• 한국초전도ㆍ저온공학회논문지
• /
• 제7권1호
• /
• pp.21-24
• /
• 2005

The problem of fluctuation-induced digital errors in a rapid single flux quantum (RSFQ) circuit has been very important issue. So in this experiment, we calculated error rate of RSFQ switch in superconductiyity ALU, The RSFQ switch should have a very low error rate in the optimal bias. We prepared two circuits Placed in parallel. One was a 10 Josephson transmission lines (JTLs) connected in series, and the other was the same circuit but with an RSFQ switch placed in the middle of the 10 JTLs. We used a splitter to feed the same input signal to the both circuits. The outputs of the two circuits were compared with an RSFQ XOR to measure the error rate of the RSFQ switch. By using a computerized bit error rate test setup, we measured the bit error rate of 2.18$\times$$10^{12}$ when the bias to the RSFQ switch was 0.398mh that was quite off from the optimum bias of 0.6mA.

• 한국전자파학회논문지
• /
• 제22권9호
• /
• pp.847-851
• /
• 2011

본 논문에서는 입력 신호의 진폭과 위상을 미세 조정할 수 있는 새로운 IQ 변조기를 제안하였다. 제안된 IQ 변조기는 저위상 편차 감쇠기, 분배기, 그리고 결합기로 구성되어 있다. 기존 감쇠기의 위상 편차 특성을 극복하기 위한 새로운 위상 보상 기술을 사용하였고, 이를 수식적으로 분석하였다. 제안하는 IQ 변조기를 통하여 완전한 $360^{\circ}$의 위상 조정과 동시에 입력 신호의 큰 진폭 조정이 가능하며, 극좌표계의 중심점을 지나는 선형적인 IQ신호 배열을 구현하였다.

• Journal of the Optical Society of Korea
• /
• 제13권2호
• /
• pp.245-250
• /
• 2009

We propose a digital holographic interference analysis method based on a 2-frame phase-shifting technique for measuring an optical mirror surface. The technique using 2-frame phase-shifting digital interferometry is more efficient than multi-frame phase-shifting techniques because the 2-frame method has the advantage of a reduced number of interferograms, and then takes less time to acquire the wanted topography information from interferograms. In this measurement system, 2-frame phase-shifting digital interferograms are acquired by moving the reference flat mirror surface, which is attached to a piezoelectric transducer, with phase step of 0 or $\pi$/2 in the reference beam path. The measurements are recorded on a CCD detector. The optical interferometry is designed on the basis of polarization characteristics of a polarizing beam splitter. Therefore the noise from outside turbulence can be decreased. The proposed 2-frame algorithm uses the relative phase difference of the neighbor pixels. The experiment has been carried out on an optical mirror which flatness is less than $\lambda$/4. The measurement of the optical mirror surface topography using 2-frame phase-shifting interferometry shows that the peak-to-peak value is calculated to be about $0.1779{\mu}m$, the root-mean-square value is about $0.034{\mu}m$. Thus, the proposed method is expected to be used in nondestructive testing of optical components.

• Progress in Superconductivity
• /
• 제7권1호
• /
• pp.36-40
• /
• 2005

The problem of fluctuation-induced digital errors in a rapid single flux quantum (RSFQ) circuit has been a very important issue. In this work, we calculated the bit error rate of an RSFQ switch used in superconductive arithmetic logic unit (ALU). RSFQ switch should have a very low error rate in the optimal bias. Theoretical estimates of the RSFQ error rate are on the order of $10^{-50}$ per bit operation. In this experiment, we prepared two identical circuits placed in parallel. Each circuit was composed of 10 Josephson transmission lines (JTLs) connected in series with an RSFQ switch placed in the middle of the 10 JTLs. We used a splitter to feed the same input signal to both circuits. The outputs of the two circuits were compared with an RSFQ exclusive OR (XOR) to measure the bit error rate of the RSFQ switch. By using a computerized bit-error-rate test setup, we measured the bit error rate of $2.18{\times}10^{-12}$ when the bias to the RSFQ switch was 0.398 mA that was quite off from the optimum bias of 0.6 mA.

• 조명전기설비학회논문지
• /
• 제28권8호
• /
• pp.6-13
• /
• 2014

In this paper, a multiwavelength-switchable first-order fiber flexible filter is newly proposed, which is based on a polarization-diversity loop. The proposed filter consists of a polarization beam splitter, three half-wave plates(HWPs), and two high birefringent fibers(HBFs). The proposed filter has a good flexibility in adjusting relative angular difference between the principal axes of two HBFs by inserting an HWP between two HBFs. The first-order flat-top or narrow band transmission spectra and the zeroth-order transmission spectra, which had a channel spacing of ~0.8nm, could be obtained by controlling the three HWPs, and, in particular, each of them could also be interleaved. In addition, zeroth-order transmission spectra with a channel spacing of ~0.8nm could be flexibly converted into those with a channel spacing of ~0.4nm through the control of three HWPs, and also be interleaved. The transmission characteristics of the proposed filter was theoretically analyzed and experimentally verified.

• 한국안전학회지
• /
• 제32권5호
• /
• pp.135-140
• /
• 2017

This study deals with the safety of roundabout. The purpose of this study is to analyze the factors affecting the pedestrian accidents of roundabout near schools. In pursuing the above, this study gives particular attentions to comparatively analyzing the pedestrian accident by number of entry and circulatory lane. The traffic accident data from 2013 to 2015 are collected from TAAS data set of Road Traffic Authority. To develop the pedestrian accident model, the Poisson and negative binomial models has been utilized in this study. Such the dependent variable as the number of pedestrian accidents and the 24 independent variables as geometry, traffic volume and others are used. The main results are as follows. First, 3 Poisson and 2 negative binomial models(${\rho}^2$ of 0.153~0.426) which are all statistically significant are developed. Second, the common variable of models based on the number of circulatory roadway lane is analyzed to be the entry lane width and that of the number of entry lane is evaluated to be the design speed. Also specific variables are evaluated to splitter island, roundabout sign, number of approach road, bus stop and elementary school. Finally, the design speed might be expected to decrease the number of pedestrian accidents near schools.

• 대한기계학회논문집B
• /
• 제23권6호
• /
• pp.722-733
• /
• 1999

The wall pressure fluctuations of a turbulent boundary layer over a flat plate have been investigated in an anechoic wind tunnel facility. The anechoic wind tunnel consists of acoustically-lined duct, muffler, and splitter-type silencer for noise suppression and vanes for reducing head losses involved. To improve spectra characteristics in high frequency range, a 1/8" pressure-type microphone sensor, which has a pin-holed cap of various diameters, was employed in this experiment. It was shown that the pin-holed microphone sensor with a dimensionless diameter $d^+$ of 7.1 resolved the high frequency pressure fluctuations most effectively among ones with various pin-hole diameters. The measured wall pressure spectra in terms of three types of scaling parameters were in good agreement with other experimental and numerical results. The pressure events of high amplitude were found to contribute to total fluctuating pressure energies in the turbulent boundary layer significantly and supposed to radiate to the far-field effectively.

• 한국콘텐츠학회논문지
• /
• 제16권3호
• /
• pp.43-51
• /
• 2016

본 논문에서는 실시간 방송 및 스마트 미러 등과 같은 사용자 개인 또는 다른 사용자들과의 상호 작용이 가능한 인터렉티브 텔레프롬프터의 개념을 소개, 논의하고 실제 제작 사례를 제시한다. 이 적용 분야에서는 사용자 자신 또는 사용자와 제3자 사이의 시선의 일치가 심리적인 측면과 비음성적 커뮤니케이션에서 중요한 역할을 차지한다. 그러나 일반적인 모니터와 카메라의 조합만으로는 실제 거울을 보는 것과 같은 시선 일치를 구현하기가 쉽지 않기 때문에, 기존 방송 현장에서 널리 사용하는 텔레프롬프터의 원리를 응용한다. 제안하는 설계에서는 기존 방식과는 달리 깊이 정보를 통한 제스처 인식까지 구현하며 가시광선 정보와 적외선 정보 각각의 효율적인 처리를 위해서 텔레프롬프터에서 핵심적인 역할을 담당하는 빔 스플리터의 설계 사례와 실험 결과를 제시한다.

• 한국전산유체공학회지
• /
• 제18권1호
• /
• pp.36-42
• /
• 2013

The performance of the wind turbine is determined by wind speed and unsteady flow characteristics. Unsteady wake flow causes not only the decline in performance but also structural problems of the wind turbine. In this paper, conceptual designs for the wind turbine tower are conducted to minimize unsteady wake flow. Numerical simulations are performed to inspect the shape effect of the tower. Through the installation of additional structures at the rear of the tower, the creation of Karman vortex is delayed properly and vortex interactions are reduced extremely, which enhance the stability of the wind turbine. From the comparative analysis of lift and drag coefficients for each structure, it is concluded that two streamwise tips with a splitter plate have the most improved aerodynamic characteristics in stabilizing wake flow.

• Journal of the Optical Society of Korea
• /
• 제4권1호
• /
• pp.7-10
• /
• 2000

The soft x-ray(10nm-100nm) interferometer is a modified Mach-Zehnder type interferometer and it consists of two beam-splitters and four totally reflecting mirrors. The beam-splitters used here are 50% transmission and 50% reflection grating type. The diffraction patterns of beam splitters(1st B.S.) were investigated with a He-Ne laser. The diffraction patterns produced by the soft x-ray interferometer (2nd B.S.) were also investigated in intensities positions. The diffraction patterns of 20 degree grazing incidence on the beam splitters(1st B.S.) show a circular array of spots. Both the reflected and the transmitted beams show the same patterns but symmetric circles on the screen. The maximum intensity appears roughly when n is in the zeroth and odd orders and the suppressed peak(missing order) appears when n is in even orders. Intensities of 3 center fringes(n = 0, $\pm$1) are stronger than others. These results confirm the reduced grating equation and make agree with the intensity distribution function. It was found that the final patterns produced by the soft x-ray interferometer (2nd B.S.) consisted of fine fringes which were caused by two of three diffraction beams that were arrived at the second beam-splitter.