• Proceeding of EDISON Challenge
• /
• 2017.03a
• /
• pp.428-432
• /
• 2017

Silicon 기반 Metal-oxide-semiconductor field-effect transistor (MOSFET)의 크기가 감소함에 따라 silicon자체의 물성적 한계가 나타나고 있다. 이를 극복하고자 III-V 화합물 반도체가 채널소자로서 각광받고 있다. 본 연구에서는 III-V 화합물반도체 중 $In_xGa_{1-x}As$는 Indium 조성에 따른 전자구조 및 n-type MOSFET의 소자 특성을 본다. Indium의 조성이 증가함에 따라 subband의 개수와 간격이 증가하게 되어 Density of state가 감소하게 된다. 이로 인하여 Indium의 조성이 증가함에 따라 $In_xGa_{1-x}As$ 채널 MOSFET에서 상대적으로 Fermi level을 더 많이 상승시키게 되어 potential barrier를 얇아지게 만들며 또한 에너지에 따른 전류 밀도를 넓게 분포하도록 만든다. 이로 인하여 단채널에서는 In 조성이 증가함에 따라 direct source-to-drain tunnelling current이 증가하게 된다. 이로 인하여 In 조성의 증가에 따라 subthreshold swing과 ON-state current가 저하된다.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.1
• /
• pp.51-54
• /
• 2004

Gallium nitride (GaN) powders were prepared by calcining a gallium(III) nitrate salt in flowing ammonia in the temperature ranging from 500 to 1050 $^{\circ}C$. The process of conversion of the salt to GaN was monitored by X-ray diffraction and $^{71}Ga$ MAS (magic-angle spinning) NMR spectroscopy. The salt decomposed to ${\gamma}-Ga_2O_3$ and then converted to GaN without ${\gamma}-{\beta}Ga_2O_3$ phase transition. It is most likely that the conversion of ${\gamma}-Ga_2O_3$ to GaN does not proceed through $Ga_2O$ but stepwise via amorphous gallium oxynitride ($GaO_xN_y$) as intermediates. The GaN nanowires and microcrystals were obtained by calcining the pellet containing a mixture of ${\gamma}-Ga_2O_3$ and carbon in flowing ammonia at 900 $^{\circ}C$ for 15 h. The growth of the nanowire might be explained by the vapor-solid (VS) mechanism in a confined reactor. Room-temperature photoluminescence spectra of as-synthesized GaN powders obtained showed the emission peak at 363 nm.

• Proceedings of the KIEE Conference
• /
• 1988.11a
• /
• pp.168-171
• /
• 1988

The p-n homo junction diode of the III-V ternary alloy semiconductor $In_{1-x}Ga_xP$ : S grown by the temperature gradient solution (TGS) was fabricated by Zn-diffusion, and it's characteristics was investigated. The carrier concentration of $In_{1-x}Ga_xP$ doped with sulfur, 0.5 mol %, was $1{\times}10^{17}cm^{-3}$ and the mobility was varied with the composition. In the case that the diffusion time was constant as 30 minutes. The temperature dependence of diffusion coefficient was decreased from D= $4.2{\times}10^{-5}$ exp (-1.74/$k_{B}T$) to D= $2.5{\times}10^{-5}$ exp (-3.272/$k_{B}T$) with increasing of composition $\times$ from 0.43 to 0.98. The major peak of E.L spectrum was due to D-A pair recombination and the peak intensity was increased with the increasing of input current. And the E.L intensity was decreased with the increasing temperature, and shift to the long wavelength. The luminescence efficiencies measured at $5^{\circ}C$, atmosphere temperature, was decreased from $2.6{\times}10^{-4}$% to $9.49{\times}10^{-6}$ % with increasing of composition it from 0.39, direct transition region, to 0.98, indirect transition region.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.26 no.2
• /
• pp.58-61
• /
• 2016

Bulk GaN crystals were grown by the basic ammonothermal method. The c-plane GaN templates grown by hydride vapor phase epitaxy were used as seed crystals and sodium metal, amide, and azide were added as a mineralizer. The growth conditions are at temperatures from $500{\sim}600^{\circ}C$ and pressures from 2~3 kbar. The growth rate for the c-axis was increased with increasing the operating pressure. Average dislocation density was measured $1{\times}10^5/cm^2$ by the cathodoluminescence measurement. The full-width at half-maximum of the X-ray diffraction rocking curve for (002) reflection was approximately 270 arcsec for Ga face and 80 arcsec for N face.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.41 no.1
• /
• pp.56-62
• /
• 1992

The GaAs bulk crystals are grown by the Synthesis Solute Diffusion(SSD) method and its properties are investigated. The crystal growth rate at optimum condition is 0.28 cm/day and their temperature dependence is R(T) = 2.92 x 10S04T exp(-1.548eV/kS1BTT) [cmS02T/day.K]. Etch pits density distribution along radial direction is order of 10S04TcmS0-2T and 10S03TcmS0-2T at the edge and middle of the wafers, respectively, and it increased exponentially along vertical direction of ingot. Moreover,it is uniformly distributed as order of 10S03TcmS0-2T in radial direction of In doped GaAs. The carrier concentration and mobilities are measured to 0.34-2.1 x 10S016T cmS0-3T and 2.3-3.3x10S03T cmS02T/V.sec, respectively.

• Solar Energy
• /
• v.20 no.2
• /
• pp.43-54
• /
• 2000

We prepared and characterized $Cu(In_{1-x}Ga_x)Se_2$(CIGS) films using a elemental co-evaporation method for absorbing layer of high efficiency thin film solar cells. The CIGS films deposited on a soda-lime glass exhibited low resistivity because of higher carrier concentration. Na was accumulated at the CIGS surface and the 0 and Se were also accumulated at the surface, suggesting that oxidation is a driving force of Na accumulation. The structure of CIGS film was modified or a secondary phase was formed in the Cu-poor CIGS bulk films probably due to the incorporation of Na into Cu vacancy sites. As the Ga/(In+Ga) ratio increased, the diffraction peaks of $Cu(In_{1-x}Ga_x)Se_2$ films were shifted to larger angle and splitted, and the grain size of $Cu_{0.91}(In_{1-x}Ga_x)Se_2$ films became smaller. All $Cu_{0.91}(In_{1-x}Ga_x)Se_2$ films showed the p-type conductivity regardless of the Ga/(In+Ga) ratio. Ag/n-ZnO/i-ZnO/CdS/$Cu_{0.91}(In_{0.7}Ga_{0.3})Se_2$/Mo solar cells were fabricated. The currently best efficiency in this study was 14.48% for $0.18cm^2$ area ($V_{oc}=581.5mV,\;J_{sc}=34.88mA$, F.F=0.714).

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.12
• /
• pp.8-14
• /
• 2011

The optimal geometry of the gate field plate in AlGaN/GaN-on-Si HEMT has been proposed using two-dimensional device simulation to achieve a high breakdown voltage for a given gate-to-drain distance. It was found that the breakdown voltage was drastically enhanced due to the reduced electric field at the gate corner when a gate field plate was employed. The electric field distribution at the gate corner and the field plate edge was investigated as functions of field plate length and insulator thickness. According to the simulation results, the electric field at the gate corner can be successfully reduced even with the field plate length of 1 ${\mu}m$. On the other hand, when the field plate length is too long, the distance between field plate and drain electrode is reduced below a critical level, which eventually lowers the breakdown voltage. The highest breakdown voltage was achieved with the field plate length of 1 ${\mu}m$. According to the simulation results varying the $SiN_x$ film thickness for the fixed field plate length of 1 ${\mu}m$, the optimum thickness range of the $SiN_x$ film was 200 - 300 nm where the electric field strength at the field plate edge counterbalances that of the gate corner.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.2-2
• /
• 2010

텐덤형 태양전지는 다양한 에너지 대역을 동시에 흡수할 수 있도록 제작할 수 있어 단일접합 태양전지에 비해 높은 에너지변환효율을 기대할 수 있다. 본 연구에서는 GaAs를 기반으로 양자점 혹은 양자우물 구조를 이용한 고효율 텐덤형 태양전지를 설계하고, 완충층 및 활성층의 특성을 분석하였다. 분자선 단결정 성장 장비를 이용하여 GaAs 기판 위에 메타모픽 (metamorphic)성장법을 이용하여 convex, linear, concave 형태로 조성을 변화시켜 $In_xAl_1-_xAs$ 경사형 완충층을 성장한 후 그 특성을 비교하였다. 또한, 최적화된 경사형 완충층 위에 1.1 eV와 1.3 eV의 에너지 대역을 각각 흡수할 수 있는 적층 (5, 10, 15 층)된 InAs 양자점 구조 또는 InGaAs 양자우물구조를 삽입하여 p-n 접합을 성장하였다. 그리고 GaAs/AlGaAs층을 이용한 터널접합에서는 GaAs층의 두께 (20, 30, 50 nm)에 따른 터널링 효과를 평가하였다. 그 결과, 경사형 완충층을 통해 조성 변화로 인한 결함을 최소화하여 다양하게 조성 변화가 가능한 고품위의 구조를 선택적으로 성장할 수 있었으며, 적층의 양자점 구조 및 양자우물 구조를 이용해 고효율 텐덤형 태양전지의 구현 가능성을 확인하였다.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.1
• /
• pp.42-48
• /
• 2011

In this paper, a passive load-pull using a GaN HEMT (Gallium Nitride High Electron Mobility Transistor) bare-chip in X-band is presented. To obtain operation conditions that characteristic change by self-heating was minimized, pulsed drain bias voltage and pulsed-RF signal is employed. An accuracy impedance matching circuits considered parasitic components such as wire-bonding effect at the boundary of the drain is accomplished through the use of a electro-magnetic simulation and a circuit simulation. The microstrip line length-tunable matching circuit is employed to adjust the impedance. The measured maximum output power and drain efficiency of the pulsed load-pull are 42.46 dBm and 58.7%, respectively, across the 8.5-9.2 GHz band.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.12
• /
• pp.1995-2000
• /
• 1989

The ion beam system of 20keV C-W (Cockroft Walton) type composed of the AuGe alloy LMIS(Liquid Metal Ion Source) has been designed and constructed. For the fabrication of the ohmic contact to the n-GaAs, the ion beam extracted from the AuGe alloy source was implanted into the n-GaAs, and it was measured by contact resistivity. The stable AuGe ion beam(2.5\ulcorner/cm\ulcorner was obtained at the extraction voltage of 14.5kV. The measurements of the contact resistivity were done by the TLM (Transmission Line Model) method and the specific contact resistivity was found to be 2.4x10**-5 \ulcornercm\ulcornerfor the implanted sample by the 1.9x10**20/cm**3 and the annealed sample at 30\ulcorner for 2 min.