• 한국화재소방학회논문지
• /
• 제23권1호
• /
• pp.21-32
• /
• 2009

본 연구에서는 임내 연료의 산불 위험성을 판단하기 위하여 영동지역에 자생하는 주요 7가지 수종의 낙엽과 생엽을 대상으로 TG/DTA와 발화점 시험기를 이용하여 열적특성과 발화특성을 고찰하였다. 가열속도 변화에 따른 열 중량변화를 분석한 결과, 가열속도가 증가할수록 열적 지연현상이 나타났지만 중량감소율에 따른 잔류량은 차이가 없는 것으로 나타났다. 수종별 온도변화에 따른 열 중량분석 결과, 낙엽과 생엽 모두 침엽수가 활엽수보다 총중량감소율이 큰 것으로 나타났다. 발화특성에 대한 분석결과로는 낙엽과 침엽수의 자연발화온도가 낮고 열에 대한 저항성이 낮기 때문에 생엽과 활엽수보다 발화 위험성이 높은 것으로 나타났다.

• 설비공학논문집
• /
• 제26권4호
• /
• pp.163-168
• /
• 2014

The plate heat exchanger has been widely used in water heating systems due to high efficiency, simple structure, and easy maintenance. However, the studies on the effects of fouling on the heat transfer performance under various operation and maintenance conditions are very limited in the open literature. The objective of this study is to investigate the effects of fouling with calcium carbonate ($CaCO_3$) on the heat transfer characteristics of the plate heat exchanger under various operating and geometric conditions. The heat transfer coefficient and pressure drop in the plate heat exchangers were measured under accelerated fouling conditions with $CaCO_3$ by varying geometric and operational parameters. The fouling resistance increased with the decrease in the flow rate, and the increase in the chevron angle and the concentration.

• Journal of Welding and Joining
• /
• 제5권3호
• /
• pp.53-61
• /
• 1987

Post weld heat treatment(PWHT) is usually carried out to remove the residual stress and to improve the microstructure and mechanical properties of welded joints. By the way, welding structure transformed owing to PWHT and reheating for repair loads the random cycles fatigue as offshore welding structure of constant low cycle fatigue as pressure vessel, and then, pre-existing flaws or cracks exist in a structural component and those cracks grow under cyclic loading. Therefore, the effects of PWHT and stress ratio on fatigue crack growth behaviors were studied on the three regions such as HAZ, sub-critical HAZ and deposit metal of welded joints in SM53 steel. Fatigue crack growth behavior of as-weld depended on microstructure and fatigue crack growth rate of HAZ was the lowest at eac region, but after PWHT it was somewhat higher than that of as-wel. In case of applying the stress($10kg/mm^2$) during PWHT, fatigue crack growth resistance tended to increase in the overall range of .DELTA.K.

• 동력기계공학회지
• /
• 제8권3호
• /
• pp.30-35
• /
• 2004

In the steel making industries, the continuous casting process has been applied to the number of company because of its economical benefit. Casting rolls are utilized for frictional drive and transport of solidifying slap. Dimensional tolerances, mechanical stability and surface condition of the cast roll can affect both the surface and internal quality of the product being cast. To overcome these problems, the industry is accelerating on the rate of technology improvements. Samples were overlaid on the S45C steel by submerged arc welding process. And the hardness, wear, electrochemical corrosion and oxidation tests were carried out. Test results were that all these materials were satisfying basic requirements of caster rolls. By these results, the addition of 0.1%Nb and 0.15%V increase mechanical properties and tempering resistance by its superior carbide forming characteristics in low carbon $12{\sim}13%Cr$ martensitic stainless steels.

• 약학회지
• /
• 제38권2호
• /
• pp.191-196
• /
• 1994

Higenamine is a tetrahydroisoquinoline alkaloid which was isolated as a cardiotonic principle from Aconiti tuber. 1.v. injection of higenamine was reported to increase the cardiac output and heart rate and to decrease the blood pressure and the systemic vascular resistance presumably by stimulating the adrenergic ${\beta}-receptors$. The anti-platelet and anti-thrombotic effects of higenamine were investigated in this paper. Higenamine(0.5 mg/ml) showed mild inhibitory effect against collagen induced platelet aggregation in vitro and the inhibito교 effect was increased with the pre-incubation$(5{\sim}30\;min)$ of platelet rich plasma(PRP) with higenamine. With the 30 min incubation, the platelet aggregation was almost completely inhibited. And the oral administration of higenamine$(50{\sim}200\;mg/kg)$ enhanced the survival in the mouse model of thrombosis and that of endotoxic shock. The anti-thrombotic and anti-septic effects of higenamine thus appear to be due to the ${\beta}-agonistic$ and the anti-platelet effects of this compound.

• 한국막학회:학술대회논문집
• /
• 한국막학회 1994년도 춘계 총회 및 학술발표회
• /
• pp.51-52
• /
• 1994

High permeability, selectivity and stability are the basic properties also required for membrane gas separations. The $CO_2$ separation by liquid membranes has been developed as a new technique to improve the permeability and selectivity of polymeric membranes. Sirkar et al.(1) have atlempted the hollow-fiber contained liquid membrane technique under four different operational modes, and permeation models have been proposed for all modes. Compared to a conventional liquid membrane, the diffusional resistance decreased by the work of Teramoto et al.(2), who referred to a moving liquid membrane. Recently, Shelekhin and Beckman (3) considered the possibility of combining absorption and membrane separation processes in one integrated system called a membrane absorber. Their analysis could be predicted effectively the performance of flat sheet membrane, however, there are restrictions for considering a flow effect. The gas absorption rate is determined by both an interfacial area and a mass transfer coefficient. It can be easily understood that although the mass transfer coefficients in hollow fiber modules are smaller than in conventional contactors, the substantial increase of the interfacial area can result in a more efficient absorber (4). In order to predict a performance in the general system of hollow-fiber membrane absorber, a gas-liquid mass transfor should be investigated inevitably. The influence of liquid velocity on both a mass transfer and a performance will be described, and then compared with experimental results. A present study is attempted to provide the fundamentals for understanding aspects of promising a hollow-fiber membrane absorber.

• 공업화학
• /
• 제20권4호
• /
• pp.396-401
• /
• 2009

전기이중층 캐패시터의 성능향상을 위한 전극물질로서 resorcinol-formaldehyde수지를 탄소원으로 사용하여 meso-pore 비율 52~64%의 기공특성을 지니며 직경 $2{\sim}10{\mu}m$의 미세구형 활성탄을 제조하였다. 이 활성탄을 전기이중층에 적용한 결과, meso-pore구조의 미세구형활성탄은 전하전달저항의 저감 및 충방전율 수용능력 향상에 효과적인 영향을 나타내어 전기이중층 캐패시터의 성능향상을 위한 효과적인 전극물질이 될 수 있음을 확인할 수 있었다.

• 한국전기전자재료학회논문지
• /
• 제22권11호
• /
• pp.969-973
• /
• 2009

In this study, the electrical and optical properties of $(SiO_2)_x(ZnO)_{100-x}$ (SZO) films prepared on the coming 7059 glass substrates by using rf-magnetron sputtering method are investigated. The deposition rate becomes maximum near 3 wt.% and gradually decreases when the $SiO_2$ content further increases. The growth rates of the SZO film with $SiO_2$ content of 3 wt.% is $4\;{\AA}/s$. We found that the average transmittance of all films is over 80% in the wavelength range above 500 nm. The optical band gap were decreased from 3.52 to 3.33 eV as an increase the deposition thickness. X-ray diffraction patterns showed that the film with a relatively low $SiO_2$ content (< 4 wt.%) is amorphous. SZO film with the $SiO_2$ contents of 2 wt.% showed the resistivity of about $3.8{\times}10^{-3}\;{\Omega}{\cdot}cm$. The sheet resistance decreases with increasing the heat treatment temperature.

• 한국정보처리학회논문지
• /
• 제4권6호
• /
• pp.1565-1575
• /
• 1997

DES 암호 알고리즘을 대체 할 수 있는 112 비트의 키 길이를 갖는 EDES라는 새로운 알고리즘이 [1,2]에서 제안 되었다. 평문은 96비트로 입력되며, 이것은 각각 32비트의 3개의 서브 블록으로 분리된다. EDES는 S-box를 8비트에서 16비트로 증가하였으며, 3개의 서브블럭에 있는 f 함수들이 비대칭적으로 수행되기 때문에 differential cryptanalysis 보다 암호 강고가 강하다. 본 논문은 EDES에 대한 하드웨어의 설계와 VLSI로 구현되는 것을 제안한다. 암호화와 복호화는 VLSI의 단일 칩내에서 구현되도록 하였으며, 만약 시스템의 클럭 주파수가 15Mhz이면 약 90Mbit/sec로 암호화 할 수 있다. 그러므로 구현된 칩은 초고속망의 프로토콜에서 온라인으로 데이터를 암호화 하는데 적용될 수 있다.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2007년도 추계학술대회 논문집
• /
• pp.1273-1278
• /
• 2007

The cement-asphalt mortar is a mixture of cement and asphalt emulsion, and is utilized as a underpouring materials for the railway track which is used to fill under slab panel space so as to provide a stabilized track support and a tool for reduction of noise and vibration. To increase the workability of grouting, this study investigates the effect of temperature on cement-asphalt mortar by analyzing its physical and mechanical properties before/after hardening according to the temperature (10, 15, 20, 25, $30^{\circ}C$). According to the test results, it is found that as for the physical property of fresh cement-asphalt mortar the more mixture temperature become higher or lower, the more fluidity become worse. But by increasing reducing agent amount and its unit quantity, the required fluidity is met. The compressive strength as physical property of hardened cement-asphalt mortar become lower when temperature is lower but taking it by and large the physical properties of cement-asphalt mortar before/after hardening aren't so affected by temperature and well satisfy the requirement. And it has proved that rate of expansion and freezing and thawing resistance aren't affected by temperature.