• Journal of Power Electronics
• /
• 제11권4호
• /
• pp.533-541
• /
• 2011

The redundant operation of a parallel AC to DC converter via a serial communication bus is presented. The proposed system consists of three isolated CUK power factor correction modules. The controller for each converter is a dsPIC30F6010 microcontroller while a RS485 communication bus and the clock signal are used for synchronizing the data communication. The control strategy of the redundant operation relies on the communication of information among each of the modules, which communicate via a RS485 serial bus. This information is received from the communication checks of the converter module connected to the system to share the load current. Performance evaluations were conducted through experimentation on a three-module parallel-connected prototype, with a 578W load and a -48V dc output voltage. The proposed system has achieved the following: the current sharing is quite good, both the transient response and the steady state. The converter modules can perform the current sharing immediately, when a fault is found in another converter module. In addition, the transient response occurs in the system, and the output voltages are at their minimum overshoot and undershoot. Finally, the proposed system has a relatively simple implementation for the redundant operation.

• 한국산학기술학회논문지
• /
• 제18권4호
• /
• pp.504-510
• /
• 2017

본 논문은 소형 가전기기를 위한 AC DC 파워모듈 설계를 제시하고 효율과 신뢰성 및 안정성 특성을 나타낸다. 제안하는 파워모듈은 PCB 테스트보드에서 PWM 제어 IC 칩, 파워모스 소자, 트랜스포머, 각종 수동소자 (저항, 커패시터, 인덕터)를 사용하여 제작하였다. 본 논문에서 제시한 AC DC 파워모듈 회로 시뮬레이션 결과를 토대로 측정한 실험에서 입력전압은 상용전원 전압 220 V (RMS), 주파수 60 HZ의 교류전압(VAC : Voltage alternating current)을 사용 하였으며, 출력전압, OCP (over current protection), EMI(electromagnetic interference), PWM 신호 펄스, 효율 측정, 패키징 여부에 따른 발열측정 등을 실시하였다. 또한 파워모듈의 온도에 따른 특성변화와 트랜스포머 기준으로 1차측의 회로와 2차측 회로의 절연상태 확인을 하기 위한 내전압 테스트 등의 신뢰성테스트를 실시하였다. 효율 및 신뢰성 측정결과, AC DC 파워 모듈이 5 V의 출력전압, 200 mV의 리플, 약 73 %의 효율, 온도 약 $80^{\circ}C$ 까지 안정적으로 동작함을 확인하였으며, 4.2 kV의 크기로 60초 동안 견디는 내압 성능을 보였다.

• 전기전자학회논문지
• /
• 제13권4호
• /
• pp.63-68
• /
• 2009

본 논문에서는 CCD 이미지 센서용 PMIC를 제안한다. CCD 이미지 센서는 온도에 민감하다. 일반적으로 낮은 효율을 갖는 PMIC에 의해 열이 발생된다. 발생된 열은 CCD 이미지 센서의 성능에 영향을 미치므로 높은 효율을 갖는 PMIC를 사용함으로써 최소화 시켜야 한다. 고효율의 PMIC개발을 위해 입력단은 동기식 step down DC-DC컨버터로 설계하였다. 제안한 PMIC의 입력범위는 5V~15V이고 PWM 제어방식을 사용하였다. PWM 제어회로는 삼각파 발생기, 밴드갭 기준 전압회로, 오차 증폭기, 비교기로 구성된다. 삼각파 발생기는 1.2MHz의 발진 주파수를 가지며, 비교기는 2단 연산 증폭기로 설계되었다. 오차 증폭기는 40dB의 DC gain과 $77^{\circ}$ 위상 여유를 갖도록 설계하였다. step down DC-DC 컨버터의 출력은 Charge pump의 입력으로 연결된다. Charge pump의 출력은 PMIC의 출력단인 LDO의 입력으로 연결된다. PWM 제어회로와 Charge pump 그리고 LDO로 구성된 PMIC는 15V, -7.5V, 5V, 3.3V의 출력전압을 갖는다. 제안한 PMIC는 0.35um 공정으로 설계하였다.

• 전기학회논문지P
• /
• 제60권4호
• /
• pp.253-256
• /
• 2011

LEDs have small size, long lifespan, high reliability, low power consumption and high color efficiency. Using such a characteristics, LED Back Light Unit has been studying actively. This paper proposes LED driver to minimize power consumption due to LED forward voltage($V_F$) difference and temperature rising. Compared to conventional LED driver, the proposed driver have excellent stability, brief structure and linear output voltage of DC-DC boost converter. Proposed LED Driver circuit was designed using 0.35um CMOS technology. And its operation was verified through simulation.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.143-146
• /
• 2004

This is a thesis that 100W class open frame type power module of a quarter-brick size appropriate for telecommunication is reported. The input voltage is established between 36 and 75 in range in order for power module to be utilized for the telecommunication, and output were set at 3.3V and 30A. A number of parts used for transformer, inductor, and hit sink are composed of PCB in order for DC-DC converter to be lowered below 8 mm. A constant current control circuit was annexed to the system as well as basic protection prototypes such as over-voltage, over-current, and over-temperature were well considered to enhance more credibility, and were tested. As a result, high circuit performance and credibility turned out to be significant.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.1093-1096
• /
• 2002

In this paper, a novel multi voltage inverter system is proposed for reductions of harmonics, which can compensate reactive power. At first, we remove capacitor at input side for reactive power compensation. Secondly, by adding DC voltage to the filter capacitor, it can control power factors as lead-phase according to alterations of loads at power reception. Thirdly, if winding and single phase-bridge inverter(auxiliary circuit) is installed to DC power for reduction of harmonic, waveform of output voltages become to 36-steps. Thus, SVC(static var compensator) systems which can reduce harmonics are designed.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 전력전자학술대회 논문집
• /
• pp.201-204
• /
• 2001

In this paper, a single-phase to three-phase PWM converter topology using six switches only for low cost induction motor drive is proposed. The converter topology is of lower cost than the conventional one, which gives sinusoidal input current, unity power factor, dc output voltage control and bidirectional power flow In addition, the source voltage sensor is eliminated by controlling the deviation between the model current and the system current to be zero. The performance of the proposed converter has been demonstrated through the computer simulation.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 추계학술대회 논문집
• /
• pp.619-625
• /
• 2008

Electrical Power supply System conditions of korea high speed train consists of main transformer, four AC-DC PWM converter of Auxiliary Block, Battery Charger in Power Car and Trailer Car, Trailer Inverter, Auxiliary inverter. Main transformer, at nominal voltage of 25kv supplied to secondary winding nominal output Voltage 383Vac, The Auxiliary block consists of AC-DC converters for generating 670VDC power, Auxiliary inverters for ventilation and air compressor, Trailer car inverter provide three phase power supplies at 440Vac for air conditioning and heating. The Battery charger Trailer and Power car supplies 72VDC all necessary equipment to energize the trainset equipment and suppy essential control. This Paper introduces the combined test results of the power supply system for korea high speed train. The main purpose of this combined test is to verify the performance of the power supply system that is designed to operate up to full load test.

• Journal of Electrical Engineering and Technology
• /
• 제8권6호
• /
• pp.1337-1344
• /
• 2013

This paper presents a simplified modulation strategy for the three-leg VSI fed two-winding induction motor. The strategy provides independent unbalanced voltage control for the main and auxiliary windings. This make the motor can be reversed rotation through the range of motor speed operation without limitation of voltage boost of the auxiliary winding. To study the advantages of the proposed drive, the experimental results such as voltage stresses, hysteresis band of the currents in locus, and also acoustic noise levels of the three-leg VSI are compared with those of the conventional two-leg topology. The results obviously show that the proposed technique achieves superior performance compared with the traditional scheme in case of dramatic increase of DC bus utilization, effective reduction of harmonic voltages content, and also significant enhancement of motor efficiency.

• 한국산학기술학회논문지
• /
• 제13권4호
• /
• pp.1777-1783
• /
• 2012

본 논문에서는 DC모터의 출력특성을 개선할 수 있는 새로운 구조의 DC모터 구동회로를 설계하였고 이 회로를 이용한 콘트롤러를 개발하였다. 설계된 구동 회로에 의하여 콘트롤러는 자체발진회로의 스위칭 신호를 갖는 트랜스포머를 이용하여 연속적으로 DC모터를 구동할 수 있다. 또한 최대속도시, 제어회로의 기준전압 값을 삼각파보다 높게 유지할 수 있고 모터 구동 FET를 항상 온 값을 가지도록 하여 최대출력을 얻을 수 있도록 한다. 제안된 구동회로를 활용하여 24V-500W급 DC모터속도 컨트롤러를 개발하였고 소형전동차를 제작하고 구동시험을 실시하였다. 구동테스트 및 특성 측정결과, 구동전류 12A로써 DC모터의 전진 및 후진 속도를 연속 가변 할 수 있음을 보였다. 그 밖에 과전류 감시기능, 모터과열 감시기능의 정상동작을 확인하였으며, 배터리 잔량이 20~100%까지 6단계로 표시할 수 있음을 확인하였다.