• Plant Resources
• /
• v.6 no.2
• /
• pp.140-143
• /
• 2003

Allium wakegi Araki was grown at plant spacings of 5, 10, 15, and 20 cm to determine the effect of planting density on the growth and yield. Allium wakegi Araki plants grown at the 5 cm plant spacing had the lowest bulb diameter and bulb weight, while plants at the lowest density (20 cm spacing) had the highest bulb diameter, bulb number, bulb weight and fresh weight. In general, plants grown at narrower spacings produced significantly smaller bulb diameter and bulb weight, but resulted in the highest yields and plants per hectare and lower fresh weights per plant.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.63 no.4
• /
• pp.378-383
• /
• 2018

The goal of this study was to examine the growth and yield according to planting density in wide-row drill seeding cultivation suitable for mechanized harvesting. We evaluated effects depending on planting densities [row spacing (30, 40, 50, and 60 cm) and plant spacing (10, 15, and 20 cm)] and cultivars ('Hongeon' and 'Arari') on growth and yield of Adzuki Beans (Vigna angularis (Willd.) Ohwi Ohashi). When row spacing decreased, the stem length increased in 'Arari' but decreased in 'Hongeon.' The stem diameter and number of branches in both the cultivars decreased with a decrease in row spacing. The pod height increased with lower planting densities. The greatest height values recorded in 'Hongeon' and 'Arari' were 5.0 cm and 8.8 cm in $30{\times}10cm$ and $50{\times}10cm$ treatments, respectively. The number of pods and number of seeds in both cultivars tended to increase with a decrease in planting density. On the other hand, in 100-seed weight, there was a difference in planting density in 'Hongeon', but no difference in 'Arari'. The highest yield was at the planting density of $40{\times}15cm$ in both 'Hongeon' and 'Arari', $285kg{\cdot}10a^{-1}$ and $374kg{\cdot}10a^{-1}$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.5C
• /
• pp.498-504
• /
• 2009

A high-performance low-complexity decoding algorithm for LDPC codes is proposed in this paper, which has the advantages of both bit-flipping (BF) algorithm and sum-product algorithm (SPA). The proposed soft bit-flipping algorithm requires only simple comparison and addition operations for computing the messages between bit and check nodes, and the amount of those operations is also small. By increasing the utilization ratio of the computed messages and by adopting nonuniform quantization, the signal-to-noise ratio (SNR) gap to the SPA is reduced to 0.4dB at the frame error rate of 10-4 with only 5-bit assignment for quantization. LDPC codes with high column or row weights, which are not suitable for the SPA decoding due to the complexity, can be practically implemented without much worsening the error performance.

• Clinics in Shoulder and Elbow
• /
• v.5 no.2
• /
• pp.73-80
• /
• 2002

Purpose: Weight lifting is a good training to control body weight, to correct body shape and to relieve stress. How-ever if the training is continued by inadequate training method and technique, the risks of the shoulder injuries are relatively high. Main Subject: The rotator cuff injury is the most common disorder to wright lifters and often results from the train- ing program of upright row, military press and pectoral deck. The chances of subacromial impingement in these postures are high because the shoulder rotates under the acromion at 90 abduction state. Shoulder instability in weight lifters can develop due to various causes. aepeated microtrauma and excessive abduction and external rotation may result in laxity of the anterior capsular structure, ligament and muscles. Behind the neck and bench press are high risk training postures. Other than those injuries, idiopathic osteolysis of distal clavicle, acromioclavicular separation, pectoralis major muscle rupture, and triceps muscle rupture nay develop. Conclusion: The best treatment option of the shoulder injury to weight lifters is to eliminate the possible risk elements for the weight lifters in training program and to provide proper and prompt treatment as soon as possible.

• Food Science and Preservation
• /
• v.9 no.3
• /
• pp.282-286
• /
• 2002

This study was conducted to improve the storability of onion bulbs by loading method under room temperature and to reduce the rot caused by field open storage. Allium cepa cv. Changnyungdeago, late strain, was used for the test at the storage condition of 1-row-6-stairs, 2-rows-6-stairs, 4-rows-6-stairs, 1-rows-8-stairs, 2-rows-8-stairs, and 4-rows-8-stairs. The results obtained art as follows: The mean temperature was maintained lowly 1.6∼3.2$\^{C}$ in 1-row-6-stairs and 1.3∼2.6$\^{C}$ in 2-rows-6-stairs in contrast to 4-rows-8-stairs and the relative humidity was high when loading rows increased. The rotting rates in 1-row-6-stairs, 2-rows-6-stairs, 4-rows-6-stairs, 1-rows-8-stairs, 2-rows-8-stairs, and 4-rows-8-stairs were 11.4%, 11.6%, 12.4%, 14.6%, 13.9% and 16.6%, respectively, and became higher with increased rows and stairs of loading. Total weight loss of onion bulbs were l2.2%, 12.7%, 13.8%, 15.5%, 15.2% and 18.0% in 1-row-6-stairs, 2-rows-6-stairs, 4-rows-6-stairs, 1-row-8-stairs, 2-rows-8-stairs, and 4-rows-8-stairs, respectively. The rot of onion bulbs was caused mainly by Fusarium sp., Aspergilus sp., Botrytis sp., and bacteria.

• Journal of Bio-Environment Control
• /
• v.14 no.1
• /
• pp.7-14
• /
• 2005

This study was conducted to develop a chain conveyor-type, row-spacing system for a plant factory. The developed system was evaluated for its practical use in growing plants. Results are intended to provide technical suggestions on the row spacing for hydroponically grown vegetables in a plant factory. The designed row-spacing system for a plant factory could be adjusted by four stages with a conveying speed range of $5.3\~15.8cm{\cdot}s^{-1}$ and with a row-space range of 10-25cm. The torque of driving shaft was measured with a torque range of 11.7-33.3 N$\cdot$m according as a trough weight changes with a range of $17\~935$ N. A measured value was $5.9\~9.8\;N{\cdot}m$ lower than a theoretical value. Travel reduction rate was shown up $1.6\~1.9\%$. The conveying time of trough was shown up 2.24 seconds in case that the designed value was 2.26 seconds. The system was evaluated to be functioning effectively according to the initial design factors in the test.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.47 no.5
• /
• pp.368-373
• /
• 2002

The strip intercropping system has used due to many advantages. Many researches supported these crop systems are usually equal to or better than monoculture crop systems in both total production and profit. There was no research to examine the important ecological factors in the competition between crops. A strip intercropping system composed of adjacent narrow strips of corn, soybean, and oat/legumes has been investigated in Iowa, USA. This study conducted to investigate why and how the differences in soybean yield are produced and affected by light, one of the microclimate, of the strip intercropping system. In height, the two rows of soybean closest to corn were taller than the two rows near the then-empty oat strip. The height of each crop decreased as the amount of light received increased. Weight of plant parts was lowest in row 1, nearest corn, and highest in row 4, next to the vacant oat strip. Daily photon flux density(PFD) increased with increasing distance from corn, with the highest value occurring on the edge next to the empty oat strip. Analyses of the relationship between light and biomass of soybean showed that all biomass measurements had a positive relationship to total PFD per day except height.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.58 no.3
• /
• pp.267-273
• /
• 2013

We evaluated the morphological characteristics of 79 popcorn inbred lines, which were developed to breeding popcorn variety at Maize Experiment Station, Gangwon Agricultural Research and Extension Services, by examining ten quantitative and three qualitative characteristics. In the survey of 3 qualitative traits for 79 popcorn inbred lines, most inbred lines respectively showed purple (46 inbred lines) at tassel color (QL1), green (55inbred lines) at silk color (QL2) and green (75 inbred lines) at stem color (QL3). While, on the survey of 10 quantitative traits among 79 popcorn inbred lines, they showed the morphological variation in plant height (QN1, $174.2{\pm}34.9$ cm), ear height (QN2, $103.4{\pm}24.7$ cm), ear length (QN3, $9.4{\pm}3.0$ cm), kernel setting length (QN4, $8.4{\pm}2.6$ cm), ear thickness (QN5, $24.9{\pm}7.7$ mm), ear row number (QN6, $14.0{\pm}2.3$ number), ear weight (QN7, $36.5{\pm}26.0$ g), kernel weight (QN8, $30.9{\pm}19.3$ g), 100 kernel weight (QN9, $10.4{\pm}3.8$ g) and germination rate (QN10, $95.3{\pm}8.1%$), respectively. As a result, 5 inbred lines (PS0-001, PS0-003, PS1-002, PS1-003, PS2-009) in the 79 popcorn inbred lines have showed comparatively high values for the five quantitative traits. On the principal component analysis, silk color (QL2), ear length (QN3), kernel setting length (QN4), ear thickness (QN5), ear weight (QN7), kernel weight (QN8) and 100 kernel weight (QN9) greatly contributed in positive direction on the first principal components, whereas tassel color (QL1), stem color (QL3), ear height (QN2) and ear row number (QN6) contributed in negative direction on the first principal component. In addition, plant height (QN1), ear height (QN2), and kernel weight (QN8) contributed in positive direction on the second principal component, and also tassel color (QL1), silk color (QL2), ear length (QN3), ear row number (QN6) and 100 kernel weight (QN9) contributed in negative direction on the second principal component.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.9
• /
• pp.2041-2047
• /
• 2013

In this paper, we proposed high speed LDPC decoding algorithm based on DVB-S2 standard. For implementing the high speed LDPC decoder, HSS algorithm which reduce the iteration numbers without performance degradation is applied. In HSS algorithm, check node update units are update at the same time of bit node update. HSS can be accelerated to the decoding speed because it does not need to separate calculation of the bit nodes, However, check node calculation blocks need many clocks because of just one memory is used. Therefore, this paper proposed dc-split memory structure in order to reduced the delay and high speed decoder is possible. Finally, this paper presented maximum split memory and throughput for various coding rates in DVB-S2 standard.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.29 no.4
• /
• pp.409-415
• /
• 1984

Finding the variations of principal agronomic traits, fourteen malting barley cultivars were tested with both narrow-spaced row seeding and broadcasting on high ridge respectively. The seeding rates were varied as 15, 20, 25, 30 and 35 liter per 10a in the narrow-spaced row seeding and 20, 25, 30, 35, and 40 litre in the broad casting on his ridge respectively. As a result of the test, there were highly significant differences in variation pattern of assessed traits among cultivars. However, the additional seeding rates in both seeding methods caused the drifts of earlier heading and maturity, longer in culm length, linear increase in number of spike and yields per unit area, slight reduction in 1000 grain weight, and slight increase in one litre weight, but no changes in number of grain per spike.