• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.42 no.3
• /
• pp.7-13
• /
• 2010

KOptimization and control of wet-end process provide a key solution to improve paper quality and production efficiency at the same time. Wet-end of paper machine is to determine three important influencing factors of papermaking i.e., retention, drainage and formation. Good formation of paper could be made at the cost of deteriorated retention or drainage. In the same manner increase of retention aid could cause the bad formation of paper. It is very important to find a proper retention chemical which may satisfy one of three factors without the sacrifice of other two. Laboratory scale analyzing or screening chemical additives of wet-end was reported in this study based on RDA sheet molding. Different from the conventional test method, simultaneous consideration of three important wet-end properties could be made by RDA and consequently more reliable prediction of actual paper machine wet-end could be expected.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.4
• /
• pp.112-120
• /
• 1996

With the MOsES (mask oxide sidewall etch scheme)process which uses the conventional i-line stepper and isotropic wet etching, CMOSFET's with fine gate pattern of 0.1.mu.m CMOSFET device, the screening oxide is deposited before the low energy ion implantation for source/drain extensions and two step sidewall scheme is adopted. Through the characterization of 0.1.mu.m CMOSFET device, it is found that the screening oxide deposition sheme has larger capability of suppressing the short channel effects than two step sidewall schem. In cse of 200.angs.-thick screening oxide deposition, both NMOSFET and PMOSFET maintain good subthreshold characteristics down to 0.1.mu.m effective channel lengths, and show affordable drain saturation current reduction and low impact ionization rates.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.342-348
• /
• 2001

This study was conducted to obtain granular crystalline gypsum that can be used as raw material for plaster boards or cements from waste Plaster board. We could disintegrate preferentially gypsum to gypsum needle in 10${\mu}{\textrm}{m}$ or less size among the contents of waste plaster board (gypsum, paper, fiber, and inorganic material .etc.) by hydration afterwards the dehydration of crushed waste plaster board. In this case, the optimum conditions for minimizing the size of gypsum were dehydration rate of 75%~ 85%, hydration concentration of 10~20%, agitation speed of 250~400rpm, crushing size of 2cm or less. Gypsum of 98.21% grade was recovered with 99.0% yield from under screenings of 325mesh wet screening which followed by the dehydration-hydration process performed in the conditions of dehydration rate of 80%, hydration concentration of 15%, agitation speed of 300rpm, crushing size of 2cm or less. Subsequently, Plate-like Crystalline gypsum of is 151${\mu}{\textrm}{m}$ size and the grade of 99.49% with the Yield of 98.0% from the upper screenings of 270mesh wet screening carried out after the re-crystallization of the recovered gypsum needle slurry.

• Resources Recycling
• /
• v.10 no.6
• /
• pp.43-52
• /
• 2001

This study was conducted to obtain granular crystalline gypsum that can be used as raw material for Plaster boards or cements from waste Plaster board. Gypsum could be Preferentially disintegrated to gypsum needle in $10\mu\textrm{m}$ or less size by hydration after the dehydration of crushed waste Plaster board. The finer the gypsum needle, it is easier to remove coarse impurities and to recover the gypsum needle. The optimum conditions for obtain the finer gypsum size were dehydration rate of 75~85%, solid concentration at hydration of 10~15%, agitation speed of 250~400 rpm, crushing size before dehydration of 2 cm or less. Gypsum of 98.21% grade was recovered with 99.0% yield as the undersize of 325 mesh wet screening followed by the dehydration-hydration process performed at the conditions of dehydration rate of 80%, solid concentration at hydration of 15%, agitation speed of 300 rpm, crushing size before dehydration of 2 cm or less. After the recrystallization of recovered gypsum, Plate-like gypsum of $151\mu\textrm{m}$ size with 99.49% grade was obtained as the oversize of 270 mesh in a wet screening.

• Resources Recycling
• /
• v.15 no.3 s.71
• /
• pp.20-29
• /
• 2006

This study was carried out for to recover the purified crystalline gypsum from phosphogypsum by means of using it's crystallographical Properties. The dehydration of hydrated phosphogypsum to $\alpha$-hemihydrate is completed with the 2 hours treatment of it in $99^{\circ}C$ waterrs. The purified crystalline gypsum having the maximum size of $200{\mu}m$ was obtained by 325# wet screening after recrystallization of the $\alpha$-hemihydrate gypsum at the condition of $Na_2SO_4$ 10 wt%, slurry density 20%, $pH\;5{\sim}6,\;65^{\circ}C$ and 4hr. In this process, the yield of gypsum was 93.9% and its grade was 99%.

• Journal of environmental and Sanitary engineering
• /
• v.10 no.3
• /
• pp.85-98
• /
• 1995

In order to ensure that all major cations and anions were accurately measured, the quality assurance checks of chemical analysis data by considering ion and conductivity balance of each precipitation sample were performed. To check the quality assurance of chemical analysis data, precipitation samples were collected by wet- only precipitation sampler at Seoul site and their chemical components were analyzed. By checking the problems for the screening methods of chemical analysis data used until recently, the f value expressed as the ratio of the sum of cations and anions equivalent concentration( $\Sigma $C/$\Sigma $A ) was found to be not ap priorate for data screening. Also, the scattering plot between cation and anion equivalent concentrations in each sample was found to show the general tendency of ion balance but was proved to not quantitate the standard of data screening at a set of samples of various concentration levels.4 more appropriate value was therefore required, h value is defined as (A-C)/C for C≥A and ( A-C)/A for C<4. This value was showed to check the ion balance in a viewpoint of quantitative as well as qualitative and to be useful in applying this expression to a measurement data set. However, the standard o( data screening must vary in response to the ion concentration of sample. In this study, the quality assurance of chemical analysis data was checked by considering both the ion balance evaluating by h value and the electrical conductivity. As these quality assurance checks were applied to Seoul data serf 67 valid samples were obtained. The result of statistical summary in the analytical parameter of precipitation samples collected for a certain period was found to be computed in the precipitation volume- weighted mean( VWM) rather than the arithmetic mean( AM), but PH In the VWM of hydrogen ion concentration. The annual VWM of pH values was 5.0(4.9 ∼ 5.1).

• Resources Recycling
• /
• v.15 no.3 s.71
• /
• pp.46-57
• /
• 2006

This study was carried out for the purpose of recovering the refined gypsum from waste phosphogypsum. The refined gypsum was recovered as a under product of 325 mesh wet screening followed by dehydration and hydration stage. The influence of dehydration temperature and time, dehydration rate, aging time, slurry density of hydration and sonication time on the yield and grade of gypsum were investigated. The refined gypsum of $94{\sim}96%$ grade is recovered in 95% yield by wet screening after selective dehydration and hydration process, from the phosphogypsum. For the better separation efficiency of gypsum, it is recommended to treat the phosphogypsum at the conditions of as follows; 6hr's dehydration at $140^{\circ}C$, hydration slury density of $3{\sim}10%$, hydration temperature of $20{\sim}30^{\circ}C$, hydration time of 2hr. In additions, addition of sodium citrate 0.005M and sonication of $5{\sim}10min.$ are effective for increase the recovery of gypsum. On the other hand, aging the dehydrated gypsum 16 hours or longer make decrease the recovery of gypsum remarkably.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.32 no.3
• /
• pp.51-59
• /
• 2004

Focusing on WBGT(Wet Bulb Globe Thermometer Index) according to the LAI(Leaf Area Index) variation of trees, this study verifies the effects of urban shade trees on the outdoor thermal environment. As for methodology, air$.$globe temperature, air humidity and WBGT were measured under three shade trees whose LAIs were 2.1, 4.0 and 8.2 respectively at midday(12:00-13:00) of 14 sunny days from the 4th through the 29th day of September 2003. Those factors were also measured at the unshaded areas and compared with the values of shaded areas. The measured site was paved with interlocking concrete bricks. The measurements were analyzed through the ANCOV A(Analysis of Covariance) and the regression routines of SPSS11 for windows (SPSS Inc., 2001). The major findings were as follows. 1. The direct correlation between WBGT and LAI was very low. On the contrary, the WBGT showed close correlation with air$.$globe temperature and air humidity, and the LAI also showed very close correlation with globe temperature. These results tell that dominant shading effect by the tree is on the screening of direct solar radiation which lower the globe temperature and WBGT consequently. 2. While the average globe temperatures and WBGT at unshadowed area were 40.4$^{\circ}C$ and 26.2$^{\circ}C$ respectively, the former under the shade tree with LAI 2.1, 4.0 and 8.2 were 34.5$^{\circ}C$, 32.6$^{\circ}C$ and 30.2$^{\circ}C$, and the latter were 24.6$^{\circ}C$, 24$^{\circ}C$ and 23.4$^{\circ}C$ respectively. 3. The relationship between LAI(x) and WBGT(y) can be presented with the following equation: y = 24.23+1.53 $e^{-x}$+0.36x $e^{-x}$+0.46 $x^2$ $e^{-x}$ ($R^2$ =.98) =.98)

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.48 no.3
• /
• pp.160-168
• /
• 2003

This study was carried out to investigate the effects of induced wet-injury conditions on barley seedling growth. Barley seedlings at the three leaf stage were grown in culture solutions with various combinations of dissolved oxygen (DO), nutrients and citric acid (CA) concentrations. Seedling growth was reduced by hypoxia. Root length and root fresh weight were most severely reduced under 1 ppm DO. Shoot growth was slightly reduced but not root growth under low nutrient condition. Seedling growth was reduced by CA in a concentration-dependant manner, Response of seedling growth was efficiently differentiated in a solution containing 1 ppm DO, one tenth of the normal P, K and Mg concentration and 3 mM CA. Under this induced wet-injury condition, overall seedling growth of 6 cultivars was reduced by 11 to 19% compared to the control condition. The results suggest that the induced wet-injury condition can be used for the screening of resistant genotypes at the seedling stage.

• Journal of Korean Society for Atmospheric Environment
• /
• v.12 no.3
• /
• pp.323-332
• /
• 1996

Precipitation samples were collected by the wet-only sampling method at Seoul from September 1993 to June 1995. Sample were analysed for the anions $(NO_3^-, NO_2^-, SO_4^{2-}, Cl^-, and F^-)$ and cations $(Na^+, K^+, Ca^{2+}, Mg^{2+}, and NH_4^+)$ in addition to pH and electric conductivity. In order to establish the chemical analysis data of high quality, the assurance checks for analytical data of precipitation were performed by considering the ion balance and by comparing the measured conductivity with the calculated conductivity. As we applied the various assurance checking methods by the ion balance used until recently to a data set measured in this study, the f value expressed as $\Sigma C/\Sigma A$ was found to be not appropriate for the data screening. Also, the scattering plot between cations and anions in each sample was found to show the general tendency of ion balance but was proved to not quantitate the standard of data screening at a data set of samples of various concentration levels. The h value defined as (A-C)/C for C $\geq$ A and (A-C)/A for C < A was used to check the ion balance. However, the standard of data screening by h value must very in response to total ion concentration of samples. In this study, the quality assurance of chemical analysis data was checked by considering both the ion balance of evaluating by h value and the conductivity balance. Further the quality control was achieved by these quality assurance methods. As the result, 67 samples among total 77 were obtained as valid. As the central tendency value for a statistical summary in the analytical parametr of samples, the volume-weighted mean value was found to represent more the general chemistry of precipitation rather than the arithmetic mean. The volume-weighted mean pH was 5.0 and 25% of samples was less than this mean. The concentrations of sufate and nitrate in precipitation were 90.4 ueq/L and 32.4 ueq/L which made up 59% and 21% of all anions. The raion of $SO_4^{2-}/(NO_3^- + NO_2^-)$ in precipitation was 2.7, which indicates that the contributions of $H_2SO_4$ and $HNO_3$ to the acidity of precipitation are 70% and 30%, respectively.