• Journal of Power System Engineering
• /
• v.14 no.6
• /
• pp.83-88
• /
• 2010

The wear behavior of epoxy matrix composites filled with nano sized silica particles is discussed in this paper. Especially, the variation of the coefficient of friction and the wear resistance according to the change of apply load and sliding velocity were investigated for these materials. Wear tests of pin-on-disc mode were carried out and the wear test results exhibited as following ; The epoxy matrix composites showed lower coefficient of friction compared to the neat epoxy through the whole sliding distance. As increasing the sliding velocity the epoxy matrix composites indicated lower coefficient of friction, whereas the neat epoxy showed higher coefficient of friction as increasing the sliding velocity. The specific friction work of both materials were increased with apply load. In case of the epoxy matrix composites, the running in periods of friction were reduced as increase in apply load. The epoxy matrix composites were improved the wear resistance by adding the nano silica particles remarkably. It is expected that the load carrying capacity of the epoxy matrix composites will be improved by increase of Pv factor.

• Journal of Forest and Environmental Science
• /
• v.33 no.4
• /
• pp.295-304
• /
• 2017

This study compared and analyzed the construction of a land use change matrix for the Intergovernmental Panel on Climate Change's (IPCC) land use, land use change, and forestry area (LULUCF). We used National Forest Inventory (NFI) permanent sample plots (with a sample intensity of 4 km) and permanent sample plots with 500 m sampling intensity. The land use change matrix was formed using the point sampling method, Level-2 Land Cover Maps, and forest aerial photographs (3rd and 4th series). The land use change matrix using the land cover map indicated that the annual change in area was the highest for forests and cropland; the cropland area decreased over time. We evaluated the uncertainty of the land use change matrix. Our results indicated that the forest land use, which had the most sampling, had the lowest uncertainty, while the grassland and wetlands had the highest uncertainty and the least sampling. The uncertainty was higher for the 4 km sampling intensity than for the 500 m sampling intensity, which indicates the importance of selecting the appropriate sample size when constructing a national land use change matrix.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.9 s.351
• /
• pp.31-37
• /
• 2006

Low-density parity-check (LDPC) codes are recently emerged due to its excellent performance. The standard for European high definition satellite digital video broadcast, DVB-S2 has adopted LDPC codes as a channel coding scheme. This paper proposes a DVB-S2 LDPC decoder architecture using a hybrid parity check matrix which is efficient in hardware implementation for both decoders and encoders. The hybrid H-matrices are constructed so that both the semi-random technique and the partly parallel structure can be applied to design encoders and decoders. Using the hybrid H-matrix scheme, the architecture of LDPC decoder for DVB-S2 can be very practical and efficient. In addition, we show a new Variable Node processor Unit (VNU) architecture to reuse the VNU for various code rates and optimized block memory placement to reuse. We design a DVB-S2 LDPC decoder of code rate 1/2 usng the proposed architecture. We estimate the performance of the DVB-S2 LDPC decoder and compare it with other decoders.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12A
• /
• pp.1185-1190
• /
• 2008

In this paper, we propose an simplified successive minimum mean square error ($S^{2}MMSE$) algorithm that can simplify the computational complexity for precoding matrix generation in the successive minimum mean square error (SMMSE) precoding method, which is adopted as a multiuser multiple-input multiple-output (MU-MIMO) precoding technique in the IST (information society technologies)-WINNER (wireless world initiative new radio) project. The original algorithm generates the precoding matrix by calculating all individual precoding vectors with each requiring its own MMSE nulling matrix, over all receive antennas for all users. In contrast, this proposed algorithm first calculates the MMSE nulling matrix for each user, and then calculates all precoding vectors for respective receive antennas of the corresponding user by using the identical MMSE nulling matrix, in which only a simple matrix-vector multiplication is required for each vector. Consequently, it can simplify significantly the computational complexity to generate a precoding matrix for SMMSE precoding.

• East Asian mathematical journal
• /
• v.28 no.5
• /
• pp.587-595
• /
• 2012

In this paper we consider the quadratic matrix equation which can be defined be $$Q(X)=AX^2+BX+C=0$$, where X is a $n{\times}n$ unknown real matrix; A,B and C are $n{\times}n$ given matrices with real elements. Newton's method is considered to find the skew-symmetric solvent of the nonlinear matrix equations Q(X). We also show that the method converges the skew-symmetric solvent even if the Fr$\acute{e}$chet derivative is singular. Finally, we give some numerical examples.

• Mass Spectrometry Letters
• /
• v.5 no.2
• /
• pp.49-51
• /
• 2014

The effectiveness of tertiary matrices composed of the combination of three common matrices (dihydrobenzoic acid (DHB), ${\alpha}$-cyano-4-hydroxycinnamic acid (CHCA), and sinapinic acid (SA)) was compared with that of single or binary matrices in the analysis of polyethylene glycol (PEG) polymers ranging from 1400 to 10000 Da using matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS). A tertiary matrix of 2,5-DHB+CHCA+SA was the most effective in terms of S/N ratios. CHCA and CHCA+SA produced the highest S/N ratios among the single matrices and the binary matrices, respectively. The improvement observed when using a tertiary matrix in analyses of PEG polymers by MALDI-TOF MS is believed to be due to the uniform morphology of the MALDI sample spots and synergistic effects arising from the mixture of the three matrix materials.

• Bulletin of the Korean Mathematical Society
• /
• v.51 no.6
• /
• pp.1615-1623
• /
• 2014

Let $G{\leq}S_n$ and ${\chi}$ be any nonzero complex valued function on G. We first study the irreducibility of the generalized matrix polynomial $d^G_{\chi}(X)$, where $X=(x_{ij})$ is an n-by-n matrix whose entries are $n^2$ commuting independent indeterminates over $\mathbb{C}$. In particular, we show that if $\mathcal{X}$ is an irreducible character of G, then $d^G_{\chi}(X)$ is an irreducible polynomial, where either $G=S_n$ or $G=A_n$ and $n{\neq}2$. We then give a necessary and sufficient condition for the equality of two generalized matrix functions on the set of the so-called ${\chi}$-singular (${\chi}$-nonsingular) matrices.

• Journal of KSNVE
• /
• v.8 no.3
• /
• pp.504-512
• /
• 1998

For analyzing the torsional vibration of a multiple stepped gear system containing a pair of triple gears, a transfer matrix model based on Hibner's branch method is developed and the natural properties of the branched rotor system are calculated with using the $\lambda$-matrix formulation. A Campbell diagram, in which the excitation sources caused by the mass unbalances of the rotors and the transmitted errors of thegearings are considered, shows that, at the neighborhood of the operating speed, there are the four critical speeds amplifying the first mode and the fifth mode. For the surpression of the gear box vibration, two ways are suggested by referring the mode shapes.

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.21-22
• /
• 2010

Matrix converter is direct power conversion system. Matrix converter has many merits that possible bidirectional power flow, input power factor own control and system without DC-link. But matrix converter has some demerits that need many switching devices and switching loss. This paper suggest optimal matrix converter control scheme for improvement for switching loss part. Proposed control scheme verified that 10% improvement in efficiency, input current's harmonic loss and output voltage's EMI improvement.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.12 no.1
• /
• pp.31-36
• /
• 1975

As the size of tanker increase, the analysis and strength prediction of the transverse web frames in a tanker have become important problems. Therefore, several papers dicussed the subject and various method of analysis have been presented. Most of these studies are based on the elastic framework analysis. Framework analysis is carried out by the matrix methods. The matrix methods used most frequently are the displacement method, force method and the transfer matrix method. In this paper, the analysis is carried out by the transfer matrix method. The program has been tested by IBM 1130 and the results of example show good agreements with those by the program of stress analysis, STRESS, which was developed in M.I.T.