• ETRI Journal
• /
• 제38권1호
• /
• pp.90-99
• /
• 2016

In this work, we investigate differentially encoded blind transceiver design in low signal-to-noise ratio (SNR) regimes for orthogonal frequency-division multiplexing (OFDM) signaling. Owing to the fact that acquisition of channel state information is not viable for short coherence times or in low SNR regimes, we propose a time-spread frequency-encoded method under OFDM modulation. The repetition (spreading) of differentially encoded symbols allows us to achieve a target energy per bit to noise ratio and higher diversity. Based on the channel order, we optimize subcarrier assignment for spreading (along time) to achieve frequency diversity of an OFDM modulated signal. We present the performance of our proposed transceiver design and investigate the impact of Doppler frequency on the performance of the proposed differentially encoded transceiver design. To further improve reliability of the decoded data, we employ capacity-achieving low-density parity-check forward error correction encoding to the information bits.

• Journal of Multimedia Information System
• /
• 제5권2호
• /
• pp.91-98
• /
• 2018

We devised a bird-borne transceiver unit for S-band packet radio communications based on the CC2500 transceiver, a device manufactured by Texas Instruments (TI). Our assessments determined the optimal parameters needed to achieve successful bird-to-center communication over a distance of 18 km and bird-to-bird communication over a distance of 200 m. These parameters included optimal modulation methods, transmission rates, and antennas. We equipped the transceiver unit with a modified dipole antenna (collinear antenna), which we tested in a 10 m anechoic chamber. Our experimental assessments and circuit design review identified the following parameters: 2FSK modulation method; 14.28 kHz frequency shift; 101.56 kHz IF reception bandwidth; and Manchester encoding (+). Our assessments showed bird-to-bird communications could be achieved over a distance of 200 m assuming MSK, FEC (+), and 500 kbps. Following tests by an official body, we obtained 28 sets of a type approval license for 2.4 GHz. In cooperation with the Yamashina Institute for Ornithology, we attempted to tag and release six or more swans. This unit gives us the ability to obtain vital data on swans. We expect this data to provide significant benefits, including clues on improving screening for infected individuals.

• 한국산학기술학회논문지
• /
• 제14권4호
• /
• pp.1877-1882
• /
• 2013

스마트 유틸리티 네트워크(SUN)용 무선전송 기술은 에너지 절약 지능형 그린 홈 네트워크 개발의 핵심 요소 기술일 뿐 아니라, 향후 ZigBee 기술을 대체하여 다양한 분야에 활용될 차세대 WPAN 기술이다. SUN 무선 전송 기술은 IEEE 802.15.4g SUN PHY-Layer 표준으로 지하나 반 지하 또는 복잡한 건물 주변과 같은 열악한 전파환경에서도 높은 링크 이득과 안정적인 전송속도의 제공이 가능한 비 면허 무선 전송기술이다. 본 논문은 IEEE 802.15.4g SUN 표준을 만족시키는 RF 송수신기 칩 개발을 위해, RF 송수신기에 대한 시스템 단위 모의실험 환경을 구축하고, 시스템 설계에 필요한 설계 방법, 요구 사양 도출 및 시스템 예상 성능에 대한 내용이다. 또한 상기 시스템 단위 모의실험 결과를 바탕으로 실제 제작한 RF 송수신기 칩의 성능은 IEEE 802.15.4g SUN PHY-Layer 표준의 요구 사양 보다 우수하였다.

• 한국전자파학회논문지
• /
• 제8권6호
• /
• pp.600-613
• /
• 1997

본 논문에서는 광대역 코드분할 다원 접속 방식을 이용하여 무선 가입자 접속 망(WLL: Wireless Local Iρop)서비스를 위한 기지국용 RF 송수신기를 고찰하였다 제작된 송수신기는 크게 수신기, 송신기 및 RF 컨트 롤러띄 세 보드로 구성하였고,5 MHz의 RF 채널 대역폭을 이용하여 넓은 동작 범위와 고감도가 요구되는 RF 수신기 및 우수한 스퓨리어스 방사 억제 특성을 가지는 송선기의 설계 및 구현에 관하여 기술하였다. 전체 송수 선부플 상용화된 부품이나 주문 제작된 소자의 규격을 토대로 RF 시뮬레이션 소프트웨어를 이용하여 위에 언급된 수신기 및 송신기의 예상 성능을 평가하였고, 이를 토대로 송수신기를 제작하였다. 측정 결과 수신기는 2.86 d dB의 잡음 지수 및 60 dB이상의 동작 영역을 가졌고, 송선기의 스퓨리어스 방사는 34.3 dBm의 출력 전력에서 -49.46 dBc의 특성을 얻어 표준 안에 제시된 성능 규격을 만족하는 좋은 결과를 얻었다.

• 한국콘텐츠학회:학술대회논문집
• /
• 한국콘텐츠학회 2005년도 추계 종합학술대회 논문집
• /
• pp.596-600
• /
• 2005

In High-speed Portable Internet system to improve performance of whole system, adaptive modulation and coding technology is used, this technology changes modulation and encoding techniques depending on wireless channel environment. Modulation technology that is used in High-speed Portable Internet system is BPSK, QPSK, 16QAMs and 64QAMs. If terminal is distant from base station transceiver system, BPSK or QPSK technology Is used and 16QAMs or 64QAM technology is used if is near in the base station transceiver system. In this paper, number of sub-channel in each modulation technology minimized total transmitting number of PDU is analyzed for efficient radio resources usage. For this, simulation is conducted and the results are presented at High-speed Portable Internet system environments.

• International Journal of Contents
• /
• 제7권1호
• /
• pp.1-7
• /
• 2011

A new power control algorithm for wireless communication which can be applied to various near distance communications and USN/RFID systems is proposed. This technique has been applied and tested to lithium coin battery operated UHF/microwave transceiver systems to show extremely long communication life time without battery exchange. The power control algorithm is based on the dynamic prediction method of arrival time for incoming packet at the receiver. We obtain 16mA current consumption in the TX module and 20mA current consumption in the RX module. The advantage provided by this method compared to others is that both master transceiver and slave transceiver can be low power consumption system.

• 전기전자학회논문지
• /
• 제22권3호
• /
• pp.878-881
• /
• 2018

In this paper, experiments through performance evaluation under real operation environment were conducted. Transceiver and microcontroller shows the characteristics for the amount of current consumption and software protocol was optimized by controlling the time of Report Attribute and electric current level. To reduce current consumption when using battery, with designing transmission of the same amount of data as soon as possible, power consumption efficiency was enhanced.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제13권5호
• /
• pp.2357-2380
• /
• 2019

In this paper, we investigate the impact of hardware impairments (HWIs) on the performance of a downlink massive MIMO system. We consider a single-cell system with maximum ratio transmission (MRT) as precoding scheme, and with all the HWIs characteristics such as phase noise, distortion noise, and amplified thermal noise. Based on the system model, we derive closed-form expressions for a typical user data rate under two scenarios: when a common local oscillator (CLO) is used at the base station and when separated oscillators (SLOs) are used. We also derive closed-form expressions for the downlink transmit power required for some desired per-user data rate under each scenario. Compared to the conventional system with ideal transceiver hardware, our results show that impairments of hardware make a finite upper limit on the user's downlink channel capacity; and as the number of base station antennas grows large, it is only the hardware impairments at the users that mainly limit the capacity. Our results also show that SLOs configuration provides higher data rate than CLO at the price of higher power consumption. An approach to minimize the effect of the hardware impairments on the system performance is also proposed in the paper. In our approach, we show that by reducing the cell size, the effect of accumulated phase noise during channel estimation time is minimized and hence the user capacity is increased, and the downlink transmit power is decreased.

• 한국마이크로전자및패키징학회:학술대회논문집
• /
• 한국마이크로전자및패키징학회 2001년도 추계 기술심포지움
• /
• pp.55-60
• /
• 2001

RF MEMS is an exciting emerging technology that has great potential to develop TOC (Transceiver-on-Chip). Applications of the RF MEMS to wireless communications systems are presented. The ability of the RF MEMS technology to enhance the performance and to reduce the size of passive components, in particular, switches, inductors, and tunable capacitors, is addressed. A number of potential wireless system opportunities for the TOC are awaiting the maturation of the RF MEMS technology.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 제14회 신호처리 합동 학술대회 논문집
• /
• pp.305-308
• /
• 2001

We analyze mathematically a VSB (vestigial side-band) transceiver system for the Advanced Television Systems Committee (ATSC) digital television standard and extract a near-baseband equivalent VSB channel model. This model shows the multi-path fading effect of the quadrature component on the in-phase component. Also, we obtain a simplified model of the VSB transceiver system, which is represented by convolution of the transmission signal (before modulation) and the VSB channel. This simplified model is efficiently used for simulation of VSB systems to improve its performances, especially in an equalization part. Applying the DTV channel specifications tested by the Advanced Television Test Conter (ATTC) to the channel model, we obtain an equivalent VSB channel and show the equalization result by using the conventional derision-feedback equalize (DFE).