• Food Science and Biotechnology
• /
• v.18 no.2
• /
• pp.299-306
• /
• 2009

The purpose of this study was to prepare stable water-in-corn oil (W/O) emulsion droplets coated by polyglycerol polyricinoleate (PGPR). W/O emulsions (20 wt% aqueous phase, 80 wt% oil phase containing 8 wt% PGPR) were produced by high pressure homogenization (Emulsions 1), however, appreciable amount of relatively large water droplets (d>$10{\mu}m$) were found. To facilitate droplet disruption, viscosity of each phase was adjusted: (i) increased the viscosity of aqueous phase by adding 0.1 wt% xanthan (Emulsions 2); (ii) decreased the viscosity of oil phase and aqueous phase by heating them separately at $50^{\circ}C$ for 1 hr immediately before emulsification (Emulsions 3). Homogenizing at the elevated temperature clearly led to a smaller water droplet size, whereas xanthan neither improved nor adversely affected on the microstructures of the emulsions. In addition, the Emulsions 3 had good stability to droplet aggregation under shearing stress, thermal processing, and long term storage.

• Environmental Analysis Health and Toxicology
• /
• v.12 no.3_4
• /
• pp.75-84
• /
• 1997

Chromatographic retention behavior and separation of various phenol derivatives on a Partisil 10 ODS 3 column-with mobile phase containing $\alpha$-cyclodextrin-were systematically studied. The decrease in k' values caused by the addition of cyclodextrins in the mobile phase was based on the formation of an inclusion complex, resulting in weakening of the hydrophobic interaction between solutes and the stationary phase. The content of the organic solvent in the mobile phase also influenced k' values of the solutes, and k' values increased with a decrease of the content of organic solvent in the mobile phase. A simple equation has been derived that reveals the hyperbolic dependence of the capacity factor on the total concentration of cyclodextrin. A plot of the reciprocal of the capacity factor against (CD)$_T$ gives a straight line and the dissociation constant, K$_D$, of the inclusion complex can be calculated from the slope. The capacity factor decreased with increasing temperature. The enthalpy was calculated from the slope of van't Hoff plots. Under optimum conditions, some mixtures of phenol derivatives were able to separated successfully.

• ETRI Journal
• /
• v.27 no.6
• /
• pp.677-684
• /
• 2005

A phased array antenna was fabricated using four-element ferroelectric phase shifters with a coplanar waveguide (CPW) transmission line structure based on a $Ba_{0.6}Sr_{0.4}TiO_3(BST)/MgO$ structure. Epitaxial BST films were deposited on MgO (001) substrates by pulsed laser deposition. To attain the large differential phase shift and small losses for a ferroelectric CPW phase shifter, an impedance-matching-part adding technique between the effective transmission line and connecting cable was used. The return loss and insertion loss for this techniqueadapted BST CPW device were improved with respect to those for a normal BST CPW device. For an X-band phased array antenna system consisting of ferroelectric BST CPW phase shifters, power divider, dc block, patch antenna, and programmed dc power, the steering beam could be tilted by $15^{\circ}$ in either direction.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.501-503
• /
• 2008

This paper presents the design of a 2.4 GHz low phase noise fully integrated LC Voltage-Controlled-Oscillator (VCO) in $0.18{\mu}m$ CMOS technology. The VCO is without any tail bias current sources for a low phase noise and, in which differential varactors are adopted for the symmetry of the circuit. At the same time, the use of differential varactors pairs reduces the tuning range, i.e., the frequency range versus VTUNE, so that the phase noise becomes lower. The simulation results show the achieved phase noise of -138.5 dBc/Hz at 3 MHz offset, while the VCO core draws 3.9mA of current from a 1.8V supply. The tuning range is from 2.28GHz to 2.55 GHz.

• Journal of Fisheries and Marine Sciences Education
• /
• v.26 no.3
• /
• pp.639-646
• /
• 2014

A heat exchanger using two-phase loop thermosyphons was developed as a waste heat recovery system. An experimental study was carried out on the heat transfer characteristics of two-phase loop thermosyphons heat exchanger and the results from the experiments were used to see the possibility which the two-phase loop thermosyphons could be an alternate solution for waste heat recovery system. In the present work, R134a has been used as the working fluid and the filling rate do working fluid and heat flux have been used as the experimental parameters. The results show that the filling rate of working fluid and heat flux are very important factors for the operation of two-phase loop thermosyphons. The experimental results showed the provisional results as a waste heat recovery system.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.3
• /
• pp.932-941
• /
• 2014

In this paper, a simulation model for 7-phase BLDC motor drives for an Autonomous Underwater Vehicles (AUV) is proposed. A 7-phase BLDC motor is designed and the electrical characteristics are analyzed using FEA program and the power electronics drives for the 7-phase BLDC motor are theoretically analyzed and the actual implementation has been accomplished using Matlab Simulink. PI controller and fuzzy controller are compared for verifying the validity of the proposed model and the informative results are described in detail. Especially A fuzzy controller is used to characterize 7-phase BLDC motor, drive systems under normal and fault operating conditions.

• Proceedings of the KIEE Conference
• /
• 2005.07b
• /
• pp.1062-1064
• /
• 2005

3 phase 4-wire system has been widely used in the customer's application due to merit of 1 bank construction of loads such as 1-phase lighting, heat and 3-phase motor. But if the load distribution is not uniformed by the operation conditions, voltage unbalance is highly appeared by the difference of each phase current value. Especially, if the linear load such as resistance or inductive load has different power factor value, voltage unbalance factor is not the same due to the phase angle and magnitude of each phase voltage. In this paper, we composed the measurement device and analyzed by varying of load pattern.

• Korean Journal of Microbiology
• /
• v.29 no.4
• /
• pp.263-266
• /
• 1991

The growth of T. novellus in auto trophic and geterotrophic media was studied to determine the time required for cells to enter stationary phase and relative percentage of ribosomal proteins. When T. novellus was grown autotrophically, growth proceeded at a slow rate characteristic of autotrophs and did not enter log phase until the end of the first day. Logarithmic growth proceeded for 3-4 days at which time the cells entered the stationary phase. In particular, logarithmic growth was accompanied by decreasing pH of culture media and in the stationary phase the pH levelled off at 6.0, a decrease of 1.6 pH value compared to original pH of media. The pH decrease was greatest during log phase when cells oxidized thiosulfate to $H_{2}$$SO_{4}$. The doubling time was about 26h. In heterotrophic media growth proceeded at a much faster rate and cells entered stationary phase 20-22h after inoculation. The doubling time was 3h. The protein content of the ribosomes in T. novellus grown heterotrophically was 4.2% greater than those from the organism grown autotrophically.

• Bulletin of the Korean Chemical Society
• /
• v.13 no.6
• /
• pp.663-665
• /
• 1992

The superconducting $YBa_2Cu_4O_8$ was synthesized in oxygen condition at 1 atm. The starting material with 1 : 2 : 4 composition was obtained by pyrolysis of EDTA complex, which was converted to 1-2-3 phase during densification, followed by the 1-2-4 phase recovery at $810^{\circ}C$ . The phase presents were identified by XRD, TG, DTA and AC magnetic susceptibility. Our data indicated that considerable amounts of 1-2-4 phase formed but with the 1 : 2 : 3 phase or possibly 2-4-7 as visible. As the P($O_2$) increased with temperature, impurity peak, CuO ($2{\Theta}$ = 38.8), gradually decrease, and we conclude that the 1-2-4 phase is predominant bulk superconductor under the high oxygen pressure.

• Korean Journal of Optics and Photonics
• /
• v.3 no.3
• /
• pp.155-160
• /
• 1992

1)iscussed in this paper are the effects of phase modulation on the line spread functions (LSF) and MTFs of ;I binocular objective system. The binocular objective lens is made in Korea. It has rotationally symmetric aberrations. The LSFs and MTFs are measured experimentally. The phase modulation is carried out by applying phase retardation n on the aperture. The area where the phase is not retarded presents a double annular type. The OTF curves of phase modulated aperture are compared with that of unmodulated aperture. The comparison shows that there is the aberration compensation effect in aberration loaded system. Therefore the performance of many optical system can be improved without any loss of light energy by properly modulating the phase on the aperture.