• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.10
• /
• pp.2066-2070
• /
• 2009

A voltage controlled attenuator using a PIN diode and two resistors of the $\pi$-type fixed attenuator is described in this paper. The proposed variable attenuator operating for a fixed attenuation range has a good input VSWR and a low intermodulation signal. For the low phase shift, a PIN diode is connected with open stub for the purpose of phase compensation. The stub for phase compensation is calculated by the Deloach method and the related circuit theory. This attenuator is easily fabricated on the microstrip and can be normally used in fine control circuits within small attenuation range. The fabricated attenuator for 2110~2170 MHz frequency band has about 4 dB of an attenuation range, $2^{\circ}$ of phase variance, and -20 dB of S11 according to the input voltage from 0 to 2.7 V.

• Journal of the Korean Institute of Navigation
• /
• v.25 no.4
• /
• pp.455-460
• /
• 2001

본 연구에서는 방향성 결합기의 특성과 PIN다이오드의 특성을 이용하여 가변 감쇠기를 구현하였다. 기존의 Even-Odd Mode해석법이 아닌 간단한 2-port 기법으로 감쇠기를 분석하였으며, 산란 파라미터는 결합포트의 종단 임피던스가 동일한 경우와 동일하지 않은 경우에 있어서의 감쇠기의 동작특성을 평가하였다. 방향성 결합기의 결합포트는 가변종단을 HP사의 전류제어 소자인 HSMP-3864 PIN다이오드를 사용하였다. 구현된 가변감쇠기는 PCS 송신주파수 1.9 GHz에서 감쇠 범위가 30 dB 이상, 삽입손실 5 dB 이하, 입·출력 반사계수 -25 dB 이하의 특성을 나타내었으며, 이는 PCS와 셀룰러 이동통신 기지국용 전력 증폭기를 온도 등과 같은 외부의 환경변화에 따라서 이득을 가변 시킬 수 있으며, 또한 증폭기의 선형성을 향상시킬 것으로 사료된다.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.07a
• /
• pp.22-23
• /
• 2003

광섬유 가변 감쇠기는 광증폭기, add／drop 모듈, Mux／Demux, 광송수신기 등 중요한 광통신 시스템의 입력 및 출력 광신호 레벨을 적절하게 제어하기 위해 요구되는 중요한 소자이다. 가변 감쇠기는 높은 신뢰성, 높은 해상도, 작은 삽입손실, 낮은 편광 및 파장 의존성 손실 등이 요구되어 진다. 가변 광감쇠기는 평면 기판에 형성된 도파로 의 열광학 효과나 전기광학 효과를 이용하는 기법과 MEMS 기술에 기초한 방법이 잘 알려져 있다. (중략)

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.6
• /
• pp.1109-1114
• /
• 2003

In this paper, the electric characteristic of the SGPS with slot in the ground plane is similar to the parallel resonant circuit. When the slot length in SGPS is equal to the half wavelength of specific frequency, the characteristic of SGPS represent the large attenuation at the specific frequency. We found out the relation between attenuation and resistor on the slot in SGPS and we designed the variable attenuator for MMIC using the variable resistor. This attenuator can be applied to AGC circuit in transceiver if the PIN diode is used replace for resistor.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.2
• /
• pp.15-18
• /
• 2014

This work studies a variable optical attenuator using a reflective type liquid crystal cell for optical switches. The proposed architecture is capable of comprising a compact and low voltage driving variable optical attenuator. The usefulness of the proposed architecture is demonstrated by showing characterization of the liquid crystal cell, temperature effects, and response characteristics of the architecture.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.28 no.3
• /
• pp.275-281
• /
• 2015

In this study, vertical motion of a Tuned Liquid Column Damper(TLCD) is measured by a variable voltage measurement system in the electric field and design parameters of the TLCD are determined. First, nonlinear damping term of the TLCD is replaced as the equivalent viscous damping term. The natural frequency and damping ratio of dynamic characteristics of the TLCD are verified. In addition, a novel liquid level measurement system is developed for measuring vertical motion of the TLCD. For the experimental achievement, experimental characterizations of natural frequency and damping ratio of the TLCD are undertaken utilizing the developed variable voltage sensing. Also, shake table testing is performed to determine the dynamic characteristics of the TLCD. As a result, the feasibility of the proposed liquid level measurement system is verified by comparison with the capacitive type wavemeter.

• Korean Journal of Optics and Photonics
• /
• v.27 no.4
• /
• pp.127-132
• /
• 2016

In this paper, a trench structure was fabricated by femtosecond-laser machining to eliminate thermal crosstalk in a multichannel variable optical attenuator (VOA), to prevent decreasing attenuation efficiency of the VOA. Trenches of a variety of widths and depths were fabricated on the VOA chips by femtosecond-laser processing. After the machining, attenuation according to current change was observed in each VOA chip module with trenches. As a result, we could observe high responsivity of attenuation and low power consumption, and that the heat of each channel barely influenced other channels.

• Korean Journal of Optics and Photonics
• /
• v.29 no.1
• /
• pp.28-31
• /
• 2018

In this paper, we have proposed and demonstrated a variable optical attenuator (VOA) incorporating a dual-fiber collimator and a bimetallic actuator. The optical attenuation between input and output single-mode fibers was tuned by tilting the angle of a reflection mirror fixed on the bimetal. The bimetal was heated or cooled by a thermoelectric cooler (TEC) and then moved the reflection mirror, due to bending and unreeling. The desired optical attenuation can be obtained through adjusting the electrical input into the TEC. The fabricated device showed 0.5 dB of insertion loss, 0.2 dB of maximum polarization-dependent loss, and 40 dB of dynamic range. The response time was measured to be about 5 s.

• Proceedings of the Optical Society of Korea Conference
• /
• 2000.02a
• /
• pp.132-133
• /
• 2000

최근, 인터넷 등의 보급으로 인하여 급증하는 다양한 형태의 정보를 효과적으로 전송하기 위하여 파장분할다중화 광통신시스템 (wavelength division multiplexed optical communication system: WDM)이 활발히 개발 및 보급되어 왔다. 가변 광감쇠기는 각 파장별 광신호의 세기를 균일하게 하여 장거리 전송을 가능하게 하는 WDM시스템의 핵심 소자이다. 폴리머 소자는 제작이 간편하고 가격이 저렴할 뿐 만 아니라 다른 소자와의 집적이 용이하고, 열광학 계수가 실리카에 비하여 10배 정도 커서 구동전력을 크게 줄일 수 있는 등의 장점으로 인하여 폴리머 광감쇠기가 활발하게 연구되어 왔다$^{(1)}$ . 본 논문에서는 미세 가공된 멤브레인형$^{(2)}$ 도파로를 이용한 저전력 폴리머 가변 광가쇠기에 관한 것이다. (중략)

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.4
• /
• pp.57-63
• /
• 2010

The damping parameter of Levenberg-Marquardt algorithm switches between error backpropagation and Gauss-Newton learning and affects learning speed. Fixing the damping parameter induces some oscillation of error and decreases learning speed. Therefore, we propose the way of a variable damping parameter with referring to the alternation of error. The proposed method makes the damping parameter increase if error rate is large and makes it decrease if error rate is small. This method so plays the role of momentum that it can improve learning speed. We tested both iris recognition and wine recognition for this paper. We found out that this method improved learning speed in 67% cases on iris recognition and in 78% cases on wine recognition. It was also showed that the oscillation of error by the proposed way was less than those of other algorithms.