• Journal of the Optical Society of Korea
• /
• v.13 no.1
• /
• pp.107-111
• /
• 2009

The properties of the chirped fiber Bragg grating (CFBG) as a chromatic dispersion compensator in differential phase-shift-keyed (DPSK) transmission are analyzed. Comparisons of a performance of a CFBG in between DPSK and On-Off Key (OOK) are shown by simulations using the commercial numerical modeling software, $OptSim^{TM}$. In the simulation, we compared the performance of the CFBG when they were used in the RZ-OOK 40 Gbps and the RZ-DPSK 40 Gbps transmission. The simulation results show the performance of an overall transmission with a CFBG in DPSK is inferior to the case of OOK, although DPSK generally has a 3 dB higher SNR (signal-to-noise ratio) than OOK.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.16 no.5
• /
• pp.12-17
• /
• 1979

This paper presents the investigation of the theoretical symbol error performances of an M-ary differential phase-shift-keyed(DPSK) system in an interference environment. A simple method is transmitted over a nondistroting channel, but additively corrupted by Gaussian noise and cochannel interference. Computed DPSK symbol error performance results for M=2, 4, and 8 are compared with the corresponding curves for coherent phase-shift-Keyed(CPSK) system as a function of carrier-to-noise power ratio(CNR) with carrier-to-interferer power ratio(CIR) as a parameter. Comparisons between DPSK systems reveal, as we might expect, that DPSK system suffers more degradation.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.49 no.1
• /
• pp.40-47
• /
• 2000

This paper presents a circuit of resonant voltage resultant type DC/DC converter consists of two unit half-bridge high frequency resonant inverters, and describes operating modes, principle and analysis of the proposed circuit. Also, the analysis of the proposed circuit has generally described by using normalized parameters. Based on the characteristic values, a method of the circuit design is proposed. According to phase shift, the output voltage of the proposed circuit can be controlled. In addition, the justification of theoretical analysis was certified by comparing to the experimental waveforms. In the future, this proposed converter show that it can be practically used as the system of fixed DC voltage source etc.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2005.11a
• /
• pp.251-255
• /
• 2005

This paper proposes a new soft switching technique for a phase-shift controlled bi-directional DC-DC converter. The described converter employs a low profile high frequency transformer and two active full-bridge converters for bidirectional power flow capability. A new soft switching technique is proposed, which guarantees soft switching over wide range (no load to full load) without any additional circuit components. In the proposed switching scheme, the switch pairs in the diagonal position of the converter each are turned on/off simultaneously by the switching signals with a variable duty ratio depending on the phase shift amount, and the converter is operated without freewheeling interval.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.389-391
• /
• 2011

This paper has been studied about design of linear 25Watt Power amplifier for VDR(VHF Data Radio). VDR's frequency band is 117.975~137MHz, and CSMA(Carrier Sense Multiple Access), D8PSK(Differential Eight Phase Shift Keyed), 25KHz's channel bandwidth use. It also stated in DO-281A MOPS output power, symbol constellation error, spurious emissions, adjacent channel power must be met. HPA is designed to meet DO-281A standard.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.4
• /
• pp.951-958
• /
• 2013

This paper proposes the controller design for a stability improvement of an on-board battery charger. The system is comprised of a power factor correction (PFC) circuit and phase shift full-bridge DC-DC converter. The PFC circuit performs the control of the DC-link voltage and the input power factor. The DC-DC converter regulates the voltage and the current in the battery using the DC-link voltage. This paper proposes the design method of PI controller for the PFC circuit using a small signal model. The analysis and design of a type-three controller for the DC-DC converter is also presented. A simulation and experiment has been performed on the on-board battery charger and their results are presented to verify the validity of the proposed system.

• Journal of the Institute of Convergence Signal Processing
• /
• v.10 no.2
• /
• pp.136-140
• /
• 2009

The performances of M-ary signals using L-branch maximum ratio combining (MRC) diversity reception in correlated Nakagami fading channels are derived theoretically. The coherent reception of M-ary differential phase shift keying (MDPSK), phase shift keying (MPSK), and quadrature amplitude modulation (MQAM) is considered. It is assumed that the fading parameters in each diversity branch are identical. The general formula for evaluating symbol error rate (SER) of M-ary signals in the independent branch diversity system is presented using the integral-form expressions. Until now, results did not extend to the various M-ary case for a coherent reception. The numerical results presented in this paper are expected to provide information for the design of radio system using M-ary modulation method for above mentioned channel environment.

• Proceedings of the KIPE Conference
• /
• 2012.07a
• /
• pp.166-167
• /
• 2012

본 논문은 전기자동차 (Electric Vehicles, EVs)용 리튬 이온 (Li-Ion) 배터리의 충전 및 충전 속도 향상을 위하여 6.6kW급 고전력 탑재형 충전기 (On-Board Charger, OBC)를 설계한다. 높은 부하 가변범위와 차량 실장 특성을 고려하여 가용 가능한 토폴로지들 중 최적의 토폴로지로 위상천이 풀-브릿지 컨버터 (Phase-Shift Full-Bridge, PSFB)를 제안하고 타당성을 밝힌다. 또한 토폴로지를 구동하는 스위칭 주파수와 주요 수동소자의 변화에 따른 부피와 효율 등의 Trade-Off 관계를 이론적으로 전개하여 최적화한다.

• Tribology and Lubricants
• /
• v.16 no.5
• /
• pp.317-323
• /
• 2000

The film thickness and shape of elastohydrodynamic lubrication is measured by optical interferometer, which is the most precise method for EHL film measurement. However, the interpretation of the image pattern from optical viscometer is not simple for two-dimensional shape. A newly developed method of image processing makes it possible to evaluate the film thickness and shape in every point of contact region with two dimensional aspects. In this study, we captured the film shape of EHL film by the monochromatic incident light and analyzed the film thickness with the image processing method, which uses phase shift method. From the values of intensity in fringes, the qualitative feature of film thickness in the contact area are obtained by using Zernike polynomial

• Smart Structures and Systems
• /
• v.9 no.6
• /
• pp.549-563
• /
• 2012

Theoretical analysis is performed on a multi-mode energy harvester design with focus on the first two vibration modes. Based on the analysis, a modification is proposed for designing a novel adaptive multi-mode energy harvester. The device comprises a simply supported beam with distributed mass and piezoelectric elements, and an adaptive damper that provides a 180 degree phase shift for the motions of two supports only at the second vibration mode. Theoretical analysis and numerical simulations show that the new design can efficiently scavenge energy at the first two vibration modes. The energy harvesting capability of the multi-mode energy harvester is also compared with that of a cantilever-based energy harvester for single-mode vibration. The results show that the energy harvesting capacity is affected by the damping ratios of different designs. For fixed damping ratio and design dimensions, the multi-mode design has higher energy harvesting capacity than the cantilever-based design.