• Proceedings of the Korea Water Resources Association Conference
• /
• 2009.05a
• /
• pp.220-224
• /
• 2009

제방을 설계하거나 기존제방의 안정성검토를 위해서는 제방의 침투해석이 필요하며, 외국에서와 같이 대규모하천이 대부분인 곳에서는 댐에서와 같이 정상침투해석을 하고 있으나 우리나라와 일본하천의 경우는 홍수지속시간이 짧아 설계홍수파형을 정상상태로 해석할 경우에는 과대한 외력을 주게되므로 시간에 따른 수위변화를 고려한 비정상 침투해석을 하여야한다. 이 경우 하천수위에 대한 홍수파형이 필요하나 국내에서는 명확한 기준이 없어 설계시 어려움이 많았다. 본 연구에서는 부정류 침투해석에 사용되는 설계홍수파형을 유도하기 위하여 수위자료가 양호한 낙동강 수계 진동 등 5개 수위관측지점의 과거 주요홍수에 대해 지속시간별 홍수위를 조사하여 무차원화시킨 후 통계적 확률적 처리를 통하여 설계홍수파형을 작성하였다. 작성된 홍수파형의 적정성은 과거 발생한 원홍수사상과 금회 유도한 설계홍수파형을 이용하여 침투해석을 시행하고 적정성을 분석하였다. 동수경사법과 한계유속법에서 오차는 각각 진동 0${\sim}$1.0%, 0.9${\sim}$1.1%, 현풍 1.6${\sim}$4.0%, 1.7${\sim}$4.1%, 왜관 0.6${\sim}$3.6%, 0.6${\sim}$3.7%, 낙동 2.0${\sim}$8.1%, 2.0${\sim}$8.1%, 정암 1.2${\sim}$9.8, 1.3${\sim}$9.9%로 나타났다. 상관성 ($R^2$)은 동수경사 0.983${\sim}$0.999, 한계유속 0.983${\sim}$0.999 정도로 매우 상관성이 높게 나타나 실무에 적용이 가능한 것으로 판단된다.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.33 no.5
• /
• pp.399-402
• /
• 2000

Very little information is known on the canning of fishery products by vacuum pack. In this paper, some fundamental process conditions for the canning of fishery products were investigated. Moisture-controlled mackerel pike, shrimp and oyster were packed in lacquered cans with spice and additives. After sealing, pressure of the cans were reduced by do-aeration through specially designed gas-tight silicone rubber plug previously attacked to the lid. On this investigation, vacuum can prior to thermal processing were set up to 15, 30, 45 and 60 cmHg, The higher vacuum in cans showed the more quick heat transfer in thermal processing. tinder 60 cmHg vacuum, the heat transfer was more quick than that of the conventional water packed products, Under 15 cmHg, however, the heat transfer was markedly increased by air which acted as an insulator in conductive heat transfer. These results demonstrated that high vacuum was essential secure for the heat processing in vacuum pack.

• Journal of the Korean Geosynthetics Society
• /
• v.19 no.4
• /
• pp.1-9
• /
• 2020

This study analyzes contaminant movement under transient flow in a rubble mound revetment offshore waste landfill barrier system that prevents contaminant runoff. The barrier system consists of bottom layer and side barrier. For the bottom layer system, impermeable clay layer is used. For the side barrier system, the HDPE barrier sheet (primary element) plays the main role, and the intermediate protection layer (supplementary element) is responsible for the barrier. Seepage, advection, dispersion numerical analysis was carried out using SEEP / W and CTRAN / W programs. As a result, under abnormal conditions considering the fluctuation in tidal range, the volume and direction of the flow velocity vector of the pore water change with time and the dispersion concentration of the contaminant changes. When comparing the case of 2 m tidal range and 8 m tidal range, the larger the tide value, the higher the concentration of contaminant under abnormal conditions. It was found that the rate of change of the concentration of the contaminant changed depending on the change in the tidal range, and as a result, the outflow of the pollutant was smaller than that in the steady flow state.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2012.05a
• /
• pp.541-545
• /
• 2012

이 연구에서는 SEEP2D 모형을 사용하여 하부에 투수지반을 갖는 제방 내부의 침투흐름에 대한 수치모의를 수행하였다. 제방의 재료는 4대강사업 낙동강 제2하구둑 건설 현장에서 채취한 시료를 사용하였으며, 입도분석과 들밀도시험을 통해 구한 제방의 건조단위중량과 다짐도 및 제방의 투수계수는 각각 $1.372g/cm^3$, 93%, 1.35 m/day이다. 투수지반층과 1:3 비탈경사를 가지는 제방모형을 제작하여 연직 이차원 정상류 침투해석 모형을 해석하는 SEEP2D 프로그램을 사용하여 나온 결과 값을 수리모형 실험 결과 값과 비교하였다. 모의조건은 0.45 m, 0.50 m, 0.55 m, 0.60 m의 4가지 수위(각각 Case1~4)조건에 대하여 수리모형실험과 동일한 조건을 수치모형에 적용하였다. 수치모형의 결과는 실험결과와 비교적 일치하였지만 제방의 비탈사면이 시작하는 부분에서는 수치모형의 결과 값보다 실험결과 값이 작은 것으로 확인되었다. 각각의 조건별로 수치해와 실험 결과값을 비교해본 결과 대체적으로 비슷한 양상을 보였지만 제방의 비탈사면이 시작하는 지점부터 수치모형의 결과 값보다 실험결과 값이 작은 것으로 확인되었다. Case3의 경우 4.35 m 지점부터 6.00 m 지점까지 유출이 발생하였으며 수치모형의 결과값과 실험결과 값의 차이가 가장 작게 나타났다. 사면유출 길이는 Case4에서 가장 길게 나타났으며 최대 4.10 cm로 발생하였다.

• International Journal of Highway Engineering
• /
• v.9 no.3
• /
• pp.111-121
• /
• 2007

During the whole month of December in 2005, Korea experienced both heavy snowfall and freezing temperature in southeast regions, which had caused frost related damages to many pavements laid on top of box culverts. In-situ observation revealed that the formation of ice lenses in subgrade and subsequent unbound layers led to upward heaving and transverse cracks in concrete and asphalt pavements. This has affected the long-term performance of pavements, as well as has threatened drivers' safety for a while. Recently, Korea Expressway Corporation has proposed a design guide to better protect newly constructed unbound pavement layers over culverts from frost heave. A trench drainage system has been selected to effectively draw off water and to alleviate pore-water pressure in soils during the coldest season. This paper presents experimental and analytical backgrounds behind this new design guide. Soil specimens retrieved from the sites are tested to quantify clay content and to estimate the permeability of subgrade. A 2-D ground seepage analysis has been conducted to better understand the changes in pore water pressures as a function of grain size. Finally, an optimum size of trench drainage is determined based on numerical analysis and workability in the field.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.10
• /
• pp.17-31
• /
• 2019

This study describes a prediction method for rainfall-induced landslides and subsequently debris flows in a regional scale areas. Special attention is given to the calculation of the propagation of debris flows by considering rainfall infiltration into soil slopes and soil entrainments by debris flows. The proposed method was verified by comparing the analytical results and the measured ones reported by the previous research. As a result, predictions and observations were quite similar in terms of the front position, the velocity, volume and momentum of debris flows. Even when applied to natural mountain slope with complicated terrain, numerical results and observations were similar. At last, the combined analysis of landslides and debris flows were conducted. The landslides prediction showed a predictive rate of about 83%, and the result of the final volume of debris flow showed an error rate of 3%. As a result, the proposed combined method for landslides and debris flows overcomes the problem of separating the landslides analysis and the debris flows simulation. Especially, the proposed method can analyze the effects of rainfall on entrainments by debris flows as well as rainfall-induced landslides and the behavior of debris flows.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.4
• /
• pp.35-42
• /
• 2012

This paper evaluates the effect of anisotropic conductivity on the seepage face and reliability index of an homogeneous dam with and without toe drain. The analysis are conducted under steady state saturated-unsaturated seepage condition using finite element method. Various anisotropic conductivity ratios were interpreted under such conditions as the vertical conductivity is reduced while the horizon conductivity is fixed. The shear strength of soil is defined by the modified Mohr-Coulomb failure criterion. The analysis results demonstrate that the length of seepage face and reliability index at the downstream and upstream of the dam increase with an increasing anisotropic ratio. These results of the seepage face and reliability index, however, depend on the total head difference between the upstream slope and downstream toe. The difference in seepage face and reliability index is attributed to the different equipotential head with different anisotropic ratios of the dam material.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.3B
• /
• pp.239-245
• /
• 2009

Levees, the hydro-engineering structure, are similar to earth dams in aspects of shape and structure. However, they are different from earth dams in the external force conditions. As a levee is the structure that is complexly affected by the flow and the water stage in the river, it may be unreasonable to analyze the seepage safety as previous studies derived from the neglect of river flow. In this study, an experiment was conducted to investigate flow structures in a trapezoidal open-channel and the influence of the channel flow on the seepage through a levee. Flow structures in a trapezoidal open-channel were distinguished from a rectangular open-channel such as velocity and bottom shear stress distributions. In case with the flow velocity of 0.5 m/s, seepage water heads were higher 10 percent as compared with the stagnant case. This result is caused by dynamic heads, secondary currents, turbulent fluctuation forces, and various physical factors. It is suggested that external force boundary considered in terms of the flow as well as the water stage is proper to seepage analyses.

• International Journal of Highway Engineering
• /
• v.12 no.1
• /
• pp.1-8
• /
• 2010

Construction of road closed to mountains is inevitable in Korea because the mountainous region in Korea is more than 70% in area. Recently, due to global warming, typhoons or heavy rainfalls frequently occur, and accordingly, mountain roads are seriously damaged by landslides, debris flows, and uplift pressure below pavement. in this study, damage on pavement by uplift pressure was investigated. Various influencing factors such as slope angle, reinforcement of slope surface, thickness of soil cover underlain by rock, and types of drainage system were considered to evaluate uplift pressure acting on the bottom of pavement. Raising of water table up to the surface of slope may depend on the duration and intensity of rainfall. It shows that the installation of subdrain can reduce the uplift water pressure. Therefore, It is concluded that the use of subdrain system is effective to decrease uplift pressure and cement treated base is more endurable than typical crushed-stone base.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.9
• /
• pp.23-30
• /
• 2012

This paper is research results of slope stability analysis associated with seepage infiltration for unsaturated soil in debris-flow occurrence slopes. Site investigations were carried out in two slopes, located at Inje in Kangwon province where debris flow occurred in 2006 and at Yangpyung in Kyeunggi province where it occurred in 2010. For unsaturated soil sampled at the zone of debris-flow initiation, soil water characteristic curves with tempe pressure cells and shear strength parameters with newly designed shear strength apparatus were obtained respectively. The commertially available software SEEP/W was used to analyze seepage infiltration in unsaturated soil, based on their properties obtained from test results and the actual rainfall data at the moment of debris flow occurrence, and slope stability analysis with the program of SLOPE/W, associated with results of seepage analysis, was performed to simulate slope failure. As results of this research, seepage infiltration to unsaturated soil due to intensive rainfall was found to cause increase of ground water table as well as degree of saturation. Through this research slope stability analysis for unsaturated soil, considering the actual rainfall characteristic, might be a reasonable method of investigating characteristics of debris flow behavior, in particular, the moment of debris flow occurrence.