right orbit through listing and analysis a series dates. Additionally, six key forest resources program's launching and the strategy shifting will take china enter a bright future.

• Journal of Digital Convergence
• /
• v.19 no.11
• /
• pp.95-112
• /
• 2021

This study analyzed the effects of healing agriculture program types on program satisfaction by using functional image and emotional image of the program as mediators for the participants of healing agriculture program. The sub-variables of the healing agriculture program were classified into horticultural healing, animal healing, food healing, and forest healing. 328 questionnaires collected from the participants of healing agriculture program in the whole country were used for empirical analysis, which used SPSS v22.0 and PROCESS macro v3.4 to analyze the parallel multiple mediation model. First, Among the types of healing agriculture programs, animal healing, food healing, and forest healing had a positive (+) effect on functional image. Second, all types of healing agriculture program had a positive (+) effect on emotional image. Third, both functional and emotional images had a significant positive effect on satisfaction. Fourth, among the types of healing agriculture program, horticultural healing, animal healing, and forest healing had a significant effect on satisfaction, while food healing did not maintain the significant effect on satisfaction. Fifth, functional image mediated between healing agriculture program and satisfaction. Sixth, emotional image mediated between healing agriculture program type and satisfaction. In the next study, it is necessary to study for the adjustment of mediators other than the mediators introduced in this study or the controlled mediated analysis through the conditional process model in which the moderator variable is introduced.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.1
• /
• pp.40-47
• /
• 2016

Instead of metal connector generally used on the structural glued laminated timber rahmen joints, the GFRP reinforced laminated plates combining veneer and GFRP (Glass Fiber Reinforced Plastic) and bonded type GFRP rod were used as the connectors. As a result of moment resistance performance evaluation on the joint part applied with these connectors, the yield moment of specimen using the GFRP reinforced laminated plates and GFRP rod pin was measured 4 % lower in comparison to the specimen (Type-1) using the metal connectors, but the initial rotational stiffness was measured 29% higher. Also, the yield moment and rotational stiffness of the specimen using the GFRP-reinforced laminated plates and wood (Eucalyptus marginata) pin showed were measured 11% and 56% higher in comparison to the Type-1 specimen, showing the best performance. It was also confirmed through the failure shape and perfect elasto-plasticity analysis that it showed ductility behavior, not brittle fracture, from the shear resisting force by the pin and the bonding strength increased and the unification of member was carried out. On the other hand, in case of the specimen bonded with GFRP rod, it was impossible to measure the bonding performance or it was measured very low due to poor bonding.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.1
• /
• pp.30-39
• /
• 2016

The evaluation of the lateral load performance for larch glulam portal frames was carried out using glass fiber reinforced plastic (GFRP) as connector in two different systems: the GFRP-reinforced laminated plates combined with veneer, and GFRP rod joints glued with epoxy resins to replace usual metal connectors for the structural glulam rahmen joints. As a result the yield strength, ultimate strength, initial stiffness of glulams of GFRP rod joints glued with epoxy resin decreased to 49%, 52% and 61% compared to those of the conventional metal connector. This connector will be a stress device where the bonding strength between the GFRP rod and glued laminated timber is important. Thus, there will be a high possibility that a problem may occur when it is applied to the field. On the other hand, the GFRP-reinforced laminated plates and wood (Eucalyptus marginata) pin were measured all within 3% for all measurements of the yield strength, ultimate strength, initial strength and ductility factor, regardless of high cross sectional loss on the glued laminated timber slit joint. In addition, the variation of stiffness on the cycle was 35%, which was the lowest, confirming that it was almost the same performance as the specimen prepared with the metal connector.

• Journal of Korean Society of Forest Science
• /
• v.106 no.3
• /
• pp.353-361
• /
• 2017

This survey was conducted to study the mountain village residents' needs and awareness of eco-tourism. The survey included opinions about introducing Eco-tourism, Residents' willingness to join, types of policies to push forward, requirements to Korea Forest Service and expected outcomes. 346 residents were selected for this survey from 33 mountain eco-villages established by Korea Forest Service and 24 rural experience villages established by Ministry of Agriculture, Food and Rural Affairs, and they respectively participated in this survey through interview from June $17^{th}$ 2015 to September $17^{th}$ 2015. As a result of major analysis, the survey showed that 86.7% of residents were in favor of the introduction of mountain village eco-tourism and 78.3% of those questioned showed the willingness of their participation of the program. Also 42.2% of respondents reacted positively that Korea Forest Service, associated administration agency and local government should be cooperated when the policies are established. 60.4% of respondents said they expect installment of recreational facilities and 67.6% said they expect development of eco-tourism program, which were respectively the highest rate as the requirements to be supported when the eco-tourism program are introduced. 86.1% said that increasing visitors will help mountain villages more revitalized as eco-tourism is introduced. This research is expected to provide information when making the mountain eco-tourism policy in the future.

• Journal of the Korean Wood Science and Technology
• /
• v.46 no.1
• /
• pp.85-92
• /
• 2018

In order to use glued built up timber beam as a structural member for post and beam construction, it must be possible to manufacture long-span lumber. In this study, the researchers conducted a performance evaluation for longitudinal bonding of lumber (cross-section $89{\times}120mm$) made from larch. The specimens were prepared in six different forms using the longitudinal bonding method. The bonding strength of these specimens was tested through tensile strength tests and bending strength tests. The tensile strength test result of the longitudinally bonded parts was better than that of the double lap specimens. And, the tensile strength value of the scarf specimen was better than that of the hooked scarf specimen. The tensile strength of the GFRP (Glass Fiber Reinforced Plastic) rod insertion bonding specimen was 3.6 MPa, which was the highest. As for the bending strength test result of the longitudinally bonded part, the average MOR (modulus of rupture) of the specimen where a GFRP rod was inserted and bonded measured 29 MPa, while the specimens of other bonded parts showed a MOR no more than 11 MPa. Toughness destruction was observed in specimens where a GFRP rod was insertion-bonded. The rest of the specimens showed brittle destruction. The average MOR strength of the Rod + Lap specimen was 30.5 MPa, which was the highest among all longitudinally bonded specimens. The bending strength of the Rod + Lap specimens showed an effective strength that was 66% of that of the control group which were not longitudinally bonded.

• Korean Journal of Environment and Ecology
• /
• v.33 no.3
• /
• pp.333-340
• /
• 2019

As the number of students in the multicultural background grows, the interest in their education is also increasing. The purpose of this study is to investigate the effect of forest healing factors on the improvement of language ability and ego-resilience of students from multicultural families. We conducted an after-school forest healing program of ten male and ten female middle school students of a multicultural preparatory school located in ${\bigcirc}{\bigcirc}$-dong in Cheongju, Chungnam Province. The experiment consisted of a total of 12 weekly one-hour (60 minutes) programs from April 12, 2018 to June 26, 2018. The forest healing program is an activity that uses the various environmental factors that exist in the forest to increase the immunity of the human body and restore physical and mental health. To determine the difference in ego-resilience before and after the program, we conducted a paired t-test and analyzed with the SPSS 18.0 program. The results showed that the ego-resilience significantly improved in all sub-factors including the positive thinking ability, problem-solving ability, intimacy ability, emotional adjustment ability, and autonomic behavior ability (p<.001). The descriptive statistics of the language ability showed the improvement in writing errors, pronunciation errors, sentence errors, tense errors, and errors in research and connection. We expect the results of this study can be used as the basic data to improve ego-resilience and language acquisition ability of middle-entry children and students from multicultural families.