• Journal of the Korean Society of Safety
• /
• v.12 no.4
• /
• pp.108-113
• /
• 1997

Plate anchors are primarily used in the foundation construction of earth-supported and earth-retaining structures. In order to estimate uplift capacity as well as suction force of clay, model tests were peformed with respect to various embedment depths and two different moisture contents in the prepared saturated kaolinite. Further, suction effects on the ultimate uplift capacity, at the various embedment depths of anchor, were also taken into account. Test results show that ultimate uplift capacity including suction force increases from 4.2kg at H/D=1 upto 11.6kg at H/D=5 in K1 and from 2.3kg at H/D=1 upto 7.3kg at H/D=5 in K2 respectively. The ratio of $F_s/Q_n/$ decreases along with the increases in the embedment ratio. In general, mud suction force under the ultimate uplift capacity in kaolinite decreases or becomes constant along with the increase of the embedment ratio.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.4
• /
• pp.137-143
• /
• 2003

The initial condition of $\Delta \sigma_3 \;=\; \Delta u$ is used for analyzing the time dependent behavior of ground. This is based on the concept that the coefficient of pore water B is the unity on the condition of saturation. but some measured consolidation data in the field showed that the pore water pressure was not dissipated as time elapsed but it was maintained constant value or it's dissipation rate was slower than that of the predicted. and so the measured data of pore water pressure was not consistent with that of settlement. In this study, the rheological model for the pore water pressure behavior on undrained condition was induced and compared with the experiment data of the literature. The result showed that the suggested model was consistent well with the result of experiment, but the suggested model could not explain the effect of the decrease of void ratio according to consolidation.

• Geomechanics and Engineering
• /
• v.17 no.1
• /
• pp.69-79
• /
• 2019

This work presents an experimental study of the hydromechanical behavior of a natural swelling soil taken from Boumagueur region east of Algeria. Several pathological cases due to the soil shrinkage / swelling phenomenon were detected in this area. In a first part, the hydric behavior on drying-wetting paths was made, using the osmotic technics and saturated salts solutions to control suction. In The second part, using a new osmotic oedometer, the coupled behavior as a function of applied stresses and suction was investigated. It was shown that soil compressibility parameters was influenced by suction variations that an increase in suction is followed by a decrease in the virgin compression slope. On the other hand, the unloading slope of the oedometric curves was not obviously affected by the imposed suction. The decrease in suction strongly influences the apparent preconsolidation pressure, ie during swelling of the samples after wetting.

• Geomechanics and Engineering
• /
• v.32 no.1
• /
• pp.21-34
• /
• 2023

In order to analyze the effect of the cyclic lateral loading on the response of a pile-soil system, a full-scale single steel pile was subjected to one-way cyclic loading. The test pile was driven into a bi-layered soil consisting of a normally consolidated saturated clay overlying a silty sandy layer, the site being submerged by water up to one meter above the mudline in order to reproduce the conditions of an offshore pile foundation. The aim of this paper is to present the main results of interpretation of the cyclic lateral tests in terms of pile deflections, bending moment, and cyclic P-Y curves. From these latter an absolute secant reaction modulus E_AS,N was derived and a simple calculation model of the test single pile is proposed based on this modulus. Two applications of the proposed model are carried out, one with a 2D finite element modelling, and the second with a load transfer curves-based method.

• The Journal of Engineering Geology
• /
• v.15 no.1
• /
• pp.9-17
• /
• 2005

A set of soil samples were picked up from a failed slope formed by rainfall in limestone zone in Jangseong-gun, Jeonnam, Korea, to find out its physical and mechanical characteristics for this study, and variation of safety factor depending on slope inclination was defined by analysing slope stability affected by rainfall. Decomposed limestone soil in the research area is composed of quartz, orthoclase, gibbsite, geothite, etc., with specific gravity of 2.73, and this soil is included in SC by unified soil classification system. Calcium ingredient decreased remarkably during weathering at its mother rock. Coefficient of permeability is 2.56×10/sup -4/ cm/ sec, similar to its value of silty clay. Cohesion decreases remarkably from 3.0 t/ ㎡ to 0.72 t/ ㎡, and Φ value of internal friction angle tends to decrease as it turns to be saturated soil from partial saturated soil in the shear test. To analyze slope stability affected by rainfall, it is reasonable to seek seepage depth with reference to rainfall＊ intensity. In the slope stability analysis, when the seepage depth is the larger, its safety factor is the less, which makes the slope unstable. Comparing with minimum safety factor, 1.5 of cut slope in consideration of the seep-age line, safety factor is found to be satisfactory only when inclination of cut slope of decomposed limestone soil is more than 1：1.2 slope at least considering rainfall. It is also found that decrease of cohesion has great effect on decline of safety factor of slope while partial saturated soil turns to be saturated soil.

• Korean Journal of Soil Science and Fertilizer
• /
• v.33 no.6
• /
• pp.377-383
• /
• 2000

The composition of primary minerals of sand fractions and secondary minerals of clay fractions were investigated on the polder soils developed from alluvio-marine deposits near to Sapgyo-lake, constructed a sea dike across river estuary located in the west coast. The effects of a topographical sequence on the physico-chemical properties and mineralogical characteristics were evaluated using XRD, DTA, and TG with the chemical composition of $H^+$ saturated clays. Soils located on the seashore side were more silt fraction, higher pH and exchangeable cations than the others. The dominant minerals of soil parent materials are in the order of quartz, feldspars, micas, chlorite and amphibole. According to the greater distance from the lake, the amount of 1:1 minerals increased, but 2:1 minerals decreased. The dominant clay minerals of polder soils are kaolinite, vermiculite and illite. Hydroxy interlayer minerals are abundant in the clay fractions derived from the soil parent materials which have relatively low soil pH.

• Korean Journal of Soil Science and Fertilizer
• /
• v.39 no.1
• /
• pp.21-28
• /
• 2006

We investigated the mobilization of Cd, Pb, and Cr in two different soils in response to sorption capacities and competition for available sorption site while they moved under saturated water conditions. Two soil samples that were clay and sandy clay loam were collected within 20 cm from the upland surface. To do this, we used three different systems of heavy metal combinations such as single, binary, and ternary as solution phase. And then we observed the breakthrough curve (BTC) and elution as a function of pore volume by applying heavy metal solution and displacing K solution until these curves reached to maximum and minimum. The results showed that BTC and elution curves were not symmetric and it required more pore volumes with increasing species of heavy metals in solution phase, as well as longer tailings. Compared the areas over and under BTC and elution curve, relatively small amount of heavy metal was displaced by K even though there were differences in electronegativity among heavy metals. Conclusively, we assumed that heavy metals transport in soil could be influenced by soil physical nonequilibrium and chemical equilibrium in solution as far as there were more than two species of heavy metals existed.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.5
• /
• pp.428-435
• /
• 2015

Pedotransfer functions (PTFs) were developed for each soil horizon to estimate hydraulic characteristics of mountainous forest soils in South Korea. Twenty one dominant soil series from 8 soil catenae such as granite-originated catena and volcanic ash-originated catena were selected for the study; gravel contents of selected soils were 10% or lower. Saturated conductivity (Ks) was measured for each horizon in situ. Particle size distribution and organic matter content of each horizon were also determined. Based on correlation analysis with total data set, sand separate showed positive relationship with Ks ($r=0.24^*$) while clay separate had negative relationship with Ks ($r=-0.29^{**}$). The correlation coefficients of sand, clay, and organic matter content with Ks increased to $0.41^{**}$, $-0.67^{***}$, and $0.58^{***}$, respectively, using data from granite- or gneiss-originated catena with exception of volcanic ash-originated catena and sedimentary rock-originated catena. Determination coefficients of PTFs were 0.31 for A horizon, 0.25 for B, and 0.35 for C with all data set while those were 0.74 for A, 0.48 for B, and 0.54 for C. Organic matter was a dominant factor affecting Ks in A horizon but clay content was selected as the only factor influencing Ks in C horizon. It implies that PTFs should be developed with understanding characteristics of parent materials and horizons. Developed PTFs for granite- or gneiss-originated catena were following: A horizon: Log ($K_s{\times}10^7$) = -0.031C + 0.398OM + 3.49 B horizon: Log ($K_s{\times}10^7$) = -0.028C + 0.141OM + 4.05 C horizon: Log ($K_s{\times}10^7$) = -0.072C + 4.66 where C is clay separate (%) and OM is organic matter content ($g\;kg^{-1}$). The unit of Ks is cm $sec^{-1}$.

• Korean Journal of Agricultural Science
• /
• v.6 no.2
• /
• pp.125-133
• /
• 1979

The characteristics of landslides occurred in August 5, 1979 in pyeongchangkun were surveyed and indentified as follows. 1. Deep limestone regions. Distinct differences in soil texture between A1 and B horizon could be observed on soil profile, which is attributed to the clay illuviation. The clay illuvial horizon is supposed to be an important cause of large scale mudflows on middle slopes by the lubricant action of ground water flowing between top soil and subsoil. 2. Shallow limestone regions. Very shallow top soils (less than 50cm) laid on tilted bedrock stratification provide a proper condition of mass soil movement if the top soil is saturated and ground water flows between top soil and bedrock when concentrated heavy rainfalls shower. 3. Granite regions. Weathering granitic bedrock produces very coarse textured top soils which are very cohesionless and have many pores. Therefore, the soil has high infiltration ratio and is easy to be saturated by water and to be detached from the bedrock. The landslides abrase very severely both sides of gully with high potential energy when they flow down. The following methods for landslide prevention can be recommended. 1. The original parts of landslides on top of the gully must be treated by intensive planting of deep rooting species and check dams. 2. Clear-cutting and crop planting on steep slope (more than 25 degrees) should be controlled and prohibited. 3. Establishment of landslide prevention forest should be practised on proper site.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.1
• /
• pp.37-49
• /
• 2008

A geothermal heat pump system is a preferable alternative energy system in Korea because it uses the heat energy of the earth, which is environmentally friendly and inexhaustible. In order to characterize the thermal conductivity and viscosity of grout materials used for backfilling ground heat exchangers, nine bentonite grouts, one marine clay from Boryung, and cement grouts adapted in the United State have been considered in this study. The bentonite grouts indicate that the thermal conductivity and viscosity increase with the content of bentonite or filler (silica sand). In addition, material segregation can be observed when the viscosity of grout is relatively low. The marine clay turns out to be unsuitable for backfilling the ground heat exchanger due to its insufficient swelling potential. The saturated cement grouts appear to possess much higher thermal conductivity than the saturated bentonite grouts, and the reduction of thermal conductivity in the cement grouts after drying specimens is less than that in the case of the bentonite grouts. Maintaining the moisture content of grouts is a crucial factor in enhancing the efficiency of ground heat exchangers.