• Korean Journal of Remote Sensing
• /
• v.15 no.1
• /
• pp.61-71
• /
• 1999

Several physical phenomena on the sea surface are analyzed from SAR images of South Sea areas, Korea. Strong wave patterns propagating in southerly direction are seen in ERS-1 SAR image on October 11, 1994, and a wave directional spectrum is calculated from this image using the SAR modulation transfer function. RADARSAT SAR image of August 15, 1996 reveals internal waves in northern coastal waters of Cheju Island. Analysis indicates that the internal waves may have been generated by the tidal currents traveling over the shallow bottom of the stratified water in the summer during the tidal changeovers fro ebb to flood and shows patterns of trains of solitons. RADARSAT SAR image taken 3 days after the oil spill accident near Goeje Isalnd on April 3, 1997 detects distinct oil slicks from the accident area but also shows slicks near the coast caused by wind sheltering of coastal mountains and chemical-biological activities.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.219-226
• /
• 2004

We measure subsidences occurred in a reclaimed coastal land, Noksan industrial complex, by using JERS-1 SAR (1996-1998) and RADARSAT-1 SAR (2002-2003) dataset. SAR with a high spatial resolution (about several or several tens meter) can reveal the two-dimensional distribution of settlement that would be bardly estimated from in situ measurements. The DInSAR results show significant deformation signal associated with soil consolidation. Accuracy of the settlements estimated by 2-pass differential interferometry (DInSAR) is evaluated using the measurements of settlement gauge. A two-dimensional subsidence map is constructed from 7 qualified pairs. Comparing the JERS-1 radar measurements with the ground truth data yields the correlation coefficient of 0.87 (RMSE of 1.44 cm). The regression line shows the gradient of 1.04 and intercepts close to the origin, which implies that the unbiased settlement can be measured by DInSAR technique. The residual settlements are also detected from RADARSAT-1 pairs. The extent and amount of the settlements are matched well with ground truth data.

• Korean Journal of Remote Sensing
• /
• v.37 no.3
• /
• pp.475-491
• /
• 2021

With the recent increase in available high-resolution (< ~1 m) satellite SAR images, the demand for precise registration of SAR images is increasing in various fields including change detection. The registration between high-resolution SAR images acquired in different look angle is difficult due to speckle noise and geometric distortion caused by the characteristics of SAR images. In this study, registration is performed in two stages, coarse and fine, using the x-band SAR data imaged at staring spotlight mode of TerraSAR-X. For the coarse registration, a method combining the adaptive sampling method and SAR-SIFT (Scale Invariant Feature Transform) is applied, and three rigid methods (NCC: Normalized Cross Correlation, Phase Congruency-NCC, MI: Mutual Information) and one non-rigid (Gefolki: Geoscience extended Flow Optical Flow Lucas-Kanade Iterative), for the fine registration stage, was performed for performance comparison. The results were compared by using RMSE (Root Mean Square Error) and FSIM (Feature Similarity) index, and all rigid models showed poor results in all image combinations. It is confirmed that the rigid models have a large registration error in the rugged terrain area. As a result of applying the Gefolki algorithm, it was confirmed that the RMSE of Gefolki showed the best result as a 1~3 pixels, and the FSIM index also obtained a higher value than 0.02~0.03 compared to other rigid methods. It was confirmed that the mis-registration due to terrain effect could be sufficiently reduced by the Gefolki algorithm.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.187-194
• /
• 2006

Recently satellite SAR techniques have become essential observation tools for various ocean phenomena such as wind, wave, and current. The CMOD4 and CMOD-IFR2 models are used to calculate the magnitude of wind at SAR resolution with no directional information. Combination of the wave-SAR spectrum analysis and the inter-look cross-spectra techniques provides amplitude and direction of the ocean wave over a square-km sized imagette, The Doppler shift measurement of SAR image yields surface speed of the ocean current along the rador looking direction, again at imagette resolution. In this paper we report the development of a SAR Ocean processor (SOP) incorporating all of these techniques. We have applied the SOP to several RADARSAT-1 images of the coast of Korean peninsula and compared the results with oceanographic data, which showed reliability of spaceborne SAR-based oceanographic research.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.30 no.1
• /
• pp.75-86
• /
• 2012

Synthetic Aperture Radar(SAR) imaging system is independent of solar illumination and weather conditions; however, SAR image is difficult to interpret as compared with optical images. It has been increased interest in multi-sensor fusion technique which can improve the interpretability of $SAR^{\circ\circ}$ images by fusing the spectral information from multispectral(MS) image. In this paper, a multi-sensor fusion method based on high-frequency extraction process using Fast Fourier Transform(FFT) and outlier elimination process is proposed, which maintain the spectral content of the original MS image while retaining the spatial detail of the high-resolution SAR image. We used TerraSAR-X which is constructed on the same X-band SAR system as KOMPSAT-5 and KOMPSAT-2 MS image as the test data set to evaluate the proposed method. In order to evaluate the efficiency of the proposed method, the fusion result was compared visually and quantitatively with the result obtained using existing fusion algorithms. The evaluation results showed that the proposed image fusion method achieved successful results in the fusion of SAR and MS image compared with the existing fusion algorithms.

• Journal of IKEEE
• /
• v.24 no.4
• /
• pp.1058-1063
• /
• 2020

This paper proposes a 12-bit SAR A/D(Successive Approximation Register Analog-to-Digital) converter that operates at low power for bio-signal and sensor signal processing. The conventional SAR A/D converter utilized the reduction of the dynamic current, which resulted in reducing total power consumption. In order to solve the limitation of the sampling time due to charging/discharging of the capacitor for reducing dynamic current, the different sampling time on the C-DAC bit switch operation was applied to reduce the dynamic current. In addition, lowering the supply voltage of the digital block to 0.6V led to 70% reduction of the total power consumption of the proposed ADC. The proposed SAR A/D was implemented with CMOS 65nm process 1-poly 6-metal, operates with a supply voltage of 1.2V. The simulation results demonstrate that ENOB, DNL/INL, power consumption and FoM are 10.4 bits, ±0.5LSB./±1.2LSB, 31.2uW and 2.8fJ/step, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.9 s.100
• /
• pp.903-908
• /
• 2005

In this paper, in order to consider SAR(Specific Absorption Rate) problem at the beginning stage of a handset development, we investigated the Shh value change by using simulation method according to various EMI(Electromagnetic Interference) paint patterns on front case of a handset and folding angles. First, we made some experiments with EMI paint pattern on front case of a handset, and obtained results showed that different patterns of EMI paint had different SAR values. Among the simulation results on SAR value according to EMI paint patterns, the hairpin pattern showed the best performance, i.e. the decrease efficiency of $8.04\%$ and completely removed pattern showed the decrease efficiency of $5.94\%$. Orignal pattern was set as the reference and the folding angle was $150^{\circ}$. Second, simulation was carried out with changing folding angle from $150^{\circ}$ to $140^{\circ}$ and $160^{\circ}$. Simulation results for the modeled handset showed that SAR value was decreased with increasing the folding angle. When the folding angle was $160^{\circ}$ and with original pattern, we got the SAR value of about 1,61 W/kg. When we applied hairpin pattern with the folding angle of $160^{\circ}$, we got the lowest SAR value of about 1.45 W/kg.

• Proceedings of the KSRS Conference
• /
• 2009.03a
• /
• pp.309-313
• /
• 2009

산불은 전세계적으로 발생하는 가장 주요한 재해현상 중 하나이다. 산불 감시나 산불에 의한 피해지역의 효과적인 관측은 피해 지역을 최소화하고, 효율적인 피해 복구 계획 수립에 매우 중요한 기초자료를 제공한다. 광학 위성 자료를 활용한 산불 피해지역 탐지가 널리 사용되고 있음에도 불구하고, 산불에 의한 연기 또는 구름 분포에 의해 종종 사용상에 제약이 있다. 본 연구에서는 2000년 4월 강원도 고성, 강릉, 삼척, 물진 지역에서 발생한 대규모 산불을 연구 대상지역으로 하여, 1998년-2000년 동안 획득된 RADARSAT-1 SAR 영상을 이용하여 산불 피해 지역 감시의 활용성을 연구하였다. 산불에 의한 산림 피해지역 관측을 위해 RADARSAT-1 SAR 영상의 후방산란관의 변화를 통한 변환 탐지를 수행하였다. 산불 피해지역에서 산불 전에 비해 산불 후에 획득된 RADARSAT-1 SAR 영상의 후방산란값이 증가하는 것으로 관측되었다. RADARSAT-1 SAR 영상으로부터 관측된 산불 피해 지역은 Landsat-7 ETM 자료와 현장 조사 자료에 의한 산불 피해 지역과 매우 상관성이 높은 것으로 관측되었다.

• Journal of the Korean Geosynthetics Society
• /
• v.21 no.4
• /
• pp.55-67
• /
• 2022

In this paper, fundamentals and recent development of the interferometric synthetic aperture radar, known as InSAR, technique for measuring ground deformation through satellite image analysis are presented together with case histories illustrating its applicability to urban ground deformation monitoring. A study area in Korea was selected and processed based on the muti-temporal time series InSAR analysis, namely SBAS (Small Baseline Subset)-InSAR and PS (Persistent Scatterers)-InSAR using Sentinel-1A SAR images acquired from the year 2014 onward available from European Space Agency Copernicus Program. The ground settlement of the study area for the temporal window of 2014-2022 was evaluated from the viewpoint of the applicability of the InSAR technique for urban infrastructure settlement monitoring. The results indicated that the InSAR technique can reasonably monitor long-term settlement of the study area in millimetric scale, and that the time series InSAR technique can effectively measure ground settlement that occurs over a long period of time as the SAR satellite provides images of the Korean Peninsula at regular time intervals while orbiting the earth. It is expected that the InSAR technique based on higher resolution SAR images with small temporal baseline can be a viable alternative to the traditional ground borne monitoring method for ground deformation monitoring in the 4^th industrial era.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.1D
• /
• pp.89-94
• /
• 2012

The RFM (Rational Function Model), as an alternative to physical sensor models has been widely used for photogrammetric processing of high resolution optical satellite imagery. However, the application of RF modeling to the SAR (Synthetic Aperture Radar) is very limited. In this paper, stereo radargrammetric processing of TerraSAR-X stereo pairs with RFM is implemented and analyzed. The investigation has shown that the accuracy of TerraSAR-X DSM is similar to that of the commercial S/W product. Finally, it is demonstrated that RFM is effective and feasible in the application to the radargrammetric SAR image processing.