• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.5
• /
• pp.189-197
• /
• 2004

The thermal rating of an overhead conductor, which is the maximum allowable current, is generally calculated on the basis of heat balance equation found in IEEE P738 standard. This is given as a function of the weather conditions such as air temperature, wind speed, wind direction, and sun heat. Wind speed among such weather parameters is strongly affected on determining the line rating when it appears very low level. Therefore there may occur inaccuracy since most anemometers used in line rating monitor systems may show low resolutions and stall speed performance. In this paper, we introduce a new methodology for determining the dynamic line rating in overhead transmission lines, without using my anemometer. It was shown that wind speed can be estimated by the temperatures of 2 indirect conductors, and through experimental study, the dynamic line rating obtained by the estimated wind speed was very closely that of weather model.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.190.1-190.1
• /
• 2010

풍력자원평가를 위해 풍력단지 개발대상지의 국지풍황 대표지점에 설치하는 풍황탑(met-tower 또는 풍황마스트; met-mast)은 모노폴(monopole), 삼각단면 트러스 또는 사각단면 트러스 구조를 갖는다. 풍향계 및 풍속계는 이러한 지지구조물에 의한 풍속의 교란 또는 차폐영향을 최소화하기 위하여 긴 붐(boom)의 끝단에 설치되지만 계측기가 풍황탑의 직후방 후류영역에 놓이게 될 경우 차폐영향을 완전히 피하기는 어렵다. 저자들의 선행연구에 따르면 풍황탑 차폐영향은 평균풍력밀도의 경우 2.5% 이상의 오차를 유발할 수 있으므로 풍력자원평가 시 필히 고려되어야 할 불확도 요인인 것이다. 이에 한국에너지기술연구원에서는 풍황탑 주위의 대기유동장을 전산유동해석을 이용하여 차폐영향의 정도를 정량적으로 수치모사함으로써 이를 보정하는 기술을 개발한 바 있다(현재 특허심사 중). KIER-$ShadeFree^{TM}$는 이 특허기술을 프로그램화 한 것으로, 시범적으로 다수의 풍황탑 풍력자원 측정자료에 적용하여 상당한 보정효과에 의한 풍력자원평가의 정확도 향상효과를 볼 수 있었다.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.15 no.1
• /
• pp.9-16
• /
• 2013

Coastal sand dune area is an important ecosystem as an ecotone which is located between coastal area and terrestrial area. In order to understand the sand dune ecosystem in terms of its habitat characteristics, micrometeorological analysis was carried out in a coastal sand dune in Hakampo, Taeanhaean National Park, Korea. Micrometeorological measurements were made to monitor air and soil temperatures, relative humidity, soil water content, rainfall, solar radiation, wind speed, and wind direction. In contrary to a forest ecosystem, the coastal sand dune grassland ecosystem was relatively hotter and very humid with heavy rainfalls concentrated between June and July. The seasonal change of daily mean soil temperature was greater than that of air temperature by $2{\sim}3^{\circ}C$. Daily mean soil water content was less than 10% throughout the year. Also, the maximum wind speed of 156.7 m $s^{-1}$ was recorded on 7 October 2011. The observed seasonal wind direction was different from those observed at Seosan by KMA (Korea Meteorological Administration). To better understand the habitat characteristics in a costal sand dune grassland ecosystem, long-term multi-year measurements are needed.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.6 no.3 s.22
• /
• pp.47-56
• /
• 2006

With the aim to develop the monitoring technology on background atmosphere and climate change over Korean Peninsula, observations and studies on chemical, physical and optical properties of the atmospheric aerosols are made. Aerosol number concentration are measured with Optical Particle Counter from 2001 to 2003 at Gosan for 8 size intervals from 0.3 to $25{\mu}m$ diameter range. For the seasonal variation, the number concentration of coarse particles in spring at Gosan was higher than other seasons due to the influence of sand storm in spring. There is no significant correlations between fine particles ($0.3{\sim}0.5{\mu}m$) and meteorological parameters, such as relative humidity, wind speed and visual range, while the correlation between the number concentration of small particles ($0.5{\sim}2.23{\mu}m$) and relative humidity showed a positive value. This trend was inversed for the case of wind speed: aerosol number concentration showed a small decreasing tendency with increasing wind speed for small particles but the high wind speed in winter season increased coarse particle concentration. Finally, Particles most efficient in light extinction were found to be at the size of about $0.5{\sim}1{\mu}m$.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.159-163
• /
• 2005

Marine accidents of 70.9% have been caused by small ships less than 100 tons in the past 5 years(1998${\sim}$2002). This is ascribable to the graying and lack in expertise on shipping of small ship operators, and merchant ships are hindered from coastal navigation due to the increase of coastal fishing boats and liners. Currently, ECDIS and GPS Plotters are widely used as navigation equipment providing route information to operators, but it can not give any function of automatic route creation and route explanation, so they are available only experienced operators. Especially, the present situation is that no study is made of the automatic route creation and route explanation using ENC for ECDIS, substitution system of paper chart. In this paper, Navigation Guiding System(NGS) is proposed to generate an optimal route where ENC and GPS data is fusioned including the wind speed and direction of anemometer. The proposed system was testified by a simulation, and its effectiveness was verified.

• Journal of Sensor Science and Technology
• /
• v.26 no.1
• /
• pp.66-72
• /
• 2017

The three dimensional ultrasonic anemometer was constructed to reduce the disadvantages of the two-dimensional anemometer and to be free from the use environment. Three pairs of transmitting and receiving ultrasonic sensors were designed to face each other at an angle of $45^{\circ}$ to the upper and lower surfaces at intervals of $120^{\circ}$. 200 kHz ultrasonic sensor Oscillation, transmission and reception, level detection, power supply circuit were designed and U, V, W wind speed vector components were obtained by measuring the time of first received ultrasonic pulse by transmitting pulse ultrasound. It is implemented as firmware in ARM Coretex-M3 processor so that horizontal and vertical wind direction and wind speed can be converted into digital signal by vector calculation. In this study, The three-dimensional ultrasonic anemometer can complement the disadvantages of the two-dimensional anemometer (mechanical and ultrasonic), and it is expected to gradually replace the two-dimensional anemometer due to its high utilization rate by collecting additional information such as vertical wind.

• Journal of Sensor Science and Technology
• /
• v.22 no.4
• /
• pp.292-296
• /
• 2013

The ultrasonic wind sensor that pass through the air, beating the delivery of ultrasonic wind speed increases or decreases by the physical characteristics of the wind speed and the direction of the sensor, the transmission and reception of ultrasonic time difference measured by a two-axis vector wind and wind speed measured by calculating a device that converts the digital signal is Anemometer and wind direction meteorological facilities management, management of the ship sail used for various purposes, including, but used the existing 3-cup (mechanical) anemometer wind rotor caused by mechanical wear parts replacement due to the short-term, the reliability of the product is low, parts replacement, and according to the characteristics caused the car, there is a problem in high maintenance costs. In addition, because the bearings use of the marine environment and the cryogenic environment was constrained. In this study, the excellent long-term reliability, using ultrasonic-type environment that is not constrained to produce wind anemometer located $90^{\circ}$ conformal road using four piezoelectric sensors were fabricated structures, the piezoelectric oscillator circuit produces a rash and receiving transmit and receive speeds the car through the two-axis vector calculation to measure wind velocity processor firmware programming, and its characteristics were tested.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.2067-2068
• /
• 2008

해안지방의 염분 누적오손 특성을 분석하기 위하여 등가염분부착밀도(ESDD : Equivalent Salt Deposit Density) 측정장치를 국내 112 곳을 선정하여 설치하였다. 해안에서 500m 지점에 풍향, 풍속계를 설치하고, 실시간으로 측정하여 바람에 의한 영향을 분석하였다. 2005년 10월부터 2007년 9월까지 측정한 결과 고창은 해안에서 50m 떨어진 지점에서 최대 D 등급, 2,000m 지점은 B등급까지 오손되었으며, 포항 호미곳은 D등급까지 오손되었다. 분석결과 동해안의 오손특성은 타 지역보다 해안에 가까울수록 부착밀도가 급격히 증가하였으나, 서해안보다는 오손정도가 낮고 남해안보다는 높게 나타났다.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2020.11a
• /
• pp.132-132
• /
• 2020

아직까지 국내에서 GM작물이 상업화를 위해 승인된 예는 없지만 생명공학기술의 발전으로 GM작물의 개발은 급속한 증가 추세에 있다. 비의도적인 방출로 인해 미승인 LMO 목화가 전국적으로 재배되어 국립종자원 주관으로 양성 판정된 재배지의 목화를 폐기 처분하였으나(2017), GM작물이 유해하다는 인식과 환경에 방출되어 생태계를 교란시킨다는 인식이 팽배해 있는 현실에서 과학적으로 유전자의 이동성을 검증하는 노력이 중요하다. 자식성 작물의 화분의 이동성 조사를 위해 중앙의 코어 위치에 LM작물을 식재한 후 LM작물 주변에 재배품종을 심어 유전자이동 가능성을 조사하고 재배 환경에 의한 영향을 평가하기 위해 포장 주변 기상상황 데이터-온도, 습도, 풍속, 풍향, 기압, 강수량 등을 분석하고 기상상황이 화분의 전이에 미치는 영향 조사하였다.

• Journal of the Korean earth science society
• /
• v.42 no.5
• /
• pp.536-555
• /
• 2021

Sea-surface wind is an important variable in ocean-atmosphere interactions, leading to the changes in ocean surface currents and circulation, mixed layers, and heat flux. With the development of satellite technology, sea-surface winds data retrieved from scatterometer observation data have been used for various purposes. In a complex marine environment such as the Korean Peninsula coast, scatterometer-observed sea-surface wind is an important factor for analyzing ocean and atmospheric phenomena. Therefore, the validation results of wind accuracy can be used for diverse applications. In this study, the sea-surface winds derived from ASCAT (Advanced SCATterometer) mounted on MetOp-A/B (METeorological Operational Satellite-A/B) were validated compared to in-situ wind measurements at 16 marine buoy stations around the Korean Peninsula from January to December 2020. The buoy winds measured at a height of 4-5 m from the sea surface were converted to 10-m neutral winds using the LKB (Liu-Katsaros-Businger) model. The matchup procedure produced 5,544 and 10,051 collocation points for MetOp-A and MetOp-B, respectively. The root mean square errors (RMSE) were 1.36 and 1.28 m s^-1, and bias errors amounted to 0.44 and 0.65 m s^-1 for MetOp-A and MetOp-B, respectively. The wind directions of both scatterometers exhibited negative biases of -8.03° and -6.97° and RMSE values of 32.46° and 36.06° for MetOp-A and MetOp-B, respectively. These errors were likely associated with the stratification and dynamics of the marine-atmospheric boundary layer. In the seas around the Korean Peninsula, the sea-surface winds of the ASCAT tended to be more overestimated than the in-situ wind speeds, particularly at weak wind speeds. In addition, the closer the distance from the coast, the more the amplification of error. The present results could contribute to the development of a prediction model as improved input data and the understanding of air-sea interaction and impact of typhoons in the coastal regions around the Korean Peninsula.