• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.5
• /
• pp.673-678
• /
• 2013

This paper considers the stability of linear systems having an interval time-varying delay using a switched system approach. The time-delay system is converted to the switched system equivalently, and then a stability criterion in the form of linear matrix inequality(LMI) is derived by using a parameter dependent Lyapunov-Krosovskii function(PD-LKF). In constructing a PD-LKF, the decomposition is employed for delay free intervals, and the reduction of conservatism is shown analytically as the number of decomposition increases. Finally, two well-known numerical examples are given to show the reduction of conservatism compared to the recent results.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.20 no.41
• /
• pp.103-112
• /
• 1997

In this paper, a nonhierarchial integrated information network with circuit switched and packet switched traffic is considered. It is assumed that circuit switched traffic is allowed to attempt an alternate path if the direct path is blocked, whereas packet switched traffic is not. The network uses a movable boundary scheme to allocate bandwidth dynamically. To analyze the performance of this type of network, EEBP(End to End Blocking Probability) is selected as a measure for circuit switched traffic and average time delay for packet switched traffic, respectively. EEBP and average time delay are derived analytically. Using the two proposed measure, the performance of the network under various bandwidth allocations and arrival patterns are observed. Moreover, the arrival rate of one link for circuit switched traffic is obtained from an approximation formula. Simulation results reveal the validity of the proposed approximation method.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.10
• /
• pp.1462-1470
• /
• 1989

This paper aims at investigating the Demand Assigned Multiple Access(DAMA) system for the packet-switched Satellite Communication. An onboard processor of the multisport beam satellite incorporates the ground controller to macimize the packet transmissions for each slot. 'Request Following' trnasmission mode is introduced as a transmission strategy of ground station under the control of its zone controller. The combined scheme of reservation channel access and contention channel access was proposed by Lee & Mark[3] for improving the Delay-Throughput performance. Our scheme provides less communication delay of approximately max. 200msec for achieving the corresponding throughput than the Lee & Mark's work does. Delay versus Throughput curves as well as Delay versus Traffic parameter curves are obtained. Numerical results obtained through the analysis and by the computer simulation show that the proposed scheme provides the low average packer delay even under the condition that the number of transponders (M)is below the half of the number of zones(N).

• ETRI Journal
• /
• v.22 no.3
• /
• pp.1-9
• /
• 2000

Self-Clocked Fair Queueing (SCFQ) algorithm has been considered as an attractive packet scheduling algorithm because of its implementation simplicity, but it has unbounded delay property in some input traffic conditions. In this paper, we propose a Rate Proportional SCFQ (RP-SCFQ) algorithm which is a rate proportional version of SCFQ. If any fair queueing algorithm can be categorized into the rate proportional class and input is constrained by a leaky bucket, its delay is bounded and the same as that of Weighted Fair Queueing (WFQ) which is known as an optimal fair queueing algorithm. RP-SCFQ calculates the timestamps of packets arriving during the transmission of a packet using the current value of system potential updated at every packet departing instant and uses a starting potential when it updates the system potential. By doing so, RP-SCFQ can have the rate proportional property. RP-SCFQ is appropriate for high-speed packet-switched networks since its implementation complexity is low while it guarantees the bounded delay even in the worst-case input traffic conditions.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.9A
• /
• pp.871-877
• /
• 2007

In this paper, we propose a new transmit diversity scheme using window functions in orthogonal frequency division multiplexing (OFDM) system. Transmit diversity of the scheme is varied with window functions and the condition of the window function to maximize transmit diversity is derived. The proposed scheme can be considered as a generalization of the diversity schemes such as cyclic delay diversity (CDD), orthogonal transmit diversity (OTD), and frequency switched transmit diversity (FSTD).

• Journal of Institute of Control, Robotics and Systems
• /
• v.9 no.1
• /
• pp.90-98
• /
• 2003

The real-time industrial network, often referred to as fieldbus, is an important element for building automated manufacturing systems. Thus, in order to satisfy the real-time requirements of field devices, numerous fieldbus protocols have been announced. But the application of fieldbus has been limited due to the high cost of hardware and the difficulty in interfacing with multi-vendor products. Therefore, as an alternative to fieldbus, the computer network technology, especially Ethernet (IEEE 802.3), is being adapted to the industrial environment. However, the crucial technical obstacle for Ethernet is its non-deterministic behavior that makes it inadequate for industrial applications where real-time data have to be delivered within a certain time limit. Recently, the development of switched Ethernet shows a very promising prospect for industrial application due to the elimination of uncertainties in the network operation resulting in much improved performance. This paper focuses on the application of the switched Ethernet for industrial communications. More specifically, this paper presents an analytical and experimental performance evaluation of the switched Ethernet and a case study about networked control system.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.4
• /
• pp.388-396
• /
• 2005

SRM has not been put into practical applications widely because of its large torque ripple, acoustic noise and low power factor. In addition, a traditional position sensor is needed for the drive control. So we propose an improved sensorless drive method of Switched Reluctance Motors using impressed voltage pulses. Conventional impressed voltage pulse method has a problem of phase delay because of low-pass filter. So in this paper we propose an unproved sensorless driving method based on the impressed voltage pulse using new pulse-shift circuit technique that overcomes the phase delay and start-up problem. Proposed method is implemented in a simple analog circuit instead of using an expensive DSP.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.1
• /
• pp.15-24
• /
• 2012

In this paper, we suggest the dynamic-response-free SMPS using a new high-resolution DPWM generator based on switched-capacitor delay technique. In the proposed system, duty ratio of DPWM is controlled by voltage slope of an internal capacitor using switched-capacitor delay technique. In the proposed circuit, it is possible to track output voltage by controlling current of the internal capacitor of the DPWM generator through comparison between the feedback voltage and the reference voltage. Therefore the proposed circuit is not restricted by the dynamic-response characteristic which is a problem in the existing SMPS using the closed-loop control method. In addition, it has great advantage that ringing phenomenon due to overshoot/undershoot does not appear on output voltage. The proposed circuit can operate at switching frequencies of 1MHz~10MHz using internal operating frequency of 100 MHz. The maximum current of the core circuit is 2.7 mA and the total current of the entire circuit including output buffer is 15 mA at the switching frequency of 10 MHz. The proposed circuit has DPWM duty ratio resolution of 0.125 %. It can accommodate load current up to 1 A. The maximum ripple of output voltage is 8 mV. To verify operation of the proposed circuit, we carried out simulation with Dongbu Hitek BCD $0.35{\mu}m$ technology parameter.

• Current Optics and Photonics
• /
• v.7 no.3
• /
• pp.297-303
• /
• 2023

In this paper, we demonstrated a high-energy (285 mJ) mid-infrared flashlamp-pumped electro-optically 𝚀-switched Er:YAG master oscillator power amplifier (MOPA) system and comprehensively investigated its temporal, spectral, and spatial characteristics. To increase the output energy, we optimized the delay between the timings at which the flashlamps of the master oscillator and power amplifier were triggered. In addition, the output energy was improved while minimizing thermal effects by cooling the MOPA system to a temperature slightly above the dew point. Consequently, the MOPA structure boosted the output energy without damaging the lithium niobate Pockels cell, which is a crucial element in 𝚀-switching. This design realized pulses with energies up to 0.285 J and pulse durations of approximately 140 ns at a wavelength of 2,936.7 nm. This high-energy mid-IR Er:YAG MOPA system can be used for various scientific, engineering, and military underwater applications.

• International Journal of Control, Automation, and Systems
• /
• v.5 no.5
• /
• pp.492-500
• /
• 2007

This paper focuses on the problem of guaranteed cost control for a class of uncertain linear delay systems with actuator failures. When actuators suffer "serious failure" the never failed actuators can not stabilize the system, based on switching strategy of average dwell time method, under the condition that activation time ratio between the system without actuator failure and the system with actuator failures is not less than a specified constant, a sufficient condition for exponential stability and weighted guaranteed cost performance are developed in terms of linear matrix inequalities (LMIs). Finally, as an example, a river pollution control problem illustrates the effectiveness of the proposed approach.