• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.6
• /
• pp.252-259
• /
• 2005

Single crystal $CuGaSe_2$ layers were grown on thoroughly etched semi-insulating CaAs(100) substrate at $450^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating $CuGaSe_2$ source at $610^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence (PL) and double crystal X-ray diffraction (DCXD). The carrier density and mobility of single crystal $CuGaSe_2$ thin films measured with Hall effect by Van der Pauw method are $4.87{\times}10^{17}cm^{-3}$ and $129cm^2/V{\cdot}s$ at 293 K, respectively. The temperature dependence of the energy band gap of the $CuGaSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)=1.7998eV-(8.7489{\times}10^{-4}eV/K)T^2/(T+335K)$. The voltage, current density of maxiumun power, fill factor, and conversion, efficiency of $n-CdS/p-CuGaSe_2$, heterojunction solar cells under $80mW/cm^2$ illumination were found to be 0.41 V, $21.8mA/cm^2$, 0.75 and 11.17%, respectively.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.3
• /
• pp.35-43
• /
• 2012

Following the companion paper (I. Comparisons with Well-known Seismic Code and Site Response Characteristics), several acceleration data recorded during recent earthquake events in Korea were analyzed to verify the suitability of the proposed two-parameters site classification system and the corresponding site coefficients. For all of rock-soil site pairs less than 30 km distant, response spectrums and corresponding site coefficients, $F_a$ and $F_v$, were determined. Unfortunately, some of data have an eccentric error, where the spectral acceleration of rock site is more amplified than that of soil site. The $F_a$ and $F_v$ for all of pairs except the pairs of error were compared with those in the current code and the proposed system. The $F_a$ and $F_v$ from the recorded motions show definitely different trend from that of the current code. In addition, the site coefficients from recorded motions at four 765 kV substation sites, which are several hundred meters distant, have a remarkably similar trend and absolute values to those in proposed two-parameters site classification system. Based on earthquake motions recorded in domestic areas including data from the four 765 kV substation sites, the two-parameters site classification and site coefficients are superior to the results obtained from the current Korean seismic code.

• Journal of the Institute of Convergence Signal Processing
• /
• v.14 no.2
• /
• pp.136-146
• /
• 2013

In this paper, the residual delay compensation algorithm is proposed for FX-type KJJVC. In case of initial version as that design algorithm of KJJVC, the integer calculation and the cos/sin table for the phase compensation coefficient were introduced in order to speed up of calculation. The mismatch between data timing and residual delay phase and also between bit-jump and residual delay phase were found and fixed. In final design of KJJVC residual delay compensation algorithm, the initialization problem on the rotation memory of residual delay compensation was found when the residual delay compensated value was applied to FFT-segment, and this problem is also fixed by modifying the FPGA code. Using the proposed residual delay compensation algorithm, the band shape of cross power spectrum becomes flat, which means there is no significant loss over the whole bandwidth. To verify the effectiveness of proposed residual delay compensation algorithm, we conducted the correlation experiments for real observation data using the simulator and KJJVC. We confirmed that the designed residual delay compensation algorithm is well applied in KJJVC, and the signal to noise ratio increases by about 8%.

• Geophysics and Geophysical Exploration
• /
• v.23 no.4
• /
• pp.230-242
• /
• 2020

We performed a magnetotelluric (MT) survey to delineate the geological structures below the depth of 20 km in the Gyeongju area where an earthquake with a magnitude of 5.8 occurred in September 2016. The measured MT data were severely distorted by electrical noise caused by subways, power lines, factories, houses, and farmlands, and by vehicle noise from passing trains and large trucks. Using machine-learning methods, we classified the MT time series data obtained near the railway and highway into two groups according to the inclusion of traffic noise. We applied three schemes, stochastic gradient descent, support vector machine, and random forest, to the time series data for the highspeed train noise. We formulated three datasets, Hx, Hy, and Hx & Hy, for the time series data of the large truck noise and applied the random forest method to each dataset. To evaluate the effect of removing the traffic noise, we compared the time series data, amplitude spectra, and apparent resistivity curves before and after removing the traffic noise from the time series data. We also examined the frequency range affected by traffic noise and whether artifact noise occurred during the traffic noise removal process as a result of the residual difference.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.4
• /
• pp.795-804
• /
• 1999

The increasing number of users of mobile communication systems and the corresponding need for increased system capacity require the use of a modulation scheme which is both power and spectrally efficient. In this paper, we numerically calculate the BER performance of DS/CDMA-BPSK system in different fading channel (Rayleigh, Rician, Shadow Rician). Also, we calculate BER performance and the channel capacity of DS/CDMA-BPSK system which is constant or nearly constant envelopes in 3-state fading channel model. The Shadow Rician fading model described in this paper apply the parameters of the Canadian Mobile Satellite (MSAT). And we assume that the 3-state fading channel model is consist of Rayleigh fading state, Rician fading state, and shadow Rician fading state. This model can be used as a basis for the simulation of the land mobile satellite channel. The dynamic 3-state fading channel model is considered corresponding to different environments and the transitions between these environments. From the numerically calculate results, the DS/CDMA-BPSK system with MUI-20, PG-511 can not achieve the BER performance ($P_b\leq10^{-5}$). And the channel capacity did not meet the system requirement. Also, we know that the BER performance is depend m the occupancy probability of radio channel and the degree of shadow. From the results, we how that during shadowed time intervals it is necessary to use some form of error control coding and receiver diversity in order to support reliable data communication.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.12 no.12
• /
• pp.5843-5848
• /
• 2011

To improve the efficiency of the channel spectrum and to reduce the power consumption of the system in EVRC, the voice signal is compressed and transmitted only when the user speaks to. In addition to this, voice frames are divided into three rates 1, 1/2 and 1/8 and each frame is handled differently. For example, we assumed that the input is silence region if the 1/8 rate is used. In this paper, the sections are firstly separated into the voiced speech signal region, unvoiced speech signal region, and silence region by using distribution characteristics of LSP parameters. Then the paper suggested to encode 1 rate for the voiced speech signal, 1/2 rate for the unvoiced speech signal region, 1/8 rate for the silence region. In other words, traditional way of transmission is used when sending full rate in the EVRC. However, when sending half rate, the voice is firstly distinguished between voiced and unvoiced. If the voice is distinguished as voiced, voice is converted into full rate before the transmission. If it is distinguished as silence, EVRC's basic rate is applied. In the experimental results with SNR, ASDM, transmission bit rate measurement, we have demonstrated that voice quality was improved by using the proposed algorithm.

• Korean Chemical Engineering Research
• /
• v.43 no.4
• /
• pp.537-541
• /
• 2005

A bubbling fluidized bed reactor was used to study $CO_2$ capture from flue gas using a sodium-based dry regenerable sorbent, sorbA which was manufactured by Korea Electric Power Research Institute. A dry sorbent, sorbA, consists of $Na_2CO_3$ for absorption and supporters for mechanical strength. $CO_2$ capture was effective in the lower temperature range of $50-70^{\circ}C$, while regeneration occurred in the range of $120-300^{\circ}C$. To increase initial $CO_2$ removal, some amount of steam was absorbed in the sorbents before injecting simulated flue gas. It was possible to remove most $CO_2$ for 1-2 minutes at $50^{\circ}C$ and residence time of 2 seconds with steam pretreatment. Little or no reduction in initial reaction rate and capture capacity was observed in multicycle tests. The carbonated and regenerated sorbent samples were analyzed by NMR to confirm the extent of reaction. The results obtained in this study can be used as basic data for the scale-up design and operation of the $CO_2$ capture process with two fluidized bed reactors.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.2
• /
• pp.9-17
• /
• 2010

Recently, there has been much interest in orthogonal frequency division multiplexing (OFDM) for next generation wireless wideband communication systems. OFDM is a special case of multicarrier transmission, where a single data stream is transmitted over a number of lower-rate subcarriers. One of the main reasons to use OFDM is to increase robustness against frequency-selective fading or narrowband interference. However, in the radio systems it is also important to distortion introduced by high power amplifiers (HPA's) such as solid state power amplifier (SSPA) considered in this paper. Since the signal amplitude of the OFDM system is Rayleigh-distributed, the performance of the OFDM system is significantly degraded by the nonlinearity of the HPA in the OFDM transmitter. In this paper, we propose a canonical piecewise-linear (PWL) model based digital predistorter to prevent signal distortion and spectral re-growth due to the high peak-to-average power ratio (PAPR) of OFDM signal and the nonlinearity of HPA's. Computer simulation on an OFDM system under additive white Gaussian noise (AWGN) channels with QPSK, 16-QAM and 64-QAM modulation schemes and modulator/demodulator implemented with 1024-point FFT/IFFT, demonstrate that the proposed predistorter achieves significant performance improvement by effectively compensating for the nonlinearity introduced by the SSPA.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.47 no.2
• /
• pp.43-49
• /
• 2010

Autonomic nervous system (ANS) acts as a control system functioning largely below the level of consciousness, and controls visceral functions. The activity of the ANS has been assessed by means of the heart rate variability (HRV). It has been reported that HRV is dependent on sex, age, body mass index, and smoking, etc. However, the effects of posture and sleep deprivation on HRV have rarely been reported. Objective of our work was to find out which posture is appropriate for stable HRV. We measured the number of sleep deprivation and HRV using power spectrum in six stages for 30 minutes. Increased low frequency (LF) power and high frequency (HF) power indicate enhanced sympathetic and parasympathetic activity, respectively. We determined the LF/HF ratio to minimize individual difference. It was found that sleep deprivation by awakening up subjects was affected by posture, which resulted in changes of LF/HF. Although LF/HF varied with time, it was more stable in sitting than in supine. In conclusion, we recommend sitting posture when measuring HRV because of less sleep deprivation resulting in less variation in LF/HF.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.6
• /
• pp.275-281
• /
• 2017

AlN is a promising material for wide band gap and high-frequency electronics device due to its wide bandgap and high thermal conductivity. AlN has advantages as materials for power semiconductors with a larger breakdown field, and a smaller specific on-resistance at high voltage. The growth of a p-type AlN epilayer with high conductivity is important for a manufacturing an AlN-based applications. In this paper, Mg doped AlN epilayers were grown by a mixed-source HVPE. Al and Mg mixture were used as source materials for the growth of Mg-doped AlN epilayers. Mg concentration in the AlN was controlled by modulating the quantity of Mg source in the mixed-source. Surface morphology and crystalline structure of AlN epilayers with different Mg concentrations were characterized by FE-SEM and HR-XRD. XPS spectra of the Mg-doped AlN epilayers demonstrated that Mg was doped successfully into the AlN epilayer by the mixed-source HVPE.