• Journal of Broadcast Engineering
• /
• v.14 no.1
• /
• pp.44-58
• /
• 2009

To provide efficient video streaming service over a wireless networks, the rate adaptation scheme should be applied at the low layer and the quality adaptation scheme should be considered at the high layer. In this paper, we propose a new cross-layer design which includes rate adaptation scheme at the MAC/PHY layers and quality control at the application layer. Proposed rate adaptation scheme improves the wireless channel utilization by transmitting the consecutive frames and selects optimal transmission mode by calculating the goodputs for each transmission mode. Based on selected transmission mode, the rate adaptation scheme calculates the rate limits and informs that to the application layer. Then the video streaming application utilizes this rate limits to adjust the quality of the video stream. Through performance evaluations, we prove that our cross-layer design improves the quality of the wireless video streaming service by means of the proposed rate adaptation scheme.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.22 no.8
• /
• pp.800-807
• /
• 2012

In this paper, radiation efficiency of the plate surround by an infinite rigid baffle is studied. The plate is simply supported and one side is in contact with air, while other side with water. The pressure and normal velocity over the plate surface are assumed as modal summations, from which a set of linear equations is obtained for fluid-structure coupled problem. It is shown that neglect of the cross modes results in overestimation of the radiation efficiency specifically for mid-frequency ranges. Based on the fact that the responses are mainly determined from the first few cross modes in addition to the diagonal terms, a new algorithm is proposed, where banded matrix is iteratively solved in computing radiation efficiency. In numerical examples, it is found that radiation efficiency obtained from banded matrix is in excellent agreement with the one from the full matrix, while computing time is significantly reduced. It is also found that as frequency grows larger, radiation efficiency considering only diagonal terms is a good approximation.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.12 s.354
• /
• pp.89-101
• /
• 2006

Frequency-variant transmission line parameters are determined. Then the signal transient characterizations of frequency-dependent multi-coupled lines are investigated. With the proposed method, an accurate signal integrity degradation such as signal ringing (overshoot, undershoot) and crosstalk noises relevant to the switching patterns of signals, rising / falling time(tr, tf) and line lengths is investigated. It is shown that there may be approximately 26% discrepancy of signal transients and 260% difference of crosstalk noises between the constant RLC model and frequency-variant RLC model in on-chip global interconnects while those of package lines are 11% and 70%, respectively.

• The Journal of the Acoustical Society of Korea
• /
• v.13 no.1E
• /
• pp.5-10
• /
• 1994

It is obtained the general expessions of the numerical method are applied for the TEM-mode analysis of multu-layer multi-coupled microstrip lines, In this paper, coupled microstrip are replaced by three-coupled microstrip lines in special aplications. Three-layer versions of three-coupled microstrip lines are specially attactive because of the additional flexibilities offered by three-layer configuration. This structure can be used for obtaining large capacitance and preventing coupling among microstrip lines in filter and coupler. Sappihre is chosen for anisotropic substrates material. The permittivity parallel to the optical axis is higher than the permittivity in the plane perpendicular to this axis.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.4
• /
• pp.532-541
• /
• 2001

In the case of the microstrip antenna with the coaxial probe-feeding, there is rapidly-varying patch current near the point where the probe feed is connected to the patch. We represent this current distribution using the attachment mode that insures continuity of currents from the feed to the patch. In this paper, we can accurately analyze the effect of a cover layer or radome for an antenna with the attachment which model rigorous probe feed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.5A
• /
• pp.474-481
• /
• 2010

In this paper, we present an effective cross layer-based video transmission algorithm over multi-hop mobile ad hoc networks. The proposed algorithm selects the most efficient PHY mode of wireless LAN multi-rate service at each node in a distributed way based on the available information at application, MAC, and physical layers in order to minimize end-to-end delay and maintain packet loss rate in tolerable range at the receiver. Finally, experimental results are provided to show superior performance of the proposed algorithm.

• Journal of the Korea Concrete Institute
• /
• v.29 no.4
• /
• pp.345-351
• /
• 2017

This study evaluated the effectiveness of V-shaped ties as an alternative to the supplementary crossties specified in ACI 318-14 on the flexural ductility of reinforced concrete columns. From column specimens tested under constant axial loads and reversed cyclic lateral loads, the mode of failure and lateral load-lateral displacement relationship were measured according to the variation of the applied axial load levels. After the columns reached the peak lateral load capacity, the $90^{\circ}$ hooks of the crossties gradually opened, which eventually caused premature buckling of the longitudinal reinforcement and severe crushing of the core concrete, whereas no V-ties were extracted from the core concrete until the column failure. As a result, the cumulative work damage indicators up to 80% of the peak lateral load for V-tie columns under the axial load level of 0.2, 0.4, and 0.55 was as much as 2.4, 2.3, and 5.2 times higher, respectively, than those of the companion crosstie columns. The superiority of the V-ties to the conventional crossties in enhancing the flexural ductility of columns became more prominent as the axial load level increases.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.10
• /
• pp.103-108
• /
• 2004

In this paper, a compact patch antenna with four T-slits fed by crossed aperture coupling is proposed for miniaturized Portable GPS handsets. The mechanism for compact size antenna is investigated with the behavior of the currents on the radiating patch. The equivalent surface current path due to the slits is lengthened, reducing the resonant frequency at a fixed patch size. The results of embedded T-slits for compact antenna size show that the resonant frequency is significantly lowered from 2.545GHz to 1.575GHz, corresponding to a 44.65% antenna size reduction compared to reference design. Experimental results show that good CP radiation patterns are obtained and impedance bandwidth (VSWR $\leq$ 2), 3dB axial ratio are about 21MHz, 19MHz at the center resonant frequency, respectively.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.83-86
• /
• 2000

가변 필터는 송수신기에서 회로를 간단히 하여 특히 멀티채널을 사용하는 송수신기에서 중추적 역할을 담당하게 된다. 본 논문에서는 소형경량이고, 구조가 단순하여 제작이 간단하며, MMIC화하기 쉬운 실용적인 가변필터를 설계 및 제작하여 그 사용가능성을 제안하였다. 본 논문에서는 중심주파수 1.95GHz, 통과대역이 100MHz인 대역통과 링 필터를 Split 모드 방식으로 구현하고 이를 바탕으로 300MHz의 가변대역폭을 갖는 필터를 제작하였다. 이 필터의 대역폭을 가변하기 위하여 바이어스전압에 따라 커패시턴스가 변화하는 Varactor 다이오드를 사용하였다.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.15 no.2
• /
• pp.144-151
• /
• 2022

In this paper, a 1.5V 256kb eFlash memory IP with low area DC-DC converter is designed for battery application. Therefore, in this paper, 5V NMOS precharging transistor is used instead of cross-coupled 5V NMOS transistor, which is a circuit that precharges the voltage of the pumping node to VIN voltage in the unit charge pump circuit for the design of a low-area DC-DC converter. A 5V cross-coupled PMOS transistor is used as a transistor that transfers the boosted voltage to the VOUT node. In addition, the gate node of the 5V NMOS precharging transistor is made to swing between VIN voltage and VIN+VDD voltage using a boost-clock generator. Furthermore, to swing the clock signal, which is one node of the pumping capacitor, to full VDD during a small ring oscillation period in the multi-stage charge pump circuit, a local inverter is added to each unit charge pump circuit. And when exiting from erase mode and program mode and staying at stand-by state, HV NMOS transistor is used to precharge to VDD voltage instead of using a circuit that precharges the boosted voltage to VDD voltage. Since the proposed circuit is applied to the DC-DC converter circuit, the layout area of the 256kb eFLASH memory IP is reduced by about 6.5% compared to the case of using the conventional DC-DC converter circuit.