• Journal of the Korean Professional Engineers Association
• /
• v.17 no.3
• /
• pp.6-21
• /
• 1984

A rock slide in amount of 100 tons in weight happened at 7: 10 a.m., 4th October 1982, on the southwestern ridge of Mt. Seunghag, Busan City. The original rock mass of the rock slide is located 850m west from the Dangri Crushed Stone Quarry. The geology of the area consists of agglomerate, andesite, andesitic tuff, and shale hornfels of the Cretaceous Yucheon Group. The rock blocks were first shifted along the steep joint plane on an andesite outcrop at the site and then to the eastern foot of the mountain slope where some private houses are placed. The mountain slope is covered with thick superficial soil. A slided monolithic-block with 83 tons in weight from the rock slide met with an accident of striking against a house with a tremendous force, to which much damage was done as much as its half was destroyed. The rock-slided block pierced the board-floored room only posited at the center and by the bedroom of the house making a pass like a bullet hole, and hence cut a big pine tree with 24 centimeters in diameter at a distance of 26 meters down the house. However nobody was killed or injured in the stricken house, though seven family members were stayed therein at the very time of accident. They really met a rare opportunity in an unhappy disaster. Measurements of the rock slide were made in the course of the field survey. The monolithic mass was transported by way of saltation, rolling, and sliding to a distance of 300 meters down along the slope dipping 30$^{\circ}$ east. It took about 16 seconds front tile outcrop to the terminal. The acceleration value of the monolithic rock slide is 2.35m/sec$^2$.

• The Journal of Engineering Geology
• /
• v.30 no.4
• /
• pp.447-456
• /
• 2020

The study area is a slope in Dogye-eup, Samcheok-si, Gangwon-do. The cutting method was applied to this slope for stabilization in 2009 due to the influence of the waste-rock dump located at the top of slope. Recently, soil cracks and creep have occurred on this slope, and the drainage channel was damaged. Therefore, it was analyzed the topography change through photogrammetry using a UAV. Orthophotos were taken in April and October 2019 respectively. From the Orthophots, Digital Surface Model (DSM) was extracted. Time series analysis was performed by comparing each DSM. The topography of October was pushed forward while maintaining the topography of April. Through these features, it is judged that the soil creep is occurring in this study area.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.6
• /
• pp.173-180
• /
• 2001

This research is aimed at investigating the dynamic response of cut-and-cover tunnel to seismic waves. We carried out shaking table test which is used a 1/40-scale(the width of prototype tunnel is about 14.2m, the height is about 8.5m) model for this research, and we analyzed the effect of depth of tunnel and slope of the ground in relation to the dynamic responses of tunnel. As a result of the test, the stress and acceleration along the tunnel decreased accordingly to the depth of increment, and this phenomenon is caused by the increase of the confining effect of ground. Also, the dynamic responses of tunnel showed a tendency to rise according as ground declined gently. In comparison the result of shaking table test with that of structural analysis on ordinary condition, we conclude that seismic waves do not affect cut-and-cover tunnel when the depth of tunnel is over the diameter of tunnel.

• Journal of Korean Society of Forest Science
• /
• v.13 no.1
• /
• pp.67-78
• /
• 1971

The measures of contour-terracing with sod has been executed as a major measures for hillside erosion control works for a long time in Korea. It is, however, recognized that pair terracings make a new slope-face having the more steeper degree of slope between the upper and the lower terraces on hillsides and it also does not contribute for establishing the natural vegetation-cover by penetration of pioneer seeds on the slope faces or cut-faces of hillsides. The study was therefore conducted in connection with the above problems on the cut-face having slope of $40^{\circ}$ and 1.6 meter in slope length with clay soils. Plot allocation for the experiment consists of 3 kinds of 3 replica plots having each $1.6m^2$ of slope area, i. e., the control plot with direct seeding on slopes only ($T_1$), the covering plot with the straw-mats after seeding on slopes ($T_2$) and the seeding plot after covering with the straw-mats. ($T_3$). The main results obtained may be summarized as follows : 1. Effects of the straw-mat mulchings on surface soil loss control:-The total amount of soil losses from each treatments are measured as 4,651 gr from $T_1$, 163 gr. from $T_2$ and 2,891 gr. from $T_3$ treatment respectively. (Refer to table No. 2, 3 and 4). In short, it is recognized that effect of $T_2$ treatment is compared as 28.5 times than that of $T_1$ treatment and 17.7 times than that of $T_3$ treatment respectively. Effect of $T_3$ treatment compared with $T_1$ treatment is also such recognizable as 1.6 times in control of surface soil losses on a slope face. 2. Effect of the straw-mat mulchings on soil moisture content on slopes; -Average per cent of surface soil moisture content by treatments show as 21.60 at the $T_1$, 23.04 at the $T_2$ and 22.21 at the $T_3$ treatment respectively and that of subsurface soil moisture content by treatment show as 23.81 at the $T_1$, 26.16 at the $T_2$ and 24.81 at the $T_3$ treatment respectively. The variance of soil moisture content by treatments was highly significant (Refer table No. 7, 8 and 9). 3. Effect of the straw-mat mulchings on vegetation establishment;-Average numbers of germination by treatments are counted as 237 Nos. at the $T_1$, 246 Nos. at the $T_2$ and 262 Nos. at the $T_3$ treatment plots and the vegetation coverage on ground was almost same as about 90% of covers in all treatments. This effect is more or less lower than that of surface soil erosion control. 4. Regarding the effect on surface soil erosion control, the straw-mat mulchings would be effective as a new measures for control of soil erosion on erosion susceptible lands such slope-faced bare-lands as cut-fill faces, mass-movement faces and bare hillsides.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.17 no.5
• /
• pp.79-89
• /
• 2014

This study was carried out to provide basic information to improve the surrounding ecosystems with benefit analysis and monitoring in cut slopes following establishment of a test construction to improve ecological environment in slopes of an expressway. Field tests from October 2012 to May 2013 were conducted in Seosejong IC and Shinyang IC. In order to improve the view of slopes, soil condition is an important factor. The earth slope, it is possible to introduce directly the plant. Stable construction method was applied, another foundation for planting is necessary. The mixing ratio of the seeds according to the experimental results, the difference was found at an early stage plants in Site I (Seosejong IC). Trees were planted on terraced structures were well coordinated and pictures. The growth of planted trees was good in Site II (Shinyang IC). Due to the use of plants in the landscape will continue to change. Thus, long-term monitoring and landscape analysis will be needed.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.13 no.3
• /
• pp.152-162
• /
• 2010

This study provides preliminary data to support the need for appropriate and thorough restoration of quarries through investigating both domestic and overseas cases of sites that were restored in environment-friendly ways to make them re-usable after extraction. In cases of areas where it is difficult to restore the cut slope, putting it to other uses such as engraving buddhist images would be helpful to reduce the restoration cost and enhance the utilization of the slope. Phased land use conversion after exploitation needs to be considered in advance; for example, the location and size of the quarry should be determined according to the pre-planned use or development of the site. Considering the circumstances in the country, serious consideration should be given to methods that allow the restoration or recovery of the damaged sites to be completed in short periods of time. Quarry restoration needs to be approached from the view of ecological restoration and if a site is deemed to be usable for another purpose, land use conversion should be considered to enhance the utilization.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.163-170
• /
• 2005

In this paper, the rock bolts, soil nails with filling grout and the micro-piling with injecting grout by pressure were applied for the stabilization of the cut slopes consisting of sedimentary rocks, igneous rocks and metamorphic rocks respectively. The field measurements and 3-D FEM analyses to find out mobilized tensile stresses of the grouted-reinforcing members installed in the drilled holes were executed on each site. With assuming the increments of the cohesive strength in the improved ground, the back analysis using direct calibration approach of changing the elastic modulus of the ground was used to find out the improved elastic modulus which yields the same tensile stresses from field measurements. The results of back analysis show that the elastic modulus of the improved ground were 4 to 6 times as large as the elastic modulus of original ground. Consequently, the design for slope reinforcement to be more rational, it is proposed that not only the improved cohesive strength is to be used in the incremental ranges on well-known previous proposed data, but also the increased elastic modulus which is about 5 times as large as the original elastic modulus is to be considered in design.

• Journal of the Korea Furniture Society
• /
• v.10 no.2
• /
• pp.73-78
• /
• 1999

This paper describes the relationship between the bending strength properties of sloped finger-jointed woods and the acoustic emissions(AEs) generated during the test. Rhus verniciflua pieces were cut in sloped-finger types and glued with three kinds of adhesives(polyvinyl acetate, polyvinyl-acryl acetate and oilic urethane resin). The slope ratios of finger joints were 0, 1.0, 1.5, and 2.0. The AE cumulative event count and cumulative count were measured during the bending test. The results were as follows: The lower the bending strength(load) was, the generation time of AE event count got and the higher the increasing rate of AE event count became in the sloped finger-jointed specimens bonded with polyvinyl acetate, polyvinyl-acryl acetate oilic urethane resin adhesives. Therefore, the slope from load-AE cumulative event count was very steep. The patterns of AE event count and count were very similar. The relationship between the MOR and the AE parameter from load and AE cumulatve event count in the early stage of the sloped finger-jointed specimens bonded with polyvinyl acetate, polyvinyl-acryl and oilic urethane resin adhesives was much greater than that between the MOE and the MOR. Therefore, the AE signals obtained during bending test are useful for estimating the strength of sloped finger-jointed Rhus verniciflua specimens.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.25 no.2
• /
• pp.62-72
• /
• 1997

This study was conducted to find out the hydroseeding timing of several herbaceous plants for the slope revegetation works. Four native plants and five introduced grasses were used for this experiment and were seeded on the cut slopes by hands in April, May, June, September and October. To identify the best seeding timing, germination percentage, ground covering rate, number of tillers and plant heights were investigated. There were wide differences in germination and ground covering rates of native plants are lower than those of cool-season foreign grasses and they show different germination rates according to seeding timing. Among them, Arundinella hirta var. ciliata shows the most apparent germinatin pattern according to seeding timing. 2. Seeding timing : Native plants tend to germinate well in May and June and cool-season foreign grasses in May and September. But Native plants show extremely low germination rates in autumn, so it is necessary to adjust the seeding rates when seeding in autumn. When seeding in May, it will be possible to use native plants-seed-mixture without using introduced foreign grasses. In sum, the best seeding timing of cool-season foreign grasses are May and September, and warm-season foreign grass is May and June. The best seeding timing of native plants seem to be in May and June.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.1602-1610
• /
• 2005

In this study was investigated and analyzed of damage characteristics for infrastructures by typhoon that have been many occur. The objective Structures were the road and hydraulic structure. The road structure was included the cut-slopes, retaining walls and bridges. The hydraulic structure is divided with the dike, small-scale dam, reservoir and floodgate. The analysis result of the bridge damage cause is river bottom height increase and passage ability decrease. The principal damage reasons of the cut-slope structure are weakening the ground due to the localized torrential downpour and drainage defective. Also, the principal damage reasons of the small-scale dam, reservoir, dike and the floodgate are continuous collapse of dike beside the floodgate.And we divided a typhoon damage occurrence cause with artificial and natural. As the result of analysis, the many damage occurrence cause will be removed by system improvement and technical development.