• Proceedings of the KIEE Conference
• /
• 2006.04a
• /
• pp.159-161
• /
• 2006

The peer-to-peer (P2P) systems have Brown significantly over last few years due to their hish potential of sharing various resources. Super-peer based P2P systems have been found very effective by dividing the peers into two layers, SP (Super-Peer) and OP (Ordinary-Peer). In this paper, we present ISP2P (Intelligent Super-peer based P2P system), which allows us to choose the best SP. Through analyzing capacity and similarity between SP and OP, we can help OPs to select the most appropriate SP respectively. Proposed system can improve the performance of the average response time by superior SP, reduce the bandwidth cost by small path length due to content similarity and solve frequent SP replacement problem by considering similarity of user behavior.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.9
• /
• pp.605-610
• /
• 1999

An SOI(Silicon-On-Insulator) LD(Lateral Double-diffused)MOS with a recessed source structure is proposed to improve the on-resistance and the breakdown voltage. The recessed source structure can decrease the on-resistance by reducing the path of electron current, also increase the breakdown voltage by extending the effective length of gate field plate. Simulation results by TSUPREM4 and MEDICI have shown that the on-resistance of the LDMOS with a recessed source was 26% lower than conventional LDMOS. The breakdown voltage of proposed device was found to be 45V while that of conventional device was 36.5 V. At the same breakdown voltage of 36.5V, the on-resistance of the LDMOS with a recessed source was 41% lower than that of conventional structure.

• Journal of the Korean Society of Radiology
• /
• v.14 no.4
• /
• pp.487-494
• /
• 2020

The distance between the source and the detector, the diameter of the detector, and the volume effect of the radiation source result in a change in solid angle at the detector entrance, which affects the determination of detection efficiency by causing a difference in path length within the detector. A typical analysis method for calculating solid angles was useful only for a source (⁶⁰Co) with a simple geometric structure, so in this experiment, the distance between the detector and the source was measured by switching on for up to 25 cm with the reference point of window cap 0.5 cm. In addition, 450 and 1000 ㎖ Marinelli beaker of standard volumetric sources were closely adhered to the detector. For circular point sources co-axial with the detector, the change in the solid angle to the distance from the detector window is equal to half the square radius of the source versus the square radius of the detector, if the resulting relationship of the calculation analysis results in the detector being less than the radius of the source. Since the solid angular difference is 0.5 the result of Monte Carlo is acceptable. The relationship between detector and source distance is shown. Solid angles have been verified to decrease rapidly with distance. Measurement and simulation results for a volumetric source show a difference of ±1.01% from a distance of 0 cm and less than 4 % when the distance is reduced to 5 and 10 cm. It can be seen that the longer distance, the smaller efficiency angle, and the exponential increase in attenuation as the energy decreases, is reflected in the calculation of efficiency. Thus, the detection efficiency has proved sufficient for the use of solid angle and Monte Carlo codes.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2007.11a
• /
• pp.11-14
• /
• 2007

Noise level and Airflow amount of a kitchen hood are affected by the conditions of airflow path. Thus this study is expected to be used as a basic reference in designing airflow path of apartment housing throughout analysing changes in noise level and airflow amount from the various conditions of airflow path. Noise level generated by the kitchen hood is estimated in a kitchen and a living room of two constructed apartment houses, and an experiment is conducted in an half anechoic chamber to analyze noise level and airflow amount by the different length, diameter and number of windings of a round shaped soft duct which is connected to the kitchen hood. The measured results in apartment houses show that the noise level in both apartments exceeds the NC standard greatly in living spaces. In apartment A, a regular apartment house, the noise level was $NC-65{\sim}75$, $NC-45{\sim}60$ and NC-70, NC-45 in the kitchen and living room with an operation of kitchen hood in 1 and 3 stages. In apartment B, an apartment complex, the noise level was NC-55 and NC-60 in the kitchen and living room with an operation of kitchen hood in 3 stages. In particular, there was an increase of noise level at 125Hz-band resulted from an amplification of sound, which requires adequate measures in noise reduction. The results measured in Half anechoic chamber show 99% of airflow amount increase with the modification of a duct' s diameter from ${\Phi}$ 100mm to ${\Phi}$ 125mm, 37% of airflow amount increase with the modification of a duct' s diameter from ${\Phi}$ 125mm to ${\Phi}$ 150mm, and 173% of airflow amount increase with the modification of a duct' s diameter from ${\Phi}$ l00mm to ${\Phi}$ 150mm. The noise level was lower than the level measured in apartment housing about 20 in NC-value and 11.4 in dB(A)-value, which was interpreted as the effect of the load by the pressure condition at the rear end of the duct. Also, an amplification of sound in 125Hz-band influenced NC-value considerably, therefore effective measure is needed.

• Journal of the Korean Home Economics Association
• /
• v.45 no.5
• /
• pp.121-133
• /
• 2007

The purpose of this study was to investigate the psychological wellbeing as applied to the bioecological family life welfare model, concerning individual attributes, family backgrounds, and family processes across the family life cycles. Based on Bronfenbrenner's bioecological perspective, the "bioecological family welfare model", which includes person (individual attributes), context (family background), process (mechanism - family process), and time (the family life cycles), was applied as a research paradigm for this study. The sample for the questionnaire study comprised for 900 families, considering the family life cycle in Busan and the Kyungnam area. The families were categorized into 6 family life cycles based on Duvall and Hill's family life cycle. For the final analysis, 628 families were used. According to the path analysis results, the length of commitment before marriage and self-esteem had significant effects on the stress coping ability. Several individual attributes and family backgrounds such as age, length of marriage, family life cycle, self-esteem and stress coping ability had significant effects on marital adjustment. The family life cycle and age were significant variables on family function. The significant variables on psychological wellbeing were monthly income, length of commitment before marriage, stress coping ability and marital adjustment. The regression model showed that the variables of the individual attributes, context and family process accounted for 51% of the psychological wellbeing. The results show that the suggested research model was significant and effective to explain the mechanism of psychological wellbeing. Individual attributes and family context have an impact on stress coping, marital adjustment, and family function, which in turn affect psychological wellbeing.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.6
• /
• pp.788-801
• /
• 1998

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed ; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antennal beam width to cover entire hot-spot region in the space and, by compensating effective burst length throughcutting down man-made noises introduced by antennal. Based on the analysis, we are developed a small-opening-cavity antennal, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antennal exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antennal under same testing condition.

• Current Research on Agriculture and Life Sciences
• /
• v.2
• /
• pp.9-14
• /
• 1984

This study was performed to obtain the effective selection informations for improvement of quality and increase of yield in red pepper. The eight parents and twenty eight crosses from partial diallel were used as materials for estimation of correlations among the pericarp characters, viz, fruit length, fruit width, pericarp thickness (fresh and dry) and pericarp weight (fresh and dry), between pericarp weight and seed weight and between pericarp weight and the percent of seed weight/pericarp weight and path coefficients on fresh and dry pericarp weight. Results were as follows. In $F_1s$, fresh and dry pericarp weight had positive correlations with fruit length, fruit width, and pericarp thickness. Fresh pericarp weight was also positively correlated with dry pericarp weight. Dry pericarp thickness had a negative correlation with fruit length but had positive correlations with fruit width and fresh pericarp thickness. Fresh pericarp thickness had a positive correlation with fruit width. Significantly positive correlations between $F_1s$ and mid-parents were observed in pericarp characters. Pericarp weight had a positive correlation with seed weight but had a negative correlation with the percent of seed weight/pericarp weight. In path coefficient analysis, it was found that fruit length, fruit width and pericarp thickness had direct effects on fresh and dry pericarp weight and that fruit length had the largest direct effect in $F_1s$.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.257-264
• /
• 2003

Tunnelling in water bearing soils influences the ground water regime. It has been indicated in the literature that the existence of ground water above a tunnel influences tunnel stability and the settlement profile. Only limited research, however, has been done on ground water movements around tunnels and their influence on tunnel performance. Time dependent soil behaviour can be caused by the changes of pore water pressure and/or the viscous properties of soil(creep) under the stress change resulting from the advance of the tunnel face. De Moor(1989) demonstrated that the time dependent deformations due to tunnelling are mainly the results of pore pressure dissipation and should be interpreted in terms of effective stress changes. Drainage into tunnels is governed by the permeability of the soil, the length of the drainage path and the hydraulic boundary conditions. The potential effect of lime dependent settlement in a shallow tunnel is likely to occur rapidly due to the short drainage path and possibly high coefficient of consolidation. Existing 2D modelling methods are not applicable to these tunnelling problems, as it is difficult to define empirical parameters. In this paper the time-based 2D modelling method is adopted to account for the three dimensional effect and time dependent behaviour during tunnel construction. The effect of coupling between the unloading procedure and consolidation during excavation is profoundly investigated with the method. It is pointed out that realistic modelling can be achieved by defining a proper permeability at the excavation boundary and prescribing appropriate time for excavation Some guidelines for the numerical modelling of drained and undrained excavation has been suggested using characteristic time factor. It is highlighted that certain range of the factor shows combined effect between the unloading procedure due to excavation and consolidation during construction.

• Journal of the Korean association of regional geographers
• /
• v.10 no.1
• /
• pp.53-66
• /
• 2004

There are various granite landforms including block stream(natural monument No. 435) within Mt. Biseul, in Daegu city. The Daegyunsa(temple) and community of rhododendron around the summit of the mountain provide visitors many objects o( interest in cultural & ecological heritage. This paper aimed to develope nature trails of various type according to visitor's characteristics. 1) Various granite landforms develope along with the main path up the mountain(block stream-gnamma-exfoliation-poligonal cracking-talus-core stone-sheeting joint-tor-free face-high flat summit). 2) The explanatory note on terminology, origin, characteristics of geomorphic resources are developed in this paper for the first time. 3) In Consideration of the path line of flow of visitor, the best field study sites and the most effective nature trails are designed for visitor. 4) Three nature tails are designed for visitor according to the type and the length of visitor's stay.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.40 no.11
• /
• pp.689-695
• /
• 2016

The performance of proton exchange membrane fuel cells (PEMFC) is strongly related to the water flow and accumulation in the gas diffusion layer (GDL) and catalyst layer. Understanding the behavior of fluid from the characteristics of the media is crucial for the improvement of the performance and design of the GDL. In this paper, a numerical method is proposed to calculate the design parameters of the GDL, i.e., permeability, tortuosity, and effective diffusivity. The fluid flow in a channel filled with randomly packed hard spheres is simulated to validate the method. The flow simulation was performed by lattice Boltzmann method with bounce back condition for the solid volume fraction in the porous media, with different values of porosities. Permeability, which affects the flow, was calculated from the average pressure drop and the velocity in the porous media. Tortuosity, calculated by the ratio the average path length of the randomly injected massless particles to the thickness of the porous media, and the resultant effective diffusivity were in good agreement with the theoretical model. The suggested method can be used to calculate the parameters of real GDL accurately without any modification.