• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.143-144
• /
• 2003

The growth characteristics of Spirulina Platensis was carried out in photo bubble bioreactor at different nitrogen soucres and concentration. The result showed that S. Platensis grew well at sodium nitrate source rather than urea source in relatively high concentration region.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.208-211
• /
• 1999

Abstract - Electrical characteristics or asymmetric n-MOSFET's with different source and drain geometry are experimently investigated using test structures having various gate width. Saturation drain current and resistance in linear region are estimated by a simple schematic model, which consists of conventional device having parasitic resistor. A comparison of experimental results of symmetric and asymmetric devices gives the parasitic resistance caused by abnormal device structure. The suggested model shows good agreement with the measured drain current for both forward- and reverse-modes.

• Journal of Environmental Science International
• /
• v.18 no.8
• /
• pp.927-932
• /
• 2009

Wind turbine noise become main environmental problem as wind energy have been installed all around. Noise from large wind turbine give annoyance to listener, moreover it increase loading to whole system by restricting blade tip speed. However accurate noise mechanism of wind turbine is not yet examined. This paper reviewed noise source and analysis theory. Broadband noise if main component of wind turbine noise and airfoil self noise is main noise source. These make acoustic analogy hard to apply for analysis. For this reason, experimental equation is method for wind turbine noise prediction up to now. Spectrum analysis shows that vortex shedding noise exists around $1k{\sim}2k$ Hz. This region is most sensitive frequency range to human. Thus it is necessary to reduce this noise source.

• The Korean Journal of Quaternary Research
• /
• v.21 no.2
• /
• pp.77-79
• /
• 2007

The source regions of Asian Dusts (Yellow Sands) in the western part of China are investigated, and the soil samples are collected samples for approximately 15 days during the spring of 2005. Particle sizes of sediments are analyzed and compared with each other. These grain-size analyses from the source areas can be compared Particle sizes between loess deposits and desert sands in western part of China and desert areas show distinctive differences. Loess deposits are predominantly composed of fine sands and silts. The distinction between the final characteristics of Asian Dust particles arrived in Korea and characteristics during transportation can be recognized comparison with the Asian Dust particles collected where the dust particles settled down. The characteristics of Asian Dust particle sizes can provide the basic information regarding the transportation history from the source region.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.25 no.6
• /
• pp.459-466
• /
• 2005

The scanning laser source (SLS) technique has been proposed recently as an effective way to investigate small surface-breaking defects, By monitoring the amplitude and frequency changes of the ultrasound generated as the SLS scans over a defect, the SLS technique has provided enhanced signal-to-noise performance compared to the traditional pitch-catch or pulse-echo ultrasonic methods, An extension of the SLS approach to map defects in microdevices is proposed by bringing both the generator and the receiver to the near-field scattering region of the defects, To facilitate near-field ultrasound measurement, silicon microcantilever probes are fabricated using microfabrication technique and their acoustical characteristics are investigated, Then, both the laser-generated ultrasonic source and the microcantilever probe are used to monitor near-field scattering by a surface-breaking defect.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.2
• /
• pp.741-751
• /
• 1996

The coupled conduction and convection heat transfer from the protruding heat source in a vertical channel is numerically investigated. Conjugate solution of the two-dimensional energy equation is obtained for the incompressible air flow over the rectangular block with local heat source. It was found that several recirculation zones and separation bubble near the block were related to Re and Gr. And the results show that fractions of the heat transfer through each of the block face, maximum temperature of the block and the relative effect of each parameter on the maximum temperature and heat transfer.

• Electrical & Electronic Materials
• /
• v.8 no.5
• /
• pp.626-632
• /
• 1995

In this paper, The effect of the impedances in SNOSFET's memory devices has been developed. The effect of source and drain impedances measured by means of two bias resistances - field effect bias resistance by inner region, external bias resistance. The effect of the impedances by source and drain resistance shows the dependence of the function of voltages applied to the gate. It shows the differences of change in source drain voltage by means of low conductance state and high conductance state. It shows the delay of threshold voltages. The delay time of low conductance state and high conductance state by the impedances effect shows 3[.mu.sec] and 1[.mu.sec] respectively.

• Current Optics and Photonics
• /
• v.2 no.6
• /
• pp.563-567
• /
• 2018

We propose and experimentally demonstrate a simple tunable photonic microwave band-pass filter with high resolution using a reflective semiconductor optical amplifier (RSOA) and an optical time-delay line. The RSOA is used as a gain medium for generating cross-gain modulation (XGM) effect as well as an optical source. The optical source provides narrow spectral width by self-injection locking the RSOA in conjunction with a partial reflection filter with specific center wavelength. Then, when the RSOA is operated in the saturation region and the modulated recursive signal is injected into the RSOA, the recursive signal is inversely copied to the injection locked optical source due to the XGM effect. Also, the tunability of the passband of the proposed microwave filter is shown by controlling an optical time-delay line in a recursive loop.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.6B
• /
• pp.641-649
• /
• 2006

The behavior of a three-dimensional pure rectangular water jet with aspect ratio of 10 was experimentally investigated based on the results of the mean velocity field obtained by PIV. The saddle back distribution was observed in the lateral distribution along the major axis. The theoretical centerline velocity equation derived from the point source concept using the spreading rate for the axisymmetric jet was in good agreement with the measured centerline velocity and gave the division of the potential core region, two-dimensional region, and axisymmetric region. The range of the two-dimensional region divided by the criterion of the theoretical centerline velocity decay for the aspect ratio of 10 was observed to be smaller than that of the transition region. The applicability of the two-dimensional model to the behavior of the rectangular jet with low aspect ratio or the wastewater discharged from a multiport diffuser in the deep water of real ocean may result in significant error in the transition and axisymmetric regions after the two-dimensional region. In the two-dimensional region, the Gaussian constant tended to be conserved, and the spreading rate slightly decreased at the end of the two-dimensional region. The normalized turbulent intensity along the centerline of the jet initially abruptly increased and showed relatively higher intensity for higher Reynolds number.

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.227-230
• /
• 1999

Rigorous formulation for solving the scattered fields by a lossy dielectric wedge is proposed. By employing the Kirchhoff's integrals in the physical domain and the extinction theorem in the mathematically complementary region, it is shown that the accurate solution is obtained by adding the numerically corrected fields generated by the multipole source expansions to the analytically approximated physical optics solution. Its accuracy is affirmed by the extinction behavior of the solution in the complementary region.