• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.699-702
• /
• 2002

A DC current sensor is disclosed in which two pairs of saturable cores are provided so as enclose a conductor carrying a direct current to be measured. On each of the saturable cores, a bias winding, a feedback winding and an output winding are wound. Circuit for detection of an asymmetry in the magnetization current, generated by a reference alternating voltage, in a signal-conditioner. The reference alternating voltage is fed to the respective series circuits such that no resultant induction current is induced in the modulating current. The voltages over the resistor form input signals for two peak value detectors, the strength of the output signal of which represents the degree of asymmetry of magnetization current. This paper describes the development a DC current sensor and its signal-conditioner.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2009년도 9th International Meeting on Information Display
• /
• pp.1088-1091
• /
• 2009

A boost converter with charge-recycling technique fabricated by $0.25{\mu}m$ CMOS BCD process can provide different supply voltages to drive series RGB LEDs in sequence for reducing the power consumption on the constant current generator. The proposed technique stores and restores extra energy to improve the efficiency, as well as enhances the reference tracking response. Experimental results show that the period of reference-tracking response can be improved. When the load current is 100mA, the periods of reference down-tracking and uptracking are smaller than $10{\mu}s$ and $20{\mu}s$, respectively. Experimental results demonstrate fast and efficient reference tracking performance is achieved.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2013년도 추계학술대회
• /
• pp.375-378
• /
• 2013

본 논문에서는 EEPROM이나 MTP 등의 NVM 메모리 IP 설계에 필요로 하는 PVT(Process-Voltage-Temperature) 변동에 둔감한 기준전압(Reference Voltage) 회로를 설계하였다. 매그나칩반도체 $0.18{\mu}m$ EEPROM 공정을 이용하여 설계된 BGR(Bandgap Reference Voltage) 회로는 wide swing을 갖는 캐스코드 전류거울 (cascode current-mirror) 형태의 저전압 밴드갭 기준전압발생기 회로를 사용하였으며, PVT 변동에 둔감한 기준전압 특성을 보이고 있다. 최소 동작 전압은 1.43V이고 VDD 변동에 대한 VREF 민감도(sensitivity)는 0.064mV/V이다. 그리고 온도 변동에 대한 VREF 민감도는 $20.5ppm/^{\circ}C$이다. 측정된 VREF 전압은 평균 전압이 1.181V이고 $3{\sigma}$는 71.7mV이다.

• Journal of Power Electronics
• /
• 제19권6호
• /
• pp.1554-1565
• /
• 2019

When grid voltage is unbalanced, the grid-connected output current and power of Virtual Synchronous Generators (VSGs) are distorted and quadratic. In order to improve the power quality of a grid connected to a VSG when the grid voltage is unbalanced, a comprehensive coordinated control strategy is proposed. The strategy uses the positive sequence current reference command obtained by a VSG in the balanced current control mode to establish a unified negative sequence current reference command analytical expression for the three objectives of current balance, active power constant and reactive power constant. In addition, based on the relative value of each target's volatility, a comprehensive wave function expression is established. By deriving the comprehensive wave function, the corresponding negative sequence current reference value is obtained. Therefore, the VSG can achieve the minimum comprehensive fluctuation under the premise that the three targets meet the requirements of grid connection, and the output power quality is improved. The effectiveness of the proposed control strategy is verified by simulation and experimental results.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2000년도 추계종합학술대회
• /
• pp.581-584
• /
• 2000

This paper describes the effect of lightning impulse current on ZnO varistors(390 V, 6.5 kA) used in low-voltage AC mains as a protective device against transient overvoltages. A lightning impulse current standardized in IEC 61000-4-5 is applied to the varistors, and the energy applied to the varistor at each time is about 12 J. In the experiment, various Parameters such as leakage current, reference voltage are measured with the number of applied impulse current. Also, micro-structure changes of the varistors after applying the lightning impulse current of 200 times are compared. The electrical characteristics of the varistors are degraded by overtime impulse current, showing increase in leakage current and decrease in reference voltage.

• 전기학회논문지
• /
• 제61권11호
• /
• pp.1606-1610
• /
• 2012

Hysteresis current regulator has been used widely because of its simple principle and structure. However, when the current band width is too narrow or the applied voltage is relatively too high, the switching frequency may increase abruptly and it generates a large amount of heat. Thus, this study will suggest a better and simple method to reduce the switching frequency. For single phase current control, the proposed hysteresis current control is executed by adding 0 mode state and comparing the slope of the current reference. This simple method decreases the generated switching frequency and significantly reduces the generated heat. This proposed method was proved with simulations and experiments comparing with the classical hysteresis current control method.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2016년도 전력전자학술대회 논문집
• /
• pp.359-360
• /
• 2016

This paper presents a new predictive current control (PCC) method to achieve the coordinate control of power and current of the matrix converter under unbalanced input voltages. In order to control the power fluctuation in the input side, the flexible source current reference is generated based on the positive-negative sequence components of the input voltage. The optimal switching state to adjust source and load currents is selected by minimization the cost function which is obtained from the sum of the absolute errors between the current references and their predictive values. Simulation results are given to validate the effectiveness of the proposed PCC method.

• 한국전기전자재료학회논문지
• /
• 제15권12호
• /
• pp.1045-1053
• /
• 2002

This paper describes characteristics of the developed current sensor by means of two identically wound magnetic cores forming a clamp like for measurement of a low DC, or AC current. This sensor consists of peak value detectors, a sensor of an electrically compensated current transformer type, a reference alternating voltage, Precision measuring circuits to measure the output signals of sensor with harmonics, and can be measured up to 2 A at DC, or AC current. The current sensor shows a measurement accuracy of less than 0.3% in the frequency range 40 Hz - 10 HBz. The resolution and sensitivity of the sensor were evaluated 0.1 mA and 10 mV/mA, respectively.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2015년도 추계학술대회
• /
• pp.458-461
• /
• 2015

본 논문에서는 저전압, 저전력 회로에 적합한 2가지 유형의 기준전압 발생회로와 1가지 유형의 기준전류 발생회로를 제안하고, $0.35{\mu}m\;CMOS$ 공정을 이용하여 설계하였다. 저전압, 저전력 특성을 얻기 위해 약반전(weak inversion) 영역에서 동작하는 MOS 트랜지스터를 사용하고, bulk-driven 기법을 이용하였다. 첫 번째 기준전압 발생회로는 1.2V의 공급전압에서 1.43uA의 전류를 소비하며, 585mV의 기준전압과 $6ppm/^{\circ}C$의 온도특성을 갖는다. 두 번째 기준전압 발생회로는 0.3V의 공급전압에서 48pW의 전력을 소비하며, 172mV의 기준전압과 $26ppm/^{\circ}C$의 온도특성을 갖는다. 기준전류 발생회로는 0.75V의 공급전압에서 246nA의 전류를 소비하며, 32.6nA의 기준전류와 $262ppm/^{\circ}C$의 온도특성을 갖는다. 모의실험을 통해 설계된 기준회로들의 성능을 검증하였다.

• 대한전기학회논문지
• /
• 제33권8호
• /
• pp.289-298
• /
• 1984

The single phase induction motor is recently requested to meet a broad speed control and smooth forward and reverse operation due to the multifarious usages. This paper deals with two phase operation of a two winding motor by reference current adaptive inverter which can supply the currents to satisfy the balanced oeration into the main and auxiliary winding through the entire operational region. According to the roposed system, the starting, forward and reverse and variable speed control of a two winding motor eliminated the capacitor from the capacitor-run motor is also possible. The formation and its principle of the reference current adaptive inverter and characteristic analysis of the motor fed by this apparatus are described in this paper. Excellent agreement with the measured results and calculated values by computer simulation is obtained.