• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.2 s.25
• /
• pp.20-25
• /
• 2006

Low frequency towed line array with high array gain and beam resolution is a long range surveillance sensor for anti-submarine warfare. The beam characteristics is however deteriorated due to the distorted line array sensor caused by low towing speed, wind, current, and towing ship maneuvering. An adaptive beamforming method is utilized in this paper to enhance the distorted line array beam performance by estimating and compensating the nonlinear array shape. A polynomial curve fitting in the least square sense is used to estimate the array shape iteratively with the distributed heading sensors data along the array. Real time array shape estimation and nonlinear array beam calculation is applied to a very long towed line array sensor system and the beam performance is evaluated and compared to the linear beamformer for the simulation and sea trial data.

• Journal of the Society of Naval Architects of Korea
• /
• v.55 no.5
• /
• pp.401-414
• /
• 2018

Planing hull type ships are often equipped with interceptor or trim tab to improve the excessive trim angle which leads to poor resistance and sea keeping performances. The purpose of this study is to design a controller to control the attitude of the ship by controllable stern interceptor and validate the effectiveness of the attitude control by the towing tank test. Embedded controller, servo motor and controllable stern interceptor system were equipped with planing hull type model ship. Prior to designing the control algorithm, a model test was performed to identify the system dynamic model of the planing hull type ship including the stern interceptor. The matrix components of model were optimized by Genetic Algorithm. Using the identified model, PID controller which is a classical controller and sliding mode controller which is a nonlinear robust controller were designed. Gain tuning of the controllers and running simulation was conducted before the towing tank test. Inserting the designed control algorithm into the embedded controller of the model ship, the effectiveness of the active control of the stern interceptor was validated by towing tank test. In still water test with small disturbance, the sliding mode controller showed better performance of canceling the disturbance and the steady-state control performance than the PID controller.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.43 no.1
• /
• pp.49-61
• /
• 2007

Otter boards in the trawl are the one of essential equipments for the net mouth to be spread to the horizontal direction. Its performance should be considered in the light of the spreading force to the drag and the stability of towing in the water. Up to the present, studies of the otter boards have focused mainly on the drag and lift force, but not on the stability of otter boards movement in 3 dimensional space. In this study, the otter board is regarded as a rigid body, which has six degrees of freedom motion in three dimensional coordinate system. The forces acting on the otter boards are the underwater weight, the resistance of drag and spread forces and the tension on the warps and otter pendants. The equations of forces were derived and substituted into the governing equations of 6 degrees of freedom motion, then the second order of differential equations to the otter boards were established. For the stable numerical integration of this system, Backward Euler one of implicit methods was used. From the results of the numerical calculation, graphic simulation was carried out. The simulations were conducted for 3 types of otter boards having same area with different aspect ratio(${\lambda}=0.5,\;1.0,\;1.5$). The tested gear was mid-water trawl and the towing speed was 4k't. The length of warp was 350m and all conditions were same to each otter board. The results of this study are like this; First, the otter boards of ${\lambda}=1.0$ showed the longest spread distance, and the ${\lambda}=0.5$ showed the shorted spread distance. Second, the otter boards of ${\lambda}=1.0$ and 1.5 showed the upright at the towing speed of 4k't, but the one of ${\lambda}=0.5$ heeled outside. Third, the yawing angles of three otter boards were similar after 100 seconds with the small oscillation. Fourth, it was revealed that the net height and width are affected by the characteristics of otter boards such as the lift coefficient.

• Journal of Ocean Engineering and Technology
• /
• v.13 no.4 s.35
• /
• pp.118-123
• /
• 1999

The mathematical model used in the simulation of ship's maneuvering contains the hydrodynamic coefficients, which are usually evaluated based on PMM model tests in the towing tank and used to predict ship's maneuvering performance when applied to the proto-type ship. The proper mathematical model has to be developed to predict ship's maneuvering motions with hydrodynamic coefficients very well. The mathematical model for PMM model tests is analyzed with identification program and the hydrodynamic coefficients and maneuvering motions by system identification we compared with those obtained directly from PMM model tests and sea trial. The mathematical model for PMM model tests was established and the magnitudes of ship's maneuvering coefficients were determined. When the identified values of coefficients were used to simulate the maneuvers, a very good agreement was obtained between the numerically simulated motion responses and those obtained from PMM model tests.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.13 no.4
• /
• pp.71-78
• /
• 2007

Towing vessels have carried out the important role and service in the maritime industry construction, such as port and sea bridge construction, fairway dredging and sea reclamation etc. Furthermore, tugboat takes the largest portion in number of vessel at the domestic registry and barges as big as the general merchant vessel, which are getting specialized and larger, are in operation. In spite of the increase of marine accidents under this situation, there has been no proper measure for the safe navigation of tugboat in the aspect of a nation. This paper aims to propose the measure for the safe navigation of tugboat according to the frequent marine accident of tugboat with sea bridge. Therefore, we show an example of the sailing schedule and operation checklist based on the analysis of statistics and precedent of marine accident and the investigation of the actual operation state of tugboat in the aspect of a contract of carriage and a personnel setup, which should be checked by the operator of tugboat, to pass through sea bridge safely and propose the safe traffic supporting system based on electronic chart system to improve the safe navigation of tugboat.

• Journal of the Society of Naval Architects of Korea
• /
• v.53 no.4
• /
• pp.315-328
• /
• 2016

Techniques for determinating hydrodynamic derivatives of underwater tow-fish using CFD(Computational Fluid Dynamics) are described in this paper. Main components of hydrodynamic derivatives are added mass, linear damping and non-linear damping coefficients. In this study, linear and non-linear damping coefficients for translational velocities are settled by CFD analysis. In order to analyze the underwater tow-fish, UlsanFOAM based on open-source CFD code, namely OpenFOAM, is employed. By simulating pitch and yaw angle variation of underwater tow-fish, 6DOF(Degree-of-Freedom) forces and moments are estimated at each attitudes. In order to determinate the hydrodynamic derivatives, curves(forces and moments vs attitude) for CFD results are fitted by least square methods. To demonstrate the applicability of the current approach, two different problems(impulsive side towing and straight towing) are simulated and all results are validated.

• Journal of Ship and Ocean Technology
• /
• v.11 no.1
• /
• pp.36-46
• /
• 2007

The maintenance of a ship is essential for safe navigation and hence regular surveys are prescribed according to the rule of classification societies. A hull inspection is generally performed by professional divers, but it takes a long time and the efficiency is low in terms of time and cost. In this research, a ROV(Remotely Operated Vehicle) named as SNU-ROV(Seoul National University-ROV) is developed to replace the conventional inspection method. In this system, the ROV is intended to be used for inspecting ship and harbor because harbor inspection is merging as a safety measure against any possible terror actions. In order to increase the efficiency of inspection, the ROV must be able to measure the exact position of damages. SNU-ROV has a positioning system based on LBL(Long Base Line). In shallow water such as harbor, however, LBL has bad DOP(Dilution of Precision) in the depth direction due to the limited depth. Thus LBL only can not locate the exact depth position. To solve the DOP problem, a pressure sensor is introduced to LBL and a complementary filter is attached by using indirect feedback Kalman filter. Thus developed positioning system is verified by simulation and experiment in towing tank.

• Proceedings of the KIEE Conference
• /
• 1993.07a
• /
• pp.198-201
• /
• 1993

In this paper a numerical model of the industrial cogeneration system which have a thermal storage tank is proposed for the short-term operation strategy. Short-term operation costs of towing cycle and bottoming cycle are calculated by using the proposed model of a thermal storage tank. Simulation results of four cases are compared and analyzed each other. By these simulations which are similar to real operation circumstances, the validity of the proposed model is verified.

• International Journal of Ocean System Engineering
• /
• v.1 no.4
• /
• pp.192-197
• /
• 2011

This paper describes the mathematical modeling, control algorithm, system design, hardware implementation and experimental test of a Manta-type Unmanned Underwater Vehicle (MUUV). The vehicle has one thruster for longitudinal propulsion, one rudder for heading angle control and two elevators for depth control. It is equipped with a pressure sensor for measuring water depth and Doppler Velocity Log for measuring position and angle. The vehicle is controlled by an on-board PC, which runs with the Windows XP operating system. The dynamic model of 6DOF is derived including the hydrodynamic forces and moments acting on the vehicle, while the hydrodynamic coefficients related to the forces and moments are obtained from experiments or estimated numerically. We also utilized the values obtained from PMM (Planar Motion Mechanism) tests found in the previous publications for numerical simulations. Various controllers such as PID, Sliding mode, Fuzzy and $H{\infty}$ are designed for depth and heading angle control in order to compare the performance of each controller based on simulation. In addition, experimental tests are carried out in a towing tank for depth keeping and heading angle tracking.

• Journal of the Society of Naval Architects of Korea
• /
• v.45 no.3
• /
• pp.269-279
• /
• 2008

In this paper, an underwater navigation system with adaptive receding horizon Kalman filter (ARHKF) is studied. It is well known that incorrect statistical information and temporal disturbance invoke errors of any navigation systems with Kalman filter, which makes the autonomous navigation difficult in real underwater environment. In this context, two kinds of problems are herein considered. The first one is the development of an algorithm, which estimates the noise covariance of a linear discrete time-varying stochastic system. The second one is the implementation of ARHKF to underwater navigation systems. The performance of the derived estimation algorithm of noise covariance and the ARHKF are verified by simulation and experiment in the towing tank of Seoul National University.