• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2008.11a
• /
• pp.203-204
• /
• 2008

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.29 no.12 s.243
• /
• pp.1615-1620
• /
• 2005

We present a novel flow-rate independent cell counter using a fixed control volume between double electrical sensing zones. The previous device based on the single electrical cell sensing in a given flow-rate requires an accurate fluid volume measurement or precision flow rate control. The present cell counter, however, offers the flow-rate independent method for the cell concentration measurement with counting cells in a fixed control volume of $22.9{\pm}0.98{\mu}{\ell}$. In the experimental study, using the RBC (Red Blood Cell), we have compared the measured RBC concentrations from the fabricated devices with those from Hemacytometer. The previous and present devices show the maximum errors of $20.3\%\;and\;16.1\%$, which are in the measurement error range of Hemacytometer (about $20\%$). The present device also shows the flow-rate independent performance at the constant flow-rates ($5{\mu}{\ell}/min$ and $10{\mu}{\ell}/min$) and the varying flow-rate (4, 2, and $4{\mu}{\ell}/min$). Therefore, we demonstrate that the present cell counter is a simple and automated method for the cell concentration measurement without requiring an accurate fluid measurement and precision flow-rate control.

• Journal of Applied Reliability
• /
• v.12 no.2
• /
• pp.67-78
• /
• 2012

An electric double-layer capacitor(EDLC) is an electrochemical capacitor with relatively high energy density, typically hundreds of times greater than conventional electrolytic capacitors. EDLCs are widely used for energy storage rather than as general-purpose circuit components. They have a variety of commercial applications, notably in energy smoothing and momentary-load devices, and energy-storage and kinetic energy recovery system devices used in vehicles, etc. This paper presents an accelerated degradation test of an EDLC with rated voltage 2.7V, capacitance 100F, and usage temperature $-40^{\circ}C{\sim}65^{\circ}C$. The EDLCs are tested at $50^{\circ}C$, $60^{\circ}C$, and $70^{\circ}C$, respectively for 1,750hours, and their capacitances are measured at predetermined times by constant current discharge method. The failure times are predicted from their capacitance deterioration patterns, where the failure is defined as 30% capacitance decrease from the initial one. It is assumed that the lifetime distribution of EDLC follows Weibull and Arrhenius life-stress relationship holds. The life-stress relationship, acceleration factor, and $B_{10}$ life at design condition are estimated by analyzing the accelerated life test data.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.5
• /
• pp.516-521
• /
• 2013

This paper investigates the two dominant but intertwined current blocking mechanisms of Switching and Kirk Effect in pure ternary InAlAs/InGaAs/InAlAs Double Heterojunction Bipolar Transistors (DHBTs). Molecular Beam Epitaxy (MBE) grown, lattice-matched samples have been investigated giving substantial experimental results and theoretical reasoning to explain the interplay between these two effects as the current density is increased up to and beyond the theoretical Kirk Effect limit for devices of emitter areas varying from $20{\times}20{\mu}m^2$ to $1{\times}5{\mu}m^2$. Pure ternary InAlAs/InGaAs/InAlAs DHBTs are ideally suited for such investigations because, unless corrective measures are taken, these devices suffer from appreciable current blocking effect due to their large conduction band discontinuity of 0.5 eV and thus facilitating the observation of the two different physical phenomena. This enhanced understanding of the interplay between the Kirk and Switching effect makes the DHBT device design and optimization process more effective and efficient.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.7 no.2
• /
• pp.76-81
• /
• 2007

Threshold voltage ($V_{th}$) modeling of doublegate (DG) MOSFETs was performed, for the first time, by considering barrier lowering in the short channel devices. As the gate length of DG MOSFETs scales down, the overlapped charge-sharing length ($x_h$) in the channel which is related to the barrier lowering becomes very important. A fitting parameter ${\delta}_w$ was introduced semi-empirically with the fin body width and body doping concentration for higher accuracy. The $V_{th}$ model predicted well the $V_{th}$ behavior with fin body thickness, body doping concentration, and gate length. Our compact model makes an accurate $V_{th}$ prediction of DG devices with the gate length up to 20-nm.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1459-1461
• /
• 1996

The optical and electrical properties of High Power AlGaAs/AlGaAs Infrared LED with DDH( Double power Double Hetero Junction) structure are investigated. The high power LED is recently studied in order to apply to high speed communication devices. The power out of AlGaAs/AlGaAs with DDH structure is 13.0[mW], the forward voltage is 1.45[V], and the average decrease rate of power out is about 5[%] after aging test. The optical and electrical properties of DDH structure LED are superior than that of SH structured LED. The DDH structured LED is suitable to the high speed communication devices.

• Korean Journal of Applied Biomechanics
• /
• v.29 no.1
• /
• pp.1-8
• /
• 2019

Objective: The purpose of this study was to confirm that the cross-country ski sprint course in PyeongChang, where the 2018 Winter Olympics course was to utilize wearable devices equipped with inertial measurement unit (IMU), global positioning system (GPS) and heart rates sensor. Method: For the data collection, two national level cross-country (XC) skiers performed classic technique on the entire sprint course. We analyzed cycle characteristics, range of motion on double poling (DP) technique, average velocity, and displacement of 3 points according to the terrain. Results: The absolute cycle time gradually decreased during starting, middle and finish sections. While the length of the DP increased and the heart rates tended to increase for men skier. In addition, the results indicated that range of motion of knee joint during starting and finish section decreased more than middle section. The errors of latitude and longitude data collected through GPS were within 3 m from 3 points. Conclusion: Through the first case study in Korea, which analyzed the location and condition of XC skiers in the entire sprint course in real time, confirmed that feedback was available in the field using various wearable sensors.

• Journal of KIISE:Computing Practices and Letters
• /
• v.16 no.2
• /
• pp.217-221
• /
• 2010

As the appearances of various new mobile devices and the explosive growth of mobile device users, many researches related to mobile P2P systems have been proceeded actively. In this paper, we propose a new search algorithm for the double-layered super peer system in the mobile environment. For the proposed search algorithm, we divide the entire experiment region into a grid of cells, each of which has the same size. The grid is configured properly by considering the communication range of a mobile device and the number of peers in the system. The proposed search algorithm is a partial flooding search method based on the directions of cells involved with the search. It reduces successfully the network traffic, but shows a low search hit ratio. To enhance the search hit ratio, we introduce a bridge-peer table for a super peer and utilize an n-way search. The experimental results show that the proposed algorithm made an average of 20~30% reduction in the number of message packets over the double-layered system. The success ratio was also improved about 2~5% over the double-layered system.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.3
• /
• pp.309-314
• /
• 2016

Objective: There are no guidelines for choosing appropriate gait assistive devices. The aim of this study was to evaluate gait assistive devices in patients with Parkinson's disease. Method: We evaluated 15 individuals with Parkinson's disease who did or did not use one of two different devices including canes and two-wheeled walkers. Data were collected using the GAITRite system. Results: Participants in the group using canes and two-wheeled walkers had significantly increased double support time and decreased gait velocity, normalized gait velocity, and stride length compared with those who did not. Participants who used a two-wheeled walker had significantly decreased gait velocity, normalized gait velocity, and stride length compared with those who used a cane. Furthermore, participants who used a two-wheeled walker had significantly decreased coefficients of variation for step time, stride length, and swing time compared with those who used a cane. Conclusion: Our results indicated that the two-wheeled walker offered the most consistent advantages for decreasing the risk of falling.

• Journal of the Korean Magnetic Resonance Society
• /
• v.17 no.2
• /
• pp.81-85
• /
• 2013

Various fluorine-containing materials are used in electronic devices like LCD display panels and Li-ion batteries. The structural conformation of fluorine in fluorinated materials is an important contributing factor that influences the chemical and physical properties. The conformation can be changed by heat and stress during manufacture or use. Understanding the conformational changes is critical for understanding the performance and durability of electronic devices. Solid-state NMR spectroscopy could be widely used for the analysis of various fluorine-containing materials for electronic devices. However, conventional CPMAS probes cannot be used for in-situ analysis of fluorine-containing electronic devices like LCD panels and Li-ion batteries. In this paper, we show the design, construction, and optimization of a $^{19}F-^{13}C$ double-resonance solid-state NMR probe for a 400MHz wide-bore magnet with a flat square coil for in-situ analysis of fluorine-containing electronic devices without observing fluorine background signals. This custom-built probe does not show any fluorine background signals, and can have higher efficiency for lossy samples.