• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.8
• /
• pp.119-125
• /
• 1995

Strained multiple quantum well(SMQW) PBH-DFB-LDs emitting at 1.55$\mu$m wavelength has been fabricated using OMVPE and LPE crystal growth tecnique. Using the SMQW active layer, a linewidty enhancement factor of 2.65 was obtained at lasing wavelength and consequnently, packaged 42 modules showed a very low average chirp of 0.44nm at 2.5Gbps NRZ direct modulation. The 77 devices showed average threshold current of 8.72mA and average slope efficiency of 0.181 mW/mA, and single longitudinal mode operation with SMSR larger than 30dB up to 5mW. Among the 77 devices, standard deviation of lasing wavelength of 3.57nm was obtained owing to a good crystal growth uniformity.

• Journal of Industrial Technology
• /
• v.26 no.A
• /
• pp.95-99
• /
• 2006

In this paper, we proposed the new wavelength tunable filter for wide tunability of fiber ring laser. The proposed filter consists of the cascaded connection of Fiber Reflection Mach-Zehnder Interferometer and Sagnac filter or of hybrid filter and Fiber Reflection Mach-Zehnder Interferometer. The simulation shows that the continuous tunable range of 50nm can be obtained and that more stable single mode operation of ring laser can be expected due to narrow FWHM. of filter spectrum.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.5 no.6
• /
• pp.560-567
• /
• 2000

A soft-switching PFC-Inverter for using AC motor drive such as the inverter air-conditioner with single phase medium size is proposed. In order to improve the power factor and the efficiency, in this paper, the ZVT topoloty in the conventional PFC-Inverter is adopted. So, the operation mode of the proposed ZVT PFC-Inverter is analyzed and the optimum circuit is designed. At last, the PSPICE, PSIM simulation and experiment results are presented in order to verify the validity of the proposed circuit.

• Journal of the Optical Society of Korea
• /
• v.20 no.3
• /
• pp.335-342
• /
• 2016

We demonstrate an optical asynchronous transfer mode/wavelength division multiplexing (OATM/WDM) optical access network, using a router based on an optical header decoder to conduct next-generation communications. The router consists of a decoder or hardware analysis processing of the header bit and switches. The router in the OATM/WDM optical access network is a key technology by which to satisfy subscribers’ requests, including reliability, cost efficiency, high speed, large-capacity transmission, and elevated information security. In this study, we carry out experiments in which a header decoder delivers to 16 and 32 subscribers with a single wavelength in the router. These experiments confirm the decoder’s successful operation via hardware using 4 and 5 header bits. We propose that this system may significantly contribute toward the realization of an optical access network that provides high-quality service to subscribers of next-generation communications.

• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.68-71
• /
• 2003

An output multiplexer of manifold type is widely employed in a recent satellite transponder due to its small size and mass. For correct operation, channel fillers in manifold multiplexer must be singly terminated. In this paper, a simple synthesis method fur a single terminated filter is described. From the given method, a 4-pole singly terminated elliptic function filter for Ka band satellite transponder is designed. The filter is shown to be suitable for satellite application and its measured results agrees well with computed ones.

• Journal of Institute of Control, Robotics and Systems
• /
• v.3 no.3
• /
• pp.280-288
• /
• 1997

In this paper, we will show that the torque ripple in closed-loop drives of permanent magnet stepping motors is reduced as properly selected lead angle control method. We propose an instantaneous torque equation, which is the function of lead angle, to estimate the influence on torque ripple. We design a closed-loop lead angle control system based on the proposed instantaneous torque equation and measure the instantaneous torque in various excitation modes. It is shown that torque ripple is greatly reduced, as seen from the experimental results as well as from the computer simulation results. For example, torque ripple reduced from 78.25% to 46.82% in the case of 50 PPS single-phase excitation mode operation.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.6
• /
• pp.51-57
• /
• 1997

Low-voltage, low-power gm-C filter utilizing newly dveloped operational transconductance amplifier (OTA) is described in this paper. The OTA has only two MOS transistors in saturation region between $V_{DD}$ and GND, and thus low voltage operation is possible. To improve the linearity, the OTA is made differential. Common mode feedback, essential in differential circuit, requires no additional implemented in $0.8\mu\textrm{m}$ CMOS process, and the center frequency can be controlled from 15MHz with 3.0V single power supply.

• Journal of the Optical Society of Korea
• /
• v.8 no.1
• /
• pp.13-16
• /
• 2004

A widely tunable SG-DFB (Sampled Grating Distributed Feedback) laser diode is proposed and its feasibility is confirmed through simulation. The new SG-DFB laser diode is composed of a pair of sampled gratings, some parts of which are gain sections and the other parts of which are phase control sections. It is shown that a few tens of nanometers can be tuned through the adjustment of two currents into the phase control sections. Higher output power is expected compared with a SG-DBR laser diode with similar parameters. The dynamic single mode operation is also observed in the time-domain simulation.

• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.1211-1213
• /
• 2003

A pulse width modulation(PWM) method for single-phase Sepic-type rectifier is introduced in this paper. The characteristics of the proposed PWM system are high performance high power factor with low input current harmonic distortion. The proposed control method is based on the average-current-mode using the dedicated integrated circuit UC3854 this technique it is possible to implement a very simple control circuit for unitary power-factor in CCM operation and also to provide over-current protection.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.5
• /
• pp.1527-1536
• /
• 2014

This paper investigates the optimal values of turn-on and turn-off angles, and ratio of flux linkage at turn-off angle and peak phase current positions of optimal control for accomplishing maximum output power in an 8/6 Switched Reluctance Generator (8/6 SRG). Phase current waveform is analyzed to determine optimal excitation angles (optimal turn-on and turn-off angles) of the SRG for maximum output power which is applied from a nonlinear magnetization curve in terms of control variables (dc bus voltage, shaft speed, and excitation angles). The optimal excitation angles in single pulse mode of operation are proposed via the analytical model. Simulated and experimental results have verified the accuracy of the analytical model.