• Journal of the Korean Data and Information Science Society
• /
• v.14 no.4
• /
• pp.751-758
• /
• 2003

We consider a life testing experiment in which several two-component shared parallel systems are put on test, and the test is terminated at a predesigned experiment time. The bivariate data obtained from such a system-level life testing can be classified into three cases: 1) the case of failed two components with known failures times, 2) the case of censored two components, and 3) the case of one censored component and the other failed component of which the failure time might be known or unknown. In this thesis, the likelihood estimators for Freund's bivariate exponential life distribution under above censoring scheme are obtained. Results of comparative studies based on Monte Carlo simulation are presented.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.30 no.3
• /
• pp.261-270
• /
• 2010

This paper presents an analytical investigation for a baseline-free imaging of a defect in plate-like structures using the time-reversal of Lamb waves. We first consider the flexural wave (A0 mode) propagation in a plate containing a defect, and reception and time reversal process of the output signal at the receiver. The received output signal is then composed of two parts: a directly propagated wave and a scattered wave from the defect. The time reversal of these waves recovers the original input signal, and produces two additional side bands that contain the time-of-flight information on the defect location. One of the side band signals is then extracted as a pure defect signal. A defect localization image is then constructed from a beamforming technique based on the time-frequency analysis of the side band signal for each transducer pair in a network of sensors. The simulation results show that the proposed scheme enables the accurate, baseline-free detection of a defect, so that experimental studies are needed to verify the proposed method and to be applied to real structure.

• Communications for Statistical Applications and Methods
• /
• v.11 no.3
• /
• pp.619-629
• /
• 2004

Binomial group testing or composite sampling is often used to estimate the proportion, p, of positive(infects, defectives) in a population when that proportion is known to be small; the potential benefits of group testing over one-at-a-time testing are well documented. The literature has focused on maximum likelihood estimation. We provide two Bayes estimators and compare them with the MLE. The first of our Bayes estimators uses an uninformative Uniform (0, 1) prior on p; the properties of this estimator are poor. Our second Bayes estimator uses a much more informative prior that recognizes and takes into account key aspects of the group testing context. This estimator compares very favorably with the MSE, having substantially lower mean squared errors in all of the wide range of cases we considered. The priors uses a Beta distribution, Beta ($\alpha$, $\beta$), and some advice is provided for choosing the parameter a and $\beta$ for that distribution.

• Archives of design research
• /
• v.16 no.2
• /
• pp.301-310
• /
• 2003

The interface design of mobile products has become a hot issue recently as a variety of products are being developed for extended usages. There have been two different views on interface design of mobile products like PDAs(personal digital assistants) or cellular phone. One 치aims that the current interface design of PC cannot be directly applied because mobile products have their own specific functions and requirements. On the meantime, the other argues that an extended application of PC metaphors to mobile products can have advantages because users'PC experiences can reduce the learning efforts and thus contribute to intuitive understanding mobile products. In this research, two types of PDAs, developed according to the aforementioned conflicting philosophies were compared and evaluated, based on laboratory-based usability testing conducted by novice users. The experiment consists of asking subjects to perform identical tasks for the two different types of products. The interaction data collected during usability testing were analyzed in terms of time taken, rate of success of tasks and errors. The experiment shows that there were some meaningful effects of users'experience of PC on the usability of PDAs.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.5C no.4
• /
• pp.145-151
• /
• 2005

The synthetic breaking test method was developed to evaluate the breaking performance of ultra high-voltage circuit breaker and made up of two independent circuits; current source circuit and voltage source circuit. In application of this test method, it is necessary to extend the arc of the test breaker. So, the new re-ignition system using VTGS (Vacuum Triggered Gap-Switch) was constructed to improve the efficiency and reliability of this test. In this re-ignition system, VTGS operates in high vacuum state of $5{\time}10^{17}$torr and control system consists of the triggering device and the air M-G (Motor-Generator). This re-ignition system showed the operating characteristics, such as delay time ($t_d$) and jitter time ($t_j$ not exceeding 5us and 1us respectively, and had the operating voltage of $25\~150kVdc$ at the gap distance of 24mm.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.8
• /
• pp.1270-1281
• /
• 1989

This paper presents two new storage schemes of 3-D objects to accelerate the finding of the first intersecting object and the shadow computation steps in ray tracing. The 3-D objects which are potentially intersected with the first reflection (refraction)ray are enrolled within a so called reflection (refraction) frustum' for a polygon object. Only those objects registered in the corres ponding frustum are immediately checked for intersection with the secondary rays emanating from the same polygon. The other is called a shadow pyramid' which contains the candidate objects possibly blocking the path from the relevant light source to any point on the relevant polgon. The shadow testing of a point is performed only against the objects contained in the associated shadow pyramid. Despite the cost needed for registration of objects within frusta or shadow pyramids, the total rendering time of ray tracing using the proposed approaches was reduced by approximately 50% (10% in color rendering time and 70% in shadoe testing time) from the conventional cell 50% (10% in color rendering time and 70% in shadow testing time) from the conventional cell traversal scheme under the 3-D uniform subdivision environment due to the fast finding of candidate objects for intersection and the reduced number of intersection calculations.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.12 no.1
• /
• pp.16-24
• /
• 1992

Moire interferometry using a diffraction grating and a laser is a powerful technique for analizing small deformation of a specimen. In the method, the x and y-directional fringe patterns are obtained by using the x and y-directional sets of two beams. If the both sets of two beams are simultaneously incident to the specimen, the x and y-directional fringe patterns are super imposed. In this case, it is difficult to separate each directional fringe pattern. Therefore each fringe pattern has been separately recorded by selecting each set of two beams. In order to analyze a two-dimensional strain changing with time, Moire interferometry using the two-dimensional fourier transform method is proposed and the x and y-directional fringes are separated. By this method, the thermal deformation of a glass plate is analyzed.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.31 no.3
• /
• pp.271-277
• /
• 2011

This study presents a nondestructive test for underwater PVC pipes. To use guided ultrasonic waves, specially denoted by cylindrical Lamb waves, a test setup was made in a water tank using the pitch and catch mode and specimens were made to give artificial cutouts located in the circumferential direction of the pipes. Total three states of damaged levels were considered to see how the guided waves interact with the defects. For the experimental adjustments, three different pipe diameters (60, 90, 114 mm) were tested, and two factors - incident angle (10 and $40^{\circ}$) and distance (50 and 200 mm) - were tried. From the results, regardless of the diameters and two experimental factors, it is shown that the degrees of defects were recognized through amplitude and arrived time of the very first part of the received cylindrical Lamb waves. Between amplitude and arrived time, it is found that the amplitude gives more sensitive results.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.6
• /
• pp.2452-2457
• /
• 2012

When a quality inspection process rejects a product unit, consecutive repeated inspections are sometimes conducted for the rejected unit to reduce a false reject possibility. This paper analyzes a special inspection process that allows up to two times of consecutive testing for each product to decrease type I inspection errors. This study uses a Markov chain to model the steps of the inspection process and a product unit's quality states during inspection. Historical inspection results from a company are used as the data for the Markov chain model. Using the Markov chain model and data, this study analyzes the effect of this special inspection rule on the proportion of the final quality levels and scrap rate. The results demonstrate that this inspection process of possible double testing could help reduce unnecessary rejects and consequently decrease material and production costs.

• The Korean Journal of Applied Statistics
• /
• v.7 no.2
• /
• pp.213-224
• /
• 1994

A diagnostic method useful for detecting outliers in testing the equality of two covariance metrics is developed using the influence curve approach. This method is easily generalized to more than two covariance matrices. A sample version for the influence measure of detecting outliers is considered based on the empirical distribution functions. The sample version includes as its component terms the well-known test statistic for detecting one outlier at a time introduced by Wilks and its generalization to the two-group case.