• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.3
• /
• pp.152-158
• /
• 2015

This paper investigated the membrane fouling potential at the state of passive adsorption which is no permeation with the test modules on COD (Chemical oxygen demand) loading rates, examined the recovery rate and resistance on membrane fouling by three cleaning manners of hydrophobic membrane in a bioreactor. The results showed that high COD loading led to the increase of extra-cellular polymeric substances and filtration resistance. The permeability resistance from 1st day to 63rd day was getting increased, however, the value of permeability resistance after 63th day during the operation period was almost same level at three COD loading rates, it was due that the biomass adhesion on membrane surface at the state of passive adsorption reached to the critical state. Also, the final recovery rates after three cleaning manners were 78%, 72% and 69% at the COD loading concentrations of 250 mg/L, 500 mg/L and 750 mg/L respectively, and then recovery rate by physical cleaning at Run 2 and Run 3 was decreased after 40th day, it proved that biomass cake, which is not easily removed, was formed on the membrane surface because of high COD loading rate and EPS concentration.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.6
• /
• pp.43-48
• /
• 2008

Power consumption during test can be much higher than that during normal operation since test vectors are determined independently. In order to reduce the power consumption during test process, a new BIST(Built-In Self Test) architecture is proposed. In the proposed architecture, test vectors generated by an LFSR(Linear Feedback Shift Resister) are transformed into the new patterns with low transitions using Bit Generator and Bit Dropper. Experiments performed on ISCAS'89 benchmark circuits show that transition reduction during scan testing can be achieved by 62% without loss of fault coverage. Therefore the new architecture is a viable solution for reducing both peak and average power consumption.

• Journal of Broadcast Engineering
• /
• v.2 no.1
• /
• pp.8-15
• /
• 1997

In this paper, a real-time operating Motion Picture Experts Group-1 (MPEG-1) audio encoder system is implemented using a TMS320C31 Digital Signal Processor (DSP) chip. The basic operation of the MPEG-1 audio encoder algorithm based on audio layer-2 and psychoacoustic model-1 is first verified by C-language. It is then realized using the Texas Instruments (Tl) assembly in order to reduce the overall execution time. Finally, the actual BSP circuit board for the encoder system is designed and implemented. In the system, the side-modules such as the analog-to-digital converter (ADC) control, the input/output (I/O) control, the bit-stream transmission from the DSP board to the PC and so on, are utilized with a field programmable gate array (FPGA) using very high speed hardware description language (VHDL) codes. The complete encoder system is able to process the stereo audio signal in real-time at the sampling frequency 48 kHz, and produces the encoded bit-stream with the bit-rate 192 kbps. The real-time operation capability of the encoder system and the good quality of the decoded sound are also confirmed using various types of actual stereo audio signals.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.1
• /
• pp.46-52
• /
• 2008

In this paper, we present the Mont-Saint-Michel virtual reality system designed to create the virtual heritage environment, which is enriched with personalized tour guide service. The tour guide system allows users to travel in the virtual heritage site and get more information about the sites or items of user's interests. It also allows users to make their own tour guidebook with the pictures they have taken during the virtual tour and more detail descriptions from the tour guide database. It then generates the web-based tour guidebook for users to utilize it for the actual site visit or share it with others over the Internet. The components of this system are designed with the consideration of reusability to be used for other interactive tour guide systems. This paper describes the motivation the development and a preliminary user study of Mont-Saint-Michel virtual reality personalized tour guide system.

• KIPS Transactions on Software and Data Engineering
• /
• v.12 no.2
• /
• pp.83-90
• /
• 2023

Blurred image is an important factor in lowering image recognition rates in Computer vision. This mainly occurs when the camera is unstablely out of focus or the object in the scene moves quickly during the exposure time. Blurred images greatly degrade visual quality, weakening visibility, and this phenomenon occurs frequently despite the continuous development digital camera technology. In this paper, it replace the modified building module based on the Deep multi-patch neural network designed with convolution neural networks to capture details of input images and Attention techniques to focus on objects in blurred images in many ways and strengthen the image. It measures and assigns each weight at different scales to differentiate the blurring of change and restores from rough to fine levels of the image to adjust both global and local region sequentially. Through this method, it show excellent results that recover degraded image quality, extract efficient object detection and features, and complement color constancy.

• The Journal of the Korea Contents Association
• /
• v.22 no.5
• /
• pp.667-684
• /
• 2022

This study analyzed the problems of skin beauty textbooks used in high school based on the NCS ability unit, and was to improve them. By the NCS standard, it focuses on the contents which can be learned during the high school course. The main results are as follows. First, the revision of textbooks is to contain NCS competency unit, which is excluded in spite of being taught. Second, Replacement is required for NCS 5 level beyond the high school. Third, the illustrated and photographic materials is revised to improve the understanding by maintaining consistency and visibility. Fourth, the contents on the practical skill need specific explanations and instructional materials. Fifth, to revise terminology and the notation system is needed in skin care. The results of this study can be used as basic data to develop an NCS learning module in the skin care field and high school textbooks.

• The Journal of the Acoustical Society of Korea
• /
• v.28 no.2
• /
• pp.148-154
• /
• 2009

In audio coding, SBR technology synthesizes the high-bands using patched time-frequency information from low-bands and the correction parameters, Since SBR transmits only correction parameters for high-bands, it provides a low-rate coding of high-bands, and is used as a core module of MPEG-4 HE-AAC, SBR was originally designed for audio signal and its performance for speech signal tends to decrease, and the major reason is an excessive noise floor in high-bands which is caused by incorrect tonality computation, In this paper, a new method to determine noise floor level in an adaptive fashion according to the speech characteristics is proposed in order to solve the problem of SBR for speech signal, The proposed method maintains the compatibility with the standard SBR, and the subjective performance evaluation shows that the proposed method improves the SBR performance especially for male speech signal compared with the standard SBR.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.31 no.6
• /
• pp.434-449
• /
• 2019

In this study, we develop a new cross-shore sediment module which takes the effect of infra-gravity waves of bound mode, and boundary layer streaming on the sediment transport into account besides the well-known asymmetry and under-tow. In doing so, the effect of individual random waves occurring during the unit observation period of 1 hr on sediment transport is also fully taken into account. To demonstrate how the individual random waves would affect the sediment transport, we numerically simulate the non-linear shoaling process of random wavers over the beach of uniform slope. Numerical results show that with the consistent frequency Boussinesq Eq. the application of which is lately extended to surf zone, we could simulate the saw-tooth profile observed without exception over the surf zone, infra-gravity waves of bound mode, and boundary-layer streaming accurately enough. It is also shown that when yearly highest random waves are modeled by the equivalent nonlinear uniform waves, the maximum cross-shore transport rate well exceeds the one where the randomness is fully taken into account as much as three times. Besides, in order to optimize the free parameter K involved in the long-shore sediment module, we carry out the numerical simulation to trace the yearly shoreline change of Mang-Bang beach from 2017.4.26 to 2018.4.20 as well, and proceeds to optimize the K by comparing the traced shoreline change with the measured one. Numerical results show that the optimized K for Mang-Bang beach would be 0.17. With K = 0.17, via yearly grand circulation process comprising severe erosion by consecutively occurring yearly highest waves at the end of October, and gradual recovery over the winter and spring by swell, the advance of shore-line at the northern and southern ends of Mang-Bang beach by 18 m, and the retreat of shore-line by 2.4 m at the middle of Mang-Bang beach can be successfully duplicated in the numerical simulation.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.36 no.2
• /
• pp.1-13
• /
• 2008

Bus stops are places that a variety of things happen including waiting, meeting and taking breaks. Therefore, these locations need to be made to meet the usage demands. They should be landscaped to provide a comfortable and satisfying environment for users. At present, bus stops are made with artificial materials and are all unified in form without consideration to landscape, ecology and other characteristics. Users are exposed to the poor surroundings. However, if small urban parks, which are of vital importance as well as extremely convenient, were connected to bus stops, the results would be a quantitative increase in the leisure locations and a qualitative change in the form of improved landscape and various forms of parks. The research was carried out to determine the effects of connecting bus stops and small parks, and the results are as follows. First, small parks provide resting areas for waiting passengers and buses. Second, it provides presently insufficient rest areas with convenience facilities and makes it more comfortable to take buses and use the park. Third, it provides a multi-functional efficient use of space that functions as both bus stop and park. Fourth, it can be a symbolic landmark that can represent the color of the area by adding a cultural element. Fifth, the existing green space in the park can contribute to the natural environment of the city. This study deduced general problems surrounding bus stops on the basis of selected indices and researched bus stops which are being used as parks and the places which have the potential for such purposes, in order to suggest a plan of attack. In addition, this proposal can create a new form of space, the bus stop park, and try to create a module of cases to establish it.

• Journal of Wetlands Research
• /
• v.25 no.2
• /
• pp.99-110
• /
• 2023

Non-point source (NP) pollutants in an agricultural landuse are discharged from a large area compared to those in other land uses, and thus effective source control measures are needed. To develop appropriate control measures, it is necessary to quantify discharge load of each source and evaluate the degree of water quality improvement by implementing different options of the control measures. This study used Hydrological Simulation Program-FORTRAN (HSPF) to quantify pollutant discharge loads from different sources and effects of different control measures on water quality improvements, thereby supporting decision making in developing appropirate pollutant control strategies. The study area is the Gyeseong river watershed in Changnyeong county, Gyeongsangnam-do, with agricultural areas occupying the largest proportion (26.13%) of the total area except for the forest area. The main pollutant sources include chemical and liquid fertilizers for agricultural activities, and manure produced from small scale livestock facilities and applied to agriculture lands or stacked near the facilities. Source loads of chemical fertilizers, liquid fertilizers and livestock manure of small scale livestock facilities, and point sources such as municipal wastewater treatment plants (WWTPs), community WWTPs, private sewage treament plants were considered in the HSPF model setup. Especially, NITR and PHOS modules were used to simulate detailed fate and transport processes including vegitation uptake, nutrient deposition, adsorption/desorption, and loss by deep percolation. The HSPF model was calibrated and validated based on the observed data from 2015 to 2020 at the outlet of the watershed. The calibrated model showed reasonably good performance in simulating the flow and water quality. Five Pollutants control scenarios were established from three sectors: agriculture pollution management (drainge outlet control, and replacement of controlled release fertilizers), livestock pollution management (liquid fertilizer reduction, and 'manure management of small scale livestock facilities) and private STP management. Each pollutant control measure was further divided into short-term, mid-term, and long-term scenarios based on the potential achievement period. The simulation results showed that the most effective control measure is the replacement of controlled release fertilizers followed by the drainge outlet control and the manure management of small scale livestock facilities. Furthermore, the simulation showed that application of all the control measures in the entire watershed can decrease the annual TN and TP loads at the outlet by 40.6% and 41.1%, respectively, and the annual average concentrations of TN and TP at the outlet by 35.1% and 29.2%, respectively. This study supports decision makers in priotizing different pollutant control measures based on their predicted performance on the water quality improvements in an agriculturally dominated watershed.