• Journal of the Korean Institute of Telematics and Electronics
• /
• v.22 no.5
• /
• pp.69-74
• /
• 1985

In this paper five-order Butterworth Low pass active RC filter is designed by using FDNR (Frequency Dependent Ncgative Resistor) Method from LC ladder filter having the lowest sensitivity. In process of Transformation to SCF (Switched Capacitor Filter) from active RC filter, Bilinear Z Transfomation method is utilized. By the design of SCF using the bilinear Z transform method the problem of aliasing can be avoided, but the frequency distortion is generated. The transformation from analog filter to digital filter is not equal in the region of the cut off frequency caused by this effect. Avoiding the problem of this effect, we use prewarping method. The result shows that the prewarped SCF makes more remarkable improvement in the frequency distortion than SCF which is transformed by using bilinear Z transform.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.12
• /
• pp.1-6
• /
• 2007

In this study, we have performed the channel modification of the conventional MHEMT (metamorphic high electron mobility transistor) to improve the breakdown characteristics. The Modified channel consists of the InxGal-xAs channel and the InP sub channel instead of the InxGa1-xAs channel. Since InP has the lower impact ionization coefficient in comparison with In0.53Ga0.47As, we have adopted the InP-composite channel in the modified MHEMT. We have investigated the breakdown mechanism and the RF characteristics for the conventional and the InP- composite channel MHEMTs. From the measurement results, we have obtained the enhanced on and off-state breakdown voltages of 2.4 and 5.7 V, respectively. Also, the increased RF characteristics have brought about the decreased output conductance for the InP-composite channel MHEMT. The cut-off frequency (fT) and the maximum oscillation frequency (fmax) for the InP-composite Channel MHEMT were 160 GHz and 230 GHz, respectively. It has been shown that the InP-composite channel MHEMT has the potential applications for the millimeter wave power device.

• 제어로봇시스템학회:학술대회논문집
• /
• 2003.10a
• /
• pp.965-969
• /
• 2003

In this paper, the implementation technique of digital crossover network using perfect linear phase IIR filters is presented. This system has various advantages which cannot be obtained from analog crossover network such as linear phase response, flat group delay and sharp cut-off at low-order over audio frequency band. The simulation results show that the group delay response is maximally flat and twice more attenuation in stop-band than the prototype elliptic IIR filter at all desired frequency.

• Proceedings of the IEEK Conference
• /
• 2000.06b
• /
• pp.88-91
• /
• 2000

An MMIC oscillator operating at the 24.55 GHz has been designed using 0.2 ${\mu}{\textrm}{m}$AlGaAs/InGaAs/GaAs Pseudomorphic HEMT technology. The active device used in the oscillator design has a 0.2 ${\mu}{\textrm}{m}$ gate length PHEMT with 4$\times$80 ${\mu}{\textrm}{m}$ gate width. We obtained 4.08 dB of S$_{21}$ gain and 317 mS/mm of transconductance, and extrapolated unit current gain cut-off frequency (f$_{T}$) and maximum oscillation frequency (fmax) were 62 GHz and 120 GHz, respectively. The circuit are based on a series feedback and negative resistance topology. Microstrip line open stub is used to terminating. The oscillator circuits has designed for delivering maximum power to load and conjugated matching. The simulated small signal negative resistance was 50 Ω. We obtained 1.002 of loop gain and 0.0005$^{\circ}$angle from the simulation by HP libra 6.1. The layout for oscillator is 1.2$\times$1.8 $\textrm{mm}^2$.>.

• Journal of the Korean Society for Precision Engineering
• /
• v.7 no.3
• /
• pp.48-55
• /
• 1990

A new curve fitting algorithm based on modal analysis is introduced for extracting the modal parameters from the measured frequency responses. To compensate the effect of cut-off frequency ranges the transfer function including residual mass and residual flexibility is employed. Model parameters are computed from the newly defined form of transfer function in a simple way. The accuracy of this algorithm is proved by applying to the 3 degrees of freedom model and vibration of cantilever beam.

• Transactions of the Korean Society of Pressure Vessels and Piping
• /
• v.5 no.1
• /
• pp.20-24
• /
• 2009

There is extensive tubing pipe in the nuclear power plant under high temperature and pressure. Erosion and corrosion defects are expected on this tubing pipe due to environmental and mechanical factors. In this study, Guided Ultrasonic Wave technique was applied to detect defects. The technique explores the advantages of the Guided Ultrasonic Wave method that inspects along the wall of the pipe and can travel long distances, providing rapid collection of data. This paper presents a case study of the Guided Ultrasonic Wave testing of 3/8" tubing pipe. This study offers to understand detected signals through correlation between amplitude and depth of defects.

• Wind and Structures
• /
• v.4 no.1
• /
• pp.63-72
• /
• 2001

This paper presents results of a study on wind loads and wind induced dynamic response of bridge jointed twin-towered buildings. Utilizing the high-frequency force balance technique, the drag and moment coefficients measured in wind tunnel tests, and the maximum acceleration rms values on the top floor of towers, are analyzed to examine the influence of building's plan shapes and of intervals between towers. The alongwind, acrosswind and torsional modal force spectra are investigated for generic bridge jointed twin-towered building models which cover twin squares, twin rhombuses, twin triangles, twin triangles with sharp corners cut off, twin rectangles and individual rectangle with the same outline aspect ratio as the twin rectangles. The analysis of the statistical correlation among three components of the aerodynamic force corroborated that the correlation between acrosswind and torsional forces is significant for bridge jointed twin-towered buildings.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.5
• /
• pp.737-746
• /
• 1990

Ga0.47In0.53As PIN photodiodes(PD) having various areas have been fabricated by liquid phase epitaxial techniques. Ternary melt has been baked out at 675\ulcorner in H2 atmosphere for 20 hours before growth, which resulted in reduction of background carrier concentration of grown epi-layer. Also, lattice mismatch has been controlled within 0.01%. The room temperature performance of 10**-4cm\ulcornerarea PIN PD at a bias voltage of -5V were` quantum efficiency(with no antireflection coating)=60% for 1.3\ulcorner light source, dark current\ulcorner5nA, and capacitance\ulcornerpE. Frequency response measurement of packaged PIN PD has shown that cut-off frequency (f-3dB) was 961MHz. This PD has shown a good eye pattern when it was incorporated in a 565Mbps optical receiver.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.23 no.5
• /
• pp.424-428
• /
• 2010

This paper describes the design and analysis of AlN piezoelectric micro energy harvester. The harvester was designed to convert ambient vibration energy to electrical power as a AlN piezoelectric material compatible with CMOS (complementary metal oxide semiconductor) process. To cut off the leakage current, AlN was used as the insulating layer. Also, Mo was used for the excellent c-axis crystal growth as the bottom electrode. The AlN harvester which it has the low operating frequency was designed by using the ANSYS FEA (finite element analysis). From the simulation results, the resonance frequency of designed model is about 360 Hz and analyzed the bending mode, displacement and expectation output.

• Journal of Genetic Medicine
• /
• v.10 no.1
• /
• pp.52-56
• /
• 2013

Mosaic trisomy 14 syndrome is a well-known but unusual chromosomal abnormality with a distinct and recognizable phenotype. Array comparative genomic hybridization (CGH) analysis has recently become a widely used method for detecting DNA copy number changes, in place of traditional karyotype analysis. However, the array CGH shows a limitation for detecting the low-level mosaicism. Here, we report the detailed clinical and cytogenetic findings of patient with low-frequency mosaic trisomy 14, initially considered normal based on usual cut-off levels of array CGH, but confirmed by G-banding karyotyping. Our patient had global developmental delay, short stature, congenital heart disease, craniofacial dysmorphic features, and dark skin patches over her whole body. Estimated mosaicism proportion was 23.3% by G-banding karyotyping and 18.0% by array CGH.