• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.27-30
• /
• 1998

본 논문에서의 기존의 2선식 댁내 망을 이용하여 ISDN PRI(2.048MHz)급의 전송을 위해 DS-CDMA방식을 적용하는 방법을 제안한다. TE 와 NT 의 신호의 검출을 위해 자기의 확산코드와 정합된 단일 사용자 검출기를 사용할 수 있으나, 검출하려는 신호와 다른 사용자 신호간의 다원접속간섭(Multiple Access Interference)에 의해 시스템의 성능이 저하된다. 본 논문에서는 다원접속간섭을 효과적으로 제거할 수 있는 최소평균제곱오차 (Minimum Mean Squared Error) 다중사용자 간섭제거기를 사용하고 컴퓨터 모의실험을 통하여 성능을 분석한다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.3
• /
• pp.229-235
• /
• 2019

The implementation of an in-band full-duplex wireless communication system is demonstrated in this study. In the analog/RF domain, the self-interference(SI) signal is reduced using a separate antenna for the transmitter and receiver paths, and most of the SI signal is canceled in the digital domain. A software defined radio(SDR) is used to implement the in-band full-duplex wireless communication system. The USRP X310 device uses transmitting and receiving antennas. By adjusting the gain of the transmitting and receiving ends of the SDR device, the magnitude of the SI signal entering the receiving antenna, and the size of the received signal from the outside, are both set to -64 dB. To verify the in-band full-duplex wireless communication performance, the source data is image and orthogonal frequency-division multiplexing is used for modulation. A WiFi standard frame with a carrier frequency of 2.67 GHz and bandwidth of 20 MHz is used. In the received signal, the SI signal is canceled by digital signal processing and the SI signal is attenuated by up to 34 dB. OFDM demodulation was impossible when the SI signal was not removed. However, the bit error rate is reduced to $2.63{\times}10^{-5}$ when the SI signal is attenuated by 34 dB, and no error is detected in the 100 Mbit data output as a result of passing through the Viterbi decoder.

• The Journal of the Acoustical Society of Korea
• /
• v.31 no.6
• /
• pp.384-390
• /
• 2012

Passive sonars employ DEMON(Detection of Envelope Modulation on Noise) processing to extract propeller information from the radiated noise of underwater targets. However, the conventional DEMON processing suffers from the interference of tonal signals because it extracts propeller signals and some types of tonal signals as well. If there are some tonals in the frequency band for DEMON processing, the conventional DEMON processing may additionally extract frequency informations originated from the interaction between different tonals. In this paper, we propose a modified DEMON processing, which can eliminate the interference of the tonals. The proposed algorithm removes tonals in DEMON processing band before demodulation processing, hence results the robustness to the interference of the tonals. Some numerical simulations demonstrate the improved performance of the proposed algorithm against the conventional algorithm.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.11 s.353
• /
• pp.141-148
• /
• 2006

This paper deals with the performance improvement by eliminating loop interference signal and inserting adaptive equalizer for phase compensation in OFDMA based Wibro relay station. The Wibro relay station is used for the extension of communication service area and for throughput improvement of base station. The loop interference is important factor of performance determination of relay station when transmitter and receiver is very closely located. In order to design interference canceller, we generated base-band OFDMA signal and then transmitted the signal along with pilot tones alined with two different combinations for training mode. And then, we generated received fading signal due to the loop interference added noise to the received signal. In the receiver, the transmitted signal is recovered by elimination of the interference signal with channel estimate and compensating phase by adaptive equalizer. The performance improvement was verified by computer simulation which show channel estimation, constellation of signal and BER characteristics according to the variation of SNR ratio.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.10 s.352
• /
• pp.18-26
• /
• 2006

In this paper, we propose new beamforming algorithm which overcomes signal cancellation effect even high cross correlation existing between target and interfering signal. Using the proposed method, we show that direction of arrival (DOA) of interfering signal can be estimated using correlation matrix and the cross-correlation can be eliminated in the correlation matrix of input signal. The proposed method gives high performance enhancement compared with the spatial averaging method in our computer simulation results.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.3
• /
• pp.393-398
• /
• 2022

During the test operation period of the wind profiler prototype, radio frequency interference (RFI) contamination occurred in the spectrum. The reference of the RFI that removed the algorithm appearing in the wind profiler spectrum were investigated, and a new algorithm was developed to remove the RFI. First, it was filtered with a threshold value of 0.1 m/s of the spectral width, and the range of the number of gates with the same radial velocity was determined according to whether the beam was a vertical beam or an oblique beam. RFI contamination was removed through filtering and scanning of non-weather signals, and the continuity of wind vectors calculated from the improved spectral radial velocity was verified.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.7 s.361
• /
• pp.35-40
• /
• 2007

As the mobile communication service is widely used and the demand for wireless repeaters is rapidly increasing because of the easiness of extending service areas. But a wireless repeater has a problem that the output of the transmit antenna is partially fed back to the receive antenna, which results in feedback interference. In this paper, we propose a new varable step-size LMS algorithm which utilizes correlation between reference and error signals to adjust the step sizes, for cancelling the feedback interference signals in the WCDMA repeater under time-varying multi-path channels. The proposed algorithm was evaluated through computer simualation by being applied to the feedback canceling filter of the WCDMA repeater. The simulation results demonstrated that the proposed one is superior to the conventional ones in terms of the cancelation perormance.

• The Journal of the Acoustical Society of Korea
• /
• v.5 no.3
• /
• pp.44-49
• /
• 1986

회로의 간편성에 최대 역점을 두어 PLL을 이용한 정현파 간섭음을 실시간으로 제거하는 방식을 제안하였다. SC 여파기를 이용한 적응 노치 여파기ㅘ 적응 대역 여파기를 자기 동조법으로 구동시킴으 로써 간섭음을 제거하였다. SC 여파기의 구동 스위칭 주파수는 제거하려는 신호 주파수으 L49배가 되 도록 하엿으며 소자의 동작 특성상 4KHz의 간섭음 제거 대역을 갖게 된다. 노치 여파기는 6차 여파기 이고 감쇄도는 중심 주파수에서 약 -56dB이다.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.225-230
• /
• 2013

In a bandpass sampling (BPS), the frequency of the sampler is lower than that of the signal being sampled. In this method, the baseband spectrum directly appears by the sampling operation, so that it is not necessary to use any frequency down-converter, which makes the receiver's hardware simpler. The second-order BPS uses two identical BPS samplers, of which sampling times are offset by each other. By exploiting the relationship between two sampled signals, it can be possible to cancel the aliased signal component or the interference due to the bandpass sampling. In order to cancel the interference, an interpolant filter is used to manipulate the phase characteristics of the BPS sampled signal. In this paper, it is introduced a multiband interpolant filter which can simultaneously cancel multiple interference signals that have been aliased from multiple frequency bands. In case of no need of interference cancellation, another method is suggested to enhance the signal quality by 3dB. A computer simulation has been performed, and the feasibility of the suggested methods has been verified.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.1
• /
• pp.36-44
• /
• 2014

Broad band and wide area satellite communication has advantage that can be always communicate with anyone regardless of time and space. In the other hands, its communication quality is easy to be affected by interference signals. Due to the fact that interference signal can be transmitted from everywhere, it's hard to find the illegal source of signal and it has huge influence. In this paper, with this influence of interference signal, we introduce the interference rejection method, implementation and test result in the digital satellite communication processing the signal using variety of digital method. It will be useful information to improve the interference rejection function and also be helpful on the field of satellite communication.