• Transactions on Electrical and Electronic Materials
• /
• 제12권4호
• /
• pp.152-155
• /
• 2011

This paper presents a comparative analysis on step and the touch voltages generated by either a sine and a ring wave voltage generator; this analysis was done as a basic study in order to develop a small and lightweight ground meter. A ring wave generator using pulsed power technology was fabricated; an experimental grounding system specified in Institute of Electrical and Electronics Engineers standards 80 and 81 was installed. The step and the touch voltages, which were measured using comparable a sine and a ring waves in terms of magnitude and frequency, were equal. Using pulsed power technology, the weight of the fabricated ring wave generator could be reduced to one-fifth of that of a sine wave generator. Consequently, if a ground meter adopts the ring wave instead of a sine wave, it will be possible to reduce the weight of a ground meter and improve the efficiency of measurement.

• 센서학회지
• /
• 제24권6호
• /
• pp.398-403
• /
• 2015

In this paper, the sine-wave and trigger pulse generator with capability of frequency high-resolution and time-variable trigger edge has implemented. It fulfills well the requirements for SS-OCT with frequency resolution of 1 Hz, frequency stability of ${\leq}{\pm}0.03Hz$ and time-variable trigger edge. Through its performance test applied to the wavelength swept laser, 90 nm, sweeping range and 10mW average optical power were obtained. This showes that the realized generator can replace the commercial high cost and high performance signal generators employed by current SS-OCT systems.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2004년도 ICCAS
• /
• pp.277-281
• /
• 2004

The following paper proposes the new design of digital sine wave generator which allows users to define the phase shift of the out put sinewave according to user's demands. This new sinewave generator will have 2 outputs, cos(${\omega}_0n$) and cos(${\omega}_0n$+${\phi}$) The design of the new system starts from the construction of discrete time system with impulse response as cos(${\omega}_0n$) in a pair of conjugate complex poles and a pair of zeros at the origin and the real axis. If users want to make a phase shift of sign wave, users can change the position of zero at the real axis. The results of the experiment have shown that the new design of sign wave generator has generated sine wave with the correct phase shift according to the theory.

• ETRI Journal
• /
• 제26권6호
• /
• pp.657-660
• /
• 2004

We propose a fine phase tuner and a rounding processor for a numerically controlled oscillator (NCO), yielding a reduced phase error in generating a digital sine waveform. By using the fine phase tuner presented in this paper, when the ratio of the desired sine wave frequency to the clock frequency is expressed as a fraction, an accurate adjustment in representing the fractional value can be achieved with simple hardware. In addition, the proposed rounding processor reduces the effects of phase truncation on the output spectrum. Logic simulation results of the NCO using these techniques show that the noise spectrum and mean square error (MSE) for eight output bits of a 3.125 MHz sine waveform are reduced by 8.68 dB and 5.5 dB, respectively, compared to those of the truncation method, and 2.38 dB and 0.83 dB, respectively, compared to those of Paul's scheme.

• 전기전자학회논문지
• /
• 제12권4호
• /
• pp.239-245
• /
• 2008

In this paper, a dc-dc power converter scheme with the FPGA based technology is proposed to apply for solar power system which has many features such as the good waveform, high efficiency, low switching losses, and low acoustic noises. The circuit configuration is designed by the conventional control type converter circuit using the isolated dc power supply. This new scheme can be more widely used for industrial power conversion system and many other purposes. Also, I proposed an efficient photovoltaic power interface circuit incorporated with a FPGA based DC-DC converter and a sine-pwm control method full-bridge inverter. The FPGA based DC-DC converter operates at high switching frequency to make the output current a sine wave, whereas the full-bridge inverter operates at low switching frequency which is determined by the ac frequency. As a result, we can get a 1.72% low THD in present state using linear control method. Moreover, we can use stepping control method, we can obtain the switching losses by Sp measured as 0.53W. This paper presents the design of a single-phase photovoltaic inverter model and the simulation of its performance.

• 전자공학회논문지SC
• /
• 제43권6호
• /
• pp.27-32
• /
• 2006

전기 저항식 습도 센서를 이용하여 온도 보상된 습도계를 개발하였다. 개발된 습도계는 사인파 발생기, 대수 변환기, 정류기, 그리고 증폭기로 구성되며, 사용된 센서의 선형화와 온도 보상을 수행한다. 습도계의 동작 원리를 제시하였고, 실험 결과들을 이용하여 이론적인 예측의 타당성을 증명하였다. 실험 결과는 습도계의 변환 감도가 약 24.8 mV/%RH이고 변환 특성의 선형 오차가 30에서 80 %RH의 상대습도 범위에서 17.2 %보다 작다는 것을 보여준다. 실험 결과는 또, 출력 전압의 온도 계수가 22에서 $40^{\circ}C$의 온도 범위에서 $10149ppm/^{\circ}C$ 이하라는 것을 보여준다.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2016년도 추계학술대회
• /
• pp.652-654
• /
• 2016

본 논문에서는 FPGA를 활용하여 SVPWM (Space Vector Pulse Width Modulation)방식의 정현파 BLDC 모터 구동 로직을 설계 및 구현하였다. Hall sensor를 이용한 BLDC 모터 구동 회로는 정현파 PWM 생성회로, 데드타임 회로 및 리드 앵글 생성 회로 등으로 구성 된다. 특히 PWM 생성 회로는 SVPWM방식을 이용하여 기존 정현파 PWM 대비 선형구간이 15.5% 증가된다. 설계한 회로는 VHDL을 이용하여 모의실험 하였으며 Xilinx Spartan-6 FPGA보드를 통하여 회로의 동작 및 성능을 검증하였다. 검증 결과 모터구동 전류의 THD (Total Harmonic Distortion)은 19.32% 로 기존 정현파 구동 회로 대비 우수한 특성을 보였으며 회전자 분해능은 $1.6^{\circ}$로 정밀 제어가 가능함을 확인하였다.

• 센서학회지
• /
• 제22권1호
• /
• pp.84-88
• /
• 2013

In this paper, the low price signal generator with capability of frequency high-resolution and variable sync pulse has implemented. It fulfils well the requirements for SS-OCT of the frequency resolution less than 1Hz, frequency stability of ${\leq}{\pm}0.5Hz$/10 min and variable sync pulse output timing. Through its performance test applied to wavelength swept laser, 120 nm sweeping range and 10 mW average optical power were obtained. This shows that the realized sine-wave generator can replace the commercial high cost and high performance signal generators employed by current SS-OCT systems.

• 전기학회논문지
• /
• 제67권7호
• /
• pp.816-823
• /
• 2018

The Auto-synchronizer is essential equipment for synchronizing a generator to the power system. It is performing that measurement of the magnitude, frequency and phase of the voltage signal of the power system and generator. It is important to select the appropriate measurement algorithm for preventing various problem such as mechanical stress and Electrical problem. Teager Energy Operator(TEO) and Discrete separation algorithm(DESA) is measurable the instantaneous parameters of a sine wave using 5 samples and can be measured at a fast and with a simple operation. Therefore it has many advantages in measuring the parameters. In this paper, it confirmed measurement results using matlab simulations when there are synchronized in order of frequency, magnitude. Also it presented methods using digital filters and sample intervals to improve accuracy.

• Journal of Power Electronics
• /
• 제15권4호
• /
• pp.939-950
• /
• 2015

A single-stage AC-AC converter has been designed for a wind energy conversion system (WECS) that eliminates multistage operation and DC-link filter elements, thus resolving size, weight, and reliability issues. A simple switching strategy is used to control the switches that changes the variable-frequency AC output of an electrical generator to a constant-frequency supply to feed into a distributed electrical load/grid. In addition, a modified random sinusoidal pulse width modulation (RSPWM) technique has been developed for the designed converter to make the overall system more efficient by increasing generating power capacity and reducing the effects of inter-harmonics and sub-harmonics generated in the WECS. The technique uses carrier and reference waves of variable switching frequency to calculate the firing angles of the switches of the converter so that the three-phase output voltage of the converter is very close to a sine wave with reduced THD. A comparison of the performance of the proposed RSPWM technique with the conventional SPWM demonstrated that the power generated by a turbine in the proposed approximately increased by 5% to 10% and THD reduces by 40% both in voltage and current with respect to conventional SPWM.