• Composites Research
• /
• v.32 no.6
• /
• pp.307-313
• /
• 2019

Triboelectric nanogenerators (TENGs), which are combined effects of triboelectricity and electric induction, is a large-area and low-cost technology that can be applied easily in our life. In this work, we applied life supplies to TENGs and analyzed a type of chemical bonding with the ratio of C-C/C-H/C-O/C=O bonding. As the ratio of C-C bonding increases, the materials can be positively charge. On the other hands, as the ratio of C-H bonding increases, the materials can be negatively charged materials. Based on these behaviors, we got a voltage of 210V, a current of 14.6 ㎂ and a maximum power of 9.8mW. Finally, we could turn on 97 light emitting diodes (LEDs) by using a wrap as a negative material and a magnetic note as a positive material.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.9
• /
• pp.1263-1307
• /
• 2002

Pseudo-first-order rate constants (kobs) have been determined for the nucleophilic substitution reactions of p-nitrophenyl diphenyl phosphinate (PNPDPP) with substituted phenoxides (XC6H4O - ) and butane-2,3-dione monoximate (Ox- ) in 0.1 M borate buffer (pH = 10.0) at 25.0 ${\pm}0.1^{\circ}C$. The kobs value increases sharply upon addition of cethyltrimethylammonium bromide (CTAB) to the reaction medium up to near 7 ${\times}$ 10-4 M CTAB and then decreases smoothly upon further addition of CTAB. The rate enhancement upon the addition of CTAB is most significant for the reaction with -O2CC6H4O- and least significant for the one with C6H5O- , indicating that the reactivity of these aryloxides in the presence of CTAB cannot be determined by the basicity alone. The strength of the interaction of these anionic aryloxides with the positively charged micellar aggregates has been suggested to be an important factor to determine the reactivity in the presence of CTAB. The kobs value for the reaction with Ox- increases also upon the addition of CTAB. However, the increase in the kobs value is much more significant for the reaction with Ox- than for the one with ClC6H4O- , indicating that Ox- is less strongly solvated than ClC6H4O- in H2O. The ${\alpha}-effect$ shown by Ox- in H2O has been attributed to the ground-state solvation difference between Ox- and ClC6H4O- .

• Journal of Microbiology and Biotechnology
• /
• v.27 no.11
• /
• pp.1999-2009
• /
• 2017

The secretion efficiency of a protein in a Sec-type secretion system is mainly determined by an N-terminal signal peptide and its combination with its cognate protein. Five signal peptides, namely, two synthetic Sec-type and three Bacillus licheniformis alpha-amylase-derived signal peptides, were compared for periplasmic expression of the human growth hormone (hGH) in E. coli. Based on in silico predictions on the signal peptides' cleavage efficiencies and their corresponding mRNA secondary structures, a number of amino acid substitutions and silent mutations were considered in the modified signal sequences. The two synthetic signal peptides, specifically designed for hGH secretion in E. coli, differ in their N-terminal positively charged residues and hydrophobic region lengths. According to the mRNA secondary structure predictions, combinations of the protein and each of the five signal sequences could lead to different outcomes, especially when accessibility of the initiator ATG and ribosome binding sites were considered. In the experimental stage, the two synthetic signal peptides displayed complete processing and resulted in efficient secretion of the mature hGH in periplasmic regions, as was demonstrated by protein analysis. The three alpha-amylase-derived signal peptides, however, were processed partially from their precursors. Therefore, to achieve efficient secretion of a protein in a heterologous system, designing a specific signal peptide by using a combined approach of optimizations of the mRNA secondary structure and the signal peptide H-domain and cleavage site is recommended.

• Health Policy and Management
• /
• v.6 no.1
• /
• pp.144-162
• /
• 1996

This study was conducted to identify the problems related to operation of the committee system in university hospitals and to propose the direction for reforming it. Data were collected by surveying 138 working-level administration managers of committees from 12 university hospitals in Seoul in October, 1995. The results were as follows: 1. The purposes of the committee were to promote the reasonable dicision making in the hospitals, to satisfy the requirement of Hospital Accreditation Program and, to execute the administrational instructions in due order. The sort of job which was charged of chairmen and the majority of committee member was doctor. 2. The committees which were to be held the meeting frequently in a year were general management committees(8.25 times/year). But in case of operation rate, medical care-related committees showed the most frequent meeting(90.15%). Most of committees made the regulations and reported the results of their meeting to the CEO of their hospitals by written documents. 3. Most doctors thought the medical care-related committees useful. Medical technicians regarded education and research-related committees as useful, while administrators favored the general management committees. 4. The factors related to the perceived performance of the committee were the kind of job, the class of job and the kind of committee. Also, the perceived performance of the committee was positively related to the usefulness in efficient management of work, and negatively to uncertainties in responsibility and a nominal role of the committee. 5. Most of the respondnts thought that the concern of the top manager about the committee was the most important factor for the improvement of committee system at hospitals. They also regarded that formalization of the objectives and regulation rule and composition of committees with members which work in various fields as essential. Further studies on the organizational and operational cjharacteristics which include general hospitals in various areas are required.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.3 no.4
• /
• pp.293-300
• /
• 2005

Ultrasonic decontamination of the type 304 stainless steel specimen loosely contaminated with $Eu_2O_3$ powders was investigated. Decontamination factors (DFs) by the three kinds of ultrasonic media such as water, pure PFC (Pefluorocarbon, $C_7F_{16}$) and a mixed solution of $99.9\;vol\%\;PFC\;and\;0.1\;vol\%$ anionic surfactant were determined. The determined DF values were 20, 50 and 200, respectively. This significant difference in the decontamination factors for the different decontamination solution was well explained by the surface tension of the media as well as the interaction between the positively charged surface of $Eu_2O_3$ powders and the anionic surfactant. Ultrasonic decontamination behavior of the loosely contaminated metal specimens such as plate, pipe, welding specimen and crevice specimen in the mixed solution of PFC and anionic surfactant was also investigated. The contaminants were completely removed for the tested specimens except for the longest specimen. For 6-cm long pipe specimen, however, $98.5\%$ of the contaminants were removed.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.47.1-47.1
• /
• 2011

We report on a direct measurement of two-dimensional chemical and electrical distribution on the surface of photovoltaic Cu(In,Ga)$Se_2$ thin-films using a nano-scale spectroscopic and electrical characterization, respectively. The Raman measurement reveals non-uniformed surface phonon vibration which comes from different compositional distribution and defects in the nature of polycrystalline thin-films. On the other hand, potential analysis by scanning Kelvin probe force microscopy shows a higher surface potential or a small work function on grain boundaries of the thin-films than on the grain surfaces. This demonstrates the grain boundary is positively charged and local built-in potential exist on grain boundary, which improve electron-hole separation on grain boundary. Local electrical transport measurements with scanning probe microscopy on the thin-films indicates that as external bias is increases, local current is started to flow from grain boundary and saturated over 0.3 V external bias. This accounts for carrier behavior in the vicinity of grain boundary with regard to defect states. We suggest that electron-hole separation at the grain boundary as well as chemical and electrical distribution of polycrystalline Cu(In,Ga)$Se_2$ thin-films.

• Journal of Pharmaceutical Investigation
• /
• v.40 no.2
• /
• pp.91-100
• /
• 2010

The objective of this work is to study transdermal delivery of donepezil hydrochloride (DH) using iontophoresis and to evaluate various factors which affect the transdermal transport. After the flux study using 4 kinds of hydrogel, hydrogel containing 8% poly(ethylene oxide) (PEO) was chosen as the hydrogel for further studies. Under experimental condition, DH was stable. We have studied the effect of polarity, current density, drug concentration and current profile on transdermal flux and compared the results. In vitro flux study was performed at $33^{\circ}C$, using side-by-side diffusion cell and full thickness hairless mouse skin. DH is positively charged at pH 7.4, and anodal delivery was much larger than cathodal and passive delivery at all current densities studied (0.2, 0.4 and 0.6 mA/$cm^2$). Cathodal delivery showed higher flux than passive flux. Flux increased as the concentration of DH in hydrogel increased. Pulsatile application of current showed smaller flux value than the application of continuous current. Based on these results, we have evaluated the possibility of delivering enough amount of DH to reach the therapeutic level. The maximum cumulative amount of DH transported for 12 hours was 455 ${\mu}g/cm^2{\cdot}hr$ when the amount of DH in the hydrogel was 3 mg/mL and the current density was 0.4 mA/$cm^2$. If the patch size is 10 $cm^2$, then we can deliver 4.6 mg for 12 hours. Because the daily dosage of DH is 5 mg, it seems possible to deliver clinically effective amount of DH using iontophoresis. This study also provides some information about the role of electrorepulsion and electroosmosis during the transport through skin.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.2
• /
• pp.242-247
• /
• 1987

Electrophysical phenomena at the silicon semiconductor-electrolyte solution interfaces were analyzed based on the zeta potential of the electrical double layer and microelectrophoresis. The suspensions were composed of the p or n-type silicon particles suspended in the KCI or pH buffer solutions. The approximate diameter of the prepared and sampled sioicon semiconductor pardticles was 1.5\ulcorner. The sign of the zeta poetntials of the p and n-type silicon particles in the KCl and pH buffer solution was positive. A range of electrophoretic mobilities of the p and n-type silicons in the KCl solutions was 5.5-8.9x10**-4 cm\ulcornerV-sec and 4.2-7.9x10**-4cm\ulcornerV-sec, respectively. The range of zeta potentials corresponding to the electrophoretic mobilities is 70.4-114.0mV nad 53.9-101.2mV, respectively. On the other hand, a range of electrophoretic mobilities of the p and n-type silicons in the pH buffer solutions was 1.1x10**-4-2.2x10**-3cm\ulcornerV-sec and 0-2.1x10**-3cm\ulcornerV-sec, respectively. The range of zeta potentials corresponding to the electrophoretic mobilities is 14.1-281.6mV and 0-268.8mV, respectively. The zeta potentials and electrical double layers of the doped silicon semiconductors are decisively influenced by the positively charged ions in the solutions. The maximum values of the zeta potentials in the KCl solutions appeared at a concentration of about 10-\ulcorner. The isoelectric point of the n-type silicon semiconductors appeared at about a pH 7. The effect of the space charge of the doped silicon semiconductors can be neglected compare with the effect of the surface charge.

• Proceedings of the Korean Biophysical Society Conference
• /
• 2003.06a
• /
• pp.68-68
• /
• 2003

HP(2-20) (AKKVFKRLEKLEKLFSKIQNDK) derived from the N-terminus of Helicobacter pylori Ribosomal Protein L1 shows potent antimicrobial activity against bacterial, fungi and cancer cells without cytotoxic effect. In order to investigate the relationships between antimicrobial activity and the structures, several analogues have been designed and synthesized. The structures of these peptides in SDS micelles have been investigated using NMR spectroscopy and they revealed that analogue 3 has the longest, well-defined alpha-helix from Val5 to Trp19. NOESY experiments performed on HP and its analogues in nondeuterated SDS micelles show that protons in the indole ring of Trp16 are in close contact with methylene protons of SDS micelles. In order to probe the position of HP and its analogues relative to the SDS micelles, spin-labeled stearate was added. Large effects are observed for the chemical shifts and the intensities of Phe5, Glu9, Phe12, and Trp16 within the helix region by 16-doxylstearate. This result implies that 16-doxylstearate is located in the center of the micelles and the hydrophobic phase of the amphiphilic ${\alpha}$-helix is located in contact with the acyl chains of the micelles. Also, Lys3 and Lys4 at N-terminus and Lys20 at C-terminus may produce an optimal arrangement for electrostatic interactions between the sulfate head groups of the SDS and the positively charged lysyl N$\sub$3/$\^$+/. Interactions between the indole ring of Trp and the membrane, as well as the amphiphilic ${\alpha}$-helical structure of HP induced by Trp at the C-terminus may allow HP to span the lipid bilayer. These structural features are crucial for their potent antibiotic activities.

• Journal of the Korean Chemical Society
• /
• v.28 no.6
• /
• pp.418-424
• /
• 1984

Rate constants for the hydrolysis of cinnamonitrile in the concentration range of 1 ∼ 5M of perchloric acid at 25$^{\circ}$C have been determined by UV spectrophotometry and from the Bunnett equations, hydration parameters (${\omega}$ = 9.8, ${\omega}^*$ = 0.42 & ${\phi}$=1.6) were obtained. CNDO/2 MO calculations were performed to determine relative stability, net charges, and overlap population of various conformational isomers. The results show that the (E)-planar is more stable than the (Z)-planar and protonation is favored on the nitrogen atom. On the basis of above findings, the acid hydrolysis is initiated by the protonation of the nitrogen atom of cinnamonitrile and then water molecule acting as nucleophile and as a proton transfer agent in the rate determining step. In the transition state of the acid hydrolysis, nucleophilic addition of water molecule occurs by sigma approach to the positively charged $C_7({\alpha}$) atom of the conjugate acid. As the results, we may conclude that the hydrolysis of cinnamonitrile in the strong acidic media proceeds through the A-2 type mechanism.