• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.4
• /
• pp.921-929
• /
• 2011

This paper describes an analysis of the decoding performance and decoding convergence speed of layered LDPC(low-density parity-check) decoder for mobile WiMAX system, and the optimal design conditions for hardware implementation are searched. A fixed-point model of LDPC decoder, which is based on the min-sum algorithm and layered decoding scheme, is implemented and simulated using Matlab model. Through fixed-point simulations for the block lengths of 576, 1440, 2304 bits and the code rates of 1/2, 2/3A, 2/3B, 3/4A, 3/4B, 5/6 specified in the IEEE 802.16e standard, the effect of internal bit-width, block length and code rate on the decoding performance are analyzed. Simulation results show that fixed-point bit-width larger than 8 bits with integer part of 5 bits should be used for acceptable decoding performance.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.2
• /
• pp.363-371
• /
• 2013

This paper describes a multi-standard LDPC decoder which supports 19 block lengths(576~2304) and 6 code rates(1/2, 2/3A, 2/3B, 3/4A, 3/4B, 5/6) of IEEE 802.16e mobile WiMAX standard and 3 block lengths(648, 1296, 1944) and 4 code rates(1/2, 2/3, 3/4, 5/6) of IEEE 802.11n WLAN standard. To minimize hardware complexity, it adopts a block-serial (partially parallel) architecture based on the layered decoding scheme. A DFU(decoding function unit) based on sign-magnitude arithmetic is used for hardware reduction. The designed LDPC decoder is verified by FPGA implementation, and synthesized with a 0.13-${\mu}m$ CMOS cell library. It has 312,000 gates and 70,000 bits RAM. The estimated throughput is about 79~210 Mbps at 100 MHz@1.8v.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.7
• /
• pp.552-558
• /
• 2014

In this paper, we propose a side-peak cancellation technique of composite binary offset carrier (CBOC) signals for e-navigation. First, we divide a CBOC sub-carrier into several sub-carrier pulses, and then, observe that CBOC autocorrelation is the sum of multiple sub-correlation functions. Finally, we propose a novel correlation function with no side-peak and a sharp main-peak by combining the sub-correlation functions to improve the positioning accuracy. From numerical results, we confirm that the proposed correlation function with a sharp main-peak provides a better positioning performance than the conventional correlation functions in terms of the tracking error standard deviation.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.7
• /
• pp.578-583
• /
• 2011

We report on the design of a holographic homogenizer composed of a periodic hologram and a condensing lens. If the hologram is periodic, the homogenizer is free from the alignment error of the incident laser beam. Holographic homogenizer also has an advantage of the flexibility in the size of the target beam. We calculated theoretically the Fraunhofer diffracted wave function when a rectangular laser beam is incident on a periodic hologram. The diffracted wave is the sum of sinc functions at regular distance. The width of each sinc function depends on the size of the incident laser beam and the distance between the sinc functions depends on the period of the hologram. We calculated numerically the diffracted light intensity for various ratios of the size of the incident laser beam to the period of the hologram. The results show that it is possible to make the diffracted beam uniform at a certain value of the ratio. The uniformity is high at the central part of the target area and low near the edge. The more sinc functions are included in the target area, the larger portion of the area becomes uniform and the higher is the uniformity at the central part. Therefore, we can make efficient homogenizer if we design a hologram so that the maximum number of the diffracted beams may be included in the target area.

• Journal of Korean Ophthalmic Optics Society
• /
• v.3 no.1
• /
• pp.189-199
• /
• 1998

The system for optical tolerances of completion spectacles was made to sum of the accumulated error - the circumstances on composing prescription, the visual-distance, the tilting angle, the losing of a temple, the vertex distance, the axis of toric lens and the sloping of lens etc. It was given by the relation of allowed values size(T) and power(D), $T=T_0e^{-aD}$. Here, $T_0$ is the size of allowed values of plane-lens with power is 0 and ${\alpha}$ is the factor of allowed values. In case of being adopted to new form s tolerance corresponding to RAL 915, for the tolerance is large direction, the factor of allowed values ${\alpha}$ is $0.166(T_0=5.90)$ and for the tolerance is small direction, the factor of allowed values ${\alpha}$ is $0.166(T_0=2.95)$.

• Journal of Korea Water Resources Association
• /
• v.39 no.6 s.167
• /
• pp.503-510
• /
• 2006

Riverbank filtration is a natural process, using alluvial aquifers to remove contaminants and pathogens in river water for the production of drinking water. Back analysis which minimizes the objective function that is typically the sum of squares of the differences between the calculated and measured quantities is used for the estimation of aquifer parameters. In this study, transmissivity is back-analysed using the BFGS (Broyden-Fletcher-Goldfarb-Shanno) scheme for optimization. MOC is used to obtain calculated groundwater level. The developed inverse model was applied to Dae-san, Chang-won city where riverbank filtration is being undertaken. The model showed good convergence behavior for different groundwater conditions. The performance of the model was better than a widely-used commercial software package in terms of error between calculated and observed groundwater level.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.52 no.5
• /
• pp.61-68
• /
• 2010

Jangchan reservoir is located in Okcheon county, Chungbuk province, of which watershed area is $29.4\;km^2$ from outside, and $5.1\;km^2$ from inside watershed, effective storage capacity is $392{\times}10^4\;m^3$, paddy area to be irrigated is 474 ha. To determine inflows from Keumcheon weir located in outside watershed on an optimum level, a repeated procedure which is composed of simulation of inflows to Keumcheon weir, setting of range of water taking at Keumcheon weir, simulation of inflows to Jangchan reservoir, estimation of paddy water from Jangchan reservoir, and simulation of water storages in Jangchan reservoir was selected. Parameters of DAWAST model for simulating inflows to Jangchan reservoir were determined to UMAX of 315 mm, LMAX of 21 mm, FC of 130 mm, CP of 0.018, and CE of 0.007 with absolute sum of errors in reservoir water storages minimized using unconstrained Simplex method because of no inflows data. Inflows to Keumcheon weir were simulated to $2,132{\times}10^4\;m^3$ on an annual average. Optimal range of water taking at Keumcheon weir to transfer to Jangchan reservoir were $0.81{\sim}50\;mm/km^2/d$, which were summed up to $1,397{\times}10^4\;m^3$ in 66% of total on an annual average. Inflows to Jangchan reservoir were simulated to $1,739{\times}10^4\;m^3$ on an annual average of which were 80 % from Keumcheon weir of outside watershed. Requirements to paddy water from Jangchan reservoir were estimated to $543{\times}10^4\;m^3$ on an annual average.

• The Journal of Industrial Distribution & Business
• /
• v.11 no.4
• /
• pp.39-46
• /
• 2020

Purpose: This study looks at the relevance between discretionary revenue and book-tax differences (hereafter BTDs). While the study of earnings management, which focused on discretionary accruals and real earnings management, has largely made, it has not yet been actively researched on discretionary revenues. Therefore, it was believed that discretionary revenue would expand the preceding study by looking at its relevance to BTD, known as financial reporting quality and measures of tax avoidance. In general, prior research suggested that earnings management make BTDs larger. Thus, the relationship between discretionary revenue and the amount of BTD is predicted positive. Research design, data and methodology: To this end, the method of discretionary revenues was used and BTDs measured in four ways. First, Earnings before income tax - estimated taxable income divided by total asset (BTD). Second is fractional rank variable of BTDs (FBTD). Third is Indicator variable equals 1 if the firm-year has a positive BTD, 0 otherwise (PBTD). Fourth is that Indicator variable equals 1 if the firm-year has a BTDs in top(bottom) quartile, 0 otherwise (LPBTD, LNBTD). 4,251 samples were analyzed in the Korean Security market (KOSPI) from 2003 to 2014. Results Empirical analysis shows that BTDs increases as discretionary revenue increases. These results were equally observed when BTDs was measured as a ranking variable or as a indicating variable. These results indicate that earnings management through the revenue of managers exacerbate the quality of financial reporting. Conclusions: In sum, discretionary revenues can be used as an indicator of making BTDs larger and meaningful as the first study of the Korean capital market where discretionary revenues affect accounting information quality. Investors need to increase interest in discretionary revenues because intervention in financial reporting through revenue accounts by managers can increase information asymmetry and agency costs. This means that studies on discretionary revenues that have been relatively small should be expanded. The results also provide important implications for the relevant authorities and investors. Despite these benefits, however, measurement error problems with estimates still appear as limited points, and prudent interpretations are required, and additional follow-up studies are needed in that variables that are not yet considered in this study may affect our findings.

• KIISE Transactions on Computing Practices
• /
• v.20 no.11
• /
• pp.579-585
• /
• 2014

A phoneme is the minimal unit of speech, and it plays a very important role in speech recognition. This paper proposes a novel method that can be used to recognize 'ㅅ', 'ㅈ', and 'ㅊ' among Korean phonemes. The proposed method is based on a volatility indicator and a turning point indicator that are calculated for each constituting block of the input speech signal. The volatility indicator is the sum of the differences between the values of each two samples adjacent in a block, and the turning point indicator is the number of extremal points at which the direction of the increment or decrement of the values of the sample are inverted in a block. A phoneme recognition algorithm combines the two indicators to finally determine the positions at which the three target phonemes mentioned above are recognized by utilizing optimized thresholds related with those indicators. The experimental results show that the proposed method can markedly reduce the error rate of the existing methods both in terms of the false reject rate and the false accept rate.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.2
• /
• pp.145-152
• /
• 2003

In this paper, assuming that the score of speech utterance is the product of HMM log likelihood and HMM weight, we propose a new method that HMM weights are adapted iteratively like the general MCE training. The proposed method adjusts HMM weights for better performance using delta coefficient defined in terms of misclassification measure. Therefore, the parameter estimation and the Viterbi algorithms of conventional 1:.um can be easily applied to the proposed model by constraining the sum of HMM weights to the number of HMMs in an HMM set. Comparing with the general segmental MCE training approach, computing time decreases by reducing the number of parameters to estimate and avoiding gradient calculation through the optimal state sequence. To evaluate the performance of HMM-based speech recognizer by weighting HMM likelihood, we perform Korean isolated digit recognition experiments. The experimental results show better performance than the MCE algorithm with state weighting.