• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.2 s.117
• /
• pp.177-182
• /
• 2007

This paper presents the InGaP/GaAs HBT differential LC VCO with low phase noise performance for adaptive feedback interference cancellation system(AF-lCS). The VCO is verified with enhanced tank structure including filtering technique. The output tuning range for proposed VCO using asymmetric inductor and symmetric capacitors withlow pass filtering technique is 207 MHz. The output powers are -6.68 including balun and cable loss. The phase noise of this VCO at 10 kHz, 100 kHz and 1 MHz are -102.02 dBc/Hz, -112.04 dBc/Hz and -130.40 dBc/Hz. The VCO is designed within total size of $0.9{\times}0.9mm^2$.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.5
• /
• pp.7-13
• /
• 1997

A X-band 3-stage monolithic LNA (low noise amplifier) with series feedback has been successfully desined and demonstrated by suign 0.5-$\mu\textrm{m}$ GaAs MESFET. In the design of the 3-stage LNA, the effects of series feedback to the noise figure, the gain, and the stability have been investigated ot find the optimal short stub length. As a result, the inductive series feedback topology which has 10degree short stub in the GaAs MESFET source lead, has been employed in the 1-st stage. The fabricated MMIC LNA's chip size is only 1mm$^{2}$/stage, which is smaller than the previously reported X-band MMIC input/output return losses are less than -10dB and -15dB, respectively. The noise figure (NF) is less than 2.6dB. The measured data show good agreement with the simulated values.

• Journal of electromagnetic engineering and science
• /
• v.6 no.1
• /
• pp.18-23
• /
• 2006

In this paper, we demonstrate a fully integrated X-band image rejection down converter, which was developed using InGaP/GaAs HBT MMIC technology, consists of two single-balanced mixers, a differential buffer amplifier, a differential YCO, an LO quadratue generator, a three-stage polyphase filter, and a differential intermediate frequency(IF) amplifier. The X-band image rejection downconverter yields an image rejection ratio of over 25 dB, a conversion gain of over 2.5 dB, and an output-referred 1-dB compression power$(P_{1dB,OUT})$ of - 10 dBm. This downconverter achieves broadband image rejection characteristics over a frequency range of 1.1 GHz with a current consumption of 60 mA from a 3-V supply.

• Archives of Pharmacal Research
• /
• v.13 no.2
• /
• pp.174-179
• /
• 1990

Second derivative (D2) spectrometry using ion-pair extraction technique was development for the determination of total glycyrrhetic acid (GA) in Glycyrrhizae Radix, Glycyr-rhizin (G) obtained from Glycyrrhizae Radix was hydrolyzed into GA in 2 N-HCI and methanol (1:1) and extracted from aqueous phase in the form of an ion-pair complex with tetrapentylammonium bromide (TPA) as a counter ion. Maximum D2 amplitude (Z value) was obtained when 1000-fold or greater molar ratio of TPA was used at pH 11. Reaction an effective extraction solvent of the ion-pair complex. The linearity of standard curve of ion-pair GA was obtained in the range of 4.120 $\mu$g/ml as GA. Assayed contents of GA in dry powder by D2 UV spectrometry and HPLC method were 5.31 $\pm$ 0.04% and 5.20 $\pm$ 0.008%, respectively.

• Journal of Powder Materials
• /
• v.19 no.4
• /
• pp.264-270
• /
• 2012

In this study, we mainly focus on the study of densification of gas-atomized Cu-50 wt.%In-13 wt.%Ga alloy powder without occurrence of crack during the forming process. Cu-50 wt.%In-13 wt.%Ga alloy powder was consolidated by sintering and rolling processes in order to obtain high density. The phase and microstructure of formed materials were examined by X-ray diffraction (XRD), scanning electron microscopy (SEM) and optical microscopy (OM), respectively. Warm rolling using copper can result in the improvement of density. The specimen obtained with 80% of rolling reduction ratio at $140^{\circ}C$ using cooper can have the highest density of $8.039g/cm^3$.

• Journal of the Korean Vacuum Society
• /
• v.15 no.5
• /
• pp.493-498
• /
• 2006

Superluminescent diodes (SLD) with the emitting wavelength of $1.55{\mu}m$ was fabricated on InGaAs quantum dot structure grown by MOCVD. The output power and 3-dB bandwidth at room temperature and continuous wave operation were 3 mw and 55 nm, respectively.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.15 no.5
• /
• pp.554-562
• /
• 2015

This paper presents the design and analysis of gate-recessed AlGaN/GaN Fin-type Field-Effect Transistor (FinFET). The three-dimensional (3-D) technology computer-aided design (TCAD) simulations were performed to analyze the direct-current (DC) and radio-frequency (RF) characteristics for AlGaN/GaN FinFETs. The fin width ($W_{fin}$) and the height of GaN layer ($H_{GaN}$) are the design parameters used to improve the electrical performances of gate-recessed AlGaN/GaN FinFET.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.53 no.6
• /
• pp.433-439
• /
• 2004

The Helicopter Simulator System is non-linear and complex. Futhermore, because of absence of its accurate mathematical model, it is difficult to control accurately its attitudes such as elevation angle and azimuth one. Therefore, we proposed a Hybrid GA-PID WAVENET(Genetic Algorithm Proportional Integral Derivative Wavelet Neural Network)control technique to control efficiently these angles. The proposed Hybrid GA-PID WAVENET is made through the following process. First, the WAVENET fundamental functions are defined. And their dilation and translation values are adjusted by GA to construct the optimal WAVENET controller. Secondly, the proportional, integral, and derivative gain coefficients of PR controller are tuned optimally. Finally, WAVENET controller which has a good transient characteristic and GA-PE controller which has a good steady state characteristic is adequately combined in hybrid type. Through the computer simulations, it is proved that the Hybrid GA-PE WAVENET control technique has a more excellent dynamic response than PID control technique and GA-PID one.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.11
• /
• pp.1071-1083
• /
• 1991

In this paper, we describe the design and realization of optical preamplifier with InGaAs APD and GaAs MESFET. Optical preamplifier which is three stage trans-impedance circuit is analyzed in detail and realized in microstrip circuits. With the kmowledge of the InGaAs, GaAs MESFET and BJT, the performance of the optical is predicted by computer simulation and the theoretical predictions are compared with the experimental results. The designed hybrid MIC optical preamplifier exhibits a bandwith of 380MHz and a receiver sensitivity of -40. 6dBm at $1.55{\mu}m$ wavelength when operating at 565Mb/s with BER of $10^{-9}$.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.3
• /
• pp.29-34
• /
• 2021

For the purpose of Application to the small radar sensor, the MMIC Chips, which are the core component of the W-band, was designed in Korea according to the characteristics of the transceiver and manufactured by 60nm GaN and 0.1㎛ GaAs pHEMT process. The output power of PA is 28 dBm at center frequency of W-band and Noise figure is 6.7 dB of switch and LNA MMIC. Output power and Noise figure of MMIC chips developed in domestic was applied to the transmitter and receiver module through W-band waveguide low loss transition structure design and impedance matching to verify the performance after the fabrication are 26.1~27.7 dBm and 7.85~10.57 dB including thermal testing, and which are close to the analysis result. As a result, these are judged that the PA and Switch and LNA MMICs can be applied to the small radar sensor.