• 한국초전도학회:학술대회논문집
• /
• v.14
• /
• pp.64-64
• /
• 2004

• IEMEK Journal of Embedded Systems and Applications
• /
• v.15 no.4
• /
• pp.159-166
• /
• 2020

The IBC (Intra-Body Communication) benefits from a wireless communication system for exchanging various kinds of digital information through wearable electronic devices and sensors. The IBC using the human body as the transmission channel allows wireless communication without the transmitting radio frequency waves to the air. This paper discusses the results of experiments on electrostatic coupling IBC based on FSK (Frequency Shift Keying) and 1 bit error correction. We implemented FSK communication and 1 bit error correction algorithm using the MCU boards and aluminum tape electrodes. The transmitter modulates digital data using 50% duty square wave as carrier signal and transmits data through human body. The receiver performs ADC (Analog to Digital Conversion) on carrier signal from human body. In order to figure out the frequency of carrier signal from ADC results, we applied zero-crossing algorithm which is used to detect the edge characteristic in computer vision. Experiment results shows that digital data modulated as square wave can be successfully transmitted through human body by applying the proposed architecture of a 1ch GPIO as a transmitter and 1ch ADC for as a receiver. Also, this paper proposes 1 bit error correction technique for reliable IBC. This technique performs error correction by utilizing the feature that carrier signal has 50% duty ratio. When 1 bit error correction technique is applied, the byte error rate at receiver side is improved around 3.5% compared to that not applied.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.5
• /
• pp.907-916
• /
• 2019

In this paper, we propose a new five-qubit multiple bit flip code that can completely protect the target qubit from all multiple bit flip errors using only CNOT gates. The proposed multiple bit flip codes can be easily extended to multiple phase flip codes by embedding Hadamard gate pairs in the root error section as in conventional single bit flip code. The multiple bit flip code and multiple phase flip code in this paper share the state vector error information by four auxiliary qubits. These four-qubit state vectors reflect the characteristic that all the multiple flip errors with Pauli X and Z corrections commonly include a specific root error. Using this feature, this paper shows that low-cost implementation is possible despite the QECC design for multiple-flip error correction by batch processing the detection and correction of Pauli X and Z root errors with only three CNOT gates. The five-qubit multiple bit flip code and multiple phase flip code proposed in this paper have 100% error correction rate and 50% error discrimination rate. All QECCs presented in this paper were verified using QCAD simulator.

• Journal of the Korea Society of Computer and Information
• /
• v.20 no.12
• /
• pp.1-8
• /
• 2015

Wear leveling techniques have been studied to prolong the lifetime of NAND flash memory. Most of studies have used Program/Erase(P/E) cycles as wear index for wear leveling. Unfortunately, P/E cycles could not predict the real lifetime of NAND flash blocks. Therefore, these algorithms have the limited performance from prolonging the lifetime when applied to the SSD. In order to apply the real lifetime, wear leveling algorithms, which use raw Bit Error Rate(rBER) as wear index, have been studied in recent years. In this paper, we propose CrEWL(Cold data identification using raw Bit error rate in Wear Leveling), which uses rBER as wear index to apply to the real lifetime. The proposed wear leveling reduces an overhead of garbage collections by using HBSQ(Hot Block Sequence Queue) which identifies hot data. In order to reduce overhead of wear leveling, CrEWL does not perform wear leveling until rBER of the some blocks reaches a threshold value. We evaluate CrEWL in comparison with the previous studies under the traces having the different Hot/Cold rate, and the experimental results show that our wear leveling technique can reduce the overhead up to 41% and prolong the lifetime up to 72% compared with previous wear leveling techniques.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.20 no.2
• /
• pp.35-40
• /
• 1983

The bit error probability of PCM/FM system was derived and numerically calculated. Binary NRZ-L baseband signal was premodulation filtered to frequency modulate a sinusoidal carrier, and a common circuit of limiter-discriminator was employed as a detector. Considering both RF spectrum limitation and bit error Probability reduction, it was found that h ≒ 3WT would be reasonable, where h is the frequency deviation ratio, W is the bandwidth of a premodulation filter and T is the time interval of one bit.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.6
• /
• pp.138-145
• /
• 1997

This paper proposes an adaptive algorithm for the quantization step size control of MPEG-2, using the information obtained from the previously encoded picture. Before quantizing the DCT coefficients, the properties of reconstruction error of each macro block (MB) is predicted from the previous frame. For the prediction of the error of current MB, a block with the size of MB in the previous frame are chosen by use of the motion vector. Since the original and reconstructed images of the previous frame are available in the encoder, we can calculate the reconstruction error of this block. This error is considered as the expected error of the current MB if it is quantized with the same step size and bit rate. Comparing the error of the MB with the average of overall MBs, if it is larger than the average, small step size is given for this MB, and vice versa. As a result, the error distribution of the MB is more concentrated to the average, giving low variance and improved image quality. Especially for the low bit application, the proposed algorithm gives much smaller error variance and higher PSNR compared to TM5 (test model 5).

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.44 no.3
• /
• pp.45-50
• /
• 2007

We present a auto compensating quantum key distribution system based on optical fiber at 1550nm. In the quantum key transmission system, main control board and phase modulation driving board are fabricated for auto controlling quantum key distribution(QKD). We tested the single photon counts per dark counts for a single photon detector, quantum key distribution rate($R_{sift}$) and the quantum bit error rate (QBER). Quantum bit error rate of 3.5% in 25km QKD is obtained. This system is commercially available.

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.194-197
• /
• 1988

The unequal bit-error-probability of rate r=b/n binary convolutional code is analyzed. The error protection affored each digit of the b-tuple information word can be different from that afforded other digit. The property of the unequal protection can be applied to transmitting sampled data in PCM system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.10
• /
• pp.821-826
• /
• 2012

Two-dimensional magnetic recording (TDMR) is treated as the next generation magnetic recording method, but because of its high channel bit error rate, it is difficult to use in practices. In this paper, we introduce a new writing method that can decrease the nonlinear media error effectively, and it can also achieve 10 Tb/$in^2$ of user bit density on a magnetic recording medium with 20 Teragrains/$in^2$.

• The Journal of the Korea Contents Association
• /
• v.12 no.8
• /
• pp.20-28
• /
• 2012

DVC(Distributed Video Coding) technique is a new paradigm, which is based on the Slepian-Wolf and Wyner-Ziv theorems. DVC offers not only flexible partitioning of the complexity between the encoder and decoder, but also robustness to channel errors due to intrinsic joint source-channel coding. Many conventional research works have been focused on the light video encoder and its rate-distortion performance improvement. However, in this paper, we propose a new DVC codec which is effectively applicable for error-prone environment. The proposed method adopts a quantiser without dead-zone and symmetric Gray code around zero value. Through computer simulations, the proposed method is evaluated by the bit errors position as well as the number of burst bit errors. Additionally, it is shown that the maximum and minimum transmission rate for the given application can be linearly determined by the number of bit errors.