DOI QR코드

DOI QR Code

Redundant Operation of a Parallel AC to DC Converter via a Serial Communication Bus

  • Kanthaphayao, Yutthana (Dept. of Electrical Eng., King Mongkut's University of Technology North Bangkok) ;
  • Kamnarn, Uthen (Dept. of Electrical Eng., Rajamangala University of Technology Lanna) ;
  • Chunkag, Viboon (Dept. of Electrical Eng., King Mongkut's University of Technology North Bangkok)
  • Received : 2010.09.23
  • Published : 2011.07.20

Abstract

The redundant operation of a parallel AC to DC converter via a serial communication bus is presented. The proposed system consists of three isolated CUK power factor correction modules. The controller for each converter is a dsPIC30F6010 microcontroller while a RS485 communication bus and the clock signal are used for synchronizing the data communication. The control strategy of the redundant operation relies on the communication of information among each of the modules, which communicate via a RS485 serial bus. This information is received from the communication checks of the converter module connected to the system to share the load current. Performance evaluations were conducted through experimentation on a three-module parallel-connected prototype, with a 578W load and a -48V dc output voltage. The proposed system has achieved the following: the current sharing is quite good, both the transient response and the steady state. The converter modules can perform the current sharing immediately, when a fault is found in another converter module. In addition, the transient response occurs in the system, and the output voltages are at their minimum overshoot and undershoot. Finally, the proposed system has a relatively simple implementation for the redundant operation.

Keywords

References

  1. S. Luo and I. Batarseh, "A review of distributed power systems part I: DC distributed power system," IEEE A&E SYSTEMS MAGAZINE, Vol. 20, No. 8, pp. 5-16, Aug. 2005. https://doi.org/10.1109/MAES.2005.1499272
  2. S. K. Mishra, S. Zhou, W. Huang, and G. Schuellein "Design of a redundant paralleled voltage regulator module system with improved efficiency and dynamic response," in Proc. 41st IAS Conf., pp. 2524-2528, 2006.
  3. Z. He and Y. Xing, "Distributed control for UPS modules in parallel operation with RMS voltage regulation," IEEE Trans. Ind. Electron., Vol. 55, No. 8, pp. 2860-2869, Aug. 2008. https://doi.org/10.1109/TIE.2008.918471
  4. J. M. Guerrero, L. Hang, and J. Uceda, "Control of distributed uninterruptible power supply systems," IEEE Trans. Ind. Electron., Vol. 55, No. 8, pp. 2845-2859, Aug. 2008. https://doi.org/10.1109/TIE.2008.924173
  5. S. Luo, Z. Ye, R.-L. Lin, and F. C. Lee, "A classification and evaluation of paralleling methods for power supply modules," in Proc. PESC, Vol. 2, pp. 901-908, 1999.
  6. J.-H. Kim, J.-G. Lim, S.-K. Chung, and Y.-J. Song, "DSP-based digital controller for multi-phase synchronous buck converters," Journal of Power Electronics, Vol. 9, No. 3, pp. 401-417, May 2009.
  7. S.-H. Li and C.-M. Liaw, "Paralleled DSP-based soft switching-mode rectifiers with robust voltage regulation control," IEEE Trans. Power Electron., Vol. 19, No. 4, pp. 937-946, Jul. 2004. https://doi.org/10.1109/TPEL.2004.830095
  8. S. K. Mazumder, M. Tahir, and K. Acharya, "Master-slave currentsharing control of a parallel DC-DC converter system over an RF communication interface," IEEE Trans. Ind. Electrol., Vol. 55, No. 1, pp. 59-66, Jan. 2008. https://doi.org/10.1109/TIE.2007.896138
  9. Y. Kanthaphayao, P. Wisutmetheekorn, U. Kamnarn, and V. Chunkag, "Distributed control of a parallel AC to DC converter," in Proc. ECTICON, Vol. 1, pp.68-71, 2009.
  10. J. Guo, D. Boroyevich, and S. H. Edwards, "Distributed, modular, open control architecture for power conversion systems," in Proc. PESC,, Vol. 3, pp. 2258-2263, 2004.
  11. G. Francis, R. Burgos, F. Wang, and D. Boroyevich, "A universal controller for distributed control of power electronics conversion systems," in COMPEL '06. IEEE Workshops on, pp. 8-14, 2006.
  12. R. V. White and D. Freeman, "Data communications issues for power system management," in Proc. APEC, pp. 1188-1199, 2007.
  13. W. Stefanutti, S. Saggini, P. Mattavelli, and M. Ghioni, "Power line communication in digitally controlled DC-DC converters using switching frequency modulation," IEEE Trans. Ind. Electorn., Vol. 55, No. 4, pp. 1509-2008, Apr. 2008. https://doi.org/10.1109/TIE.2008.917145
  14. M. Popal, A. S. Popa, V. Cretu, and M. Micea, "Monitoring serial communications in microcontroller based embedded systems," in Computer Engineering and Systems, pp. 56-61, 2006.
  15. K. Kutluay, I. Cadirci, A. Yafavi, and Y. Cadirci, "Dual 8-b microcontrollers," IEEE Industry Applications Magazine, Vol. 12, pp. 59-67, Jan./Feb. 2006.
  16. K. Siri, C. Q. Lee, and T.-F. Wu, "Current distribution control for paralle1 connected converters: part I," IEEE Trans. on Aerosp. Electron. Syst., Vol. 28, No. 3, pp. 829-840, Jul. 1992. https://doi.org/10.1109/7.256303
  17. dsPIC30F6010 High-performance digital signal controllers data sheet, Microchip Technology Inc., 2004
  18. B.-R. Lin, "Analysis of neural and fuzzy-power electronic control," IEE Proc.-Sci. Meus. Technol., Vol. 144, No. 1, Jun. 1997.
  19. A. R. Ofoli and A. Rubaai, "Real-time implementation of a fuzzy logic controller for switch-mode power-stage DC-DC converter," IEEE Trans. Ind. Appl., Vol. 42, No. 6, Oct. 2006.
  20. C. S. Chang and W. Fu, "Area load frequency control using fuzzy gain scheduling of PI controllers," ARTICLE Electr. Power Syst. Res., Vol. 42, No. 2, pp.145-152, Aug. 1997. https://doi.org/10.1016/S0378-7796(96)01199-6
  21. S. Md. Ayob, Z. Salam, and N. A. Azli, "A new optimum design for a single input fuzzy controller applied to DC to AC converters," Journal of Power Electronics, Vol. 10, No. 3, pp. 306-312, May 2010 https://doi.org/10.6113/JPE.2010.10.3.306
  22. L. Guo, J. Y. Hung, and R. M. Nelms, "Evaluation of DSP-based PID and fuzzy controllers for DC-DC converters," IEEE Trans. Ind. Electron., Vol. 56, No. 6, pp. 2237-2248, Jun. 2009. https://doi.org/10.1109/TIE.2009.2016955
  23. G.-B. Chung, "Investigation of PID fuzzy controller for output voltage regulation of current-doubler-rectified asymmetric half-bridge DC/DC converter," Journal of Power Electronics, Vol. 7, No. 1, pp. 21-27, Jan. 2007.
  24. S. Md. Ayob, N. A. Azli, and Z. Salam, "PWM DC-AC converter regulation using a multi-loop single input fuzzy PI controller," Journal of Power Electronics, Vol. 9, No. 1, pp. 124-131, Jan. 2009.
  25. V. Chunkag and U. Kamnarn, "Parallelling three-phase AC to DC converter using CUK rectifier modules based on power balance control technique," IET Power Electron., Vol. 3, No. 4, pp. 511-524, Jul. 2010. https://doi.org/10.1049/iet-pel.2008.0209
  26. U. Kamnarn and V. Chunkag, "Analysis and design of a modular threephase AC-to-DC converter using CUK rectifier module with nearly unity power factor and fast dynamic response," IEEE Trans. Power Electron., Vol. 24, No. 8, Aug. 2009.

Cited by

  1. Improved Droop Method for Converter Parallel Operation in Large-Screen LCD TV Applications vol.14, pp.1, 2014, https://doi.org/10.6113/JPE.2014.14.1.22
  2. A Review of Power Electronic Converters for Variable Speed Pumped Storage Plants: Configurations, Operational Challenges, and Future Scopes vol.6, pp.1, 2018, https://doi.org/10.1109/JESTPE.2017.2707397