• Current Optics and Photonics
• /
• v.2 no.1
• /
• pp.27-33
• /
• 2018

We report the physical implementation of a tunable photonic microwave delay line filter based on injection locking of a single Fabry-Perot laser diode (FP-LD) to a reflective semiconductor optical amplifier (RSOA). The laser generates equally spaced multiple wavelengths and a single tapped-delay line can be obtained with a dispersive single mode fiber. The filter frequency response depends on the wavelength spacing and can be tuned by the temperature of the FP-LD varying lasing wavelength. For amplitude control of the wavelengths, we use gain saturation of the RSOA and the offset between the peak wavelengths of the FP-LD and the RSOA to decrease the amplitude difference in the wavelengths. From the temperature change of total $15^{\circ}C$, the filter, consisting of four flat wavelengths and two wavelengths with slightly lower amplitudes on both sides, has shown tunability of about 390 MHz.

• Proceedings of the Optical Society of Korea Conference
• /
• 1991.06a
• /
• pp.121-125
• /
• 1991

A basic coherent optical transmission was demonstrated using FSK modulation and heterodyne detection scheme. Optical frequency of DFB LD light source at the transmitter side was stabilized with Fabry Perot etalon and bias feedback circuit. A tunable external cavity LD was used as a local oscillator at the receiver. Heterodyned output signal at IF frequency of 2GHz was measured and discussed.

• Journal of the Optical Society of Korea
• /
• v.15 no.3
• /
• pp.227-231
• /
• 2011

An external optical modulation using absorption s in a Fabry-Perot laser diode (FP-LD), has been proposed and experimentally demonstrated for multicasting in a WDM-PON. The center wavelengths of absorption s in an FP-LD move to short-wavelength rapidly by only a small current (~1 mA) injection. If the current injection is stopped, the s move back to the original position. Such a movement of the s can make the FP-LD act as an external optical modulator, which is found to modulate at a maximum modulation speed of 800 Mbps or more. For a multicasting transmitter in a WDM-PON, the proposed modulator can be cost-effectively applied to a multi-wavelength laser source with the same periodicity of the longitudinal mode. Instead of the multi-wavelength laser source, tunable-LDs are used for experiments. The 32 channel multicasting system with the proposed modulator has been demonstrated, showing power penalties of 1.53~4.15 dB at a bit error rate of $10^{-9}$ with extinction ratios better than 14.5 dB at 622 Mbps.

• ETRI Journal
• /
• v.45 no.2
• /
• pp.193-202
• /
• 2023

We demonstrate the transmission of uncompressed 4K videos over the photonics-based terahertz (THz) wireless link using a directly modulated distributed feedback laser diode (DFB-LD). For optical heterodyne mixing and data modulation, a DFB-LD was employed and directly modulated with a 5.94-Gb/s non-return-to-zero signal, which is related to a 6G-serial digital interface standard to support ultra-high-definition video resolution. We derived the optimal frequency of the THz carrier by varying the wavelength difference between DFB-LD output and Tunable LD output in the THz signal transmitter to obtain the best transmission performances of the uncompressed 4K video signals. Furthermore, we exploited the negative laser-to-filter detuning for the adiabatic chirp management of the DFB-LD by the intentional discrepancy between the center wavelength of the optical band-pass filter and the output wavelength of the DFB-LD. With the help of the abovementioned methods, we successfully transmitted uncompressed 4K video signals over the 2.3-m wireless transmission distance without black frames induced by time synchronization error.

• Transactions of the Society of Information Storage Systems
• /
• v.3 no.1
• /
• pp.23-27
• /
• 2007

Blu-ray disc 이후의 차세대 고밀도 광 기록 기술로 주목받는 홀로그래픽 데이터 스토리지 시스템을 설계, 제작하고 기록 재생 test 를 수행하였다. 시스템은 각도 다중화법을 채택하였고, 파장 405nm, NA 0.55 신호광 Fourier 변환 렌즈로 미디어에 defocus 하여 기록하였다. 1 page 용량은 raw bit 로 0.74Mbit 이고, SLM 과 CCD 의 over-sampling 비율은 1:1.5 가 되도록 구성하였다. 얻어진 raw 이미지는 위치 및 distortion 보상등의 신호처리 후, 70page 다중화 조건에서 bER $1{\times}10-2$ 수준으로 재생해 낼 수 있었다. 온도 변화에 의한 신호 열화를 보상하기 위해 External Cavity Tunable Blue LD 를 개발하여 온도 변화 $10^{\circ}C$까지 보상 가능함을 확인하였다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.04a
• /
• pp.198-202
• /
• 2003

Tunable laser diode module with 50GHz-spacing internal wavelength locker was developed. Angle tilting dependency on FSR and peak wavelength shift and the proper initial tilting angle was calculated. By tilting the etalon, the response of the internal wavelength locker module was tuned. As a result, the fabricated internal wavelength locker module showed good performance over 62 channels.

• Korean Journal of Optics and Photonics
• /
• v.15 no.5
• /
• pp.469-474
• /
• 2004

We have fabricated and designed wavelength-tunable sampled grating distributed Bragg reflector laser diodes(SGDBR-LD) by using, for the first time, planar buried heterostructures(PBH). The diodes have low threshold current values and high-performance of laser operation. Growth condition using metal organic chemical vapor deposition(MOCVD) was optimized for the formation of a good butt-coupling at the interface. A maximum output power of the fabricated device was 20 mW under 200 mA continuous wave(CW) operation at $25^{\circ}C$. Average threshold current and voltage were 12 mA and 0.8 V, approximately. This output power is higher than those of ridge waveguide(RWG) and buried ridge stripe(BRS) structures by amounts of 9 mW and 13 mW, respectively. We obtained a tuning range of 44.4nm which is well matched with the target value of our design. The side mode suppression ratio of more than 35 dB was obtained for the whole tuning range. Optical output power variation was less than 5 dB, which is 4 dB smaller than that of RWG structures.

• Korean Journal of Optics and Photonics
• /
• v.14 no.3
• /
• pp.321-326
• /
• 2003

We constructed grating- tuned external cavity semiconductor lasers using Littman and Littrow configuration, for which the wavelengths are tuned by rotation of the grating. This wavelength tunable semiconductor laser is one of the main devices of WDM optical communication. In Littman configuration, the wavelength range of about 60 nm (The C- and L-band range of 1,530~1,590 nm) was obtained by changing the incidence angle of the grating about $\pm$1$^{\circ}$ from the incidence angle of 70$^{\circ}$. In the 40 nm tuning range, the output power variation was less than 1.25 ㏈ and the side mode suppression ratio(SMSR) was 32 ㏈. In Littrow configuration (The incidence angle and the first order diffraction angle is the same, i.e. $\alpha$=$\delta$), the wavelength tuning range was about 80 nm for the same conditions used in Littman configuration except the incidence angle ($\alpha$=49$^{\circ}$). In 60 nm tuning range, the output power variation was less than 1.5 ㏈ and SMSR was 35 ㏈.

• Korean Journal of Optics and Photonics
• /
• v.17 no.6
• /
• pp.544-547
• /
• 2006

A time-domain modeling approach is used to study characteristics of a widely tunable coupled-ring reflector (CRR) laser diode(LD). The CRR consists of a bus waveguide and two coupled ring resonators coupled to the bus without resorting to distributed Bragg grating structure. The tuning range can be a few tens of nanometers with a side mode suppression ratio exceeding 35dB through the adjustment of currents into the phase control sections in the rings. The CRR laser diode has long effective cavity length compared to conventional laser diodes. Accordingly, a broad additional resonance peak in the amplitude modulation characteristics is observed between 20 to 30 GHz, implying the extension of amplitude modulation bandwidth.

• Korean Journal of Optics and Photonics
• /
• v.13 no.5
• /
• pp.384-389
• /
• 2002

A new idea of the wavelength locking module for DWDM application was investigated in the present research. Only one etalon photo-diode is generally used in the internal/external wavelength locking system. For the internal wavelength locking module with 50 GHz applications, an algle tuning method of the etalon commonly applied. However, the alignment process of the etalon with the angle tuning method is limited because the lock performance is extremely sensitive accoriding to the change of the tilting angle. In an optical viewpoint, the alignment tolerance of the locker module with the etalon PD array block was good, and the precise tuning of the wavelength was possible. The characteristics of free spectral range (FSR) and peak shift of wavelength according to the tilting angle with the locker module was investigated. For the present module, the optimized initial tilting angle was experimentally obtained.