• Structural Monitoring and Maintenance
• /
• v.2 no.2
• /
• pp.145-164
• /
• 2015

Bridge scour is the predominant cause of overwater bridge failures in North America and around the world. Several sensing systems have been developed over the years to detect the extent of scour so that preventative actions can be performed in a timely manner. These sensing systems have drawbacks, such as signal inaccuracy and discontinuity, installation difficulty, and high cost. Therefore, attempts to develop more efficient monitoring schemes continue. In this study, the viability of using optical dissolved oxygen (DO) probes for monitoring scour depths was explored. DO levels are very low in streambed sediments, as compared to the standard level of oxygen in flowing water. Therefore, scour depths can be determined by installing sensors to monitor DO levels at various depths along the buried length of a bridge pier or abutment. The measured DO is negligible when a sensor is buried but would increase significantly once scour occurs and exposes the sensor to flowing water. A set of experiments was conducted in which four dissolved oxygen probes were embedded at different soil depths in the vicinity of a mock bridge pier inside a laboratory flume simulating scour conditions. The results confirmed that DO levels jumped drastically when sensors became exposed during scour hole evolution, thereby providing discrete measurements of the maximum scour depth. Moreover, the DO probes could detect any subsequent refilling of the scour hole through the deposition of sediments. The effect of soil permeability on the sensing response time was also investigated.

• Journal of Korea Water Resources Association
• /
• v.30 no.4
• /
• pp.335-346
• /
• 1997

This study aims at examining closely the scour around a pier due to irregular water stage changes during flood. At the Sangye bridge is located lowermost downstream of the Bocheong stream in the Kum River, the IHP experimental watershed. For this purpose, we have analyzed the change of scour depths due to stage hydrographs of experimental basin by a simulation. To examine the scour phenomenon around a pier due to irregular stage change in flood, we have analyzed the change of scour depth corresponding to stage hydrograph of field watershed after verification of model channel. From this study, the following conclusions are made: First, in case of predicting the maximum scour depth around a pier with stage hydrograph in the state of steady flow, we should choose the highest stage. Second, after increasing the stage, the equilibrium scour depth became smaller than the maximum scour depth. Therefore, in case of estimating the maximum scour depth in rivers, it is recommended that we should consider additional scour depth with is reduced by infilling the sediments.

• Proceedings of the Korea Water Resources Association Conference
• /
• 1987.07a
• /
• pp.87-87
• /
• 1987

Bridge piers are sometimes damaged by local scour. Although the problem of local scour around pier has been studied extensively, it has been difficult to estimate local scour deth quantitatively. This study is concerned with local scour around semicylindrical piers arranged in various types under the condition of clear water scour. Through dimensional analysis, it was found that scour depths were relative to Re, Fr, and Ns. In the case of semicylindrical piers, the variation of dimensionless scour depth with dimensionless time (effect of Ns, pier diameter and length, incidence angle) and the variation of scour depth with vortex intensity and resistance are investigated experimentally to obtain a formula. And forula for estimating the maximum depth of scour is obtained.

• Water for future
• /
• v.20 no.1
• /
• pp.41-47
• /
• 1987

Bridge piers are sometimes damaged by local scour. Although the problem of local scour around pier has been studied extensively, it has been difficult to estimate local scour depth quantitatively. This study is concerned with local scour around semicylindrical piers arranged in various types under the condition of clear water scour. Through dimensional analysis, it was found that scour depths were relative to Re, Fr, and Ns. In the case of semicylindrical piers, the variation of dimensionless scour depth with dimensionless time (effect of Ns, pier diameter and length, incidence angle) and the variation of scour depth with vortex intensity and resistance are investigated experimentally to obtain a formula. And formula for estimating the maximum depth of scour is obtained.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.1
• /
• pp.163-168
• /
• 2020

Since the industrialization in the 1960s, Korea has been expanding its transportation infrastructure, such as building bridges. Owing to bridge construction, studies on stability review have been carried out, and stability-securing technology has been developed. On the other hand, these were applied mainly to the upper part of the bridge, so applications to the lower part are limited. In particular, scour at the bridge pier causes erosion in the riverbed and bridge collapse. Hence, prevention studies and countermeasures are needed. In this study, an empirical formula was developed to evaluate the scour depth of a bridge, which was calculated through multiple linear regression analysis using the hydraulic model study data conducted in previous studies. The formula, which had a value of 0.91, was applied to the model test data that was not used for development to verify the developed formula. When the pier scour depths were compared in 23 cases, the error rate was less than 20% in 16 cases (70%). The empirical formula developed in this study is applicable to pier scour-depth calculations. Further research will be needed to develop a more accurate empirical formula for pier scour-depth calculations, and it is expected to reduce bridge damage caused by scour.

• Proceedings of the Korea Water Resources Association Conference
• /
• 1997.05a
• /
• pp.122-127
• /
• 1997

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.2B
• /
• pp.169-175
• /
• 2008

The clear-water scour experiments were conducted to shed light on the unsteadiness of the horseshoe vortex around a bridge pier since the fluctuations of velocity components and unsteadiness of the horseshoe vortex can be considered as one of the main factors on local scour. The characteristics of the flow speed and turbulence around a bridge pier was examined using an Acoustic Doppler Velocimeter (ADV) and the flow visualization with kaolin clay particles upstream of a bridge pier. The outcomes of this study on the turbulence characteristics related with scour mechanism were presented with the quadrant analysis, the integral time scales, and the bed shear stresses before and after scouring, respectively. The bed shear stress before scouring was approximately quadruple times higher than that of the equilibriums state. It implies that the unsteadiness of the horseshoe vortex would play a significant role in the initial development of scour depth. Therefore, the bimodal distribution of flow velocity was identified as one of the mechanical properties of the horseshoe vortex and the unsteadiness of horseshoe vortex can be one of the major characteristics to understand the flow sturucture and local pier scour.

• Journal of Korea Water Resources Association
• /
• v.31 no.3
• /
• pp.269-277
• /
• 1998

Laboratory flume experiments to investigate the characteristics of the flows and local scour around circular bridge pier in a curved channel are performed. In this study, the effect of a circular collar device for controlling the depth of scour is examined. The scour depth with a collar is about 40% of the scour depth without collar in the straight course of the flume while it is about 44% of the scour depth without collar at the location of 150' in the curved channel. As the results of experiments using the collar of which diameter is twice of pier, the reduction of scour depth is the most effective in a straight channel when the location of collar is 0.2h( h:depth) below the channel bottom. And, the reduction of scour depth is the most effective in a curved channel when the location of collar is 0.1h below the channel bottom.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.3
• /
• pp.67-74
• /
• 2004

A case study was performed to verify the applicability of existing formulae for predicting bridge scour in cases where its piers are founded in fine-grained soils. The object of study was the Kanghwa Choji Bridge area where the streambed consists of mainly clayey soil. Site investigation included: direct measurement of scour depths around piers using an ultrasonic probe; and collection of undisturbed soil samples which were later used to determine geotechnical properties and scour rate under different stream velocities. Scour depth prediction was made by employing several conventional methods and compared with the measured value. All methods, not taking soil's intrinsic property against erosion into consideration, overestimated scour depth by a factor of 3.6 to 6.5. On the other hand, the SRICOS method yielded a reasonably acceptable overestimation by a factor of 1.7.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.3 no.2 s.9
• /
• pp.139-145
• /
• 2003

This study is to propose reduction effect of scour depth and a optimum size of circular collar through experimental analyses with various collar sizes. To do so, we carried out hydraulic model experiments. In the case of with considering the collar, the effect of reduction of scour depth increased according to the increase of collar size. When size of collar is 2 as the ratio of collar diameter(W) to pier diameter(D), scour depth is decreased about 67% and deposition height is increased about 70%. The optimal size of collar proposed in this study is W/D=2 by analyzing reduction effect of scour depth, size of scour hole, and deposition height.