• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2007.04a
• /
• pp.55-58
• /
• 2007

This study describes a problem of the Original Bench Mark which is used currently. We calculate New Mean Sea Level(MSL) in Incheon Port using tide data for 57 months and take 8 points GPS/Leveling data in research area. We calculate orthometric height of one control point using tide data and GPS/Leveling data. After fixed the control point, we decide final orthometric heights using relative geoidal height and ellipsoidal height from GPS survey. To analysis the Original Bench Mark compares final orthometric heights with the orthometric heights in Korea height system. We get the result that the New Original Bench Mark's height is 26.7176m. It appears 3.05cm difference as the Original Bench Mark's height is 26.6871cm in Korea height system.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.1
• /
• pp.71-74
• /
• 2002

The apparent barrier height for charge transfer through an interfacial water layer between a Pt/Ir tip and a gold surface has been measured using STM technique. The average thickness of the interfacial water layer inside an STM junction was controlled by the amount of moisture. A thin water layer on the surface was formed when relative humidity was in the range of 10 to 80%. In such a case, electron tunneling through the thin water layer became the majority of charge transfers. The value of the barrier height for the electron tunneling was determined to be 0.95 eV from the current vs. distance curve, which was independent of the tip-sample distance. On the other hand, the apparent barrier height for charge transfer showed a dependence on tip-sample distance in the bias range of 0.1-0.5 V at a relative humidity of approximately 96%. The non-exponentiality for current decay under these conditions has been explained in terms of electron tunneling and electrochemical processes. In addition, the plateau current was observed at a large tip-sample distance, which was caused by electrochemical processes and was dependent on the applied voltage.

• Journal of Forest and Environmental Science
• /
• v.33 no.2
• /
• pp.97-104
• /
• 2017

Investigation was carried out on response of Tetrapleura tetraptera (Schum. and Thonn.) to soil, water and light with the view of its domestication and introduction to different ecological regions. The experiment was arranged in a factorial experiment of $3{\times}3{\times}3$ in a completely randomized design (CRD) with three replicates. The factors were: soil textural class (Loamy sand, Sand and Sandy clay loam), watering regime (daily, twice a week and once a week) and light intensity (100%, 75% and 50%). Soil textural classes had significant influence on collar diameter, stem height, number of leaflets, root/shoot ratio and relative growth rate of Tetrapleura seedlings. Seedlings grown on loamy sand recorded the highest mean value- 2.28 mm for collar diameter, stem height- 12.9 cm, number of leaflets- 19.9, chlorophyll b- $0.34mg\;mL^{-1}$, leaf relative water content- 27.4% and relative growth rate- $0.037mg\;g^{-1}\;day^{-1}$. Watering regime had significant influence on the collar diameter of Tetrapleura. Seedlings watered daily recorded the highest mean value- 2.25 mm for collar diameter. Light intensity significantly influenced collar diameter and root/shoot ratio. Seedlings exposed to 100% light intensity recorded higher mean value for collar diameter- 2.28 mm and root/shoot ratio- 1.481 cm. The interaction between soil textural class and light intensity significantly affected collar diameter, stem height and number of leaflets. Higher mean value for collar diameter (2.47 mm) stem height (13.25 cm) and number of leaflets (21.16) were recorded while the interaction between soil textural class, light intensity and watering regime was significant for only number of leaflets. Tetrapleura exhibited some level of tolerance to different soil texture, drought and light intensity. Therefore, Tetrapleura has the potentials to be raised in different ecological zones characterized by difference in soil, rainfall and amount of sunshine.

• 한국터널공학회:학술대회논문집
• /
• 2005.04a
• /
• pp.233-247
• /
• 2005

Most tunnel lining material which has been used in the domestic is a concrete. But many problems as the construction period, the cost, and the crack occurrence for the design, construction, and management were happened in the concrete lining. For this reason, many research institutes like the Korea Highway Corporation recognize the necessity of an alternate material development and grow on the interest for that. So in this study, the seismic behaviour characteristics for the application of the Corrugated Steel Plate Lining in cut-and-cover tunnel are evaluated as several conditions for the backfill height, the cutting slope, and the relative density of backfill soil are changed. The compressive stress which is calculated in the Corrugated Steel Plate Lining by the seismic load is decreased as the backfill height increases and the cut slope grows gentle. Also, the moment shows the tendency of decrease according to the increase of the backfill height. But in the case of the relative density of the backfill soil is small, the moment increases according to the increase of the backfill height and affects the dynamic behaviour characteristic. So it is considered that the relative density of the backfill soil is also the important point. As the result in analyzing the seismic response characteristics of the reinforcement spacing of the Corrugated Steel Plate, the variation in the compressive force is hardly happened, but the moment and the shear force increase on the reinforcement spacing being narrow.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.7
• /
• pp.629-639
• /
• 2016

Batch process TRN(Terrain Relative Navigation) using an altimeter is a technique to correct position by correlating a series of periodically measured terrain height profile and terrain height candidate profile of the DEM(Digital Elevation Map). However, it is generally known that the performance of TRN is degraded when measured terrain height profile and terrain height candidate profiles of the DEM are similar at hill or repetitive terrain. In this paper, area based terrain slope roughness index[11] is applied and area based terrain curvature roughness index which can detect similarity of terrain in ROI(Region Of Interest) is proposed to overcome this problem. Applying terrain roughness indexes to terrain relative navigation system of lunar lander, it is shown that TRN using area based terrain roughness results in improved performance compared to conventional trajectory based method through simulation.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.6
• /
• pp.67-76
• /
• 2007

Raining method has been widely used for preparing sand specimen because of its ability to reconstitute the homogeneous specimen with desired relative density and its reliability established by the numerous experiments on diverse influential factors. In conventional raining methods, adjustment of relative density is achieved by controlling the shutter porosity and the whole system is required to be re-adjusted to achieve the target relative density when the granular characteristics are changed. It is also observed from conventional methods that certain degrees of spatial variation in density exist and the limited range of relative density is reproduced. In this paper, raining system with porous plate is proposed. It is shown that the wide range of relative density can be achieved by controlling failing height only. This enhanced system is able to obviate the subtle control of shutter porosity and minimize the effect of falling distance, which in turn ensures the homogeneity of the specimen, especially for low relative density.

• Journal of Ecology and Environment
• /
• v.36 no.3
• /
• pp.151-158
• /
• 2013

We estimated phenotypic selection on the height and number of flowering-stalks in a rosette annual Cardamine hirsuta by applying path analysis to the data collected at three natural populations located in central Japan. The path from rosette size was positively connected with the fruit production through the both height and number of flowering-stalks. In the all three populations, the paths from the number of stalks were more strongly connected with the fruit production than from the height of stalks. The paths from the rosette size showed similar magnitude with the number of stalks and the height of stalks. The direct path from rosette size to the fruit production was detected only at one site. These results suggest stronger phenotypic selection on the rosette size through the number of stalks than the height of stalks. The lateral branching rather than increment of individual inflorescence size is the major response to control the fruit production for C. hirsuta growing in a natural habitat.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.622-627
• /
• 2004

There are many difficulties in realizing Ultra-micro gas turbine system. Among them, the effects of tip clearance upon the micro turbine flowfield are discussed in this paper. The flowfield was investigated numerically with the Reynolds-averaged three-dimensional thin-layer Navier-Stokes equations. Calculations were conducted with clearance height from 0％ to 10% of the passage height. Leakage mass flow and deterioration of efficiency are proportional to the clearance height for the clearance height larger than 4%. However, in the case of 2% clearance, leakage flow is significantly reduced due to relative motion of the casing and as a result deterioration of efficiency is very small. It is difficult to control tip clearance in micro turbines, but the results of this study indicate that if the clearance height is controlled within a few per-cent of passage height, deterioration of stage performance will be small.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.10
• /
• pp.7138-7145
• /
• 2015

In this study, experiments were conducted to investigate the correspondence between the output voltage of the photoelectric sensor and the frost height under heating and defrosting capacity test condition (dry bulb temperature $2^{\circ}C$, wet bulb temperature $1^{\circ}C$) described at KS C 9306, where a real heat exchanger was used as a test rig instead of a large-scale model. A digital microscope and a photoelectric sensor unit consisting of an emitter and a transistor (receiver) were installed in the front of it. A linear correlation is proposed to predict the frost height based on 150 experimental data, approximately 54% of the measured data are consistent with the predicted frost heights within a relative deviation of ${\pm}10%$, it yields good agreement with 90% of the measured data when the frost height larger than 0.3mm with in a relative deviation of ${\pm}10%$. Compared with Xiao's correlation, the slope namely, the change of frost height in accordance with the change of output voltage is consistent within the error of 2.3%. But vertical intercept shows big difference with Xiao's correlation, because it was developed with a large scale model instead of a real heat exchanger.

• Journal of Preventive Medicine and Public Health
• /
• v.12 no.1
• /
• pp.24-30
• /
• 1979

This study was conducted to find out the most suitable weight-height index out of the $weight/height^{p}-type$ indices that could be used for the evaluation of nutritional status in an epidemiological survey and for the screening of the obesity. The subjects were chosen randomly, 2,182 males and 719 females from college students and office workers in Seoul districts. The 'best' power-type weight-height index for Korean men and women of all ages from 16 to 59 was found to be $weight/height^{1.54}$ for males and $weight/height^{1.42}$ for females. $Weight/height^2$ (Kaup index), however, was the best suited weight-height index for each age group of both sexes except that relative weight (weight/height) was considered to be desirable to apply for males of teen-aged and of over fifties and for females of over forties of age. Normal ranges of Kaup index values for males and females of each age group were presented in tables 5 and 6. These findings suggest that Koreans are generally leaner than other ethnic groups of the same sex and age.