• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.35T no.1
• /
• pp.125-132
• /
• 1998

In this paper, radio-wave propagation characteristics for L-band frequency are investigated using real data in case of base station in universal domestic environment. L-band frequency was recently emphasized the importance in PCS network. Measure+ments are carried out on vertical polarization characteristics in the 1.805 GHz frequency, three different estimated models, 3km 300m and 30m, are measured separately for 3 or 4 months at TX/RX fixed states. The experimental results of the estimated models are indicating the difference of 1~6dB compared to the theoretical value. The results present useful data in determining the base station sites.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.10 no.1
• /
• pp.18-26
• /
• 1973

In AM detection system, when the ratio of the frequency of the carrier to that of the modulating signal becomes less than a ratio of approximately 10:1, AM detectors become unable to detect the impressed signal in a satisfactory waveform. The failure of detecting such a super wide-band AM signal resulting from charging and discharging transient phenomena in associated diode circuit during the detecting of AM signal, has been a cause of limiting the channel capacity in AM or FM super multiplexing systems. This Paper presents the "Poly-phase Envelope Detection System" as a suitable method to solve the problem and the analyses of the system suggested. This system will make it possible to take the envelope out of the impressed AM signal to any desired degree of accuracy even when the ratio of the frequency of the carrier to that of the modulating signal approaches unity. Experiments were carried out to verify the validity of the theory of Poly-phase Envelope Detection System by adopting the frequency conversion method from among the two proposals.proposals.

• Korean Journal of Remote Sensing
• /
• v.33 no.6_1
• /
• pp.947-960
• /
• 2017

Soil moisture plays an important role to affect the Earth's radiative energy balance and water cycle. In general, satellite observations are useful for estimating the soil moisture content. Passive microwave satellites have an advantage of direct sensitivity on surface soil moisture. However, their coarse spatial resolutions (10-36 km) are not suitable for regional-scale hydrological applications. Meanwhile, in-situ ground observations of point-based soil moisture content have the disadvantage of spatially discontinuous information. This paper presents an experimental soil moisture retrieval using Sentinel-1 SAR (Synthetic Aperture Radar) with 10m spatial resolution for cropland in South Korea. We developed a soil moisture retrieval algorithm based on the technique of linear regression and SVR (support vector regression) using the ground observations at five in-situ sites and Sentinel-1 SAR data from April to October in 2015-2017 period. Our results showed the polarization dependency on the different soil sensitivities at backscattered signals, but no polarization dependence on the accuracies. No particular seasonal characteristics of the soil moisture retrieval imply that soil moisture is generally more affected by hydro-meteorology and land surface characteristics than by phenological factors. At the narrower range of incidence angles, the relationship between the backscattered signal and soil moisture content was more distinct because the decreasing surface interference increased the retrieval accuracies under the condition of evenly distributed soil moisture (during the raining period or on the paddy field). We had an overall error estimate of RMSE (root mean square error) of approximately 6.5%. Our soil moisture retrieval algorithm will be improved if the effects of surface roughness, geomorphology, and soil properties would be considered in the future works.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.42 no.1
• /
• pp.95-100
• /
• 2005

This paper proposes a DVS method which effectively reduces the power consumption of multimedia signal processor. Analytic derivations of effective range of its power saving factor are obtained with the assumption of a Gaussian distribution for the frame-based computational burden of the multimedia processor. A closed form equation of the power saving factor is derived in terms of the mean-standard deviation of the distribution. An MPEG-2 video decoder algorithm and AAC encoder algorithm are tested on ARM9 RISC processor for the experimental verification of the power saying of the proposed DVS approach. The experimental results with diverse MPEG-2 video and audio files show 50～30% power saving factor and show good agreement with those of the analytically derived values.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.8
• /
• pp.684-692
• /
• 2016

In this paper, a non-offset longitudinal shunt slot excited by an asymmetry compound iris on the broad wall of a rectangular waveguide is presented as an element for a waveguide slot-array antenna(WSAA). By properly adjusting the iris dimension, a resonance of the slot at a desired frequency can be achieved. The proposed resonant slot has some advantageous properties, such as a wide range of normalized resonant conductance, and minimum change of phase in the waveguide at the resonance. In addition, when the slots are arrayed for a waveguide slot antenna, the unwanted cross-polarization level can be reduced because each slot is placed in a straight line. A $8{\times}1$ WSAA with -20 dB side-lobe level(SLL) is designed, fabricated, and tested experimentally. The measured results are well agreed with the simulated ones and have an SLL of -18.13 dB and a cross-polarization level of -48.85 dB at 9.41 GHz, which was improved by about 15 dB of that of the conventional longitudinal slot array antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.12
• /
• pp.1427-1434
• /
• 2008

Compact quadruple inverted-f antenna(QIFA) with circular polarization for GPS receiver is proposed. Radiation efficiency is decreased when 4-port antenna is smaller. A new matching method is proposed by considering both a return loss at one port and mutual coupling between ports to increase radiation efficiency. Experimental results show that the proposed QIFA has a 3-dB beamwidth of more than 120 degrees and a front-to-back ratio of more than 15 dB. Also, the QIFA has the peak gain of -2.5 dBic and the axial ratio under 0.5 dB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.9
• /
• pp.1023-1029
• /
• 2010

In this paper, we proposed the broadband polarization diversity antenna operating in the PCS, WCDMA and WiBro band for mobile base station. We designed the antenna using the dipole antenna of the square loop type and microstrip feeding structure. Additionally, we used the choke box to remove the distortion of radiation patterns by the reflector structure when operating broadband. The simulation was performed using MWS in a commercial tool of CST company and the antenna was fabricated on a teflon substrate with 3.33 of the relative permittivity. The proposed antenna has the bandwidth of 640 MHz(from 1.75 to 2.39 GHz) when VSWR is below 1.5. At the operating bands, the interisolation between the cross-pair radiators is less than -25 dB and the maximum gains for PCS, WCDMA and WiBro band are 8.9, 8.2 and 8.6 dBi, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.6
• /
• pp.664-670
• /
• 2014

Generally, the properties of metamaterials are analyzed based on the infinite array of the unit cells. In real application of the metamaterial, however, the array has to be finite. Hence, it is important that a method can analyze the effect of the finite array of the metamaterial. In this paper, a model is proposed which can calculate the scattering by a large-size finite array of an I-shaped metamaterial without a full-wave simulation. The proposed model is based on the surface current estimation of each unit cells. The ratio of the current distribution on a finite array of the metamaterial to that of the infinite array of the same metamaterial for a TM polarized incident wave is approximated as a quartic polynomial. The coefficients of the polynomial are a function of the physical dimension of the metallic patch. Hence, the current distribution of the finite metamaterial can be estimated based on the proposed polynomial and the current of the infinite array. The scattered field is calculated by using the surface current model. The proposed model is numerically and experimentally verified by comparing calculated and measured RCS(Radar Cross Section) data.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.9 s.100
• /
• pp.893-902
• /
• 2005

We propose a novel single-feed triangular patch antenna with bar-type slots for dual-band circular polarization operation. And also propose a H-type slotted triangular patch antenna to enhance the ratio of the resonance frequencies. 3 cases of desist examples with bar-type slots were investigated and also 4 cases of H-slotted antennas were investigated to meet the dual-band requirement for GPS(Global Positioning System) and DMB(Digital Multimedia Broadcasting). One suitable design example was implemented and measured. Simulation results of the design example for GPS and DMB system show that axial ratio and maximum gain are 3.80 dB, 8.85 dBi for low-band at 1.575 GHz and 2.02 dB, 8.60 dBi for high-band at 2.642 GHz, respectively. Measured results of the implemented antenna show that $S_{11}$ is -12.43 dB for low-band at 1.575 GHz and less than -18.75 dB for high-band, respectively.

• Journal of IKEEE
• /
• v.27 no.1
• /
• pp.71-77
• /
• 2023

In this paper, a dual-band stopband frequency selective surface that can be applied to Wi-Fi 6E systems is designed to block external interfering signals with adjacent operating frequency spectrum in indoor wireless LAN environments. The proposed frequency selective surface structure has frequency blocking characteristics in the 2.4GHz and 6GHz bands, and is realized through a modified crossed dipole structure and an interlocking puzzle form between unit structures. The proposed structure is designed to have stable frequency response characteristics with respect to incident angle and polarization, and the experimental results show good agreement with the simulation results for incident waves from 0° to 45°.