• The Transactions of the Korean Institute of Power Electronics
• /
• v.7 no.1
• /
• pp.101-110
• /
• 2002

A method to control the inverter output voltage lineally in over modulation mode of the third harmonics injected PWM inverter is proposed. The third harmonics injected PWM has a extended linear region compared with the sine PWM. But it still has a maximum voltage about 90% compared with the six step inverter. Therefore, to control the output voltage linearly in over modulation mode, analyzing the relationship between the modulation index and the peak of the fundamental component of the modified reference voltage, we can settle the problem in over modulation mode without iteration. Then we can increase the maximum fundamental component of the third harmonics injected PWM inverter comparative to six-step inverter continuously in over modulation mode. The simulation results of the inverter-induction motor system shows the validity of this method and experimental results prove it.

• Journal of the Korean earth science society
• /
• v.22 no.2
• /
• pp.112-119
• /
• 2001

The Yangsan fault in the southeastern Korea has been receiving increasing attention in its seismic activity. In this fault region, by using the extended coda-normalization method for 707 seismograms of local earthquakes, were obtained 0.009f$^{-1.05}$ and 0.004f$^{-0.70}$ for fitting values of Q$_p^{-1}$ and Q$_s^{-1}$, respectively. These results indicate that Q$_p^{-1}$ and Q$_s^{-1}$ in the southeastern Korea is the lowest level in the world although the exponent values agree well with those in the other areas. The low Q-1 is not related to the movement of the Yangsan fault but to the tectonically inactive status like a shield area.

• Convergence Security Journal
• /
• v.19 no.3
• /
• pp.13-19
• /
• 2019

MANET has many security vulnerabilities because it consists of only mobile nodes using wireless. In particular, it is a very important factor determining network performance that excludes the participation of malicious nodes through accurate reliability measurements and authentication of nodes participating in the network. In this paper, we proposed a technique applied with blockchain technology in order to prevent forgery of authentication information for nodes participating in the network. And, an area-based hierarchical structure was applied to increase the efficiency of authentication for nodes and apply the optimal technique of block generation and exchange protocol. In addition, four data payloads were added to the block header in order to add authentication information for nodes in block. To improve the reliability by applying the blockchain technique to the hop-by-hop data transfer method between mobile nodes, blockchain exchange protocol through transaction creation, block packaging and verification processes were implemented. We performed the comparative experiment with the existing methods to evaluate the performance of the proposed method and confirmed the excellent performance by the experiment results.

• Environmental and Resource Economics Review
• /
• v.28 no.4
• /
• pp.557-581
• /
• 2019

This study tries to quantify the regional NIMBY costs to nuclear power plants. NIMBY costs are estimated as willingness to pays for avoiding nuclear power plants near residential areas through the contingent valuation method(CVM). In the study, it was assumed that the nuclear power plants were newly constructed around the residences. The result of 600 respondents living within a radius of 30 km of nuclear power plants compared to the result of 600 respondents living in the metropolitan area, which revealed that there were significant NIMBY costs to the construction of nuclear power plants in all residences. By region, the willingness to pay in the metropolitan area was greater than that in the nuclear power areas. This study focuses on NIMBY to nuclear power plants from a regional point of view, which can provide important information in establishing prudent and sound nuclear power policies.

• Journal of the Korea Computer Graphics Society
• /
• v.30 no.1
• /
• pp.11-17
• /
• 2024

Lung cancer segmentation in chest CT images is challenging due to the varying sizes of tumors and the presence of surrounding structures with similar intensity values. To address these issues, we propose a lung cancer segmentation network that incorporates deep supervision and utilizes UNet3+ as the backbone. Additionally, we propose a hybrid lesion focal loss function comprising three components: pixel-based, region-based, and shape-based, which allows us to focus on the smaller tumor regions relative to the background and consider shape information for handling ambiguous boundaries. We validate our proposed method through comparative experiments with UNet and UNet3+ and demonstrate that our proposed method achieves superior performance in terms of Dice Similarity Coefficient (DSC) for tumors of all sizes.

• Journal of KIISE:Databases
• /
• v.27 no.1
• /
• pp.53-63
• /
• 2000

The mobile computing service market is increasing rapidly due to the development of low-cost wireless network technology and the high-performance mobile computing devices. In recent years, several methods have been proposed to effectively deal with restrictions of the mobile computing environment such as limited bandwidth, frequent disconnection and short-lived batteries. Amongst those methods, much study is being done on the caching method - among the data transmitted from a mobile support station, it selects those that are likely to be accessed in the near future and stores them in the local cache of a mobile host. Existing cache replacement methods have some limitations in efficiency because they do not take into consideration the characteristics of user mobility and spatial attributes of geographical data. In this paper, we show that the value and the semantic of the data, which are stored in the cache of a mobile host, changes according to the movement of the mobile host. We argue it is because data that are geographically near are better suited to provide an answer to a users query in the mobile environment. Also, we define spatial location of geographical data has effect on, using the spatial attributes of data. Finally, we propose two new cache replacement methods that efficiently support user mobility and spatial attributes of data. One is based on the location of data and the other on the meaningful region of data. From the comparative analysis of the previous methods and that they improve the cache hit ratio. Also we show that performance varies according to data density using this, we argue different cache replacement methods are required for regions with varying density of data.

• Journal of Environmental Science International
• /
• v.26 no.11
• /
• pp.1297-1306
• /
• 2017

This study identified physical characteristics and aerosol particle sources of $PM_{10}$ and $PM_{2.5}$ in the industrial complex of Busan Metropolitan City, Korea. Samples of $PM_{10}$, $PM_{2.5}$ and also soil, were collected in several areas during the year of 2012 to investigate elemental composition. A URG cyclone sampler was used for collection. The samples were collected according to each experimental condition, and the analysis method of SEM-EDX was used to determine the concentration of each metallic element. The comparative analysis indicated that their mass concentration ranged from 1% to 3%. The elements in the industrial region that were above 10% were Si, Al, Fe, and Ca. Those below 5% were Na, Mg, and S. The remaining elements (1% of total mass) consisted of elements such as Ni, Co, Br and Pb. Finally, a statistical tool was applied to the elemental results to identify each source for the industrial region. From a principal components analysis (SPSS, Ver 20.0) performed to analyze the possible sources of $PM_{10}$ in the industrial region, five main factors were determined. Factor 1 (Si, Al), which accounted for 15.8% of the total variance, was mostly affected by soil and dust from manufacturing facilities nearby, Factors 2 (Cu, Ni), 3 (Zn, Pb), and 4 (Mn, Fe), which also accounted for some of variance, were mainly related to iron, non-ferrous metals, and other industrial manufacturing sources. Also, five factors determined to access possible sources of $PM_{2.5}$, Factor 1 (Na, S), accounted for 13.5% of the total variance and was affected by sea-salt particles and fuel incineration sources, and Factors 2 (Ti, Mn), 3 (Pb, Cl), 4 (K, Al) also explained significant proportions of the variance. Theses factors mean that the $PM_{2.5}$ emission sources may be considered as sources of incineration, and metals, and non-ferrous manufacturing industries.

• Journal of Conservation Science
• /
• v.30 no.4
• /
• pp.329-334
• /
• 2014

A scientific analysis of ancient textiles provides significant data to understand weaving techniques and culture of textiles in each region and charateristics of materials used at that time. In addition, species identification of waterlogged wooden objects is a scientific analysis method that allow us to verify information of relation of foreign species trade and exchange, of preferable species through kinds of wooden products, and of forest environment as well as method setting of conservation. As a result of a species analysis about historical textiles and a wooden comb in a bronze bowl that were excavated from Hapgang-ri, Dong-Myun, Yungi-gun, Chungcheongnam-do, Textile1 and Textile3 are identified as Urticacese Boehmeri nivea ; ramie, Textie2 is identified as Malvaceae Gossypium herbaceum, and a wooden comb is identified as Betulaceae Betula spp. It is expected that this result will help to make further comparative studies, identifying species of textiles and trees of ancient times.

• Economic and Environmental Geology
• /
• v.14 no.2
• /
• pp.93-102
• /
• 1981

Studies of model potential fields continued upward and downward show differences depending on the method of continuation. Beginning with a magnetic field computed over a buried vertical cylinder, the field was continued to various levels by a method introduced by Henderson (Lagrangian interpolation) and by a spectral method (frequency domain analysis). Resultant fields show (1) no significant differences in upward continued values, (2) in downward continuation, accurate values are obtained with the spectral method over the central part of the anomaly, and (3) accurate values are obtained with Henderson's method on the flanks of the anomaly, while oscillations usually characterize the spectral method in this region. Essentially the same observations are made for derivative calculations. Field oscillations are empirically predicted at levels continued to approximately two-thirds of the depth of the source. Our spectral computer program output yields marked oscillations at one-half of the depth of the source. Henderson's method shows no oscillations at this depth and only minor oscillations at the top of the body (some negative values appear on the flanks of the anomaly). The Henderson output is a smooth field even if continued below the top of the body. These results suggest that the presence of oscillations cannot be used to identify the top of a buried source without careful consideration of the method used to continue the field. Use of the derivative to outline and isolate anomalies must similarly include consideration of the method of calculation.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.20 no.2
• /
• pp.105-114
• /
• 2018

The aim of this study was to evaluate the change of phenolic compounds after phosphite treatment on Cheorwon onion. Onion is a perennial plant belonging to the lily family. It is native to Persia of Southwest Asia. It is widely cultivated in the temperate regions of the world. Onion is a good name for the 'Okchong' to drop blood cholesterol and cardiovascular blood flow to increase the prevention of adult diseases. Cheorwon area is inland, but it has high continental climate due to its high altitude. Therefore it is said that the onion cultivated in this region has higher sugar content and higher taste than onion grown in the southern region. Phosphorus components are particularly important ingredients for promoting muscle development. However, if the phosphoric acid content of the soil part is maintained to a large extent until the harvest, the competition of the nutrients tends to cause decay of the root part. Therefore, it is important to improve the quality and shelf life of onion by inducing nutrient balance by applying foliar fertilization method on the reducing phosphorus at harvest time. In this study, acidity was controlled by diluting phosphorous acid(H₃PO₃) and potassium hydroxide(KOH), followed by leaf surface treatment with phosphite on onion. In this study, the concentration of phosphite was diluted to 500, 1,000, 1,500ppm and sprayed three times over the onion leaves in May 2018 using an atomizer and harvested at the end of June, and the phenolic compounds were analyzed by HPLC. As a result, the content of quercetin, one of the important substances in onion, was phosphite 500ppm(179.70㎍/g), 1,000(150.27), 1,500(105.95). The contents of caffeic acid, p-coumaric acid, ferulic acid, rutin, kaempferol, and sugar content were higher in the treatments than in the control. Therefore, the phosphite does not have a great influence on the growth, but it may play a role as a method of achieving balance with nitrogen in the rainy season by supplying the role of the material catalyst and the water soluble phosphoric acid and the potassium in the influence of the material change.