• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.15 no.4
• /
• pp.119-132
• /
• 2012

The unmanaged abandoned concrete roads are vulnerable toward the issues on soil and water pollution, which requires flexible managing method such as eco-corridor after the process of ecological restoration. Among various alternations of abandoned concrete-paved roads, ecological restoration technique may be the most suitable method in sites including high quality of natural environment. Therefore, as in Young dong province, GyungBu express highway (227.24~229.04km), which is near to Hwang-gan IC, the survey to measure its effect of soil under the paving and water pollution by abandoned concrete roads was discussed. Then, the restoration method of plantings of landscape trees and hydro-seeding methods of artificial soil media was appraised through consecutive monitoring. The soil adequacy analysis shows lower percentage of heavy metal substance in each depth level compared to standard limit stated by the Ministry of Environment, along with low concerns raised after the analysis on heavy metal content of the spilled water on the concrete roads. Meanwhile, Korean Weigela (Weigela subsessilis L.H. Baily) was found to be withered in small-scale landscape trees planting sites. Among the seeding plants. the family of leguminosae, Silene armeria, Dendranthema boreale, Caryopteris incana and Aster yomena show good establishment results. Overall studies on planting of small and large landscape trees, planting method of container plants, planting method of ground cover plants, and germination and development trend of seeding plants of the experimental restoration site on abandoned concrete roads are revealing specific trends in the way landscape woody plants establishment and growth. Finally, this study suggests further studies and survey on varied plant restoration methods on abandoned concrete-roads for developed design guidelines of their methods.

• Journal of the Institute of Convergence Signal Processing
• /
• v.8 no.3
• /
• pp.211-216
• /
• 2007

The quality of tap water on the whole water-supply system, from a large filtration plant to a private faucet, has to be guaranteed the standards of drinking water. At this point in time, however, the supply process of the tap water has not been monitored and managed scientifically. The piped water, especially the most small-scale reservoirs(underground or overhead type) are always exposed to various contaminations and impurities. Recently monitoring systems of water-quality were spread on some large filtration plants or distributing reservoirs. In particular, the water quality monitoring method using the internet is adopted into some local government whose inhabitants can check up the water quality anytime and anywhere. The construction of this system that has to apply a large scale needs, and has a limitation on the small water-supply system, such as apartments, public facilities and small-scale underground or overhead reservoirs. In this work, we suggest the integration system of individual water-quality sensor modules that have a low price. By using the developed integration system and monitoring program operated on the internet, the system managers of reservoirs can monitor and manage water-quality characteristic values of drinking water in online. Since the proposed system was modularized, the system can be applied easily into various reservoirs with a low cost and regardless of its scale, small or large.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.21 no.4
• /
• pp.286-296
• /
• 2019

Land suitability assessments have been a crucial issue for enhancing productivity in agriculture and conserving agricultural lands. Based on soil and climate information, land suitability assessment for peaches (Prunus persica) and grapes (Vitis vinifera L.) were conducted using the maximum limiting characteristic method (MLCM) in South Korea. In peaches, S1 (highly suitable) exists on 2.21% of the land, S2 (moderately suitable) on 19.20%, N1 (currently not suitable) on 12.07%, and N2 (permanently not suitable) on the remaining 66.52%. In grapes, 3.65% of the land is classified as S1, 17.98% as S2, 11.85% as N1 and 66.52% as N2. In both fruit trees, the results acquired from soil and climatic information were similar to those from soil information alone. The data also suggest that the grades by soil information were relatively low over the land. With the assumption that the more suitable area a province has, the more will be cultivated for the fruit trees, we compared the percentages of area for peach and grape farming per province with the results by MLCM, and suggested that some provinces with a small percentage of farm can be encouraged to plant more in suitable areas as dictated by MLCM for the species. In the near future, we plan to use an advanced method such as analytic hierarchy process (AHP) to conduct similar tests, in which having reference data of yields or benefits per farm can efficiently increase the accuracy of the measurements.

• Applied Chemistry for Engineering
• /
• v.17 no.1
• /
• pp.22-27
• /
• 2006

Thermal treatment and ozone oxidation methods were examined to reuse waste activated sludge (WAS) produced from a livestock wastewater treatment plant. Analysis of WAS property was made to study usefulness of the recycled waste as fertilizer. From the results of quantitative analysis, WAS particles were found to be composed of 44.25 wt% carbon, 8.43 wt% nitrogen, and 1.35 wt% phosphorus. It was confirmed that the inactivation of pathogenic microorganism was required from the quantitative analysis of microbes. From the results of TSS, COD, SCOD, and pathogenic microorganism measurement, the optimal operating conditions of thermal treatment and ozone oxidation were determined to be 70, 10 min and $0.6L\;O_3/L\;solution{\cdot}min$, 60 min, respectively. The optimized thermal treatment and ozone oxidation represented the efficient pathogen inactivation and particle dissolution, respectively. However, the two methods examined were not themselves sufficient but they need to combine with another treatment for the effective reuse of wastes.

• Applied Chemistry for Engineering
• /
• v.17 no.5
• /
• pp.552-556
• /
• 2006

An advanced oxidation process catalyzed by iron ions in the presence of hydrogen peroxide, the so-called Fenton's reaction, has been applied to the treatment of steam generator chemical cleaning waste containing highly concentrated iron(III)- ethyl-enediaminetetraaceticacid (Fe(III)-EDTA) of 70000 mg/L. The experiments for the degradation of Fe(III)-EDTA were carried out not only with a simulated waste, but also with the real one. The effect of pH and the amount of hydrogen peroxide added to the waste on the degradation was examined, and the results were discussed in several aspects. The optimal pH to maximize the degradation efficiency was dependent on the amount of hydrogen peroxide added to the waste. i.e., when the amount of hydrogen peroxide was different, maximum degradation efficiency was obtained at different pH's. The optimal amount of hydrogen peroxide relative to that of Fe(III)-EDTA was found to be 24.7 mol ($H_{2}O_{2}$)/mol (Fe(III)-EDTA) at pH around 9.

• Journal of Radiation Protection and Research
• /
• v.38 no.4
• /
• pp.228-233
• /
• 2013

It has been continuously generated the requirement for the replacement of the main components such as a steam generator due to the deterioration of the nuclear power plant all around the world. Also, a large amount of radioactive metal was generated during the decommissioning in a short period. It is required to make an accurate measurement of the residual radioactivity for recycling the metal waste for releasing from regulatory control. In planning the measurement procedures, the influence of geometry, self-absorption, density and other relevant factors on the representativeness of the measurements should be considered for the decommissioning metal waste. In this study, the method for measurement procedures, the source term evaluation, the ways to secure representative samples, the measurement device for wide area and the self-absorption correction factors for different density were evaluated. The metal samples for measurement were prepared for securing the simple geometry and representative by melting process. The developed correction method for measuring the radioactivity a variety density of metal waste could improve the reliability of the evaluation results for clearance.

• Korean Journal of Environment and Ecology
• /
• v.30 no.2
• /
• pp.228-242
• /
• 2016

This research was conducted for understanding the evergreen forest community structure of the Bijin Island. The island was worth of vegetational value because of the representative warm temperate species such as Castanopsis cuspidata was distribute there. According to the results of community classification by TWINSPAN and DCA, the Bijin Island evergreen forest were classified by 9 communities, such as C. cuspidata, C. cuspidata-Pinus thunbergii, Neolitsea sericea-Camellia japonica, Platycarya strobilacea, Quercus serrata-Decidus broad-leaved, Alnus firma, P. thunbergii. Due to the C. cuspidata, N. sericea, Ca. japonica etc. were still dominated at canopy and under-canopy layer, so the evergreen forest will be sustain current conditions for a while if there is no artificial disturbances that were caused by human. Pl. strobilacea community will be expected to replace N. sericea and also Q. serrata-Decidus broad-leaved community will be changing caused by mutual competition. Normally, in the way of the succession process of the warm temperate forest, P. thunbergii will be expect via deciduous broad-leaved to evergreen forest such as Machilus thunbergii, C. cuspidata var. sieboldii, and N. sericea. In case of species diversity index, P. thunbergii comm.(1.2739), Q. serrata-Decidus broad-leaved comm.(1.2325), Decidus broad-leaved comm.(1.1807), and A. firma comm.(1.0854) are relatively high, while C. cuspidata and N. sericea-Ca. japonica that was dominated by evergreen species at canopy layer and P. thunbergii that was damaged by fire are relatively low(0.7380~0.8416). Soil pH was 4.72~6.33, electric conductance was 0.035~0.128dS/m, and content of organic matter was 3.4~17.4%.

• Clean Technology
• /
• v.5 no.1
• /
• pp.78-85
• /
• 1999

In the Kimchi manufacturing industry that has recently been on its greatest growth, the rinsing process for salt-pickled Chinese cabbage in a brining step generates a vast amount of rinsing wastewater containing salts, colloids, and organics released from the raw material. In this study, the experimental method was developed to optimize the rinsing water consumption and thus to minimize the rinsing wastewater generation. The continuous counter-current rinsing basin in the actual plant was simulated through the lab-scale three batch-wise rinsing tanks. Rinsing efficiencies for the brined cabbage from the same brining tank were almost in the same level, whereas those varied substantially from source to source in the raw Chinese cabbage provided. When rinsing water used were decreased from 3.3 L/head to 2.7 L/head, no significant change was observed with respect to COD, turbidity, conductivity, $Na^+$, and $Cl^-$ concentrations in the extracted solution of the rinsed cabbage. However, the quality of the extracted solution was badly deteriorated as the amount of rinsing water used dropped down to below 2.7 L/head. The reduction of rinsing water up to 18% was proved to be possible without any negative effect on the quality of the product, Kimchi.

• Korean Journal of Agricultural Science
• /
• v.13 no.2
• /
• pp.255-264
• /
• 1986

The objectives of this study were to examine the viscoelastic behaviour of stem samples of rice in force-relaxation and rheological model to represent its relaxation behaviour, and to study the effects of rate of deformation and initial deformation on the relaxation time. The results were as follows; 1. In the process of loading and unloading, there is any plastic deformation so called elasto-plastic hysterisis. 2. Loading and unloading of stem of rice for several cycles has also shown the reduction of plastic or residual deformation and work hardening. 3. The relaxation behaviour of stem of rice in compression may be described by a generalized Maxwell model consisting of three Maxwell units in parallel. The rheological equation of such a model is given as $$F(t)=C_1e^{{-t/{\tau}}_1}+C_2e^{{-t/{\tau}}_2}+C_3e^{{-t/{\tau}}_3}$$ 4. Force relaxation always increased with increasing rates of deformation and initial deformation.

• Korean Journal of Materials Research
• /
• v.9 no.10
• /
• pp.1018-1024
• /
• 1999

The effects of operating temperature and stress on degradation of components in high temperature steam generator were investigated. Several 2.25CrlMo tubes which had operated over 20 years and an unused 9CrlMoVNb tube were tested. For the former samples, the amount of $\textrm{M}_{6}\textrm{C}$ carbide and its size are increased with the aging or operating time. The precipitation behavior of carbides ($\textrm{M}_{2}\textrm{O}$, $\textrm{M}_{6}\textrm{C}$) is changed with the operating temperature of the tubes. However, unused 9CrlMoVNb samples show a different carbide precipitation process due to high chromium, vanadium, and niobium contents. The amount of Cr-rich $\textrm{M}_{23}\textrm{C}_{6}$ carbide is significantly increased with aging time, but that of $\textrm{M}_{6}\textrm{C}$ type carbide is rarely changed with aging time at elevated temperatures.